In vitro wound healing improvement by low-level laser therapy application in cultured gingival fibroblasts

The aim of this study was to determine adequate energy doses using specific parameters of LLLT to produce biostimulatory effects on human gingival fibroblast culture. Cells (3 10 4 cells/cm 2) were seeded on 24-well acrylic plates using plain DMEM supplemented with 10 fetal bovine serum. After 48-hour incubation with 5 CO2 at 37C, cells were irradiated with a InGaAsP diode laser prototype (LASERTable; 780 3 nm; 40mW) with energy doses of 0.5, 1.5, 3, 5, and 7J/cm 2. Cells were irradiated every 24h totalizing 3 applications. Twenty-four hours after the last irradiation, cell metabolism was evaluated by the MTT assay and the two most effective doses (0.5 and 3J/cm 2) were selected to evaluate the cell number (trypan blue assay) and the cell migration capacity (wound healing assay; transwell migration assay). Data were analyzed by the Kruskal-Wallis and Mann-Whitney nonparametric tests with statistical significance of 5. Irradiation of the fibroblasts with 0.5 and 3J/cm 2 resulted in significant increase in cell metabolism compared with the nonrradiated group (P 0.05). Both energy doses promoted significant increase in the cell number as well as in cell migration (P 0.05). These results demonstrate that, under the tested conditions, LLLT promoted biostimulation of fibroblasts in vitro. Copyright © 2012 Fernanda G. Basso et al.

Micro-inverter for integrated grid-tie PV module using resonant controller

Two-stage isolated converters for photovoltaic (PV) applications commonly employ a high-frequency transformer on the DC-DC side, submitting the DC-AC inverter switches to high voltages and forcing the use of IGBTs instead of low-voltage and low-loss MOSFETs. This paper shows the modeling, control and simulation of a single-phase full-bridge inverter with high-frequency transformer (HFT) that can be used as part of a two-stage converter with transformerless DC-DC side or as a single-stage converter (simple DC-AC inverter) for grid-connected PV applications. The inverter is modeled in order to obtain a small-signal transfer function used to design the PResonant current control regulator. A high-frequency step-up transformer results in reduced voltage switches and better efficiency compared with converters in which the transformer is used on the DC-DC side. Simulations and experimental results with a 200 W prototype are shown. © 2012 IEEE.

Wound healing of dehiscence defects following different root conditioning modalities: An experimental study in dogs

Objective: The purpose of this study was to investigate the periodontal healing pattern of dehiscence-type defects following different chemical root conditioning modalities. Materials and methods: Buccal osseous dehiscence defects were created on six teeth of seven dogs. After dental plaque accumulation, defects were treated with sterile saline solution (control group) or one chemical conditioning modality: citric acid (CA group), ethylenediaminetetraacetic acid (EDTA group), tetracycline (TTC group), citric acid + tetracycline (CA + TTC group), or tetracycline + citric acid (TTC + CA group). After 3 months of healing, clinical parameters were evaluated, and the animals were killed. Histological sections were processed, and a computer-assisted histometric analysis was used to evaluate the formation of new cementum, new bone, and epithelial apical migration. Results: All treatments yielded significant improvements in terms of probing depth decrease and clinical attachment level gain compared to baseline values; however, without significant differences among the groups (p > 0.05; one-way ANOVA). The highest amount of new cementum was noted in the EDTA group (3.72 ± 0.83 mm, 77.6 %), while the lowest amount of new bone was observed in the TTC group (0.7 ± 0.94 mm, 14.3 %). However, no statistically significant differences could be observed among the groups regarding epithelial apical migration, new cementum, and alveolar bone formation (p > 0.05). Conclusion: Chemical root surface conditioning did not promote any significant improvement in periodontal healing pattern of dehiscence-type defects in dogs. Clinical Relevance: Chemical root surface conditioning after surgical debridement did not promote positive or negative effects on periodontal healing pattern of dehiscence-type defects. © 2012 Springer-Verlag Berlin Heidelberg.

Topical application of the lectin Artin M accelerates wound healing in rat oral mucosa by enhancing TGF-β and VEGF production

The lectin Artin M has been shown to accelerate the wound-healing process. The aims of this study were to evaluate the effects of Artin M on wound healing in the palatal mucosa of rats and to investigate the effects of Artin M on transforming growth factor beta (TGF-β) and vascular endothelial growth factor (VEGF) secretion by rat gingival fibroblasts. A surgical wound was created on the palatal mucosa of 72 rats divided into three groups according to treatment: C - Control (nontreated), A - Artin M gel, and V - Vehicle. Eight animals per group were sacrificed at 3, 5, and 7 days postsurgery for histology, immunohistochemistry and determination of the levels of cytokines, and growth factors. Gingival fibroblasts were incubated with 2.5 μg/mL of Artin M for 24, 48, and 72 hours. The expression of VEGF and TGF-β was determined by enzyme-linked immunosorbent assay. Histologically, at day 7, the Artin M group showed earlier reepithelialization, milder inflammatory infiltration, and increased collagen fiber formation, resulting in faster maturation of granular tissue than in the other groups (p < 0.05). Artin M-induced cell proliferation in vivo and promoted a greater expression of TGF-β and VEGF in both experiments (p < 0.05). Artin M was effective in healing oral mucosa wounds in rats and was associated with increased TGF-β and VEGF release, cell proliferation, reepithelialization, and collagen deposition and arrangement of fibers. © 2013 by the Wound Healing Society.

Antimicrobial Brazilian propolis (EPP-AF) containing biocellulose membranes as promising biomaterial for skin wound healing

Among remarkable discoveries concerning propolis, such as antifungal, antiviral, and antioxidant activities, its anti-inflammatory, and mainly its antibacterial, properties deserve special attention when skin wound healing is concerned. Based on this and knowing the distinctive performance of bacterial (BC) membranes on wound healing, in this work it is proposed to demonstrate the potent antimicrobial activity and wound healing properties of a novel propolis containing biocellulose membrane. The obtained propolis/BC membrane was able to adsorb propolis not only on the surface, but also in its interstices demonstrated by scanning electron microscopy, X-ray diffraction, Fourier transform infrared (FT-IR) spectroscopy, and thermogravidimetric assays. Additionally, the polyphenolic compounds determination and the prominent antibacterial activity in the membrane are demonstrated to be dose dependent, supporting the possibility of obtaining propolis/BC membranes at the desired concentrations, taking into consideration its application and its skin residence time. Finally, it could be suggested that propolis/BC membrane may favor tissue repair in less time and more effectively in contaminated wounds. © 2013 Hernane da Silva Barud et al.

The influence of topic and systemic administration of copaiba oil on the alveolar wound healing after tooth extraction in rats

The Copaiba oil has been used as an auxiliary treatment of inflammations, skin disorders and stomach ulcers, however, in dentistry, this alternative medicine has not been investigated yet. The purpose of this study was to evaluate the influence of topic and systemic administration of copaiba oil on the alveolar wound healing after tooth extraction. Twenty-eight wistar male rats had their lower first molar teeth extracted. Subsequently, they were divided in four groups, according to the treatment performed: (a) alveolar socket irrigation with copaiba oil; (b) alveolar socket irrigation with physiological serum; (c) daily gavage with copaiba oil or (d) daily gavage with physiological serum. After the sacrifice, the mandibles were removed and processed in order to obtain decalcified histological sections. The results demonstrated high level of epithelial migration, small number of inflammatory cells and vascular enhancement in the animals which received systemic administration of copaiba oil. The rats treated with topic administration of copaiba oil presented ulcerations and large number of inflammatory cells. An increased bone neoformation was observed in both groups treated with copaiba oil when compared with placebo group. It could be concluded that topic or systemic administration of copaiba oil leads to a better alveolar bone healing, however the topic application on connective tissue should be carefully considered, regarding the whole socket wound healing. © Medicina Oral S. L. C.I.F. B 96689336 - eISSN: 1989-5488.

Sistema para analizar el crecimiento del comercio internacional: Module to Analyse the Growth of International Commerce (MAGIC): manual de uso

Incluye Bibliografía

Módulo para analizar el crecimiento del comercio internacional: Module to Analyse the Growth of International Commerce (MAGIC): manual de uso

Incluye Bibliografía

Module for the Analysis of Growth of International Commerce (MAGIC PLUS)

On 12 September 2006, on the occasion of the launching of the report Latin America and the Caribbean in the World Economy, 2005-2006, the Executive Secretary of ECLAC, José Luis Machinea, presented a new version of the software program Module for the Analysis of Growth of International Commerce (MAGIC).  The first version of MAGIC was created by ECLAC Subregional Headquarters in Mexico , to conduct ex post analysis of the competitiveness of countries' exports to the United States market. The new application architecture was made possible thanks to financial support from the Canadian International Development Agency (CIDA) and the Division of Production, Productivity and Management of ECLAC headquarters in Santiago , Chile .  This issue of the FAL Bulletin reviews the progress of MAGIC in the ten years it has been functioning, and the evolution which has made it one of ECLAC's most popular, versatile, and technologically advanced applications.  

Evaluation report of the training workshop on the use of the module to analyse growth of international commerce (Magic Plus) and the competitive analysis of nations (TRADECAN 2009) software

The aim of the workshop was to provide a functional overview of the software package, to enable participants to use the software in order to inform more evidence-based trade strategies, and build capacity for researchers and trade negotiators to provide more rigorous, analytical policy research to inform future trade negotiations. Participants came from the ministries of trade of the following CDCC member countries: Dominica, Grenada, Jamaica, Saint Lucia, Saint Kitts and Nevis, Saint Vincent and the Grenadines, and Trinidad and Tobago. Representatives of the following regional institutions were represented: the Caribbean Community/Caribbean Regional Negotiating Mechanism (CARICOM/CRNM); the Organisation of Eastern Caribbean States (OECS); the University of Guyana, University of Suriname and the University of the West Indies (UWI). It was hoped the workshop would be a stepping stone towards more advanced trade analysis training. The list of participants appears as Annex I.

Micro-inverter for integrated grid-tie photovoltaic module using resonant controller

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Development of organic-inorganic polymeric film formers for controlled drug release and wound care

Film forming polymeric systems represents a new and unexplored technology of systems forskin or wounds protection and for controlled drug release. The aim of this work was to study the use of polymeric organic-inorganic ureasil-polyether hybrids synthesized by the sol-gel process as film forming system containing silver sulfadiazine as model drug. The film formationtime can be controlled by changing the precursor/catalyst ratio used during the step of hydrolysis and condensations. The results showed that the precursor/catalyst proportion influences both the visual characteristics and time required to form the film. The precursor/catalyst ratio equal to 20.8 m/v was considered ideal due to promote the homogeneous and transparent film formation in less than 5 minutes. The release profile of sulfadiazine is dependent on the characteristics of the matrixes: matrix more hydrophobic as ureasil-POP provided a slowed released mainly due to the low swelling of the matrix. The more hydrophilic ureasil-POE matrix presents a large capacity to swell and favors the faster release of the drug. The set of results showed the possibility of future use of these systems for treating wounds caused by burns.