Barium in sediments and pore waters of several ODP Leg 170 and Leg 205 sites

Barium concentrations were measured on 17 pore fluid and 13 sediment samples from Sites 1253 and 1254 drilled offshore Costa Rica during Ocean Drilling Program (ODP) Leg 205. An additional 83 pore fluid and 29 sediment samples were analyzed for Ba concentrations from Sites 1039 and 1040 drilled during ODP Leg 170 offshore Costa Rica. Sites 1039/1253 and 1040/1254 are part of a transect across the Middle America Trench offshore Nicoya Peninsula. The entire incoming sediment section is being underthrust beneath the margin, providing an ideal setting to examine Ba cycling in the shallow levels of the subduction zone. Results from these analyses indicate that a significant amount of Ba is liberated from the mineral barite (BaSO4) in the uppermost hemipelagic sediments arcward of the trench. The shallow distillation of Ba may impact the amount of sedimentary Ba reaching the deeper subduction zone.

Consolidation properties and permeability values of sediments from three ODP Leg 205 sites

Vertical permeability and sediment consolidation measurements were taken on seven whole-round drill cores from Sites 1253 (three samples), 1254 (one sample), and 1255 (three samples) drilled during Ocean Drilling Program Leg 205 in the Middle America Trench off of Costa Rica's Pacific Coast. Consolidation behavior including slopes of elastic rebound and virgin compression curves (Cc) was measured by constant rate of strain tests. Permeabilities were determined from flow-through experiments during stepped-load tests and by using coefficient of consolidation (Cv) values continuously while loading. Consolidation curves and the Casagrande method were used to determine maximum preconsolidation stress. Elastic slopes of consolidation curves ranged from 0.097 to 0.158 in pelagic sediments and 0.0075 to 0.018 in hemipelagic sediments. Cc values ranged from 1.225 to 1.427 for pelagic carbonates and 0.504 to 0.826 for hemipelagic clay-rich sediments. In samples consolidated to an axial stress of ~20 MPa, permeabilities determined by flow-through experiments ranged from a low value of 7.66 x 10**-20 m**2 in hemipelagic sediments to a maximum value of 1.03 x 10**-16 m**2 in pelagic sediments. Permeabilities calculated from Cv values in the hemipelagic sediments ranged from 4.81 x 10**-16 to 7.66 x 10**-20 m**2 for porosities 49.9%-26.1%.

Sedimentary data from the Semlac loess-paleosol sequence

The volumetric magnetic susceptibility was measured at frequencies of 300 and 3000 Hz in a static field of 300 mA/m using a Magnon International VSFM in the Laboratory for Environmental- and Palaeomagnetism at the University of Bayreuth. The magnetic susceptibility was mass-normalised. The frequency dependence was calculated as MSfd = (MSlf - MShf) / MSlf *100 [%]. A spectrophotometer (Konica Minolta CM-5) was used to determine the colour of dried and homogenised sediment samples by detecting the diffused reflected light under standardised observation conditions (2° Standard Observer, Illuminant C). Colour spectra were obtained in the visible range (360 to 740 nm), in 10 nm increments, and the spectral data was converted into the Munsell colour system and the CIELAB Colour Space (L*a*b*, CIE 1976) using the Software SpectraMagic NX (Konica Minolta). The measurement of the particle size was conducted by using a Laser Diffraction Particle Size Analyzer (Beckman Coulter LS 13 320 PIDS) and by calculating the mean diameters of the particles within a size range of 0.04 - 2000 µm. Each sample was measured two times in two different concentrations to increase accuracy. Finally all measurements with reliable obscuration (8 - 12 %) were averaged.