Neutron production at the heavy ion research facility in Lanzhou

In this work, the neutron radiation field at Heavy Ion Research Facility in Lanzhou (HIRFL) was investigated. Total neutron yields, spectra and angular distributions in the bombardment of various thick targets by C-12 and O-18 ions with energies up to 75 MeV/u were obtained using the activation method. The neutron dose equivalent rates of 60 MeV/u O-18 on various thick targets at different angles were measured with a modified A-B remmeter. Our results are compared with those of other reports.

Production cross-section of Ra-230 in the reaction of 60 MeV/u O-18 ions with U-238

A thick natural uranium target was bombarded with a 60 MeV/u O-18 beam. The neutron-rich isotope Ra-230 as the target residue was produced through the multinucleon transfer reaction (U-238-4p-4n). The barium and radium fraction as BaCl2 precipitate were radiochemically separated first from the mixture of uranium and reaction products. Then, the radium fraction was separated from BaCl2 precipitate by using cation exchange technique. The gamma-ray spectra of the Ra fraction were measured using an HPGe detector. The production cross sections of Ra-230 were obtained by a combination of the radiochemical separation technique and off-line gamma-ray spectroscopy. The cross section of Ra-230 has been determined to be 66 +/- 20 mu b.

Isospin effect of projectile fragment yields

Isospin asymmetry is very important in the nuclear equation of state (EOS), isotope yield from the projectile fragments can give information of the reaction process. In this paper projectile fragment yields are measured in the collision Ar-36,Ar-40 + Ni-64 at incident energy 50 MeV/u with different isospin asymmetry project Ar-36,Ar-40, data analysis, particle identification and event selection are described. Isotope yields are compared in these two reactions, and axe also compared with the empirical parametrization of fragmentation cross-section calculated by EPAX.

Angular dispersion and deflection function for heavy ion elastic scattering

The differential cross sections for elastic scattering products of F-17 on Pb-208 have been measured. The angular dispersion plots of ln(d sigma/d theta) versus theta(2) are obtained from the angular distribution of the elastic scattering differential cross sections. Systematical analysis on the angular dispersion for the available experimental data indicates that there is an angular dispersion turning angle at forward angular range within the grazing angle. This turning angle can be clarified as nuclear rainbow in classical deflection function. The exotic behaviour of the nuclear rainbow angle offers a new probe to investigate the halo and skin phenomena.

Elastic scattering angular dispersion of weakly bound nucleus F-17

The differential cross-sections for elastic scattering of F-17 and O-17 on Pb-208 have been measured at Radioactive Ion Beam Line at Lanzhou (RIBLL). The variation of the logarithms of differential cross-sections with the square of scattering angles, viz. angulax dispersion plot, shows clearly that there exists a turning point in the range of small scattering angles (6 degrees-20 degrees) for F-17 due to its exotic structure, while no turning point was observed for O-17. The experimental results have been compared with previous data of other groups. Systematical analysis on the available data seems to conclude that there is an exotic behavior of elastic scattering angular dispersion of weakly bound nuclei with halo or skin structure as compared with that of the stable nuclei. Therefore the fact that the turning point of the elastic scattering angular dispersion plot appears at small angle for weakly bound nuclei can be used as a new probe to investigate the halo and skin phenomenon.

Production cross-section of Th-236 in the interaction of U-238 with 60MeV/u O-18 Ions

The neutron-rich target-like isotope Th-236 was produced in U-238-2p multinucleon transfer reaction between a 60MeV/u O-18 beam and nature U-238 targets. The thorium activities were radiochemically separated from the mixture of uranium and reaction products. The isotope Th-236 was identified by 642.2keV, 687.6keV and 229.6keV characteristic gamma-rays. The production cross section of Th-236 has been determined to be 250 +/- 50 mu b.

Pa-239 may influence astrophysics study

The estimation method of the universe age using the nuclear cosmochronology by the heavy chronometers is essentialized. The influence of the novel long half-life of Pa-239 on the universe age estimation is simply mentioned.

Exotic behavior of elastic scattering differential cross-sections of weakly bound nucleus F-17 at small angles

The differential cross-sections for elastic scattering of F-17 and O-17 on Pb-208 have been measured at Radioactive Ion Beam Line at Lanzhou (RIBLL). The variation of the logarithms of differential cross-sections with the square of scattering angles shows clearly that there exists a turning point in the range of small scattering angles (6 degrees-20 degrees) for F-17 having exotic structure, while no turning point was observed in the O-17 elastic scattering. The experimental results have been compared with previous data. Systematical analysis on the available data seems to conclude that there is an exotic behavior of elastic scattering differential cross-sections of weakly bound nuclei with halo or skin structure as compared with that of the ordinary nuclei near stable line. Therefore the fact that the turning point of the logarithms of differential cross-sections appears at small angle for weakly bound nuclei could be used as a new probe to investigate the halo and skin phenomenon.

Exotic behaviour of angular dispersion of weakly bound nucleus F-17 at small angles

The differential cross sections of F-17 and O-17 elastic scattering products on Pb-208 have been measured at the Radioactive Ion Beam Line at Lanzhou (RIBLL). Two angular dispersion plots of ln(d sigma/d theta) versus theta 2 are obtained from the angular distribution of the elastic scattering differential cross sections. The angular dispersion plot exhibits a clear turning point for F-17 in the range of small scattering angles 6 degrees-20 degrees due to its exotic structure, but for O-17, the turning point is not observed in the same angular range. The experimental results have been compared with previous data of other groups. Systematical analysis on the available data supports the above conclusion that there is an exotic behaviour of the angular dispersion plot of weakly bound nuclei with halo or skin structure as compared with that of the ordinary nuclei near stable line. Therefore the turning point of the angular dispersion plot appears at small angle for weakly bound nuclei with halo or skin structure, and can be used as a new probe to investigate the halo and skin phenomena of weakly bound nuclei.

Development of multi-channel gated integrator and PXI-DAQ system for nuclear detector arrays

A multi-channel gated integrator and PXI based data acquisition system have been developed for nuclear detector arrays with hundreds of detector units. The multi-channel gated integrator can be controlled by a programmable Cl controller. The PXI-DAQ system consists of NI PXI-1033 chassis with several PXI-DAQ cards. The system software has a user-friendly GUI which is written in C language using LabWindows/CVI under Windows XP operating system. The performance of the PXI-DAQ system is very reliable and capable of handling event rate up to 40 kHz. (C) 2010 Elsevier B.V. All rights reserved.

基于实物界面的虚拟装配

虚拟装配技术能够有效的提高产品生产效率，降低成本。目前虚拟装 配技术已经成为各高校和研究所的重点研究方向之一。在传统的虚拟装配 程序中，用户与计算机通常是通过GUI 界面的 CAD 软件，或者是带有数据 手套和跟踪器的虚拟现实系统与计算机进行交互。而这些交互手段都存在 着自身的不足，例如 CAD软件的交互不自然，学习难度大，而虚拟手缺乏 对零件抓取的真实感受，对零件的姿态调整难以控制等等。而实物用户界 面的出现很好的解决了这个问题，通过它可以将现实世界中的实物对象和 虚拟模型建立关联，用户通过操作实物标记控制虚拟零件模型，不仅可以 使用户自由的控制虚拟零件的姿态，而且具有比较高的切实感，此外这种 虚拟装配方式还克服了传统 CAD 软件界面复杂学习困难的缺点，能让用户 在短时间内掌握系统的使用，是一种新颖的虚拟装配方式。 本文基于增强现实技术，将实物用户界面应用到虚拟装配系统中，在 单摄像头的条件下，将虚拟零件模型加载至实物标记上，用户通过操作实 物标记来控制虚拟模型，完成装配过程。相比于传统的虚拟装配交互方式， 增强了用户操作的切实感。根据装配任务需求设计了 4 类实物标记，在满 足虚拟装配任务需求的前提下大大降低了用户的认知负担。并且提出了 3 种交互技术，包括单手遮挡与接近性原理，匹配约束信息提示与判定，以 及视点控制等，结合碰撞检测技术来实现精确而又自然的虚拟装配。

EQCM characterization of self-assembled kinetics of 4-pyridyl hydroquinone at Pt surface and its ion transfer in electrochemical redox

The adsorbed kinetics, proton transportation in electrochemical redox process of 4-pyridyl hydroquinone (4PHQ) self-assembled monolayer (SAM) modified Pt electrode were studied by electrochemical quartz crystal microbalance (EQCM) in situ. It proved that the electrode was modified by a monolayer and underwent a rapid electron transfer. It was a slow adsorbed kinetic process. The ion transfer in the electrochemical redox at the SAM-modified electrode surface mainly involved into the hydrate hydrogen ion.

Detection of hydrazine, methylhydrazine and isoniazid by capillary electrophoresis with a 4-pyridyl hydroquinone self-assembled microdisk platinum electrode

Capillary electrophoresis (CE)/electrochemical detection (EC) for the simultaneous detection of hydrazine, methylhydrazine, and isoniazid has been developed with a 4-pyridyl hydroquinone self-assembled microdisk platinum electrode. Such an electrode has very high catalytic ability for hydrazines and they could be detected even at 0.0 V. The responses for hydrazine, methylhydrazine, and isoniazid are linear over 3 orders of detected concentration and of magnitude of 0.2-400 mu M, 0.2-400 mu M, 0.5 mu M-2 mM, with correlation coefficients of 0.9998, 0.9991, and 0.9982, respectively. And they could be detected to levels of 0.1, 0.1 and 0.2 mu M, respectively. This modified electrode was found to be very stable and reproducible when continuously used as detector for capillary electrophoresis for period of at least 4 weeks with no apparent loss of response. (C) 1999 Elsevier Science B.V. All rights reserved.

Electrocatalytic oxidation of hydrazines at a 4-pyridyl hydroquinone self-assembled platinum electrode and its application to amperometric detection in capillary electrophoresis

4-Pyridyl hydroquinone on a platinum electrode adsorbs through the pyridine nitrogen forming stable self-assembled layers. The electrocatalytical oxidation of hydrazines was performed by the modified electrode. The overpotential of hydrazines was decreased markedly at the self-assembled monolayer (SAM) electrode. The mechanism of hydrazine oxidation was also investigated. Amperometric detection of hydrazine under zero potential (vs Ag\AgCI\sat. KCl) was exhibited by the SAM electrode used as an electrochemical detector in a flow system. (C) 1998 Elsevier Science S.A. All rights reserved.

Tremolite-reinforced nylon 66 composites: Mechanical and rheological properties

The reinforcement effect of an acicular inorganic filler, tremolite, on nylon 66 was studied. The mechanical properties of tremolite-filled nylon 66 composites and the effect of the filler particle size on them were obtained. The dynamic mechanical properties and rheological properties of the composites were measured. Two treatments, silane and unsaturated polyester, were used to improve the interface between tremolite and the nylon matrix. The morphologies of the composites were investigated using SEM. (C) 1998 John Wiley & Sons, Inc.