Feeding high-moisture corn grain silage to broilers fed alternative diets and maintained at different environmental temperatures

The effects of the dietary substitution of dry corn by high-moisture corn grain silage (HMCGS) were evaluated on the performance, nutrient digestibility and serum biochemical parameters of broilers reared in an alternative production system and submitted to different environmental temperatures. A total of 288 one-day-old male Cobb chicks were distributed according to a randomized block design in a 3x4 factorial arrangement: three environmental temperatures (hot, thermoneutral or cold) and four levels of HMCGS in substitution of dry corn (0%, 20%, 40% or 60%). The acid analysis showed that the evaluated HMCGS contained average percentage values of ethanol, lactic acid, and acetic acid (expressed in 100% of dry matter) of 0.7690, 2.7320 and 0.0249%, respectively. Propionic and butyric acids were not detected. Dry corn and HMCGS presented pH values of 5.8 and 3.3, respectively. The inclusion of HMCGS reduced dietary pH, as shown by the values of 5.7, 5.4, 5.1 and 4.8 recorded for the diets containing 0%, 20%, 40% and 60% of HMCGS, respectively. There was no significant interaction between diets and environmental temperature. HMCGS may replace up to 40% dry corn in broiler diets when performance, triglyceride levels, and HDL-cholesterol ratio is considered, and up to 60% when nutrient digestibility is evaluated. High environmental temperature impairs broiler performance, nutrient digestibility, and serum biochemistry, demonstrating the influence of environmental temperature on broiler metabolism and performance.

Andropogon grass consortium with stylo in two times: the forage response and sources of phosphorus rates

The use of legumes intercropped with forage in the Brazilian savannah (Cerrado) region is an alternative to reverse the process of pasture degradation. The natural phosphorus deficiency in this region and the high retention capacity of this nutrient in the soil are factors that directly affect the sustainability of the production system. The objective of this study was to evaluate the effect of a phosphate with medium solubility (Arad) compared to more soluble sources such as triple superphosphate and mono-ammonium phosphate, on the formation and maintenance of pastures of Andropogon gayanus with or without the introduction of Stylosantes guianensis in pasture already established in the Brazilian savannah. Two experiments were carried out under field conditions in an Oxisol using a randomized block design with split plots, plots with two sources of phosphorus (Arad and super-triple or MAP) and subplots with different levels of phosphorus. The study showed that andropogon grass, even though characterised as forage requiring low fertilization, responded to increased fertilization, especially with the use of more soluble sources of P at planting. From the second year on, with the introduction of Stylosantes guianensis, verified effects were seen on legumes in their efficiency of utilization of residual fertilization from the first year; however, this didn't affect legume dry matter production resulting from the P sources used for the andropogon grass. The mixed stands of andropogon grass and Stylosantes guianensis made it more advantageous to increase the P sources using phosphate fertilizer with lower solubility (Arad), when compared to MAP.

Viabilidade agroeconômica do consórcio de couve com espinafre 'Nova Zelândia'

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Comportamento ingestivo, desempenho e características de carcaça de cordeiros semi-confinados em sistema integrado de produção

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

A sewage sludge co-composting process using respirometric monitoring method in hermetic rotary reactor

This paper has the objective of monitoring the biological activity of composting process of sewage sludge, sugarcane bagasse and ground coffee in a hermetic rotary reactor using the respirometric method in laboratory scale, in order to obtain parameters and system design for large scale projects. Another particularity of this study is the use of a hermetic reactor with gas purging cycles. Purging was performed when the percentage of oxygen reached less than 5%, thus eliminating the gaseous mixture (with elevated CO2 ratio) and the introduction of environmental air with around 21% of O2, successively until the compost was stabilized. The average purge intervals obtained were 29 h and 2 min with reactor rotation frequency of 15 min. The time of the compost stabilization was optimized in 60% if compared to the 90 days in the traditional method. The results obtained can be used to design the process in industrial scale using a simple O2 gas analyzer.

Impactos do manejo de um sistema plantio direto no crescimento e produtividade do arroz de terras altas e feijão de inverno em sucessão e nos atributos do solo

Pós-graduação em Agronomia - FEIS

Análise energética e ambiência de modelos arquitetônicos propostos pelo programa nacional de habitação rural

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Seletividade dos herbicidas Bentazon e Nicosulfuron para Crotalaria juncea e Crotalaria spectabilis em consórcio com a cultura do milho

Pós-graduação em Agronomia (Produção Vegetal) - FCAV

Drivers of change in animal protein production systems: changes from 'traditional' to 'modern' beef cattle production systems in Brazil

Until 1990, beef cattle production in Brazil was recognized as an enterprise of low investment, low cost of production, as well as an extensive production system that used large land areas to be economically feasible. The situation changed for the Brazilian beef market when the economy stabilized in 1994 and all sectors involved in the beef supply chain were able to predict their associated costs and profits. During the same period, purchasing power of the Brazilian population grew, and as a consequence, consumers began to demand higher quality beef products. This new scenario in the late 1990s and early 2000s has led to more intensive beef production systems in Brazil as well as the need for a greater understanding of how technologies might be applied. As consequence of this evolution, in the last five years, a necessity to increase beef production has occurred. The quality of Brazilian beef has improved compared with beef produced 15 years ago, but continued improvements are needed to achieve excellence in terms of large-scale production of high quality beef, be sustainable over a long period of time, and increase our contribution to global food security.

Atributos do solo e modalidade de semeadura na consorciação de milho com forrageiras e desempenho agronômico do feijoeiro em sucessão

Pós-graduação em Agronomia - FEIS

Two extensions for the ALWABP: Parallel stations and collaborative approach

In this article, we introduce two new variants of the Assembly Line Worker Assignment and Balancing Problem (ALWABP) that allow parallelization of and collaboration between heterogeneous workers. These new approaches suppose an additional level of complexity in the Line Design and Assignment process, but also higher flexibility; which may be particularly useful in practical situations where the aim is to progressively integrate slow or limited workers in conventional assembly lines. We present linear models and heuristic procedures for these two new problems. Computational results show the efficiency of the proposed approaches and the efficacy of the studied layouts in different situations. (C) 2012 Elsevier B.V. All rights reserved.

Tillering dynamics in pastures of guinea grass subjected to grazing severities under intermittent stocking

This experiment was carried out to analyze the tillering dynamics of the species Panicum maximum cv. Mombaca subjected to three post-grazing heights: residue of 30 cm (30); residue of 50 cm (50); and residue of 50 cm during spring and summer, lowered to 40 cm in the first fall season grazing and to 30 cm in the following grazing cycle, resuming to 50 cm after the first grazing of the following spring season (50-30). Grazings were initiated whenever the swards intercepted 95% of the incident light. The post-grazing heights were allocated in the experimental units in a completely randomized block design with three replications. The density of basal tillers did not vary between the residual heights evaluated. Swards managed with variable residual height (50-30) presented higher rates of appearance and mortality of basal tillers during the summer of 2007, indicating high tiller renovation. Regardless of the post-grazing height evaluated, lower rates of appearance of basal tillers were found in the spring of 2006. The stability index of guinea grass cv. Mombaca was close to 1.0 throughout the experimental period. Swards managed with variable post-grazing present structural changes able to improve the regrowth vigor, which may be important to maximize the use of the forage species in the production system.

Life cycle assessment of sugarcane ethanol and palm oil biodiesel joint production

Sugarcane (Saccharum spp.) and palm tree (Elaeis guianeensis) are crops with high biofuel yields, 7.6 m(3) ha (1) y(-)1 of ethanol and 4 Mg ha(-1) y(-1) of oil, respectively. The joint production of these crops enhances the sustainability of ethanol. The objective of this work was comparing a traditional sugarcane ethanol production system (TSES) with a joint production system (JSEB), in which ethanol and biodiesel are produced at the same biorefinery but only ethanol is traded. The comparison is based on ISO 14.040:2006 and ISO 14044:2006, and appropriate indicators. Production systems in Cerrado (typical savannah), Cerradao (woody savannah) and pastureland ecosystems were considered. Energy and carbon balances, and land use change impacts were evaluated. The joint system includes 100% substitution of biodiesel for diesel, which is all consumed in different cropping stages. Data were collected by direct field observation methods, and questionnaires applied to Brazilian facilities. Three sugarcane mills situated in Sao Paulo State and one palm oil refinery located in Para State were surveyed. The information was supplemented by secondary sources. Results demonstrated that fossil fuel use and greenhouse gas emissions decreased, whereas energy efficiency increased when JSEB was compared to TSES. In comparison with TSES, the energy balance of JSEB was 1.7 greater. In addition, JSEB released 23% fewer GHG emissions than TSES. The ecosystem carbon payback time for Cerrado, Cerradao, and Degraded Grassland of JSEB was respectively 4, 7.7 and -7.6 years. These are typical land use types of the Brazilian Cerrado region for which JSEB was conceived. (C) 2012 Elsevier Ltd. All rights reserved.

Qualifying instrument for evaluation of food and nutritional care in hospital

Establishing criteria for hospital nutrition care ensures that quality care is delivered to patients. The responsibility of the Hospital Food and Nutrition Service (HFNS) is not always well defined, despite efforts to establish guidelines for patient clinical nutrition practice. This study describes the elaboration of an Instrument for Evaluation of Food and Nutritional Care (IEFNC) aimed at directing the actions of the Hospital Food and Nutrition Service. This instrument was qualified by means of a comparative analysis of the categories related to hospital food and nutritional care, published in the literature. Elaboration of the IEFNC comprised the following stages: (a) a survey of databases and documents for selection of the categories to be used in nutrition care evaluation, (b) a study of the institutional procedures for nutrition practice at two Brazilian hospitals, in order to provide a description of the sequence of actions that should be taken by the HFNS as well as other services participating in nutrition care, (c) design of the IEFNC based on the categories published in the literature, adapted to the sequence of actions observed in the routines of the hospitals under study, (d) application of the questionnaire at two different hospitals that was mentioned in the item (b), in order to assess the time spent on its application, the difficulties in phrasing the questions, and the coverage of the instrument, and (e) finalization of the instrument. The IEFNC consists of 50 open and closed questions on two areas of food and nutritional care in hospital: inpatient nutritional care and food service quality. It deals with the characterization and structure of hospitals and their HFNS, the actions concerning the patients' nutritional evaluation and monitoring, the meal production system, and the hospital diets. "This questionnaire is a tool that can be seen as a portrait of the structure and characteristics of the HFNS and its performance in clinical and meal management dietitian activities." (Nutr Hosp. 2012;27:1170-1177) DOI:10.3305/nh.2012.27.4.5868

A Unified Framework for e-Commerce Systems Development : Business Process Pattern Perspective

In electronic commerce, systems development is based on two fundamental types of models, business models and process models. A business model is concerned with value exchanges among business partners, while a process model focuses on operational and procedural aspects of business communication. Thus, a business model defines the what in an e-commerce system, while a process model defines the how. Business process design can be facilitated and improved by a method for systematically moving from a business model to a process model. Such a method would provide support for traceability, evaluation of design alternatives, and seamless transition from analysis to realization. This work proposes a unified framework that can be used as a basis to analyze, to interpret and to understand different concepts associated at different stages in e-Commerce system development. In this thesis, we illustrate how UN/CEFACT’s recommended metamodels for business and process design can be analyzed, extended and then integrated for the final solutions based on the proposed unified framework. Also, as an application of the framework, we demonstrate how process-modeling tasks can be facilitated in e-Commerce system design. The proposed methodology, called BP3 stands for Business Process Patterns Perspective. The BP3 methodology uses a question-answer interface to capture different business requirements from the designers. It is based on pre-defined process patterns, and the final solution is generated by applying the captured business requirements by means of a set of production rules to complete the inter-process communication among these patterns.