The Impact of Supervisor's Advice, Codes of Conduct, Accountability and Moral Attentiveness of Individuals on Discriminatory Behaviour Against Immigrants.

Past studies on the personnel selection demonstrated that a supervisor's advice to discriminate can lead to compliant behaviours. This study had the aim to extend past findings by examining what can overcome the powerful influence of the hierarchy. 50 Swiss managers participated to an in-basket exercise. The main task was to evaluate Swiss candidates (in-group) and foreigners (out-groups: Spanish and Kosovo Albanians) and to select two applicants for a job interview. Main results were the effect of codes of conduct to prevent discrimination against out-group applicants in the presence of a supervisor's advice to prefer in-group members. But, when participants were accountable to an audience, this beneficial effect disappears because participants followed the supervisor's advice. The second aim was to assess if the difference in responses between participants was related to their difference in moral attentiveness. Results showed some significant relationships but not always in the direction expected.

Determination of compression behaviour of coating layer

The strength properties of paper coating layer are very important in converting and printing operations. Too great or low strength of the coating can affect several problems in printing. One of the problems caused by the strength of coating is the cracking at the fold. After printing the paper is folded to final form and the pages are stapled together. In folding the paper coating can crack causing aesthetic damage over printed image or in the worst case the centre sheet can fall off in stapling. When folding the paper other side undergoes tensile stresses and the other side compressive stresses. If the difference between these stresses is too high, the coating can crack on the folding. To better predict and prevent cracking at the fold it is good to know the strength properties of coating layer. It has measured earlier the tensile strength of coating layer but not the compressive strength. In this study it was tried to find some way to measure the compressive strength of the coating layer and investigate how different coatings behave in compression. It was used the short span crush test, which is used to measure the in-plane compressive strength of paperboards, to measure the compressive strength of the coating layer. In this method the free span of the specimen is very small which prevent buckling. It was measured the compressive strength of free coating films as well as coated paper. It was also measured the tensile strength and the Bendtsen air permeance of the coating film. The results showed that the shape of pigment has a great effect to the strength of coating. Platy pigment gave much better strength than round or needle-like pigment. On the other hand calcined kaolin, which is also platy but the particles are aggregated, decreased the strength substantially. The difference in the strength can be explained with packing of the particles which is affecting to the porosity and thus to the strength. The platy kaolin packs up much better than others and creates less porous structure. The results also showed that the binder properties have a great effect to the compressive strength of coating layer. The amount of latex and the glass transition temperature, Tg, affect to the strength. As the amount of latex is increasing, the strength of coating is increasing also. Larger amount of latex is binding the pigment particles better together and decreasing the porosity. Compressive strength was increasing when the Tg was increasing because the hard latex gives a stiffer and less elastic film than soft latex.

Thermoplastic bioactive composite – with special reference to dissolution behaviour and tissue response

Bioactive glasses are surface-active ceramic materials which support and accelerate bone growth in the body. During the healing of a bone fracture or a large bone defect, fixation is often needed. The aim of this thesis was to determine the dissolution behaviour and biocompatibility of a composite consisting of poly(ε-caprolactone-co-DL-lactide) and bioactive glass (S53P4). In addition the applicability as an injectable material straight to a bone defect was assessed. In in vitro tests the dissolution behaviour of plain copolymer and composites containing bioactive glass granules was evaluated, as well as surface reactivity and the material’s capability to form apatite in simulated body fluid (SBF). The human fibroblast proliferation was tested on materials in cell culture. In in vivo experiments, toxicological tests, material degradation and tissue reactions were tested both in subcutaneous space and in experimental bone defects. The composites containing bioactive glass formed a unified layer of apatite on their surface in SBF. The size and amount of glass granules affected the degradation of polymer matrix, as well the material’s surface reactivity. In cell culture on the test materials the human gingival fibroblasts proliferated and matured faster compared with control materials. In in vitro tests a connective tissue capsule was formed around the specimens, and became thinner in the course of time. Foreign body cell reactions in toxicological tests were mild. In experimental bone defects the specimens with a high concentration of small bioactive glass granules (<45 μm) formed a dense apatite surface layer that restricted the bone ingrowth to material. The range of large glass granules (90-315 μm) with high concentrations formed the best bonding with bone, but slow degradation on the copolymer restricted the bone growth only in the superficial layers. In these studies, the handling properties of the material proved to be good and tissue reactions were mild. The reactivity of bioactive glass was retained inside the copolymer matrix, thus enabling bone conductivity with composites. However, the copolymer was noticed to degradate too slowly compared with the bone healing. Therefore, the porosity of the material should be increased in order to improve tissue healing.

Effect of magnesium sulphate and L-tryptophan and genotype on the feed intake, behaviour and meat quality of pigs

Sixty-nine entire male pigs with different halothane genotype (homozygous halothanepositive – nn-, n=36; and homozygous halothane negative – NN-, n=33) were fed with a supplementation of magnesium sulphate (Mg) and/or L-tryptophan (Trp) in the diet for 5days before slaughter. Animals were housed individually and were submitted to stressful ante mortem conditions (mixed in the lorry according to treatments and transported 1h on rough roads). Individual feed intake was recorded during the 5-day treatment. At the abattoir, pig behaviour was assessed in the raceway to the stunning system and during the stunning period by exposure to CO2. Muscle pH, colour, water holding capacity, texture and cathepsin activities were determined to assess meat quality. The number of pigs with an individual feed intake lower than 2kg/day was significantly different among diets (P<0.05; Control: 8.7%; Mg&Trp: 43.5%; Trp:17.4%) and they were considered to have inadequate supplement intake. During the antemortem period, 15.2% of pigs included in the experiment died, and this percentagedecreased to 8.7% in those pigs with a feed intake > 2kg/day, all of them from thestress-sensitive pigs (nn). In general, no differences were observed in the behaviour ofpigs along the corridor leading to the stunning system and inside the CO2 stunningsystem. During the stunning procedure, Trp diet showed shorter periods of muscularexcitation than control and Mg&Trp diets. The combination of a stressful ante mortemtreatment and Mg&Trp supplementation led to carcasses with high incidence of severeskin lesions. Different meat quality results were found when considering all pigs orconsidering only those with adequate supplement intake. In this later case, Trp increased pH45 (6.15) vs Control diet (5.96) in the Longissimus thoracis (LT) muscle (P<0.05) and pH at 24h (Trp: 5.59 vs C: 5.47) led to a higher incidence of dark, firm and dry (DFD) traits in SM muscle (P<0.05). Genotype affected negatively all the meat quality traits. Seventy-five percent of LT and 60.0% of the SM muscles from nn pigs wereclassified as pale, soft and exudative (PSE), while none of the NN pigs showed these traits (P<0.0001). No significant differences were found between genotypes on the incidence of DFD meat. Due to the negative effects observed in the Mg&Trp group in feed intake and carcass quality, the utilization of a mixture of magnesium sulphate and tryptophan is not recommended

Polychlorinated dibenzo-p-dioxins (PCDD), dibenzofurans (PCDF) and polychlorinated biphenyls (PCB): main sources, environmental behaviour and risk to man and biota

Polychlorinated dibenzo-p-dioxins (PCDD) and dibenzofuranes (PCDF) and polychlorinated biphenyls (PCB) are types of persistent and bioaccumulating organic pollutants with enhanced chronic toxicity and carcinogenic properties and can be considered as environmental indicators of anthropogenic activities since their occurrence in the environment can always be linked to anthropogenic activities. The present paper reviews the main sources and behaviour of these compounds in the environment as well as the risks they represent to man and biota.

Synthesis, characterization and thermal behaviour of solid-state compounds of benzoates with some bivalent transition metal ions

Solid-state MBz compounds, where M stands for bivalent Mn, Fe, Co, Ni, Cu and Zn and Bz is benzoate, have been synthesized. Simultaneous thermogravimetry and differential thermal analysis (TG-DTA), differential scanning calorimetry (DSC), infrared spectroscopy and complexometry were used to characterize and to study the thermal behaviour of these compounds. The procedure used in the preparation of the compounds via reaction of basic carbonates with benzoic acid is not efficient in eliminating excess acid. However the TG-DTA curves permitted to verify that the binary compounds can be obtained by thermosynthesis, because the benzoic acid can be eliminated before the thermal decomposition of these compounds. The results led to information about the composition, dehydration, thermal stability, thermal decomposition and structure of the isolated compounds. On heating, these compounds decompose in two (Mn, Co, Ni, Zn) or three (Fe, Cu) steps with formation of the respective oxide (Mn3O4, Fe2O3, Co3O4, NiO, CuO and ZnO) as final residue. The theoretical and experimental spectroscopic studies suggest a covalent bidentate bond between ligand and metallic center.

Relationships between adolescents and parents values and parents answering behaviour

In this paper we set out a confirmatory factor analysis model relating the values adolescents and their parents aspire to for the child’s future. We approach a problem when collecting parents’ answers and analysing paired data from parents and their child: the fact that in some families only one parent answers, while in others both meet to answer together. In order to account for differences between one-parent and two-parent responses we follow a multiple group structural equation modelling approach. Some significant differences emerged between the two and one answering parent groups. We observed only weak relationships between parents’ and children’s values

Learning in Consumer Behaviour

Tämän kandidaatintyön tavoitteena on esittää kuvaus kulutusoppimisen teorioista ja tämän lisäksi kuvata käytännön sovelluksia liittyen kulutuskäyttäytymiseen ja mainontaan. On olemassa kaksi keskeistä ajattelutapaa liittyen oppimisen teorioihin. Ensimmäisen suuntauksen kannattajat näkevät oppimisen puhtaasti behavioristisena, eli että se on seurausta toistoista, ja siten ne näkevät yksilön "mustana laatikkona", jossa syötteenä on ärsyke ja suoritteena on tietty käytös. Toisen suuntauksen kannattajien mielestä oppiminen on kognitiivinen prosessi; kaikista yksinkertaisimmista tapauksista lähtien yksilö prosessoi informaatiota ratkaistakseen omia ongelmiaan. Käytännössä kumpaakin teoriaa tarvitaan selittämään oppimista ilmiönä, koska oppiminen on yhdistelmä toistoja ja kognitiivisia prosesseja. Työmme näyttää kuinka markkinoijat hyödyntävät näitä kahta teoriaa käytännössä mainonnassaan, tarkoituksenaan tuotemerkkinsä ja tuotteidensa asemointi markkinoilla suhteessa kilpailijoihinsa.

Thermal behaviour study of solid state compounds of manganese (II), zinc (II) and lead (II) with cinnamic acid

Compounds of cinnamic acid with manganese, zinc and lead have been prepared in aqueous solution. Thermogravimetry, derivative thermogravimetry (TG, DTG), differential scanning calorimetry (DSC), X-ray diffraction and complexometry have been used in the characterization as well as in the study of the thermal stability and interpretation concerning the thermal decomposition.

Thermal behaviour studies of solid state compounds of cinnamylidenepyruvate with trivalent lanthanides and yttrium (III) in an atmosphere of CO2

Solid state cinnamylidenepyruvate of trivalent lanthanides (except for promethium) and yttrium, were prepared. Thermogravimetry, derivative thermogravimetry (TG, DTG), differential scanning calorimetry (DSC), X-ray diffraction powder patterns and complexometry were used to characterize and to study the thermal behavior of these compounds in a dynamic CO2 atmosphere. The results obtained showed significative differences on the thermal stability and thermal decomposition of these compounds, with regard to the thermal behavior study in a dynamic air atmosphere.

Synthesis, characterization and thermal behaviour of solid state compounds of 2-chlorobenzylidenepyruvate with trivalent aluminium, gallium, indium and scandium metals

Solid state compounds M-2-Cl-BP, where 2-Cl-BP is 2-chlorobenzylidenepyruvate and M represents Al, Ga, In, and Sc were prepared. X-ray powder diffractometry, infrared spectroscopy and simultaneous thermogravimetry-differential thermal analysis (TG-DTA), have been used to characterize and to study the thermal behavior of these compounds. The results provided information concerning the stoichiometry, crystallinity, thermal stability and thermal decomposition of the compounds.

Synthesis, characterization and thermal behaviour of solid state compounds of 4-methoxybenzoate with Manganese, Nickel and Copper

Solid state M-L compounds, where M stands for bivalent Mn, Ni, Cu and L is 4-methoxybenzoate, have been synthesized. Simultaneous thermogravimetry - differential thermal analysis (TG-DTA), X-ray powder diffractometry, infrared spectroscopy, elemental analysis and complexometry were used to characterize and to study the thermal behaviour of these compounds. The results led to information about the composition, dehydration, thermal stability and thermal decomposition of the isolated compounds.