Patterns of sedentary behavior : insights from observational and experimental studies on body composition and energy expenditure

It is recognized that sedentary behavior (SB) has deleterious effects on numerous health outcomes and it appears that physiological mechanisms underlying these harms are distinct from the ones explaining moderate-to-vigorous physical activity (MVPA) benefits. Sedentary behavior represents a large portion of human���s life and is increasing with technological development. A new current of opinion supports the idea that the manner SB is accumulated plays an important role. This dissertation presents six research studies conducted under the scope of SB. In the methodological area, the first study highlighted the magnitude of potential errors in estimating SB and its patterns from common alternative methods (accelerometer and heart rate monitor) compared to ActivPAL. This study presented the accelerometer as a valid method at a group level. Two studies (2 and 5) were performed in older adults (the most sedentary group in the population) to test the associations for SB patterns with abdominal obesity using accelerometry. The findings showed positive graded associations for prolonged sedentary bouts with abdominal obesity and showed that those who interrupted SB more frequently were less likely to present abdominal obesity. Therefore, public health recommendations regarding breaking up SB more often are expected to be relevant. The associations between sedentary patterns and abdominal obesity were independent of MVPA in older adults. However, the low MVPA in this group makes it unclear whether this independent relationship still exists if highly active persons are analysed. Study 3 inovates by examining the association of SB with body fatness in highly trained athletes and found SB to predict total fat mass and trunk fat mass, independently of age and weekly training time. Study 4 also brings novelty to this research field by quantifying the metabolic and energetic cost of the transition from sitting to standing and then sitting back down (a break), informing about the modest energetic costs (0.32 kcal��min���1). Finally, from a successful multicomponent pilot intervention to reduce and break up SB (study 6), an important behavioral resistance to make more sit/stand transitions despite successfully reducing sitting time (~ 1.85 hours��day-1) was found, which may be relevant to inform future behavioral modification programs. The present work provides observational and experimental evidence on the relation for SB patterns with body composition outcomes and energy regulation that may be relevant for public health interventions.

Landscape Patterns of Permafrost Disturbance and Degradation in the Canadian High Arctic

Intensification of permafrost disturbances such as active layer detachments (ALDs) and retrogressive thaw slumps (RTS) have been observed across the circumpolar Arctic. These features are indicators of unstable conditions stemming from recent climate warming and permafrost degradation. In order to understand the processes interacting to give rise to these features, a multidisciplinary approach is required; i.e., interactions between geomorphology, hydrology, vegetation and ground thermal conditions. The goal of this research is to detect and map permafrost disturbance, predict landscape controls over disturbance and determine approaches for monitoring disturbance, all with the goal of contributing to the mitigation of permafrost hazards. Permafrost disturbance inventories were created by applying semi-automatic change detection techniques to IKONOS satellite imagery collected at the Cape Bounty Arctic Watershed Observatory (CBAWO). These methods provide a means to estimate the spatial distribution of permafrost disturbances for a given area for use as an input in susceptibility modelling. Permafrost disturbance susceptibility models were then developed using generalized additive and generalized linear models (GAM, GLM) fitted to disturbed and undisturbed locations and relevant GIS-derived predictor variables (slope, potential solar radiation, elevation). These models successfully delineated areas across the landscape that were susceptible to disturbances locally and regionally when transferred to an independent validation location. Permafrost disturbance susceptibility models are a first-order assessment of landscape susceptibility and are promising for designing land management strategies for remote permafrost regions. Additionally, geomorphic patterns associated with higher susceptibility provide important knowledge about processes associated with the initiation of disturbances. Permafrost degradation was analyzed at the CBAWO using differential interferometric synthetic aperture radar (DInSAR). Active-layer dynamics were interpreted using inter-seasonal and intra-seasonal displacement measurements and highlight the importance of hydroclimatic factors on active layer change. Collectively, these research approaches contribute to permafrost monitoring and the assessment of landscape-scale vulnerability in order to develop permafrost disturbance mitigation strategies.

2008 Greenhouse Gas Emissions from Selected Iowa Source Categories

This report is the second inventory of point source-specific greenhouse gas emissions conducted by the Department of Natural Resources, covering more industrial sectors and greenhouse gas pollutants than the previous year. This report is required by Iowa Code 455B.851 to be submitted annually to the Iowa General Assembly and the Governor,

2009 Greenhouse Gas Emissions from Selected Iowa Source Categories

This objective report is the third inventory of point source-specific greenhouse gas emissions conducted by the Department of Natural Resources. This report is required by Iowa Code 455B.851

Electromagnetic Emissions from Wireless Power Transfer System

In this paper, the measurement and analysis of the electromagnetic radiated emissions from the wireless power transfer system is reported. The aim is to evaluate the level of the electromagnetic field produced by the magnetic resonance wireless power transfer system. Due to the advances of the wireless power transfer technology, it becomes feasible to apply the wireless power transfer in the electric vehicles charging. Among the existent wireless power transfer technologies, the magnetic resonant coupling is proven to be the most suitable for this task. Because of strong electromagnetic field generated by wireless power transfer system the electromagnetic compatibility has become an important issue.

Production of activated carbons from single and mixtures of synthetic polymers

The production of activated carbons (ACs) involves two main steps: the carbonization of the carbonaceous of raw materials at temperatures below 1073 K in the absence of oxygen and the activation had realized at the temperature up to 1173 but the most useful temperature at 1073 K. In our study we used the most common industrial and consumer solid waste, namely PET, alone or blended with other synthetic polymer PAN. By mixing the two polymers in different ratios, an improvement of the yield of the AC production was found and some textural properties were enhanced by comparison with the AC prepared using each polymer separately. When all the samples were exposed through the carbonization process with a pyrolysis the mixture of PAN-PET (1:1w/w) yield around 31.9%, between that obtained with PET (16.9%) or PAN (42.6%) separately. The combine activation, with CO2 at 1073 K, allow ACs with a lower burn-off degree isothermally, when compared with those attained with PET or PAN alone, but with similarly chemicals or textural properties. The resultant ACs are microporous in their nature, as the activation time increase, the PET-PAN mixture AC are characterized by a better developed porous structure, when associated with the AC prepared from PAN. The AC prepared from PET-PAN mixture are characterized by basic surface characteristics, with a pHpzc around 10.5, which is an important characteristic for future applications on acidic pollutants removals from liquid or gaseous phase. In this study we had used the FTIR methods to determine the main functional groups in the surface of the activated carbons. The adsorbents prepared from PAN fibres presents an IR spectrum with similar characteristics to those obtained with PET wastes, but with fewer peaks and bands with less intensity, in particular for the PAN-8240 sample. This can be reflected by the stretching and deformation modes of NH bond in the range 3100 ��� 3300 cm-1 and 1520 ��� 1650 cm-1, respectively. Also, stretching mode associated to C���N, C=N, can contributed to the profile of IR spectrum around 1170 cm-1, 1585 ��� 1770 cm-1. And the TGA methods was used to study the loses of the precursors mass according to the excessive of the temperature. The results showed that, there were different decreasing of the mass of each precursors. PAN degradation started at almost 573 K and at 1073 K, PAN preserve more than 40% of the initial mass. PET degradation started at 650 K, but at 1073 K, it has lost 80% of the initial mass. However, the mixture of PET-PAN (1:1w/w) showed a thermogravimetric profile between the two polymers tested individually, with a final mass slightly less than 30%. From a chemical point of view, the carbonisation of PET mainly occurs in one step between 650 and 775 K.

Effect of seasons on enteric methane emissions from cattle grazing Urochloa brizantha.

Abstract: The objective of this study was to evaluate the effect of seasons under a tropical climate on forage quality, aswell the effect of an Urochloa brizantha cv. Marandu grazing system on enteric methane (CH4) emissions fromNellore cattle in the Southeast region of Brazil. Sixteen Nellore steers (18 months old and initial weight 318.0 �� 116.59 kg of LW; final weight 469 �� 98.50 kg of LW) were used for a trial period of 10 months, with four collection periods in winter (August), spring (December), summer (February) and autumn (May). Each collection period consisted of 28 days, corresponding to the representative month of each season where the last six days were designed for methane data collection. Animals were randomly distributed within 16 experimental plots, distributed in four random blocks over four trial periods. CH4 emissions were determined using the sulphur hexafluoride (SF6) tracer gas technique measured by gas chromatography and fluxes of CH4 calculated. The forage quality was characterized by higher CP and IVDMD and lower lignin contents in spring, differing specially from winter forage. Average CH4 emissions were between 102.49 and 220.91 g d-1 (37.4 to 80.6 kg ani-1 yr-1); 16.89 and 30.20 g kg-1 DMI; 1.35 and 2.90 Mcal ani-1 d-1; 0.18 and 0.57 g kg-1 ADG-1 and 5.05 and 8.76% of GE. Emissions in terms of CO2 equivalents were between 4.68 and 14.22 g CO2-eq-1 g-1 ADG. Variations in CH4 emissions were related to seasonal effect on the forage quality and variations in dry matter intake.

Modeling nitrous oxide emissions in grass and grass-legume pastures in the western Brazilian Amazon.

Mineral nitrogen (N) dynamics in soil and the exchange of N gaseous in the interface soil-atmosphere are intimately associated with animal manure in pastures. According to soil inorganic-N pools and the site studied, forest or pasture, and pastures age the soil inorganic-N pools of ammonium and nitrate can be similar in the forest or ammonium dominated in the pasture. Also annual average net nitrification rates at soil surface in forest can be higher than in pasture suggesting a higher potential for nitrate-N losses either through leaching or gaseous emissions from intact forests compared with established pastures (NEILL et al., 1995).

Emissions from cattle farming in Brazil.

2016

Hiring Graduates: Perspectives from Advertising and Public Relations Employers

This paper looks at employer expectations of advertising and public relations graduates seeking an entry level position. For employers in both disciplines, the top three priorities are the same generic skills ��� communications skills, personality traits and strategic or analytical thinking. However, some significant differences were observed, with PR practitioners assigning more importance to practical aspects such as experience in the field and internships. Public relations employers also tend to think that advertising graduates require less strategic skills than public relations graduates. Advertising practitioners generally considered the skills of entry level recruits to be more consistent across the two disciplines.

Cross-cultural consumer/consumption research : dealing with issues emerging from globalization and fragmentation

To understand the effects of globalization and fragmentation, macromarketing scholars need insights about links between individual consumer behavior and societal outcomes. The challenge in this regard is to create a program of macrooriented cross-cultural research. This article offers a crosscultural consumer behavior research framework for this purpose. The framework encompasses four key areas of consumer behavior that are related to the forces of globalization and fragmentation, including the environment, identity, wellbeing,and market structure and policy. A discussion of these substantive areas is followed by a suggested macro-microoriented research agenda and a call for paradigm plurality in pursuing this agenda.

Technology strategy : findings from adoption and adaptation of Japanese manufacturing management (JMM) to ASEAN and Australasian automotive manufacturers

The purpose of this study is to demonstrate the appropriateness of ���Japanese Manufacturing Management��� (JMM) strategies in the Asian, ASEAN and Australasian automotive sectors. Secondly, the study assessed JMM as a prompt, effective and efficient global manufacturing management practice for automotive manufacturing companies to learn; benchmark for best practice; acquire product and process innovation, and enhance their capabilities and capacities. In this study, the philosophies, systems and tools that have been adopted in various automotive manufacturing assembly plants and their tier 1 suppliers in the three Regions were examined. A number of top to middle managers in these companies were located in Thailand, Indonesia, Malaysia, Singapore, Philippines, Viet Nam, and Australia and were interviewed by using a qualitative methodology. The results confirmed that the six pillars of JMM (culture change, quality at shop floor, consensus, incremental continual improvement, benchmarking, and backward-forward integration) are key enablers to success in adopting JMM in both automotive and other manufacturing sectors in the three Regions. The analysis and on-site interviews identified a number of recommendations that were validated by the automotive manufacturing company���s managers as the most functional JMM strategies.

Citizen Consultation from Above and Below : The Australian Perspective

In Australia, a range of Federal Government services have been provided online for some time, but direct, online citizen consultation and involvement in processes of governance is relatively new. Moves towards more extensive citizen involvement in legislative processes are now being driven in a ���top-down��� fashion by government agencies, or in a ���bottom-up��� manner by individuals and third-sector organisations. This chapter focusses on one example from each of these categories, as well as discussing the presence of individual politicians in online social networking spaces. It argues that only a combination of these approaches can achieve effective consultation between citizens and policymakers. Existing at a remove from government sites and the frameworks for public communication which govern them, bottom-up consultation tools may provide a better chance for functioning, self-organising user communities to emerge, but they are also more easily ignored by governments not directly involved in their running. Top-down consultation tools, on the other hand, may seem to provide a more direct line of communication to relevant government officials, but for that reason are also more likely to be swamped by users who wish simply to register their dissent rather than engage in discussion. The challenge for governments, politicians, and user communities alike is to develop spaces in which productive and undisrupted exchanges between citizens and policymakers can take place.

What are the lessons for entrepreneurship from creativity and design?

Entrepreneurship and innovation make significant contributions to the success of firms and both notions are often linked directly or indirectly to notions of creativity and more recently design (Drucker, 1985; Kelley, 2001; Nystrom, 1993). This theoretical paper investigates the processes involved in entrepreneurship, creativity and design and identifies key processes relevant to entrepreneurial practice.