Predictive control of a current-source inverter for solar photovoltaic grid interface

Solar photovoltaic systems are an increasing option for electricity production, since they produce electrical energy from a clean renewable energy resource, and over the years, as a result of the research, their efficiency has been increasing. For the interface between the dc photovoltaic solar array and the ac electrical grid is necessary the use of an inverter (dc-ac converter), which should be optimized to extract the maximum power from the photovoltaic solar array. In this paper is presented a solution based on a current-source inverter (CSI) using continuous control set model predictive control (CCS-MPC). All the power circuits and respective control systems are described in detail along the paper and were tested and validated performing computer simulations. The paper shows the simulation results and are drawn several conclusions.

The impact of poor power quality in solar photovoltaic microgeneration: technical problems and losses of revenue

This paper presents a critical and quantitative analysis of the influence of the Power Quality in grid connected solar photovoltaic microgeneration installations. First are introduced the main regulations and legislation related with the solar photovoltaic microgeneration, in Portugal and Europe. Next are presented Power Quality monitoring results obtained from two residential solar photovoltaic installations located in the north of Portugal, and is explained how the Power Quality events affect the operation of these installations. Afterwards, it is described a methodology to estimate the energy production losses and the impact in the revenue caused by the abnormal operation of the electrical installation. This is done by comparing the amount of energy that was injected into the power grid with the theoretical value of energy that could be injected in normal conditions. The performed analysis shows that Power Quality severally affects the solar photovoltaic installations operation. The losses of revenue in the two monitored installations M1 and M2 are estimated in about 27% and 22%, respectively.

Three-phase current-source shunt active power filter with solar photovoltaic grid interface

This paper presents the proposal of a three phase current source shunt active power filter (CS-SAPF) with photovoltaic grid interface. The proposed system combines the compensation of reactive power and harmonics with the injection of energy from a solar photovoltaic array into the electrical power grid. The proposed equipment presents the advantage of giving good use to the current source inverter, even when the solar photovoltaic array is not producing energy. The paper describes the control system of the CS SAPF, the energy injection control strategy, and the current harmonics and power factor compensation strategy. Simulation results to assess the performance of the proposed system are also presented.

Interceptação de radiação solar e distribuição espacial de área foliar em floresta de terra firme da Amazônia Central, Brasil

A ocorrência de radiação solar em meio florestal e a sua relação com a distribuição espacial dos elementos vegetais são investigadas neste trabalho. Técnicas experimentais de amostragem de radiação no interior de coberturas vegetais de grande porte são desenvolvidas e testadas, tendo como base dispositivos de suporte móveis constituídos por reticulados modulares suspensos na parte superior das grandes árvores, que permitem a disposição dos sensores de radiação em diferentes níveis de uma mesma vertical e a replicação das medidas em diferentes verticais no interior da cobertura. As medidas de radiação solar foram realizadas no sítio experimental da Reserva Florestal Ducke (02°56' S; 59°57' W), Manaus — Brasil, no período de 29 de outubro a 11 de dezembro de 1998. A inversão de modelo físico de radiação permitiu o estabelecimento da função de densidade de área foliar para a vegetação do local. Os valores obtidos para o índice de área foliar (IAF) nas três verticais em condições de radiação difusa foram 6,6, 6,3 e 6,2.

Atenuação de radiação solar e distribuição vertical de área foliar em floresta - reserva Jaru - Rondônia, Brasil

A atenuação de radiação solar em meio vegetal e sua relação com a distribuição espacial dos elementos vegetais são estudadas neste trabalho. Técnicas experimentais de amostragem de radiação no interior de coberturas vegetais de grande porte são utilizadas, tendo como base dispositivos de suporte móveis constituídos por reticulados modulares suspensos na parte superior das grandes árvores, que permitem a disposição dos sensores de radiação em diferentes níveis de uma mesma vertical no interior da cobertura. As medidas de radiação solar foram realizadas no sítio experimental da Reserva Florestal Jaru (10°05' S; 61°55' W), Ji-Paraná - Brasil, no período de 30 de outubro a 24 de novembro de 1999. A inversão de modelo físico de radiação permitiu o estabelecimento da função de densidade de área foliar com um valor médio de índice de área foliar IAF de 5,6 para a vegetação do local.

Comparative environmental life-cycle analysis of concretes using biomass and coal fly ashes as partial cement replacement material

Nowadays, the concrete production sector is challenged by attempts to minimize the usage of raw materials and energy consumption, as well as by environmental concerns. Therefore, it is necessary to choose better options, e.g. new technologies or materials with improved life-cycle performance. One solution for using resources in an efficient manner is to close the materials' loop through the recycling of materials that result either from the end-of-life of products or from being the by-product of an industrial process. It is well known that the production of Portland cement, one of the materials most used in the construction sector, has a significant contribution to the environmental impacts, mainly related with carbon dioxide emission. Therefore, the study and utilization of by-products or wastes usable as cement replacement in concrete can supply more sustainable options, provided that these type of concrete produced has same durability and equivalent quality properties as standard concrete. This work studied the environmental benefits of incorporating different percentages of two types of fly ashes that can be used in concrete as cement replacement. These ashes are waste products of power and heat production sectors using coal or biomass as fuels. The results showed that both ashes provide a benefit for the concrete production both in terms of environmental impact minimization and a better environmental performance through an increase in cement replacement. It is possible to verify that the incorporation of fly ashes is a sustainable option for cement substitution and a possible path to improve the environmental performance of the concrete industry.

Life cycle analysis of zero waste management for Jonggol green city

A Zero waste management is believed to be one of methods to gain sustainability in urban areas. Take advantages of resources as enough as the needs and process it until the last part to be wasted is a contribution to take care the environment for the next generation. Reduce, reuse, and recycle are three simplesactivities which are until nowadays consideredas the back bone of zero waste. Jonggolgreen city is a new urban area in Indonesia with a 100 ha of surface area zoned as education tourism area. It is an independent area with pure natural resources of water, air, and land to be managed and protected. It is planned as green city through zero waste management since2013. In this preliminary period, a monitoring tool is being prepared by applying a Life Cycle Analysis (LCA) for urban areas [1]. This paper will present an explanatory assessment ofthe zero waste management for Jonggolgreen city. The existing situation will be examined through LCA and afterwards,the new program and the proposed green design to gain the next level of zero waste will be discussed. The purpose is to track the persistence of the commitment and the perception of the necessary innovationsin order to achieve the ideal behavior level of LCA.

Radiação solar e distribuição vertical de área foliar em floresta - Reserva Biológica do Cuieiras ZF2, Manaus

Neste estudo, a distribuição vertical de área foliar em floresta é investigada em conexão com o regime de radiação, usando as medidas de radiação solar realizadas no período de julho a novembro de 2001, na Reserva Biológica do Cuieiras - Manaus ZF2, km 14 e km 34, na Amazônia Central. Técnicas experimentais de amostragem de radiação no interior de coberturas vegetais de grande porte são utilizadas, com dispositivos de suporte móveis constituídos por reticulados modulares, que permitem a disposição dos sensores de radiação em diferentes níveis de uma mesma vertical no interior da cobertura. Inversão de modelos radiativos em coberturas vegetais densas permite as análises sobre a distribuição vertical de área foliar. A variabilidade espacial de área foliar (IAF, função a(z)) é estabelecida para os dois sítios experimentais a partir de medidas de radiação solar, individualizadas em três verticais em cada um desses locais. O índice de área foliar total médio (IAF) da vegetação local para o sítio experimental do km 14 alcançou o valor de 6,4 e para o sítio experimental do km 34 o valor de 6,1. Uma análise comparativa é desenvolvida sobre distribuições verticais de área foliar obtidas em sítios experimentais da Amazônia, usando o mesmo sistema de medidas de radiação solar.

Improving buildings energy performance: comparison between simple payback period and life cycle costs analysis

The building sector is one of the Europeâ s main energy consumer, making buildings an important target for a wiser energy use, improving indoor comfort conditions and reducing the energy consumption. To achieve the European Union targets for energy consumption and carbon reductions it is crucial to act in new, but also in existing buildings, which constitute the majority of the building stock. In existing buildings, the significant improvement of their efficiency requires important investments. Therefore, costs are a major concern in the decision making process and the analysis of the cost effectiveness of the interventions is an important path in the guidance for the selection of the different renovation scenarios. The Portuguese thermal legislation considers the simple payback method for the calculations of the time for the return of the investment. However, this method does not take into consideration inflation, cash flows and cost of capital, as well as the future costs of energy and the building elements lifetime as it happens in a life cycle cost analysis. In order to understand the impact of the economic analysis method used in the choice of the renovation measures, a case study has been analysed using simple payback calculations and life cycle costs analysis. Overall results show that less far-reaching renovation measures are indicated when using the simple payback calculations which may be leading to solutions less cost-effective in a long run perspective.

Intermetallic layer formation and influence in solder joints reliability

Dissertação de mestrado integrado em Materials Engineering

Conceção técnica e avaliação económica de um veículo solar para venda de produtos refrigerados

Dissertação de mestrado integrado em Engenharia Mecânica

Silicon nanowire arrays coupled with cobalt phosphide spheres as low-cost photocathodes for efficient solar hydrogen evolution

We demonstrate the first example of silicon nanowire array photocathodes coupled with hollow spheres of the emerging earth-abundant cobalt phosphide catalysts. Compared to bare silicon nanowire arrays, the hybrid electrodes exhibit significantly improved photoelectrochemical performance toward the solar-driven H2 evolution reaction.

Desenvolvimento de microcápsulas ativadas por radiação solar para aplicação em painéis cerâmicos exteriores

Dissertação de mestrado integrado em Engenharia de Materiais

Estufa de aproveitamento solar térmico para reabilitação de edifícios

Dissertação de mestrado em sustentabilidade do ambiente construido