Gap size measurement: the proposal of a new field method

In the tropical Atlantic Forest, 42 canopy gaps had their areas estimated using four different field methods of measurement: Runkle, Brokaw and Green [Runkle, J.R., 1981. Gap formation in some old-growth forests of the eastern United States. Ecology 62, 1041-1051; Brokaw, N.V.L., 1982. The definition of treefall gap and its effect on measures of forest dynamics. Biotropica 14, 158-160; Green, P.T., 1996. Canopy Gaps in rain forest on Christmas Island, Indian Ocean: size distribution and methods of measurement. J. Trop. Ecol. 12, 427-434] and a new method proposed in this work. It was found that within the same gap delimitation, average gap size varied from 56.0 up to 88.3 m(3) while total sum of gap area varied from 2351.3 to 3707.9 m(3) Differences among all methods and between pairs of method proved to be statistically significant. As a consequence, gap size-class distribution was also different between methods. When one method is held as a standard, deviation on average values of gap size ranged between 11.8 and 59.7% as deviations on single gap size can reach 172.8%. Implications on forest dynamics were expressed by the forest turnover rate that was 24% faster or 15% slower depending on the method adopted for gap measurement. Based on my results and on methods' evaluation, the use of a new method is proposed here for future research involving the measure of gap size in forest ecosystems. Finally, it is concluded that forest comparisons disregarding the influence of different methods of gap measurement should be reconsidered. (c) 2005 Elsevier B.V. All rights reserved.

Influence of management and environmental factors on mating success of Africanized queen honey bees

Environmental factors and management techniques were evaluated in São Paulo, Brazil, for enhanced production of Africanized queen honey bees. Queens were reared by the Doolittle method; 12 breeder, 6 cell-builder, and 36 3-frame nucleus colonies were used. Nine groups of four virgin Africanized queen honey bees were subjected to the following treatments: queens were either 1-2, 3-4 or 5-6 days old and were released into mating nuclei containing either capped brood, uncapped brood or no brood. This was repeated sixteen times between August 1990 and August 1992. Seven repetitions occurred during nectar flow periods and nine repetitions occurred during nectar-dearth periods. Overall, 59% of 576 queens were successfully introduced and mated. The best results (93% success) were obtained during nectar flows, with 3- to 4-day-old queens released into nuclei containing capped brood. During nectar dearths the best mating success came from queens introduced into broodless nuclei (63%), the age of the queen did not influence mating success. Mating success decreased when wind velocity increased; this was the only significant meteorological effect found.

An intelligent system for pavement management

This paper describes a method for the evaluation of pavement condition through artificial neural networks using the MLP backpropagation technique. Two of the most used procedures for detecting the pavement conditions were applied: the overall severity index and the irregularity index. Tests with the model demonstrated that the simulation with the neural network gives better results than the procedures recommended by the highway officials. This network may also be applied for the construction of a graphic computer environment.

Tillage and phosphorus management effects on enzyme-labile bioactive phosphorus availability in Cerrado Oxisols

Phosphorus (P) is an essential element in crop nutrition, which can be growth limiting or an environmental contaminant, if present in excess. Tillage practices have a direct effect on the behavior and availability of soil P. Sorption and availability of various P forms were evaluated in an incubation-fractionation study of three soils, a Typic Paleudults (CR soil) and two Cerrado Oxisols (Latossolo Vermelho-Amarelo [LVA] and Latossolo Vermelho [LV]) with distinct biogeochemical characteristics and tillage management history. Phosphate and myo-inositol hexakisphosphate (mIPH) were strongly sorbed by the soils. Maximum adsorption capacities (S(max)) were 2.2-6.9, 3.3-7.8, and 1.6-19.8 mmol kg(-1) for phosphate in the 0-40 cm depths of the CR, LV, and LVA soils, respectively. For mIPH, S. were 1.2-3.7, 3.7-5.5, and 4.6-5.2 mmol kg(-1). Saturation indices reflected the long-term effect of repeated manure applications on the Paleudults and the near saturation of its P holding capacity, in contrast to the recently cultivated Cerrado soils. Tillage method appeared to have altered P retention characteristics of the near-surface zone very slightly, while increases in ligand-exchangeable (EEP;) and enzyme-labile organic P (EDTA-PHP) forms were observed in no-till Oxisols. In the Paleudults, added manure P increased bioactive P fractions and P saturation of no-till near-surface soil zone. Estimates of all bioactive P fractions using the ligand-based enzymatic assay showed it to be an effective method for assessing P availability in soil and developing sustainable P management strategies, particularly in Cerrado Oxisols that were low in organic matter while having an extensive P-fixing capacity. Published by Elsevier B.V.

Digital image analysis of root distribution towards improved irrigation water and soil management: Grapevine and date palm study cases

It is presented two study cases about the approach in root analysis at field and laboratory conditions based on digital image analysis. Grapevine (Vitis vinifera L.) and date palm (Phoenix dactylifera L.) root systems were analyzed by both the monolith and trench wall method aided by digital image analysis. Correlation between root parameters and their fractional distribution over the soil profile were obtained, as well as the root diameter estimation. Results have shown the feasibility of digital image analysis for evaluation of root distribution.

The Brazilian Seismographic Integrated Systems (BRASIS): Infrastructure and data management

In geophysics and seismology, raw data need to be processed to generate useful information that can be turned into knowledge by researchers. The number of sensors that are acquiring raw data is increasing rapidly. Without good data management systems, more time can be spent in querying and preparing datasets for analyses than in acquiring raw data. Also, a lot of good quality data acquired at great effort can be lost forever if they are not correctly stored. Local and international cooperation will probably be reduced, and a lot of data will never become scientific knowledge. For this reason, the Seismological Laboratory of the Institute of Astronomy, Geophysics and Atmospheric Sciences at the University of São Paulo (IAG-USP) has concentrated fully on its data management system. This report describes the efforts of the IAG-USP to set up a seismology data management system to facilitate local and international cooperation. © 2011 by the Istituto Nazionale di Geofisica e Vulcanologia. All rights reserved.

Analysis of inventory management in small business auto parts

The objective of this study was to analyze the production process and supply control in order to identify possible gaps and develop a method for managing supplies. The relevance of this research is on the benefits that can obtain by identifying the problems of supply control. The research method used was the case study, which was grounded on tripod semi-structured interviews, on-site observation, and document analysis. This methodology was very suitable because it can be analyzed and cross checked. The possibility of implementation of the proposal obtained from the theoretical framework, that together with the complementary actions suggested here, offers the opportunity to make the process more productive and profitable. This work allowed one to observe the weaknesses in managing the supply chain and at what points to work should be improved. It allowed to use some scientific models in the company object of study in order to improve supply management. © 2011 IEEE.

Delineation of specific management areas for coffee cultivation based on the soil-relief relationship and numerical classification

Predicting and mapping productivity areas allows crop producers to improve their planning of agricultural activities. The primary aims of this work were the identification and mapping of specific management areas allowing coffee bean quality to be predicted from soil attributes and their relationships to relief. The study area was located in the Southeast of the Minas Gerais state, Brazil. A grid containing a total of 145 uniformly spaced nodes 50 m apart was established over an area of 31. 7 ha from which samples were collected at depths of 0. 00-0. 20 m in order to determine physical and chemical attributes of the soil. These data were analysed in conjunction with plant attributes including production, proportion of beans retained by different sieves and drink quality. The results of principal component analysis (PCA) in combination with geostatistical data showed the attributes clay content and available iron to be the best choices for identifying four crop production environments. Environment A, which exhibited high clay and available iron contents, and low pH and base saturation, was that providing the highest yield (30. 4l ha-1) and best coffee beverage quality (61 sacks ha-1). Based on the results, we believe that multivariate analysis, geostatistics and the soil-relief relationships contained in the digital elevation model (DEM) can be effectively used in combination for the hybrid mapping of areas of varying suitability for coffee production. © 2012 Springer Science+Business Media New York.

Factors affecting the adoption of green supply chain management practices in Brazil: Empirical evidence

The aim of this study is to identify and analyse the factors that affect the adoption of Green Supply Chain Management practices based on empirical evidence from the Brazilian electronics sector. Data are collected in a survey of 100 electronics companies and analysed using statistical analysis of variance and regression methods. The study finds that the size of the company, previous experience with Environmental Management Systems, and the use of hazardous inputs are positively correlated with GSCM practices adoption. Surprisingly, formal pressure from the stronger tier/player in the supply chain is not correlated with the adoption of GSCM practices. Finally, we present some explanations for these findings and suggestions for future research. © 2013 Copyright Taylor and Francis Group, LLC.

Knowledge-based risk management: Survey on Brazilian software development enterprises

A risks management, carried on in an effective way, leads the software development to success and may influence on the organization. The knowledge takes part of such a process as a way to help taking decisions. This research aimed to analyze the use of Knowledge Management techniques to the Risk Management in software projects development and the possible influence on the enterprise revenue. It had, as its main studying subject, Brazilian incubated and graduated software developing enterprises. The chosen research method was the Survey type. Multivariate statistical methods were used for the treatment and analysis of the obtained results, this way identifying the most significant factors, that is, enterprise's achievement constraining factors and those outcome achievement ones. Among the latter we highlight the knowledge methodology, the time of existence of the enterprise, the amount of employees and the knowledge externalization. The results encourage contributing actions to the increasing of financial revenue. © 2013 Springer-Verlag.

Arthrocentesis procedure: Using this therapeutic maneuver for TMJ closed lock management

Temporomandibular joint (TMJ) disorder is a term that encompasses a number of overlapping conditions, such as closed lock. Closed lock of the TMJ is considered a consequence of a nonreducing deformed disc acting as an obstacle to the sliding condylar head that usually causes a decrease in the maximum mouth opening and acute pain. The management of the TMJ is still controversial. Thus, arthrocentesis of the TMJ is a valuable modification of the traditional method of arthroscopic lavage, which consists of washing the joint in order to remove chemical inflammatory mediators and intra-articular adhesions, changing intra-articular pressure. TMJ disorder has always presented as a therapeutic challenge to maxillofacial surgeons. Therefore, this paper aimed to describe a clinical report of a closed lock of the left TMJ in a 19-year-old female subject who was successfully treated by arthrocentesis procedure. © 2013 by Mutaz B. Habal, MD.

Failure of miniplate osteosynthesis for the management of atrophic mandibular fracture

Fractures of the severely atrophic (<10 mm) edentulous mandible are not common, and these fractures with a vertical height of 10 mm or less have long been recognized as being particularly problematic. Although there are advances in the treatment of the atrophic mandibular fracture, the treatment remains controversial. There are some options for treatment planning because of using small miniplates to large reconstruction plates. However, when the fixation method fails, it causes malunion, nonunion, and/or infection, and sometimes it has been associated with large bone defects. The authors describe a clinical report of a failed miniplate fixation for atrophic mandibular fracture management. The authors used a load-bearing reconstruction plate combined with autogenous bone graft from iliac crest for this retreatment. The authors show a follow-up of 6 months, with union of the fracture line and no complication postoperatively. © 2013 by Mutaz B. Habal, MD.

The meaning of evidence-based management to brazilian senior nurse leaders

Purpose: The study objective was to understand the meaning of evidence-based management for senior nurse leaders in accredited, public hospitals in the State of Sao Paulo, Brazil. Design and Method: A phenomenological approach was used to analyze interviews conducted with 10 senior nurse leaders between August 2011 and March 2012. The analytic method was developed by the Brazilian phenomenologist, Martins. Findings: Senior nurse leaders described how they critically appraise many sources of evidence when making managerial decisions. They emphasized the importance of working with their teams to locally adapt and evaluate best evidence associated with managerial decision making and organizational innovations. Their statements also demonstrated how they use evidence-based management to support the adoption of evidence-based practices. They did not, however, provide specific strategies for seeking out and obtaining evidence. Notable challenges were traditional cultures and rigid bureaucracies, while major facilitators included accreditation, teamwork, and shared decision making. Conclusions: Evidence-based management necessitates a continuous process of locating, implementing, and evaluating evidence. In this study leaders provided multiple, concrete examples of all these processes except seeking out and locating evidence. They also gave examples of other leadership skills associated with successful adoption of evidence-based practice and management, particularly interdisciplinary teamwork and shared decision making. Clinical Relevance: This study demonstrates senior nurse leaders' awareness and utilization of evidence-based management. The study also suggests what aspects of evidence-based management need further development, such as more active identification of potential, new organizational innovations. © 2013 Sigma Theta Tau International.

Barreiras e motivações à adoção de práticas de Green Supply Chain Management: estudo de casos no setor de baterias automotivas

Pós-graduação em Engenharia de Produção - FEB

Sugarcane trash management assessed by the interaction of yield with soil properties

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)