Genetically modified insect resistance in cotton: some farm level economic impacts in India

The paper explores the impact of insect-resistant Bacillus thuringiensis (Bt) cotton on costs and returns over the first two seasons of its commercial release in three sub-regions of Maharashtra State, India. It is the first such research conducted in India based on farmers' own practices rather than trial plots. Data were collected for a total of 7793 cotton plots in 2002 and 1577 plots in 2003. Results suggest that while the cost of cotton seed was much higher for farmers growing Bt cotton relative to those growing non-Bt cotton, the costs of bollworm spray were much lower. While Bt plots had greater costs (seed plus insecticide) than non-Bt plots, the yields and revenue from Bt plots were much higher than those of non-Bt plots (some 39% and 63% higher in 2002 and 2003, respectively). Overall, the gross margins of Bt plots were some 43% (2002) and 73% (2003) higher than those of non-Bt plots, although there was some variation between the three sub-regions of the state. The results suggest that Bt cotton has provided substantial benefits for farmers in India over the 2 years, but there are questions as to whether these benefits are sustainable. (c) 2004 Elsevier Ltd. All rights reserved.

Inequality and GM crops: a case study of Bt cotton in India

Critics of genetically modified (GM) crops often contend that their introduction enhances the gap between rich and poor farmers, as the former group are in the best position to afford the expensive seed as well as provide other inputs such as fertilizer and irrigation. The research reported in this paper explores this issue with regard to Bt cotton (cotton with the endotoxtin gene from Bacillus thuringiensis conferring resistance to some insect pests) in Jalgaon, Maharashtra State, India, spanning the 2002 and 2003 seasons. Questionnaire–based survey results from 63 non–adopting and 94 adopting households of Bt cotton were analyzed, spanning 137 Bt cotton plots and 95 non–Bt cotton plots of both Bt adopters and non–adopters. For these households, cotton income accounted for 85 to 88% of total household income, and is thus of vital importance. Results suggest that in 2003 Bt adopting households have significantly more income from cotton than do non–adopting households (Rp 66,872 versus Rp 46,351) but inequality in cotton income, measured with the Gini coefficient (G), was greater amongst non–adopters than adopters. While Bt adopters had greater acreage of cotton in 2003 (9.92 acres versus 7.42 for non–adopters), the respective values of G were comparable. The main reason for the lessening of inequality amongst adopters would appear to be the consistency in the performance of Bt cotton along with the preferred non–Bt cultivar of Bt adopters—Bunny. Taking gross margin as the basis for comparison, Bt plots had 2.5 times the gross margin of non–Bt plots of non–adopters, while the advantage of Bt plots over non–Bt plots of adopters was 1.6 times. Measured in terms of the Gini coefficient of gross margin/acre it was apparent that inequality was lessened with the adoption of Bunny (G = 0.47) and Bt (G = 0.3) relative to all other non–Bt plots (G = 0.63). Hence the issue of equality needs to be seen both in terms of differences between adopters and non–adopters as well as within each of the groups.

Pesticide productivity and transgenic cotton technology: The South African smallholder case

This paper empirically investigates how the productivity of pesticide differs in Bt versus non-Bt technology for South African cotton smallholders, and what the implications for pesticide use levels are in the two technologies. This is accomplished by applying a damage control framework to farm-level data from Makhathini flats, KwaZulu-Natal. Contrary to findings elsewhere, notably China, that farmers over-use pesticides and that transgenic technology benefits farmers by enabling large reductions in pesticide use, the econometric evidence here indicates that non-Bt smallholders in South Africa under-use pesticide. Thus, the main potential contribution of the new technology is to enable them to realise lost productivity resulting from under-use. By providing a natural substitute for pesticide, the Bt technology enables the smallholders to circumvent credit and labour constraints associated with pesticide application. Thus, the same technology that greatly reduces pesticide applications but only mildly affects yields, when used by large-scale farmers in China and elsewhere, benefits South-African smallholder farmers primarily via a yield-enhancing effect.

Logit models for identifying the factors that influence the uptake of new 'no-tillage' technologies by farmers in the rice-wheat and the cotton-wheat farming systems of Pakistan's Punjab

In the 'rice-wheat' and the 'cotton-wheat' farming systems of Pakistan's Punjab, late planting of wheat is a perennial problem due to often delayed harvesting of the previously planted and late maturing rice and cotton crops. This leaves very limited time for land preparation for 'on-time' planting of wheat. 'No-tillage' technologies that reduce the turn-round time for wheat cultivation after rice and cotton have been developed, but their uptake has not been as expected.-This paper attempts to determine the farm and farmer characteristics and other socio-economic factors that influence the adoption of 'no-tillage' technologies'. Logit models were developed for the analysis undertaken. In the 'cotton-wheat' system personal characteristics like education, tenancy status, attitude towards risk implied in the use of new technologies and contact with extension agents are the main factors that affect adoption. As regards the 'rice-wheat' system, resource endowments such as farm size, access to a 'no-tillage' drill, clayey soils and the area sown to the rice-wheat sequence along with tenancy and contact with extension agents were dominant in explaining adoption. (C) 2002 Elsevier Science Ltd. All rights reserved.

Identification of mutations conferring insecticide-insensitive AChE in the cotton-melon aphid, Aphis gossypii Glover

We have identified two mutations in the ace1 gene of Aphis gossypii that are associated with insensitivity of acetylcholinesterase (AChE) to carbamate and organophosphate insecticides. The first of these, S431F (equivalent to F331 in Torpedo californica), is associated with insensitivity to the carbamate insecticide pirimicarb in a range of A. gossypii clones. The S431F mutation is also found in the peach-potato aphid, Myzus persicae (Sulzer), and a rapid RFLP diagnostic allows the identification of individuals of both aphid species with a resistant genotype. This diagnostic further revealed the presence of S431 in several other pirimicarb-susceptible aphid species. The serine at this position in the wild-type enzyme has only been reported for aphids and provides a molecular explanation of why pirimicarb has a specific aphicidal action. A less specific insensitivity to a wide range of carbamates and organophosphates is associated with a second mutation, A302S (A201 in T. californica).

Method for the production of cotton somatic embryos. United States Patent Application

The present invention provides Inter alia, a method for the production of cotton somatic embryos comprising (a) isolating a totipotent stomatal cell-containing epidermal explant from leaf material excised from a cotton plant; and (b) culturing said explant in a basal medium which comprises an embryogenic callus-inducing quantity of an auxin and a cytokinin under an embryogenic callus inducing intensity of light until embryogenic callus is formed; and (c) sub-culturing said embryogenic callus onto a somatic embryo differentiation media to produce said somatic embryos. Plants may be regenerated from the somatic embryos and in a particular embodiment of the invention said totipotent stomatal cell is transformed, prior to the inducement of embryogenic callus, with a polynucleotide that provides for a desired agronomic trait.

Durability assessment of PbTe/II-IV infrared filters (Space Shuttle 1st LDEF)

Residual stress having been further reduced, selected infrared coatings composed of thin films of (PbTe/ ZnS (or ZnSe) can now be made which comply with the durability requirements of MIL-48616 whilst retaining transparency. Such improved durability is due to the sequence:- i) controlled deposition, followed by ii) immediate exposure to air, followed by iii) annealing in vacuo to relieve stress. (At the time of writing we assume the empiric procedure "exposure to air/annealing in vacuo" acts to relieve the inherent stresses of deposition). As part of their testing, representative sample filters prepared by the procedure are being assembled for the shuttle's 1st Long Duration Exposure Facility (to be placed in earth orbit for a considerable period and then recovered for analysis). The sample filters comprise various narrowband-designs to permit deduction of the constituent thin film optical properties. The Reading assembly also contains representative sample of the infrared crystals, glasses, thin-film absorbers and bulk absorbers, and samples of shorter-wavelength filters prepared similarly but made with Ge/SiO. Findings on durability and transparency after exposure will be reported.