Pitahaya aging diagnostic by impedance/capacitance spectroscopy

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Classification of intact açai (Euterpe oleracea Mart.) and jucara (Euterpe edulis Mart) fruits based on dry matter content by means of near infrared spectroscopy

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Mapping of clay, iron oxide and adsorbed phosphate in Oxisols using diffuse reflectance spectroscopy

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Paleometry: a brand new area in brazilian science

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Uso da espectroscopia do infravermelho próximo (NIR) como método não destrutivo para a discriminação de aguardentes de cana-de-açúcar produzidas no Estado de São Paulo e Minas Gerais, e predição do teor de etanol

Pós-graduação em Alimentos e Nutrição - FCFAR

Estimativa do número de frutos verdes em laranjeiras com o uso de imagens digitais

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Ex vivo torsional properties of the Targon Vet Nail System in canine femurs: comparison with the 2.4 mm LC-DCP Plate

Pós-graduação em Cirurgia Veterinária - FCAV

Efeito do Ácido Ascórbico em melões 'Orange Flesh' minimamente processados

The aim of this work was to evaluate the application of different concentrations of ascorbic acid on Orange Flesh melon. Whole Melons were sanifi ed with 500 mg L-1 of sodium hypochlorite for 10 minutes and the cuts into cubes with 100 mg L-1 for 1 minute before being tested under different concentrations of ascorbic acid (0, 1, 2 and 3%) in immersion at room temperature for 10 minutes. After drainage, the cuts were packed in PET packages lined with polyethylene fi lm of 18 µm and stored at 5 ± 1°C and 85 ± 5% of RH for 8 days, being evaluated every 2 days. Physicochemical, microbiological and sensorial analyses were performed. The experimental design utilized for the experiment was the completely randomized in factorial scheme. Ten replicates were used for non-destructive analyses and 3 replicates were used for destructive ones. The application of ascorbic acid reduced the loss of mass; the fruits presented a low population of psychrotrophic bacterias, fi lamentous, fungi and yeasts, reduction of soluble solids, pH and fi rmness and, consequently, extended postharvest life of the fruits by 2 days. The appearance, fl avor and taste were also affected. The application of 1% of ascorbic acid was the best treatment for the fresh cuts “Orange Flesh” melons.

Application of dendrogeomorphology on the study of soil sediment deposition in the stems of Guarea guidonea trees in a disturbed riparian forest in Goias state, Brazil

The sediments resulting of natural or anthropic erosion are deposited on the soil surface and around the trunks of trees occurring in riparian forests. For assessment of the erosion, tree-rings of roots and stems were analyzed. Guarea guidonea trees from a riparian forest affected by the sedimentation of soil erosion from pastures and soybean fields in state of Goias were selected. Wood samples were extracted through a non-destructive method at three heights from trunks of trees located in three positions (top, middle and bottom) of a riparian slope. The evaluation revealed a deposition of a thick sediment layer up to 34 cm around the base of tree trunks during the past 24 years. The inter-correlations between the tree-rings widths present in wood samples at the base and at 50 and 100 cm from Guarea guidonea tree trunks presented low, medium and high values. These values resulted from the low tree-rings distinctiveness in the wood; the absence of some rings as well as the eccentricity of the pith. The analyses of dendrogeomorphology allowed the determination of the date of seed germination and tree growth and inference on the periods of sediment deposition in the trunk of the trees.

A palaeobiologist's guide to 'virtual' micro-CT preparation

This paper provides a brief but comprehensive guide to creating, preparing and dissecting a 'virtual' fossil, using a worked example to demonstrate some standard data processing techniques. Computed tomography (CT) is a 3D imaging modality for producing 'virtual' models of an object on a computer. In the last decade, CT technology has greatly improved, allowing bigger and denser objects to be scanned increasingly rapidly. The technique has now reached a stage where systems can facilitate large-scale, non-destructive comparative studies of extinct fossils and their living relatives. Consequently the main limiting factor in CT-based analyses is no longer scanning, but the hurdles of data processing (see disclaimer). The latter comprises the techniques required to convert a 3D CT volume (stack of digital slices) into a virtual image of the fossil that can be prepared (separated) from the matrix and 'dissected' into its anatomical parts. This technique can be applied to specimens or part of specimens embedded in the rock matrix that until now have been otherwise impossible to visualise. This paper presents a suggested workflow explaining the steps required, using as example a fossil tooth of Sphenacanthus hybodoides (Egerton), a shark from the Late Carboniferous of England. The original NHMUK copyrighted CT slice stack can be downloaded for practice of the described techniques, which include segmentation, rendering, movie animation, stereo-anaglyphy, data storage and dissemination. Fragile, rare specimens and type materials in university and museum collections can therefore be virtually processed for a variety of purposes, including virtual loans, website illustrations, publications and digital collections. Micro-CT and other 3D imaging techniques are increasingly utilized to facilitate data sharing among scientists and on education and outreach projects. Hence there is the potential to usher in a new era of global scientific collaboration and public communication using specimens in museum collections.

Bending stiffness evaluation of Teca and Guajara lumber through tests of transverse and longitudinal vibration

The grading of structural lumber besides contributing for increasing the structure's safety, due to the reduction of the material variability, also allows its rational use. Due to the good correlation between strength and bending stiffness, the latter has been used in estimating the mechanical strength of lumber pieces since the 60's. For industrial application, there are equipment and techniques to evaluate the bending stiffness of lumber, through dynamic tests such as the longitudinal vibration technique, also known as stress wave, and the transverse vibration technique. This study investigated the application of these two techniques in the assessment of the modulus of elasticity in bending of Teca beams (Tectona grandis), from reforestation, and of the tropical species Guajara (Micropholis venulosa). The modulus of elasticity estimated by dynamic tests showed good correlation with the modulus measured in the static bending test. Meantime, we observed that the accuracy of the longitudinal vibration technique was significantly reduced in the evaluation of the bending stiffness of Teca pieces due to the knots existing in this species.

Prismatic magnetite magnetosomes from cultivated Magnetovibrio blakemorei strain MV-1: a magnetic fingerprint in marine sediments?

The magnetic properties (first-order reversal curves, ferromagnetic resonance and decomposition of saturation remanent magnetization acquisition) of Magnetovibrio blakemorei, a cultivated marine magnetotactic bacterium, differ from those of other magnetotactic species from sediments deposited in lakes and marine habitats previously studied. This finding suggests that magnetite produced by some magnetotactic bacteria retains magnetic properties in relation to the crystallographic structure of the magnetic phase produced and thus might represent a magnetic fingerprint for a specific magnetotactic bacterium. The use of this fingerprint is a non-destructive, new technology that might allow for the identification and presence of specific species or types of magnetotactic bacteria in certain environments such as sediments.

Aplicação do método de ensaio das frequências naturais de vibração para obtenção do módulo de elasticidade de peças estruturais de madeira

Existem diversas técnicas para caracterização do módulo de elasticidade de madeiras e, dentre as atualmente empregadas, destacam-se aquelas que utilizam as frequências naturais de vibração, por serem técnicas não destrutivas e, portanto, apresentarem resultados que podem ser repetidos e comparados ao longo do tempo. Este trabalho teve como objetivo avaliar a eficácia, dos métodos de ensaios baseados nas frequências naturais de vibração comparando-os aos resultados obtidos na flexão estática na obtenção das propriedades elásticas em peças estruturais de madeira de reflorestamento que são usualmente empregadas na construção civil. Foram avaliadas 24 vigas de Eucalyptus sp. com dimensões nominais (40 x 60 x 2.000 mm) e 14 vigas de Pinus oocarpa com dimensões nominais (45 x 90 x 2.300 mm), ambas sem tratamento; 30 pranchas com dimensões nominais (40 x 240 x 2.010 mm) e 30 pranchas com dimensões nominais (40 x 240 x 3.050 mm), ambas de Pinnus oocarpa e com tratamento preservativo à base de Arseniato de Cobre Cromatado - CCA. Os resultados obtidos apresentaram boa correlação quando comparados aos resultados obtidos pelo método mecânico de flexão estática, especialmente quando empregada a frequência natural de vibração longitudinal. O emprego da frequência longitudinal mostrou-se confiável e prático, portanto recomendada para a determinação do módulo de elasticidade de peças estruturais de madeira. Verificou-se ainda que, empregando a frequência longitudinal, não há necessidade de um suporte específico para os corpos de prova ou calibrações prévias, reduzindo assim o tempo de execução e favorecendo o ensaio de grande quantidade de amostras.

X-Ray analysis to assess mechanical damage in sweet corn seeds

The X-ray test is a precise, fast and non-destructive method to detect mechanical damage in seeds. In the present study, the efficiency of X-ray analysis in identifying the extent of mechanical damage in sweet corn seeds and its relationship with germination and vigor was evaluated. Hybrid 'SWB 551' (sh2) seeds with round (R) and flat (F) shapes were classified as large (L), medium (M1, M2 and M3) and small (S), using sieves with round and oblong screens. After artificial exposure to different levels of damage (0, 1, 3, 5 and 7 impacts), seeds were X-rayed (15 kV, 5 min) and submitted to germination (25 °C/5 days) and cold (10 °C/7 days) tests. Digital images of normal and abnormal seedlings and ungerminated seeds from germination and cold tests were jointly analyzed with the seed X-ray images. Results showed that damage affecting the embryonic axis resulted in abnormal seedlings or dead seeds in the germination and cold tests. The X-ray analysis is efficient for identifying mechanical damage in sweet corn seeds, allowing damage severity to be associated with losses in germination and vigor.

Ensayo de correlación entre los parámetros geofísicos e hidrológicos de los depósitos volcánicos de la Caldera de Bandama (Gran Canaria)

[EN]The geometry and the hydraulic conductivity of the unsaturated zone is difficult to study from traditional techniques, like samples from trenches that normally provide surficial data or boreholes, that are expensive and provide local information. Non-destructive geophysical techniques and among them the electrical resistivity tomography method can be applicable in volcanic areas, where the lava flows and pyroclastic deposits have a wide range of values depending on the degree of fracturing and weathering of lava flows, and porosity and texture of the pyroclastic deposits. In order to characterize the subsurface geology below the golf course of Bandama (Gran Canaria) has conducted a campaign of electrical resistivity tomography profiles.