The implementation of FT-Raman spectroscopy to study solid state moisture induced changes in the crystallographic nature of pharmaceutical excipients - a lesson in humidity

An aqueous solution of sucrose was lyophilised, producing amorphous sucrose. This wasthen stored under different humidity at 25ºC for 1 week, allowing some samples tocrystallise. FT-Raman spectroscopy and PXRD have been successfully shown toqualitatively distinguish between amorphous and crystalline samples of sucrose. The datafrom the two techniques is complementary.

Liquid and solid-state structures of 1,3-dimethylimidazolium salts

Using neutron and single crystal X-ray diffraction the structures of 1,3-dimethylimidazolim chloride and hexafluorophosphate salts have been determined in the liquid and the solid-state. The relative hydrogen bonding characteristics and sizes of the two anions force the ions to pack differently. In each case, a strong correlation between the crystal structure and liquid structure is found.

Solid-state analysis of low-melting 1,3-dialkylimidazolium hexafluorophosphate salts (ionic liquids) by combined x-ray crystallographic and computational analyses

The interactions of ions in the solid state for a series of representative 1,3-dialkylimidazolium hexafluorophosphate salts (either ionic liquids or closely related) have been examined by crystallographic analysis, combined with the theoretical estimation of crystal-packing densities and lattice-interaction energies. Efficient close-packing of the ions in the crystalline states is observed, but there was no compelling evidence for specific directional hydrogen-bonding to the hexafluorophosphate anions or the formation of interstitial voids. The close-packing efficiency is supported by the theoretical calculation of ion volumes, crystal lattice energies, and packing densities, which correlated well with experimental data. The crystal density of the salts can be predicted accurately from the summation of free ion volumes and lattice energies calculated. Of even more importance for future work, on these and related salts, the solid-state density of 1,3-dialkylimidazolium hexafluorophosphate salts can be predicted with reasonable accuracy purely on the basis of on ab initio free ion volumes, and this allows prediction of lattice energies without necessarily requiring the crystal structures.

Organometallic polymers: An infinite organoplatinum chain in the solid state formed by (C CH center dot center dot center dot ClPt)hydrogen bonds

The new platinum complex [PtCl[C6H2(CH(2)NMe(2))(2) -2,6-(C=CH)-4)] exhibits a polymeric linear -C=CH ... ClPt-hydrogen-bonded structure in the solid state.

A search for interstellar gas-phase CO2 gas: Solid state abundance ratios

We present searches for gas-phase CO2 features in the ISO-SWS infrared spectra of four deeply embedded massive young stars, which all show strong solid CO2 absorption. The abundance of gas-phase CO2 is at most 2. 10(-7) with respect to H-2, and is less than 5% of that in the solid phase. This is in strong contrast to CO, which is a factor of 10-100 more abundant in the gas than in solid form in these objects. The gas/solid state ratios of CO2, CO and H2O are discussed in terms of the physical and chemical state of the clouds.

Spray Congealed Lipid Microparticles with High Protein Loading: Preparation and Solid State Characterization

The spray-congealing technique, a solvent-free drug encapsulation process, was successfully employed to obtain lipid-based particulate systems with high (10–20% w/w) protein loading. Bovine serum albumin (BSA) was utilised as model protein and three low melting lipids (glyceryl palmitostearate, trimirystin and tristearin) were employed as carriers. BSA-loaded lipid microparticles were characterised in terms of particle size, morphology and drug loading. The results showed that the microparticles exhibited a spherical shape, mean diameter in the range 150–300 µm and an encapsulation efficiency higher than 90%. Possible changes in the protein structure as a result of the manufacturing process was then investigated for the first time using UV spectrophotometry in fourth derivative mode and FT-Raman spectroscopy. The results suggested that the structural integrity of the protein was maintained within the particles. Thermal analysis indicated that the effect of protein on the thermal properties of the carriers could be detected. Spray-congealing could thus be considered a suitable technique to produce highly BSA-loaded microparticles preserving the structure of the protein.

Solid-state sodium-selective sensors based on screen-printed Ag/AgCl reference electrodes

The potentiometric and AC impedance characteristics of all solid-state sodium-selective electrodes based on planar screen-printed Ag/AgCl electrodes are described. Two solid-state designs have been investigated. The first was based on the deposition of a sodium-selective PVC membrane directly on top of a screen-printed Ag/AgCl electrode, The second design included a NaCl doped hydrogel layer, between the PVC and Ag\AgCl layers. The hydrogel provides a mechanism to relieve any blockage to charge transfer occurring when PVC membranes are used directly on top of Ag/AgCl and also improves adhesion between the two layers. Results suggest the electrodes display Fast ion exchange kinetics, low noise and drift. The performance compares favorably to that of a conventional ion-selective electrode with internal filling solution.

Homologous size-extension of hybrid vanadate capsules – solid state structures, solution stability and surface deposition

The dimensions and cavity sizes of the molecular capsules with the general formula [V₁₀O₁₈L₄]¹⁰⁻ can be controlled modularly through the nature of the bifunctional, rigid organophosphonate ligands L¹ and L² (L¹ = bis(4-phosphonatophenyl)ethyne and L² = bis(4-phosphonatophenyl)butadiyne); the solution stability of the molecular entities as demonstrated by ESI-MS studies permits their assembly on the Au(111) surface on a sub-monolayer scale giving rise to a 2D supramolecular structure that is comparable to the packing arrangements of the capsules in the crystal structures.

Polymorphism in Sulfadimidine/4-Aminosalicylic Acid Cocrystals: Solid-State Characterization and Physicochemical Properties

Polymorphism of crystalline drugs is a common phenomenon. However, the number of reported polymorphic cocrystals is very limited. In this work, the synthesis and solid-state characterization of a polymorphic cocrystal composed of sulfadimidine (SD) and 4-aminosalicylic acid (4-ASA) is reported for the first time. By liquid-assisted milling, the SD:4-ASA 1:1 form I cocrystal, the structure of which has been previously reported, was formed. By spray drying, a new polymorphic form (form II) of the SD:4-ASA 1:1 cocrystal was discovered which could also be obtained by solvent evaporation from ethanol and acetone. Structure determination of the form II cocrystal was calculated using high-resolution X-ray powder diffraction. The solubility of the SD:4-ASA 1:1 cocrystal was dependent on the pH and predicted by a model established for a two amphoteric component cocrystal. The form I cocrystal was found to be thermodynamically more stable in aqueous solution than form II, which showed transformation to form I. Dissolution studies revealed that the dissolution rate of SD from both cocrystals was enhanced when compared with a physical equimolar mixture and pure SD.

Electrochemical promotion of catalysis using solid-state proton-conducting membranes

A solid-state electrochemical reactor with ceramic proton-conducting membrane has been used to study the effect of electrochemically induced hydrogen spillover on the catalytic activity of platinum during ethylene oxidation. Suitable proton-conducting electrolyte membranes (Gd-doped BaPrO ₃ (BPG) and Y-doped BaZrO₃ (BZY)) were fabricated. These materials were chosen because of their protonic conductivity in the operational temperature region of the reaction (400-700 °C). The BZY-based electrochemical cell was used to investigate the open-circuit voltage (OCV) dependence on H₂ partial pressure with comparison being made to the theoretical OCV as predicted by the Nernst equation. Furthermore, the BZY pellets were used to study the effect of proton transfer of the catalytic activity of platinum during ethylene oxidation. The reaction was found to exhibit electrochemical promotion at 400 °C and to be electrophilic in nature, i.e. proton addition to the platinum surface resulted in an increase in reaction rate. At higher temperatures, the rate was not affected, within experimental error, by proton addition or removal. Under similar conditions, AC impedance showed that there was a large overall cell resistance at 400 °C with significantly decreased resistance at higher temperatures. It is possible that there could be a relationship between large cell resistances and the onset of electrochemical promotion in this system but there is, as yet, no conclusive evidence for this. © 2003 Elsevier B.V. All rights reserved.

Matéria húmica de sapal: variações estruturais e complexação com o cobre

No presente trabalho foram estudadas as variações na composição, estrutura e comportamento das substâncias húmicas sedimentares (SHS), promovidas pela presença de duas espécies de plantas da família Chenopodiacea, presentes nos sapais da Ria de Aveiro: a Halimione portulacoides e a Arthrocnemum fruticosum. Para além das variações espaciais horizontais, foram investigadas as variações ao longo de um perfil de profundidades. Desta forma, para além da camada superficial (0-10 cm) de sedimentos com diferentes espécies de plantas e sem plantas, também foram investigadas camadas de sedimentos intermédia (20-25 cm) e profunda (45-50 cm). Para a extracção das SHS recorreu-se a uma pequena modificação do método proposto pela International Humic Substances Society (IHSS) para extracção e purificação de substâncias húmicas de solos. As SH extraídas foram caracterizadas através dos métodos espectroscópicos de absorção no ultravioleta visível, de fluorescência molecular síncrona, de absorção no infravermelho com transformadas de Fourier (FTIR) e de RMN 13C em estado sólido. Estas técnicas de caracterização foram complementadas pela análise elementar e termogravimetria. Em algumas amostras, foram ainda determinados o conteúdo em alguns metais por ICP-AES e o conteúdo funcional ácido por titulações potenciométricas. Após exaustiva caracterização das amostras de AH, procedeu-se ao estudo da sua capacidade de complexação com o cobre, recorrendo a titulações monitorizadas por fluorescência molecular síncrona. Os resultados revelaram que a colonização de sedimentos por plantas vasculares superiores conduz a uma alteração profunda no ambiente sedimentar e que esta é reflectida na diagénese das substâncias húmicas sedimentares, tendo-se observado variações a uma pequena escala espacial. O estudo deste tipo de variações nunca tinha sido efectuado em trabalhos anteriores. Nos ácidos fúlvicos detectaram-se diferenças na composição e estrutura das amostras correspondentes às camadas superiores de sedimentos, reflectindo a presença de diferentes colonizações vegetais. Relativamente aos ácidos húmicos, foi possível classificá-los em dois tipos distintos. Os AH do tipo I correspondem aos sedimentos superficiais e intermédios dos locais com plantas. Neste tipo de AH verificou-se uma incorporação de polissacarídeos e estruturas peptídicas, em estados de humificação pouco desenvolvidos. Os AH do tipo II correspondem aos sedimentos mais profundos de todos os locais e aos intermédios do local sem plantas e caracterizam-se por um maior grau de humificação e polimerização, um maior conteúdo aromático e de estruturas conjugadas e um maior conteúdo de grupos carboxílicos. Essas diferenças estruturais conduzem a diferentes comportamentos ácido/base e de complexação com o cobre. Assim, os AH do tipo I, que apresentam sinais espectroscópicos mais baixos associados a grupos carboxílicos e fenólicos, têm menor conteúdo de grupos funcionais ácidos e menor capacidade de complexação com o cobre quando se consideram ligandos característicos de unidades aromáticas conjugadas. Relativamente aos valores de log K dos complexos de AHS com o cobre, as amostras representativas da camada superficial dos sedimentos com plantas apresentaram valores superiores aos das restantes amostras de AH estudadas, cujos valores de log K são similares entre si. Atendendo aos resultados de análise elementar e espectroscópica, este facto pode estar associado à presença de compostos de azoto não peptídicos. Quanto a outros ligandos para o cobre, nomeadamente os representativos de estruturas peptídicas contendo o aminoácido triptofano e estruturas aromáticas simples, não foi possível obter resultados conclusivos. Dado que os ácidos húmicos do tipo I demonstraram um maior conteúdo peptídico e menor conteúdo aromático, o estudo destes ligandos torna-se importante para compreender melhor o efeito da presença de plantas nos sedimentos de sapal sobre o comportamento dos ácidos húmicos sedimentares como ligandos para o cobre. Refere-se ainda que foram detectadas certas especificidades na variação das características do sedimento e das substâncias húmicas com a profundidade nos diferentes locais estudados que não podem ser explicadas meramente com a presença de material vegetal oriundo de diferentes espécies de plantas, requerendo um conhecimento mais aprofundado das comunidades bentónicas e do ambiente físico-químico do sedimento.

Disposable solid state probe for optical screening of chlorpromazine

We are presenting a simple, low-cost and rapid solid-state optical probe for screening chlorpromazine (CPZ) in aquacultures. The method exploits the colourimetric reaction between CPZ and Fe(III) ion that occurs at a solid/liquid interface, the solid layer consisting of ferric iron entrapped in a layer of plasticized PVC. If solutions containing CPZ are dropped onto such a layer, a colour change occurs from light yellow to dark pink or even light blue, depending on the concentration of CPZ. Visual inspection enables the concentration of CPZ to be estimated. The resulting colouration was also monitored by digital image collection for a more accurate quantification. The three coordinates of the hue, saturation and lightness system were obtained by standard image processing along with mathematical data treatment. The parameters affecting colour were assessed and optimized. Studies were conducted by visible spectrophotometry and digital image acquisition, respectively. The response of the optimized probe towards the concentration of CPZ was tested for several mathematical transformations of the colour coordinates, and a linear relation was found for the sum of hue and luminosity. The limit of detection is 50 μM (corresponding to about 16 μg per mL). The probe enables quick screening for CPZ in real water samples with prior sample treatment.