Active immunization against hepatitis B virus (HBV) with low-doses of plasma-derived vaccine by intradermal route

Schedule for vaccination against HBV infection has usually been based on three separate injections of 20 meg of the vaccine by intramuscular route. One of the main shortcomings to its use in large scale programs has been its high cost. Ninety out of 300 health workers were submitted to three injections of 2 meg of plasma-derived vaccine (PDV) by intradermal (ID) route on days 0, 30, and 180. Anti-HBs was detected in 74 (82.2%) after the second dose and in 80 (88.9%) after the third dose, a non-significant difference. However, levels above 10 times the cut-off were observed in 29 (32.2%) and 77 (85.5%), respectively (p < 0.001). The results showed that a low-dose schedule is effective when used in health workers and should be tried with other risk groups.

GFRP waste reinforced polymer mortars: a new waste management solution for GFRP scrap material

To date, glass fibre reinforced polymer (GFRP) waste recycling is very limited and restricted by thermoset nature of binder matrix and lack of economically viable enduse applications for the recyclates. In this study, efforts were made in order to recycle grinded GFRP waste proceeding from pultrusion production scrap, into new and sustainable composite materials. For this purpose, GFRP waste recyclates, a mix of powdered and fibrous materials, were incorporated into polyester based mortars as fine aggregate and filler replacements, at different load contents (between 4% up to 12% of total mass) and particle size distributions. Potential recycling solution was assessed by mechanical behaviour of resultant GFRP waste modified polymer mortars. Test results revealed that GFRP waste filled polymer mortars present improved flexural and compressive behaviour over unmodified polyester based mortars, thus indicating the feasibility of GFRP waste reuse in concrete-polymer composites.

An experimental study on recycling and reuse of pultruded composite material wastes

Glass fibre-reinforced plastics (GFRP) have been considered inherently difficult to recycle due to both: cross-linked nature of thermoset resins, which cannot be remoulded, and complex composition of the composite itself. Presently, most of the GFRP waste is landfilled leading to negative environmental impacts and supplementary added costs. With an increasing awareness of environmental matters and the subsequent desire to save resources, recycling would convert an expensive waste disposal into a profitable reusable material. In this study, efforts were made in order to recycle grinded GFRP waste, proceeding from pultrusion production scrap, into new and sustainable composite materials. For this purpose, GFRP waste recyclates, were incorporated into polyester based mortars as fine aggregate and filler replacements at different load contents and particle size distributions. Potential recycling solution was assessed by mechanical behaviour of resultant GFRP waste modified polymer mortars. Results revealed that GFRP waste filled polymer mortars present improved flexural and compressive behavior over unmodified polyester based mortars, thus indicating the feasibility of the GFRP industrial waste reuse into concrete-polymer composite materials.

Towards Active Course Marks for Autonomous Sailing Competitions

This paper describes the environmental monitoring / regatta beacon buoy under development at the Laboratory of Autonomous Systems (LSA) of the Polytechnic Institute of Porto. On the one hand, environmentalmonitoring of open water bodies in real or deferred time is essential to assess and make sensible decisions and, on the other hand, the broadcast in real time of position, water and wind related parameters allows autonomous boats to optimise their regatta performance. This proposal, rather than restraining the boats autonomy, fosters the development of intelligent behaviour by allowing the boats to focus on regatta strategy and tactics. The Nautical and Telemetric Application (NAUTA) buoy is a dual mode reconfigurable system that includes communications, control, data logging, sensing, storage and power subsystems. In environmental monitoring mode, the buoy gathers and stores data from several underwater and above water sensors and, in regatta mode, the buoy becomes an active course mark for the autonomous sailing boats in the vicinity. During a race, the buoy broadcasts its position, together with the wind and the water current local conditions, allowing autonomous boats to navigate towards and round the mark successfully. This project started with the specification of the requirements of the dual mode operation, followed by the design and building of the buoy structure. The research is currently focussed on the development of the modular, reconfigurable, open source-based control system. The NAUTA buoy is innovative, extensible and optimises the on board platform resources.

Evaluation of temporal, seasonal and geographic stability of the molluscicidal property of Euphorbia splendens latex

Laboratory tests with aqueous solutions of Euphorbia splendens var. hislopii latex have demonstrated seasonal stability of the molluscicidal principle, with LD90 values of 1.14 ppm (spring), 1.02 ppm (fall), 1.09 ppm (winter), and 1.07 ppm (summer) that have been determined against Biomphalaria tenagophila in the field. Assays on latex collected in Belo Horizonte and Recife yielded LD90 values similar to those obtained with the reference substance collected in Rio de Janeiro (Ilha do Governador), demonstrating geographic stability of the molluscicidal effect. The molluscicidal action of aqueous dilutions of the latex in natura, centrifuged (precipitate) and lyophilized, was stable for up to 124 days at room temperature (in natura) and for up to 736 days in a common refrigerator at 10 to 12ºC (lyophilized product). A 5.0 ppm solution is 100% lethal for snails up to 13 days after preparation, the effect being gradually lost to almost total inactivity by the 30th day. This observation indicated that the active principle is instable. These properties together with the wide distribution of the plant, its resistance and adaptation to the tropical climate, its easy cultivation and the easy obtention of latex and preparation of the molluscicidal solution, make this a promising material for large-scale use in the control of schistosomiasis

Estimation of 3D shapes using active surface models

This paper addresses the estimation of surfaces from a set of 3D points using the unified framework described in [1]. This framework proposes the use of competitive learning for curve estimation, i.e., a set of points is defined on a deformable curve and they all compete to represent the available data. This paper extends the use of the unified framework to surface estimation. It o shown that competitive learning performes better than snakes, improving the model performance in the presence of concavities and allowing to desciminate close surfaces. The proposed model is evaluated in this paper using syntheticdata and medical images (MRI and ultrasound images).

Mn-II and Cu-II complexes with arylhydrazones of active methylene compounds as effective heterogeneous catalysts for solvent- and additive-free microwave-assisted peroxidative oxidation of alcohols

A one-pot template reaction of sodium 2-(2-(dicyanomethylene) hydrazinyl) benzenesulfonate (NaHL1) with water and manganese(II) acetate tetrahydrate led to the mononuclear complex [Mn(H2O)(6)](HL1a)(2)center dot 4H(2)O (1), where (HL1a) -= 2-(SO3-)C6H4(NH)=N=C(C N) (CONH2) is the carboxamide species derived from nucleophilic attack of water on a cyano group of (HL1) . The copper tetramer [Cu-4(H2O)(10)(-) (1 kappa N: kappa O-2: kappa O, 2 kappa N: k(O)-L-2)(2)]center dot 2H(2)O (2) was obtained from reaction of Cu(NO3)(2)center dot 2.5H(2)O with sodium 5-(2( 4,4-dimethyl-2,6-dioxocyclohexylidene) hydrazinyl)-4-hydroxybenzene-1,3-disulfonate (Na2H2L2). Both complexes were characterized by elemental analysis, IR spectroscopy, ESI-MS and single crystal X-ray diffraction. They exhibit a high catalytic activity for the solvent-and additive-free microwave (MW) assisted oxidation of primary and secondary alcohols with tert-butylhydroperoxide, leading to yields of the oxidized products up to 85.5% and TOFs up to 1.90 x 103 h(-1) after 1 h under low power (5-10 W) MW irradiation. Moreover, the heterogeneous catalysts are easily recovered and reused, at least for three consecutive cycles, maintaining 89% of the initial activity and a high selectivity.

Via algaliada versus mudança de bitola dos eixos do material circulante

Trabalho Final de Mestrado para obtenção do grau de Mestre em Engenharia Civil

Projeto estrutural de um edifício público em Camama - Angola

O presente trabalho tem como objetivo o cálculo e desenvolvimento de um projecto estrutural de um edifício público. O edifício em questão será construído em Camama, Angola. Ao longo deste trabalho são apresentadas as diferentes etapas necessárias para a conceção do projeto estrutural de um edifício em betão armado. As opções consideradas na realização deste projeto e as respetivas justificações, podem ser encontradas ao longo deste documento. Estas são reforçadas através da apresentação de plantas estruturais com os seus elementos e os cálculos considerados necessários. Este trabalho foi elaborado com o apoio do programa de cálculo ROBOT Structural Analysis para a caracterização e análise das ações atuantes. Apesar da localização do edifício ser em Angola, as ações e as bases de projeto são definidas de acordo com as normas portuguesas. A utilização destas normas foi possível através de referências comuns a ambos os países, bem como algumas considerações tendo em conta as condições de construção em Luanda. Para a definição do projeto estrutural foram fornecidas as plantas de arquitetura, cortes e alçados do edifício. Estas plantas apresentam os respetivos materiais não estruturais, a utilizar após a sua construção. Em adição foi fornecida uma sondagem geotécnica do terreno de construção.

A conservação material e documental da obra “Instalação191093,parte1” de Francisco Rocha

Dissertação apresentada na Faculdade de Ciências e Tecnologia para obtenção do grau de Mestre em Conservação e Restauro

Active replication of hepatitis B virus (HBV) in HIV type 1 and in HIV type 2 infected patients

To evaluate the effect of concurrent infection by HIV on HBV infection or immunity, we have studied a group of 66 HIV1+ symptomatic Caucasian patients and another of 38 African HIV2+ asymptomatic individuals, concerning their HBV status: serological markers of infection and presence of HBV-DNA in serum, the last taken as sign of hepatitis B virus active replication, were monitored. HIV+ groups were compared with seronegative controls, adequately matched for age, sex and ethnological background. HBV DNA was found in 7.6% of HIV1+ Caucasian patients and 3.2% of seronegative controls; in African HIV2+ individuals 2.6% were also HBV DNA+, a percentage close to that found in HIV2 seronegative controls (2.9%). No correlation was found between HIV infection and HBV active replication. Immunodepression that follows HIV infection over time may be compatible with a degree of T cell function capable of avoiding reinfection with or reactivation of HBV, even in symptomatic stages of acquired immunodeficiency syndrome. Our findings are relevant to the choice of preventive strategies in populations at risk for HIV and HBV infection.

Human cutaneous leishmaniasis caused by Leishmania (Viannia) braziliensis in Santiago del Estero, Argentina: identification of parasites by monoclonal antibodies and isoenzymes

Diagnostic and parasite characterization and identification studies were carried out in human patients with cutaneous leishmaniasis lesions in Santiago del Estero, Northern Province of Argentina. Diagnostic procedures were biopsies of lesions for smears and inoculations in hamster, needle aspirations of material from ulcers for "in vitro" cultures. Immunodiagnostic techniques applied were IFAT-IgG and Montenegro skin test. Primary isolation of eight stocks of leishmanial parasites was achieved from patients with active lesions. All stocks were biologically characterized by their behaviour in hamster, measurements of amastigote and promastigotes and growth "in vitro". Eight stocks were characterized and identified at species level by their reactivity to a cross-panel of sub-genus and specie-specific Monoclonal Antibodies through an Indirect Immunofluorescence technique and a Dot-ELISA. We conclude from the serodeme analysis of Argentina stocks that: stocks MHOM/AR/92/SE-1; SE-2; SE-4; SE-8; SE-8-I; SE-30; SE-34 and SE-36 are Leishmania (Viannia) braziliensis. Three Leishmania stocks (SE-1; SE-2 and SE-30) did not react with one highly specie-specific Monoclonal Antibody (Clone: B-18, Leishmania (Viannia) braziliensis marker) disclosing two serodeme group patterns. Five out of eight soluble extracts of leishmanial promastigotes were electrophoresed on thin-layer starch gels and examined for the enzyme MPI, Mannose Phosphate Isomerase; MDH, Malate Dehydrogenase; 6PGD, 6 Phosphogluconate Dehydrogenase; NH, Nucleoside Hydrolase, 2-deoxyinosinc as substrate; SOD, Superoxide Dismutase; GPI, Glucose Phosphate Isomerase and ES, Esterase. From the isoenzyme studies we concluded that stocks: MHOM/AR/92/SE-1; SE-2; SE-4; SE-8 and SE-8-I are isoenzymatically Leishmania (Viannia) braziliensis. We need to analyze more enzymes before assigning them to a braziliensis zymodeme.

Dinâmicas recentes da relação das famílias com a escola em contextos urbanos material e simbolicamente depreciados: relato de uma aproximação, no terreno, ao ponto de vista dos professores

O presente artigo apresenta e discute alguns resultados de uma investigação sociológica em curso acerca das transformações sociais resultantes das intervenções urbanísticas e habitacionais promovidas pelo Estado no centro do Porto ao longo do último meio século. A investigação em causa é bastante abrangente – quer do ponto de vista do horizonte temporal que abarca, quer do ponto de vista temático –, pelo que neste artigo as atenções estarão centradas na enunciação, a partir da reconstituição empírica e analítica dos pontos de vista de educadores e professores de um agrupamento vertical de escolas, de algumas das dinâmicas recentes da relação das famílias com a instituição escolar em contextos sociais caracterizados por níveis elevados de privação económica e cultural e por processos vincados de segregação física e simbólica.

Effect of active components from Garlic on AGEs formation

Advanced glycation end-products are Maillard reaction products that are found in thermal processed food. This compounds are often referred as unhealthy for human diet, namely because of their capacity to form amino-acid dimers. There is a broad range of answers to get about how these products are formed, how they interact with the organism and how these reactions can be inhibited to prevent the referred effects. Some compounds from garlic are thought to be able to inhibit these reactions. This study using spectrophotometric, High Performance Liquid Chromatography-Tandem Mass Spectrometry (HPLC-MS/MS) and Fourier transformed infrared spectroscopy (FTIR) analysis, helps to understand better not only not only the effect of some compounds obtained from garlic, diallyl sulfide (DAS), diallyl disulfide (DADS) and diallyl trisulfide (DATS), on these AGEs production reaction, but also helped to understand better the reaction itself.