Design construction and testing of a heat loop for study of fouling and its interrelationship to corrosion in heat exchanger tubes

A heat loop suitable for the study of thermal fouling and its relationship to corrosion processes was designed, constructed and tested. The design adopted was an improvement over those used by such investigators as Hopkins and the Heat Transfer Research Institute in that very low levels of fouling could be detected accurately, the heat transfer surface could be readily removed for examination and the chemistry of the environment could be carefully monitored and controlled. In addition, an indirect method of electrical heating of the heat transfer surface was employed to eliminate magnetic and electric effects which result when direct resistance heating is employed to a test section. The testing of the loop was done using a 316 stainless steel test section and a suspension of ferric oxide and water in an attempt to duplicate the results obtained by Hopkins. Two types of thermal ·fouling resistance versus time curves were obtained . (i) Asymptotic type fouling curve, similar to the fouling behaviour described by Kern and Seaton and other investigators, was the most frequent type of fouling curve obtained. Thermal fouling occurred at a steadily decreasing rate before reaching a final asymptotic value. (ii) If an asymptotically fouled tube was cooled with rapid cir- ·culation for periods up to eight hours at zero heat flux, and heating restarted, fouling recommenced at a high linear rate. The fouling results obtained were observed to be similar and 1n agreement with the fouling behaviour reported previously by Hopkins and it was possible to duplicate quite closely the previous results . This supports the contention of Hopkins that the fouling results obtained were due to a crevice corrosion process and not an artifact of that heat loop which might have caused electrical and magnetic effects influencing the fouling. The effects of Reynolds number and heat flux on the asymptotic fouling resistance have been determined. A single experiment to study the effect of oxygen concentration has been carried out. The ferric oxide concentration for most of the fouling trials was standardized at 2400 ppM and the range of Reynolds number and heat flux for the study was 11000-29500 and 89-121 KW/M², respectively.

From theory-inspired to theory-based interventions : A protocol for developing and testing a methodology for linking behaviour change techniques to theoretical mechanisms of action

This research is funded by UK Medical Research Council grant number MR/L011115/1

From Theory-Inspired to Theory-Based Interventions : A Protocol for Developing and Testing a Methodology for Linking Behaviour Change Techniques to Theoretical Mechanisms of Action

This research is funded by UK Medical Research Council grant number MR/L011115/1. We would like to thank the 105 experts in behaviour change who have committed their time and offered their expertise for study 2 of this research. We are also very grateful to all those who sent us peer-reviewed behaviour change intervention descriptions for study 1. Finally, we would like thank Dr. Emma Beard and Dr. Dan Dediu for their statistical input and to all the researchers, particularly Holly Walton, who have assisted in the coding of papers for study 1.

Development and testing of an analytical framework for immunization program planning in Canada

Thèse numérisée par la Direction des bibliothèques de l'Université de Montréal.

Development and Testing of An Automatic Lung IMRT Planning Algorithm

Knowledge-based radiation treatment is an emerging concept in radiotherapy. It

mainly refers to the technique that can guide or automate treatment planning in

clinic by learning from prior knowledge. Dierent models are developed to realize

it, one of which is proposed by Yuan et al. at Duke for lung IMRT planning. This

model can automatically determine both beam conguration and optimization ob-

jectives with non-coplanar beams based on patient-specic anatomical information.

Although plans automatically generated by this model demonstrate equivalent or

better dosimetric quality compared to clinical approved plans, its validity and gener-

ality are limited due to the empirical assignment to a coecient called angle spread

constraint dened in the beam eciency index used for beam ranking. To eliminate

these limitations, a systematic study on this coecient is needed to acquire evidences

for its optimal value.

To achieve this purpose, eleven lung cancer patients with complex tumor shape

with non-coplanar beams adopted in clinical approved plans were retrospectively

studied in the frame of the automatic lung IMRT treatment algorithm. The primary

and boost plans used in three patients were treated as dierent cases due to the

dierent target size and shape. A total of 14 lung cases, thus, were re-planned using

the knowledge-based automatic lung IMRT planning algorithm by varying angle

spread constraint from 0 to 1 with increment of 0.2. A modied beam angle eciency

index used for navigate the beam selection was adopted. Great eorts were made to assure the quality of plans associated to every angle spread constraint as good

as possible. Important dosimetric parameters for PTV and OARs, quantitatively

re

ecting the plan quality, were extracted from the DVHs and analyzed as a function

of angle spread constraint for each case. Comparisons of these parameters between

clinical plans and model-based plans were evaluated by two-sampled Students t-tests,

and regression analysis on a composite index built on the percentage errors between

dosimetric parameters in the model-based plans and those in the clinical plans as a

function of angle spread constraint was performed.

Results show that model-based plans generally have equivalent or better quality

than clinical approved plans, qualitatively and quantitatively. All dosimetric param-

eters except those for lungs in the automatically generated plans are statistically

better or comparable to those in the clinical plans. On average, more than 15% re-

duction on conformity index and homogeneity index for PTV and V40, V60 for heart

while an 8% and 3% increase on V5, V20 for lungs, respectively, are observed. The

intra-plan comparison among model-based plans demonstrates that plan quality does

not change much with angle spread constraint larger than 0.4. Further examination

on the variation curve of the composite index as a function of angle spread constraint

shows that 0.6 is the optimal value that can result in statistically the best achievable

plans.

The association of HIV counseling and testing with HIV risk behaviors in a random population-based survey in Kisumu, Kenya.

HIV testing has been promoted as a key HIV prevention strategy in low-resource settings, despite studies showing variable impact on risk behavior. We sought to examine rates of HIV testing and the association between testing and sexual risk behaviors in Kisumu, Kenya. Participants were interviewed about HIV testing and sexual risk behaviors. They then underwent HIV serologic testing. We found that 47% of women and 36% of men reported prior testing. Two-thirds of participants who tested HIV-positive in this study reported no prior HIV test. Women who had undergone recent testing were less likely to report high-risk behaviors than women who had never been tested; this was not seen among men. Although rates of HIV testing were higher than seen in previous studies, the majority of HIV-infected people were unaware of their status. Efforts should be made to increase HIV testing among this population.

Development and testing of an analytical framework for immunization program planning in Canada

Thèse numérisée par la Direction des bibliothèques de l'Université de Montréal.

Development and Testing of the Elderly Social Vulnerability Index (ESVI): A Composite Indicator to Measure Social Vulnerability in the Jamaican Elderly Population

Over the last two decades social vulnerability has emerged as a major area of study, with increasing attention to the study of vulnerable populations. Generally, the elderly are among the most vulnerable members of any society, and widespread population aging has led to greater focus on elderly vulnerability. However, the absence of a valid and practical measure constrains the ability of policy-makers to address this issue in a comprehensive way. This study developed a composite indicator, The Elderly Social Vulnerability Index (ESVI), and used it to undertake a comparative analysis of the availability of support for elderly Jamaicans based on their access to human, material and social resources. The results of the ESVI indicated that while the elderly are more vulnerable overall, certain segments of the population appear to be at greater risk. Females had consistently lower scores than males, and the oldest-old had the highest scores of all groups of older persons. Vulnerability scores also varied according to place of residence, with more rural parishes having higher scores than their urban counterparts. These findings support the political economy framework which locates disadvantage in old age within political and ideological structures. The findings also point to the pervasiveness and persistence of gender inequality as argued by feminist theories of aging. Based on the results of the study it is clear that there is a need for policies that target specific population segments, in addition to universal policies that could make the experience of old age less challenging for the majority of older persons. Overall, the ESVI has displayed usefulness as a tool for theoretical analysis and demonstrated its potential as a policy instrument to assist decision-makers in determining where to target their efforts as they seek to address the issue of social vulnerability in old age. Data for this study came from the 2001 population and housing census of Jamaica, with multiple imputation for missing data. The index was derived from the linear aggregation of three equally weighted domains, comprised of eleven unweighted indicators which were normalized using z-scores. Indicators were selected based on theoretical relevance and data availability.

An R-package for the Estimation and Testing of Multiple Covariates and Biomarker Interactions for Survival Data Based on Local Partial Likelihood

When we study the variables that a ffect survival time, we usually estimate their eff ects by the Cox regression model. In biomedical research, e ffects of the covariates are often modi ed by a biomarker variable. This leads to covariates-biomarker interactions. Here biomarker is an objective measurement of the patient characteristics at baseline. Liu et al. (2015) has built up a local partial likelihood bootstrap model to estimate and test this interaction e ffect of covariates and biomarker, but the R code developed by Liu et al. (2015) can only handle one variable and one interaction term and can not t the model with adjustment to nuisance variables. In this project, we expand the model to allow adjustment to nuisance variables, expand the R code to take any chosen interaction terms, and we set up many parameters for users to customize their research. We also build up an R package called "lplb" to integrate the complex computations into a simple interface. We conduct numerical simulation to show that the new method has excellent fi nite sample properties under both the null and alternative hypothesis. We also applied the method to analyze data from a prostate cancer clinical trial with acid phosphatase (AP) biomarker.

Journalistic organisations with regard to training and professional changes. Parallelisms with academic discourse

The present paper analyses the parallelism existing between academic and professional discourse regarding three interrelated subjects: journalists´ training needs, their adaptation to multimedia profile changes and recognition of University graduates via professional regulation. This study relies on a bibliographical review and brings together the opinion of five professional groups by means of an interview using an openended questionnaire. The results show a coincidence in both discourses regarding the need for firmly grounded training of the journalists with study plans which integrate the new profiles. At the same time, it reflects the discrepancy of the journalistic groups with regard to professional regulation based on the University degree, whose vindication does not appear to be a priority in academic circles.

Evaluation and Testing of a Lightweight Fine Aggregate Concrete Bridge Deck in Buchanan County, Iowa, TR-648, 2016

Internal curing is a relatively new technique being used to promote hydration of Portland cement concretes. The fundamental concept is to provide reservoirs of water within the matrix such that the water does not increase the initial water/cementitious materials ratio to the mixture, but is available to help continue hydration once the system starts to dry out. The reservoirs used in the US are typically in the form of lightweight fine aggregate (LWFA) that is saturated prior to batching. Considerable work has been conducted both in the laboratory and in the field to confirm that this approach is fundamentally sound and yet practical for construction purposes. A number of bridge decks have been successfully constructed around the US, including one in Iowa in 2013. It is reported that inclusion of about 20% to 30% LWFA will not only improve strength development and potential durability, but, more importantly, will significantly reduce shrinking, thus reducing cracking risk. The aim of this work was to investigate the feasibility of such an approach in a bridge deck.

Flow Regime Identification Methodology with Mcnp-X Code And Artificial Neural Network

This paper presents flow regimes identification methodology in multiphase system in annular, stratified and homogeneous oil-water-gas regimes. The principle is based on recognition of the pulse height distributions (PHD) from gamma-ray with supervised artificial neural network (ANN) systems. The detection geometry simulation comprises of two NaI(Tl) detectors and a dual-energy gamma-ray source. The measurement of scattered radiation enables the dual modality densitometry (DMD) measurement principle to be explored. Its basic principle is to combine the measurement of scattered and transmitted radiation in order to acquire information about the different flow regimes. The PHDs obtained by the detectors were used as input to ANN. The data sets required for training and testing the ANN were generated by the MCNP-X code from static and ideal theoretical models of multiphase systems. The ANN correctly identified the three different flow regimes for all data set evaluated. The results presented show that PHDs examined by ANN may be applied in the successfully flow regime identification.

Clinical Psychologists Training and Supervising IAPT Therapists to Work with Long-term Conditions and Medically Unexplained Symptoms: A Service Development Project

An IAPT service and a clinical health psychology team piloted a service development providing Step 2 and Step 3 services for individuals with long-term health conditions. Results indicate that such services may be offered with access to specialist training and supervision.