Evaluation of PCC Specification Changes Impact on Durability: 1992 - 1997 Core Study, MLR-98-06, 2005

In 1990, early distress had shown up on US 20 in Hamilton/Webster counties, three years after paving. Since that time, over a dozen more projects, constructed between 1984 and 1994, have been found to exhibit similar early distress. Several changes to the concrete and Portland cement specifications occurred in 1994 and 1996. This study was undertaken to investigate in place concrete pavements before and after specification changes were implemented. The objective of this research is to evaluate the impact of Portland cement and concrete specification changes made in 1994 and 1996 on PCC durability. Cores were obtained in 1998 and 2003 from projects constructed in 1992, before specification changes, and 1997 after specification changes. The following is a brief summary of the conclusions: 1. The pavements in the study constructed under the new specifications are performing much better after 5 years of service than the pavements constructed under the old specifications. 2. According to ISU, micro-cracking is evident in all concrete that has been in service, due to thermal stresses and loading stresses. Also, the low vacuum SEM will desiccate the concrete enough to cause micro-cracking. The SEM should not be used as a tool to indicate micro-cracking. 3. Use of Type II cement (C3A <8%) and a 3.0% SO3 limit does not completely eliminate ettringite infilling in air voids, as indicated in the bottom of the 1997 cores. 4. In areas of high moisture (bottom of the core), infilling is present in most of the 1997 cores. 5. Low air content and high spacing factor in the top of 1992 cores apparently causes F/T cycling cracking and then increased moisture paths from cracking causes infilling. 6. Use of ground granulated blast furnace slag (GGBFS) and fly ash reduces ettringite infilling either by diluting the aluminate (C3A) or lowering permeability, which slows ingress of moisture. 7. The specification changes that made the biggest impact on pavement durability are the limits on vibration and increase in air content in September 1994. 8. Investigations of cores from pavements placed in 2002 and 2003 indicate improved air contents and spacing factors. In-place air content and spacing factors should be monitored to determine if appropriate air void parameters are being met.

Tissue-based immune monitoring I: tumor core needle biopsies allow in-depth interrogation of the tumor microenvironment.

We sought to assess the feasibility and reproducibility of performing tissue-based immune characterization of the tumor microenvironment using CT-compatible needle biopsy material. Three independent biopsies were obtained intraoperatively from one metastatic epithelial ovarian cancer lesion of 7 consecutive patients undergoing surgical cytoreduction using a 16-gauge core biopsy needle. Core specimens were snap-frozen and subjected to immunohistochemistry (IHC) against human CD3, CD4, CD8, and FoxP3. A portion of the cores was used to isolate RNA for 1) real-time quantitative (q)PCR for CD3, CD4, CD8, FoxP3, IL-10 and TGF-beta, 2) multiplexed PCR-based T cell receptor (TCR) CDR3 Vβ region spectratyping, and 3) gene expression profiling. Pearson's correlations were examined for immunohistochemistry and PCR gene expression, as well as for gene expression array data obtained from different tumor biopsies. Needle biopsy yielded sufficient tissue for all assays in all patients. IHC was highly reproducible and informative. Significant correlations were seen between the frequency of CD3+, CD8+ and FoxP3+ T cells by IHC with CD3ε, CD8A, and FoxP3 gene expression, respectively, by qPCR (r=0.61, 0.86, and 0.89; all p< 0.05). CDR3 spectratyping was feasible and highly reproducible in each tumor, and indicated a restricted repertoire for specific TCR Vβ chains in tumor-infiltrating T cells. Microarray gene expression revealed strong correlation between different biopsies collected from the same tumor. Our results demonstrate a feasible and reproducible method of immune monitoring using CT-compatible needle biopsies from tumor tissue, thereby paving the way for sophisticated translational studies during tumor biological therapy.

Aspergillus protein degradation pathways with different secreted protease sets at neutral and acidic pH.

Aspergillus fumigatus grows well at neutral and acidic pH in a medium containing protein as the sole nitrogen source by secreting two different sets of proteases. Neutral pH favors the secretion of neutral and alkaline endoproteases, leucine aminopeptidases (Laps) which are nonspecific monoaminopeptidases, and an X-prolyl dipeptidase (DppIV). Acidic pH environment promotes the secretion of an aspartic endoprotease of pepsin family (Pep1) and tripeptidyl-peptidases of the sedolisin family (SedB and SedD). A novel prolyl peptidase, AfuS28, was found to be secreted in both alkaline and acidic conditions. In previous studies, Laps were shown to degrade peptides from their N-terminus until an X-Pro sequence acts as a stop signal. X-Pro sequences can be then removed by DppIV, which allows Laps access to the following residues. We have shown that at acidic pH Seds degrade large peptides from their N-terminus into tripeptides until Pro in P1 or P'1 position acts as a stop for these exopeptidases. However, X-X-Pro and X-X-X-Pro sequences can be removed by AfuS28 thus allowing Seds further sequential proteolysis. In conclusion, both alkaline and acidic sets of proteases contain exoprotease activity capable of cleaving after proline residues that cannot be removed during sequential digestion by nonspecific exopeptidases.

The Determinants of Exit in Argentina: Core and Peripheral Regions

This paper analyses the regional determinants of exit in Argentina. We find evidence of a dynamic revolving door by which past entrants increase current exits, particularly in the peripheral regions. In the central regions, current and past incumbents cause an analogous displacement effect. Also, exit shows a U-shaped relationship with respect to the informal economy, although the positive effect is weaker in the central regions. These findings point to the existence of a core-periphery structure in the spatial distribution of exits. Key words: firm exit, count data models, Argentina JEL: R12; R30; C33

Cooperative games with size-truncated information

[Eng] We study the marginal worth vectors and their convex hull, the socalled Weber set, from the original coalitional game and the transformed one, which is called the Weber set of level k. We prove that the core of the original game is included in each of the Weber set of level k, for any k, and that the Weber sets of consecutive levels form a chain if and only if the original game is 0-monotone. Even if the game is not 0-monotone, the intersection of the Weber sets for consecutive levels is always not empty, what is not the case for non-consecutive ones. Spanish education system.

Cooperative games with size-truncated information

[Eng] We study the marginal worth vectors and their convex hull, the socalled Weber set, from the original coalitional game and the transformed one, which is called the Weber set of level k. We prove that the core of the original game is included in each of the Weber set of level k, for any k, and that the Weber sets of consecutive levels form a chain if and only if the original game is 0-monotone. Even if the game is not 0-monotone, the intersection of the Weber sets for consecutive levels is always not empty, what is not the case for non-consecutive ones. Spanish education system.

Sierpinski curve Julia sets for quadratic rational maps

We investigate under which dynamical conditions the Julia set of a quadratic rational map is a Sierpiński curve.

Axiomatization of the nucl eolus of assignment games

On the domain of general assignment games (with possible reservation prices) the core is axiomatized as the unique solution satisfying two consistency principles: projection consistency and derived consistency. Also, an axiomatic characterization of the nucleolus is given as the unique solution that satisfies derived consistency and equal maximum complaint between groups. As a consequence, we obtain a geometric characterization of the nucleolus. Maschler et al. (1979) provide a geometrical characterization for the intersection of the kernel and the core of a coalitional game, showing that those allocations that lie in both sets are always the midpoint of certain bargaining range between each pair of players. In the case of the assignment game, this means that the kernel can be determined as those core allocations where the maximum amount, that can be transferred without getting outside the core, from one agent to his / her optimally matched partner equals the maximum amount that he / she can receive from this partner, also remaining inside the core. We now prove that the nucleolus of the assignment game can be characterized by requiring this bisection property be satisfied not only for optimally matched pairs but also for optimally matched coalitions. Key words: cooperative games, assignment game, core, nucleolus

Correlation of Locally-Based Performance of Asphalts with Their Physicochemical Parameters, Progress Report 2, HR-298, 1989

This project was undertaken to study the relationships between the performance of locally available asphalts and their physicochemical properties under Iowa conditions with the ultimate objective of development of a locally and performance-based asphalt specification for durable pavements. Physical and physicochemical tests were performed on three sets of asphalt samples including: (a) twelve samples from local asphalt suppliers and their TFOT residues, (b) six core samples of known service records, and (c) a total of 79 asphalts from 10 pavement projects including original, lab aged and recovered asphalts from field mixes, as well as from lab aged mixes. Tests included standard rheological tests, HP-GPC and TMA. Some specific viscoelastic tests (at 5 deg C) were run on b samples and on some a samples. DSC and X-ray diffraction studies were performed on a and b samples. Furthermore, NMR techniques were applied to some a, b and c samples. Efforts were made to identify physicochemical properties which are correlated to physical properties known to affect field performance. The significant physicochemical parameters were used as a basis for an improved performance-based trial specification for Iowa to ensure more durable pavements.

Catalogación y valoración de las webquests desde el área de educación física y el tratamiento de temáticas transversales

Gears of the current millennium have been activated by the hit entry into the information society that has generated a whole range of social and educational changes, it is difficult to stay out of their influence, such as: the dizzying presence of new technologies (NNTT) and the entrenchment of a crisis of values. Physical education has been affected by this avalanche of developments that have sparked the birth of original teaching and learning tools that can be applied in the classroom. In this sense, WebQuests have been configured as a unifying and educational activities that allow addressing the treatment of specific thematic area that we are dealing with the work of certain cross¿cutting. But how do you know what product we have before us, what is its effectiveness? What criteria will allow us to classify it as a fit and capable of being applied in our particular educational context? To clarify these and other issues that any teacher could arise before the election of a multimedia educational materials, our particular object of study has a double claim on the one hand, developing two tools: the card catalog and the heading of Valuation of WebQuests and secondly, to apply these tools in order to find out / determine the degree of quality of a sample of WebQuests. In this article sets forth, in summary form, the various stages of what our research has gone since the establishment of a synthesized theoretical basis, via the definition of the basic guidelines for the design of the exhibition and research results and ending with The list of the ideas and proposals arising from thework.

A security layer for JXTA core protocols

JXTA define un conjunto de seis protocolos básicos especialmente adecuados para una computación ad hoc, permanente, multi-hop, peer-to-peer (P2P). Estos protocolos permiten que los iguales cooperen y formen grupos autónomos de pares. Este artículo presenta un método que proporciona servicios de seguridad en los protocolos básicos: protección de datos, autenticidad, integridad y no repudio. Los mecanismos que se presentan son totalmente distribuidos y basados ¿¿en un modelo puro peer-to-peer, que no requieren el arbitraje de un tercero de confianza o una relación de confianza establecida previamente entre pares, que es uno de los principales retos en este tipo de entornos.

Performance Characteristics of an Axial-Flux Solid-Rotor-Core Induction Motor

The integration of electric motors and industrial appliances such as pumps, fans, and compressors is rapidly increasing. For instance, the integration of an electric motor and a centrifugal pump provides cost savings and improved performance characteristics. Material cost savings are achieved when an electric motor is integrated into the shaft of a centrifugal pump, and the motor utilizes the bearings of the pump. This arrangement leads to a smaller configuration that occupies less floor space. The performance characteristics of a pump drive can be improved by using the variable-speed technology. This enables the full speed control of the drive and the absence of a mechanical gearbox and couplers. When using rotational speeds higher than those that can be directly achieved by the network frequency the structure of the rotor has to be mechanically durable. In this thesis the performance characteristics of an axial-flux solid-rotor-core induction motor are determined. The motor studied is a one-rotor-one-stator axial-flux induction motor, and thus, there is only one air-gap between the rotor and the stator. The motor was designed for higher rotational speeds, and therefore a good mechanical strength of the solid-rotor-core rotor is required to withstand the mechanical stresses. The construction of the rotor and the high rotational speeds together produce a feature, which is not typical of traditional induction motors: the dominating loss component of the motor is the rotor eddy current loss. In the case of a typical industrial induction motor instead the dominating loss component is the stator copper loss. In this thesis, several methods to decrease the rotor eddy current losses in the case of axial-flux induction motors are presented. A prototype motor with 45 kW output power at 6000 min-1 was designed and constructed for ascertaining the results obtained from the numerical FEM calculations. In general, this thesis concentrates on the methods for improving the electromagnetic properties of an axial-flux solid-rotor-core induction motor and examines the methods for decreasing the harmonic eddy currents of the rotor. The target is to improve the efficiency of the motor and to reach the efficiency standard of the present-day industrial induction motors equipped with laminated rotors.

Model for managing non-core ideas to new companies, products and services in a Finnish forest company

Suomalainen metsäteollisuus on muutoksen partaalla. Uutisissa on nähty miten metsäyrityksen sulkevat tehtaita ja paperikoneita. Suomalaisessa metsäteollisuudessa keskitytään tällä hetkellä lähinnä kulujen alentamiseen ja tuottavuuden parantamiseen. Edellytyssille, että suomalainen metsäteollisuus pysyy kilpailukykyisenä, ovat kuitenkinuudet innovaatiot ja toimialojen välinen yhteistyö. Työn tavoitteena oli luoda toimintamalli UPM-Kymmene Oyj:lle, minkä avulla ydinliiketoimintaan kuulumattomat tuote- ja palveluideat saataisiin hyödynnettyä. Aihe on erittäin ajankohtainen, mikäli halutaan pitää tuotanto jatkossakin Suomessa. Luotumalli painottaa pk-sektorin roolia ja potentiaalia kehittää UPM-Kymmeneltä peräisin olevia ja heidän ydinliiketointaan kuulumattomista tuote ja palveluideoistauusia yrityksiä, tuotteita ja palveluita. Malli edustaa uudenlaista ajattelutapaa ja sen käyttöönotto vaatii perinteisen yrityskulttuurin uudistamista UPM-Kymmenessä.