An uncommon period of cold and change of lapse rate in the Rocky Mountains of Colorado and Wyoming

EXTRACT (SEE PDF FOR FULL ABSTRACT): Temperature and lapse rate show extreme departures from mean values for May 1981 through October 1986 at the high-elevation station D1 on Niwot Ridge in the Front Range, Colorado. If the D1 record is accurate, this period may present an opportunity to identify factors that influence temperature at high elevations, but not necessarily at low elevations. This paper focuses on four questions: (1) Is the D1 temperature record accurate? (2) What is the geographical extent of this anomalous cold period? (3) Are there any identifiable contributing factors or physical events relating to this period? (4) Is there evidence of a similar anomalous period in the past?

A note on the use of ground water for successful breeding of common carps in extremely cold climate

Common carps are known for prolific breeding habits but they generally do not breed in water with temperature value less than 20 degree C. During winter months of 1985 when the temperature ranged from 15.5-20.5 degree C, the common carps were successfully bred by using ground water having temperature of 25-26 degree C and the results are discussed.

Abrasive wear of steel during rolling-sliding contact with rock counterfaces

In many mining operations (e.g. excavation, drilling, tunnelling, rock crushing) metallic components are forced against abrasive rocks in a complex motion. This study examines the relative importance of combined rolling and sliding motion in the two-body abrasive wear of a low carbon tempered martensitic steel against rock counterfaces. A novel wear test rig has been used to vary the amount of rolling and sliding motion between a rotating steel cylinder and a counter-rotating sandstone (highly abrasive) or limestone (much less abrasive) disc. Weight-loss measurements reveal that the wear rate of the steel increases as the amount of motion against the rock counterface is reduced from pure sliding to approximately 50% sliding (and approximately 50% rolling). Scanning electron microscopy shows that when the amount of motion is reduced from pure sliding to approximately 50% sliding the topographical and sub-surface physical properties of the worn steel and rock surfaces are modified.

Comparison of effectiveness of heat and cold shocks applied in the induction of gynogenesis in Clarias gariepinus (Burchell)

An experiment was conducted to optimize the procedure of gynogenesis in African catfish, Clarias gariepinus by suppressing meiotic and mitotic cell divisions in fertilized eggs. Gynogensis was conducted by fertilizing normal eggs with UV-irradiated sperm followed by either heat or cold shocking Irradiation of spermatozoa was given for a duration of 1 min and the eggs were fertilized in vitro. Cold shock at a temperature of 3± 1°C for a duration of 30 and 60 min and heat shock at a temperature of 39± 1°C for a duration of 1 and 2 min was applied to induce diploidy. Higher percentage of hatching (68.66) was observed for meiotic gynogens at a shock temperature of 39± 1°C for a duration of 1 min, 5 min after fertilization (af). Higher percentage of mitotic gynogenetic induction (15.33) was observed at a temperature shock of 39± 1°C for a duration of 1 min, 30 min af.