LAPMv2 - software for underwater large-area photo-mosaicking

LAPMv2 is a research software solution specifically developed to allow marine scientists to produce geo-referenced visual maps of the seafloor, known as mosaics, from a set of underwater images and navigation data. LAPMv2 has a graphical user interface that guides the user through the different steps of the mosaicking workflow. LAPMv2 runs on 64-bit Windows, MacOS X and Linux operating systems. There are two versions for each operating system: (1) the WEB-installers (lightweight but require an internet connection during the installation) and (2) the MCR installers (large files but can be installed on computer without internet-connection). The user manual explains how to install and start the program on the different operating systems. Go to http://www.lapm.eu.com for further information about the latest versions of LAPMv2.

A Chaotic Spread Spectrum System for Underwater Acoustic Communication

The work is supported in part by NSFC (Grant no. 61172070), IRT of Shaanxi Province (2013KCT-04), EPSRC (Grant no.Ep/1032606/1).

Using augmented state Kalman filter to localize multi autonomous underwater vehicles

The present paper describes a system for the construction of visual maps ("mosaics") and motion estimation for a set of AUVs (Autonomous Underwater Vehicles). Robots are equipped with down-looking camera which is used to estimate their motion with respect to the seafloor and built an online mosaic. As the mosaic increases in size, a systematic bias is introduced in its alignment, resulting in an erroneous output. The theoretical concepts associated with the use of an Augmented State Kalman Filter (ASKF) were applied to optimally estimate both visual map and the fleet position.

Inter-carrier interference mitigation for underwater acoustic communications

Communicating at a high data rate through the ocean is challenging. Such communications must be acoustic in order to travel long distances. The underwater acoustic channel has a long delay spread, which makes orthogonal frequency division multiplexing (OFDM) an attractive communication scheme. However, the underwater acoustic channel is highly dynamic, which has the potential to introduce significant inter-carrier interference (ICI). This thesis explores a number of means for mitigating ICI in such communication systems. One method that is explored is directly adapted linear turbo ICI cancellation. This scheme uses linear filters in an iterative structure to cancel the interference. Also explored is on-off keyed (OOK) OFDM, which is a signal designed to avoid ICI.

Possibilities of advanced MAG-welding processes in shipbuilding

In shipbuilding industry welding of primer coated and tack welded steel products cause different issues. Primer coated steel products are commonly used at shipyards to ensure corrosion free storage of products in outdoor conditions. However usage of primer can cause imperfections to welds. To prevent porosity primed steel products are usually welded with tubular welding wires. Tack welds cause commonly interferences in mechanized welding when over welded, which increases costs related to welding due to increased need of preparing and repairing. The aim of this study is to research possibilities of advanced solid wire MAG-welding processes to deal with these two previously mentioned problems. This study concentrates to examine possibilities of MAG-welding, pulse MAG-welding, double pulse MAG-welding, RapidArc and ForceArc processes. Large amount of experiments were made to find out the produced porosity and the ability to over weld tack welds with each process in different circumstances. In welding of primed steel products porosity is caused mainly by hydrogen, CO, CO2, nitrous gases and zinc fumes. It was found in experiments that porosity of MAG-welding can be greatly decreased by using pulse MAG-welding instead. Also reduction of welding speed, usage of air gap and usage of solid wire product with higher amount of alloying elements reduces porosity. Researched advanced MAG-welding processes did not have an improvement into over welding of tack welds. With studied throat thicknesses and welding positions conventional MAG-welding managed better over welding of tack welds than the four studied advanced MAG-welding processes. Studied solid wire MAG-welding processes would be best suited at shipyard for mechanized welding in welding position PB. In welding positions PD and PG tubular welding wires are clearly more productive.

Comparison of EN & ASME welding and its allied processes standards

This thesis is made in cooperation with Wärtsilä and Sandvik. The main purpose of the thesis is to clarify the best suitable American standards for European standards used in Wärtsilä’s investigation checklist and to make wide and easily readable tables for Wärtsilä and their subcontractors. One of the most important issues is to make clear if the compared American standards are demanding enough for Wärtsilä’s needs. The research is done by comparing EN standards mentioned in Wärtsilä’s investigation checklist to corresponding ASME, AWS, ASNT and ASTM standards. The research shows that there is visible lack of requirements in American standards compared to European ones. Some areas of American standards are more demanding than European standards but in larger scale EN standards are much wider and more demanding than American standards. Because of these reasons, usage of European standards should be recommended for Wärtsilä’s subcontractors to ensure the quality and reliability of production.

An explanatory model of underwater adaptation

The underwater environment is an extreme environment that requires a process of human adaptation with specific psychophysiological demands to ensure survival and productive activity. From the standpoint of existing models of intelligence, personality and performance, in this explanatory study we have analyzed the contribution of individual differences in explaining the adaptation of military personnel in a stressful environment. Structural equation analysis was employed to verify a model representing the direct effects of psychological variables on individual adaptation to an adverse environment, and we have been able to confirm, during basic military diving courses, the structural relationships among these variables and their ability to predict a third of the variance of a criterion that has been studied very little to date. In this way, we have confirmed in a sample of professionals (N = 575) the direct relationship of emotional adjustment, conscientiousness and general mental ability with underwater adaptation, as well as the inverse relationship of emotional reactivity. These constructs are the psychological basis for working under water, contributing to an improved adaptation to this environment and promoting risk prevention and safety in diving activities.

A surface plasmon resonance system for the underwater detection of domoic acid

Over the past decade Surface Plasmon Resonance (SPR) techniques have been applied to the measurement of numerous analytes. In this article, an SPR biosensor system deployed from an oceanographic vessel was used to measure dissolved domoic acid (DA), a common and harmful phycotoxin produced by certain microalgae species belonging to the genus Pseudo-nitzschia. During the biosensor deployment, concentrations of Pseudo-nitzschia cells were very low over the study area and measured DA concentrations were below detection. However, the in situ operational detection limit of the system was established using calibrated seawater solutions spiked with DA. The system could detect the toxin at concentrations as low as 0.1 ng mL−1 and presented a linear dynamic range from 0.1 ng mL−1 to 2.0 ng mL−1. This sensor showed promise for in situ detection of DA.

International workshop on "Different survey methods for coral reef fish, including methods based on underwater video"

In September 2013, staff from the University of the South Pacific (USP) Honiara campus, the Secretariat of the Pacific Community (SPC) and IFREMER (UR LEADNC, AMBIO project) in New Caledonia, and the French Institute for Pacific Coral Reefs (IRCP) in Moorea, French Polynesia, co-facilitated a workshop entitled “Different survey methods of coral reef fish, including the methods based on underwater video”. The workshop was attended by students from USP, NGO and fisheries officers. They were trained to several underwater visual census techniques and to the STAVIRO video-based technique, including both field work and data analysis.

Underwater acoustic networks: the FP7 UAN project

The EU-funded project UAN - Underwater Acoustic Network aims at conceiving, developing and testing at sea an innovative and operational concept for integrating in a unique communication system submerged, surface and aerial sensors with the objective of protecting off-shore and coastline critical infrastructures. A crucial aspect of the project consisted in the use of autonomous underwater vehicles (AUVs) as mobile nodes in the underwater acoustic communication network. In particular, AUVs have the role of adapting the network geometry to the variation of the acoustic channel. This paper reports on the project concept and vision as well as on the progress of its various development phases. The recent at-sea successes that have been demonstrated within the UAN framework are detailed and results of the final UAN project demonstration, UAN11, held in the May of 2011, are reported. The UAN network was in operation for five continuous days with up to five nodes, of which three of them were mobile nodes. © IFAC.

Libs in cultural heritage: recognition and identification of objects in an underwater archaeological shipwreck

Nowadays, one of the most important areas of interest in archeology is the characterization of the submersed cultural heritage. Mediterranean Sea is rich in archaeological findings due to storms, accidents and naval battles since prehistoric times. Chemical analysis of submerged materials is an extremely valuable source of information on the origin and precedence of the wrecks, and also the raw materials employed during the manufacturing of the objects found in these sites. Nevertheless, sometimes it is not possible to extract the archaeological material from the marine environment due to size of the sample, the legislation or preservation purposes. In these cases, the in-situ analysis turns into the only alternative for obtaining information. In spite of this demand, no analytical techniques are available for the in-situ chemical characterization of underwater materials. The versatility of laser-induced breakdown spectroscopy (LIBS) has been successfully tested in oceanography 1. Advantages such as rapid and in situ analysis with no sample preparation make LIBS a suitable alternative for field measurements. To further exploit the inherent advantages of the technology, a mobile fiber-based LIBS platform capable of performing remote measurements up to 50 meters range has been designed for the recognition and identification of artworks in underwater archaeological shipwrecks. The LIBS prototype featured both single-pulse (SP-LIBS) and multi-pulse excitation (MP-LIBS) 2. The use of multi-pulse excitation allowed an increased laser beam energy (up to 95 mJ) transmitted through the optical fiber. This excitation mode results in an improved performance of the equipment in terms of extended range of analysis (to a depth of 50 m) and a broader variety of samples to be analyzed (i.e., rocks, marble, ceramics and concrete). In the present work, the design and construction considerations of the instrument are reported and its performance is discussed on the basis of the spectral response, the remote irradiance achieved upon the range of analysis and its influence on plasma properties, as well as the effect of the laser pulse duration and purge gas to the LIBS signal. Also, to check the reliability and reproducibility of the instrument for field analysis several robustness tests were performed outside the lab. Finally, the capability of this instrument was successfully demonstrated in an underwater archaeological shipwreck (San Pedro de Alcántara, Malaga).

Underwater survey of ichthyofauna of eastern Atlantic seamounts: Gettysburg and Ormond (Gorringe Bank)

Gettysburg and Ormond are seamounts belonging to the Gorringe Bank, which is located on the Europen-African plate boundary. Given the importance of these oceanic features for understanding marine biodiversity patterns, two surveys were carried out in 1998 (Gettysburg) and 1999 (Ormond) using diving, photography and video for species identification and abundance evaluation. Of the 9 fish species found at Gettysburg and 11 at Ormond, 6 were common to both sites and these included the dominant species: the oceanic and commercially important, Seriola rivoliana, and the coastal, typically Atlantic-Mediterranean Coris julis and Anthias anthias. The strong representation of coastal, demersal and Atlantic-Mediterranean species in the Gorringe Bank region and the presence of Abudefduf luridus, an endemic Macaronesian species, at Gettysburg suggests that the upper part of these seamounts may have acted and still act as “stepping stones” for the dispersal of coastal species.