Optimised microwave-assisted synthesis of methylcarbonate salts: a convenient methodology to prepare intermediates for ionic liquid libraries

The reaction of 1-butylpyrrolidine with dimethyl carbonate to yield the ionic liquid precursor, 1-butyl-1-methylpyrrolidinium methylcarbonate, has been investigated under microwave heating conditions and the reaction parameters optimised to achieve 100% yield of the pyrrolidinium salt with no by-products in under 1 h. The reactions of tributylamine, trioctylphosphine, and 1-butylimidazole with dimethyl carbonate under comparable conditions have also been evaluated, yielding the corresponding methylcarbonate salts which can be used as intermediates for the preparation of halide-free ionic liquids without generating any undesirable salt wastes.

Catalytic Mo2C coatings for the water gas shift reaction: Electrosynthesis in molten salts

Electrosynthesis methods using molten salts are suggested for obtaining a new catalytic system based on the Mo2C/Mo composition for the water gas shift reaction. The coatings obtained by the discharge of the carbonate ion on a molybdenum substrate and by the simultaneous reduction of the electroactive species MoO42 and CO32- are catalytically more active than bulk Mo2C or the commercial catalyst Cu-ZnO-Al2O3 by one and three orders of magnitude, respectively.

Synthesis of protective Mo-Si-B coatings in molten salts and their oxidation behavior in an air-water mixture

The formation of various phases during boronizing of silicided molybdenum substrates (MoSi2/Mo) was investigated. Boronizing treatments were conducted in molten salts under an inert gas atmosphere in the 700-1000 degrees C temperature range for 3-7 h. Depending on the process type (non-current or electrochemical) and molten salt temperature, the formation of different boride phases (MoB, Mo2B5, MoB2, MoB4) was observed. At the same time, substantial oxidation of the bulk molybdenum disilicide phase (MoSi2) to the Mo5Si3 phase was observed in non-current boronizing. The oxidation resistance of the coatings was investigated by the weight change in an air-water (2.3 vol.%) mixture at a temperature of 500 degrees C for a period up to 700 h. Results indicated that a two-phase microstructure consisting of the MoSi2, matrix phase with 12-15 wt.% of the MoB4 phase greatly improved the oxidation resistance of the molybdenum substrates. The weight gain rate observed was 6.5 center dot 10(-4) mg/cm(2) h. (c) 2006 Elsevier B.V. All rights reserved.

Synthesis of molybdenum borides and molybdenum silicides in molten salts and their oxidation behavior in an air-water mixture

The formation of various coatings in molybdenum-boron and molybdenum-silicon systems was investigated. Boronizing and siliciding treatments were conducted in molten salts under inert gas atmosphere in the 850-1050 degrees C temperature range for 7 h. The presence of boride (e.g. Mo2B, MoB, Mo2B5) and silicide (MoSi2, Mo5Si3) phases, formed on the surface of Mo plates, was confirmed by X-ray diffraction analysis. The distribution of elements was determined by means of wavelength dispersive spectroscopy (WDS) spectra of the surface and line-scan analyses from surface to interior. Depending on the process type (diffusional or electrochemical) and temperature, the thickness of the protective layers formed on the substrate ranged from 6 to 40 gm. The oxidation resistance of obtained phases was investigated in an air-water mixture in the temperature range of 500-700 degrees C for a period up to 400 h. An improved oxidation behavior of coated plates in comparison with that of pure molybdenum was observed. (c) 2004 Elsevier B.V. All rights reserved.

Vapour layer formation by electrical discharges through electrically conducting liquids-modelling and experiment

Experimental and finite element modelling methods are used to study the formation of vapour layers in electrical discharges through saline solutions. The experiments utilize shadowgraphic and photometric methods to observe the time dependence of thin vapour layers and plasma formation around electrodes driven by moderate voltage (<500 V) pulses, applied to an electrode immersed in a conducting saline solution. Finite element multiphysics software, coupling thermal and electrical effects, is employed to model the vapour layer formation. All relevant electrical and thermal properties of the saline are incorporated into the model, but hydrodynamic and surface tension effects are ignored. Experimental shadowgraph and modelling images are compared, as are current histories, and the agreement is very good. The comparison of experiment and modelling gives insight into both vapour layer production and subsequent plasma production. We show that, for example, superheating of the saline above its normal vaporization temperature may be playing a significant role in vapour formation. We also show that electric fields of approaching 10(7) V m(-1) can be achieved in the vapour layer.

Effectiveness of using clinical guidelines for conducting palliative care family meetings in Japan

PURPOSE: The purpose of this study is to pilot test the effectiveness of using recently developed clinical guidelines from Australia for conducting palliative care family meetings in Japan. METHODS: Palliative care family meetings were conducted using clinical guidelines with 15 primary family carers of cancer patients who were admitted to an acute care hospital in Japan. Using the pre-family meeting questionnaire, the primary carers were asked to write key concerns to discuss during the family meetings and rate their concerns via a numerical rating scale: how upset/worried they were about the problem, frequency in which problem occurs, life interference with the problem, and the confidence to deal with the problem. Within 3 days after the meeting, the primary carers were asked to complete the post-meeting questionnaire to evaluate the effectiveness of the family meeting. RESULTS: There was a significant improvement in family carers' psychological well-being in the post-meeting questionnaires compared to the pre-meeting questionnaires as follows: how upset/worried they were about the problem, t(14)?=?3.1071, p?

It's all about relationships:A qualitative study of health researchers' perspectives of conducting interdisciplinary health research

Background. Interdisciplinary research has been promoted as an optimal research paradigm in the health sciences, yet little is known about how researchers experience interdisciplinarity in practice. This study sought to determine how interdisciplinary research was conceptualized and operationalized from the researcher's perspective and to better understand how best to facilitate interdisciplinary research success. Methods. Key informant interviews were conducted with health researchers with expertise or experience in conducting interdisciplinary research. Interviews were completed either in person or over the telephone using a semi-structured interview guide. Data collection occurred simultaneously with data analysis so that emerging themes could be explored in subsequent interviews. A content analysis approach was used. Results. Nineteen researchers took part in this study. Interdisciplinary research was conceptualized disparately between participants, and there was modest attention towards operationalization of interdisciplinary research. There was one overriding theme, "It's all about relationships", that emerged from the data. Within this theme, there were four related subthemes: 1) Involvement in interdisciplinary research; 2) Why do I do interdisciplinary research?; 3) Managing and fostering interdisciplinary relationships; and 4) The prickly side to interdisciplinary research. Together, these themes suggest that the choice to conduct interdisciplinary research, though often driven by the research question, is highly influenced by interpersonal and relationship-related factors. In addition, researchers preferred to engage in interdisciplinary research with those that they had already established relationships and where their role in the research process was clearly articulated. A focus on relationship building was seen as a strong facilitator of interdisciplinary success. Conclusion. Many health researchers experienced mixed reactions towards their involvement in interdisciplinary research. A well thought-out rationale for interdisciplinary research, and strategies to utilize the contribution of each researcher involved were seen as facilitators towards maximizing the benefits that could be derived from interdisciplinary research. © 2008 Nair et al; licensee BioMed Central Ltd.

Chiral thiouronium salts: synthesis, characterisation and application in NMR enantio-discrimination of chiral oxoanions

Chiral thioureas and functionalised chiral thiouronium salts were synthesised starting from the relatively cheap and easily available chiral amines: (S)-methylbenzylamine and rosin-derived (+)-dehydroabietylamine. The introduction of a delocalised positive charge to the thiourea functionality, by an alkylation reaction at the sulfur atom, enables dynamic rotameric processes: hindered rotations about the delocalised CN and CS bonds. Hence, four different rotamers/isomers may be recognised: syn-syn, syn-anti, anti-syn and anti-anti. Extensive H-1 and C-13 NMR studies have shown that in hydrogen-bond acceptor solvents, such as perdeuteriated dimethyl sulfoxide, the syn-syn conformation is preferable. On the other hand, when using non-polar solvents, such as CDCl3, the mixture of syn-syn and syn-anti isomers is detectable, with an excess of the latter. Apart from this, in the case of S-butyl-N,N'-bis(dehydroabietyl)thiouronium ethanoate in CDCl3, the H-1 NMR spectrum revealed that strong bifurcated hydrogen bonding between the anion and the cation causes global rigidity without signs of hindered rotamerism observable on the NMR time scale. This suggested that these new salts might be used as NMR discriminating agents for chiral oxoanions, and are indeed more effective than their archetypal guanidinium analogues or the neutral thioureas. The best results in recognition of a model substrate, mandelate, were obtained with S-butyl-N,N'-bis(dehydroabietyl) thiouronium bistriflamide. It was confirmed that the chiral recognition occurred not only for carboxylates but also for sulfonates and phosphonates. Further H-1 NMR studies confirmed a 1 : 1 recognition mode between the chiral agent (host) and the substrate (guest); binding constants were determined by H-1 NMR titrations in solutions of DMSO-d(6) in CDCl3. It was also found that the anion of the thiouronium salt had a significant influence on the recognition process: anions with poor hydrogen-bond acceptor abilities led to the best discrimination. The presence of host-guest hydrogen bonding was confirmed in the X-ray crystal structure of S-butyl-N,N'-bis(dehydroabietyl)thiouronium bromide and by computational studies (density functional theory).

Ethical dilemmas for clinical psychologists in conducting qualitative research

Clinical psychologists often use qualitative methods to explore sensitive topics with vulnerable individuals, yet there has been little discussion of the specific ethical issues involved. For clinicians conducting qualitative research, there are likely to be ethical dilemmas associated with being both a researcher and a practitioner. We argue that this overarching issue frames all other ethical issues raised. This article provides an overview of the range of ethical issues that have been discussed in general in relation to qualitative research and considers the specific nature of these in relation to the discipline of clinical psychology. Such issues will be exemplified by reference to some of our own research and practice and the extant literature. We conclude with some suggestions for good practice, although our aim is to trigger debate rather than to establish prescriptive guidelines.

Guidelines and considerations for conducting experiments using tissue microarrays

Tissue microarrays (TMAs) represent a powerful method for undertaking large-scale tissue-based biomarker studies. While TMAs offer several advantages, there are a number of issues specific to their use which need to be considered when employing this method. Given the investment in TMA-based research, guidance on design and execution of experiments will be of benefit and should help researchers new to TMA-based studies to avoid known pitfalls. Furthermore, a consensus on quality standards for TMA-based experiments should improve the robustness and reproducibility of studies, thereby increasing the likelihood of identifying clinically useful biomarkers. In order to address these issues, the National Cancer Research Institute Biomarker and Imaging Clinical Studies Group organized a 1-day TMA workshop held in Nottingham in May 2012. The document herein summarizes the conclusions from the workshop. It includes guidance and considerations on all aspects of TMA-based research, including the pre-analytical stages of experimental design, the analytical stages of data acquisition, and the postanalytical stages of data analysis. A checklist is presented which can be used both for planning a TMA experiment and interpreting the results of such an experiment. For studies of cancer biomarkers, this checklist could be used as a supplement to the REMARK guidelines.