Investigation of flat spectrum radio sources by the interplanetary scintillation method at 111 MHz

Abstract. Interplanetary scintillation observations of 48 of the 55 Augusto et al. (1998) flat spectrum radio sources were carried out at 111 MHz using the interplanetary scintillation method on the Large Phased Array (LPA) in Russia. Due to the large size of the LPA beam (1◦ × 0.5◦) a careful inspection of all possible confusion sources was made using extant large radio surveys: 37 of the 48 sources are not confused. We were able to estimate the scintillating flux densities of 13 sources, getting upper limits for the remaining 35. Gathering more or improving extant VLBI data on these sources might significantly improve our results. This proof-of-concept project tells us that compact (<1 ) flat spectrum radio sources show strong enough scintillations at 111 MHz to establish/constrain their spectra (low-frequency end). Key words. galaxies: general – galaxies: active – galaxies: quasars: general

Synthesis of slightly < 111 >-oriented 0.65Pb(Mg1/3Nb2/3)O-3-0.35PbTiO(3) ceramic prepared from fine powders

Slightly < 111 >-oriented 0.65Pb(Mg1/3Nb2/3)03-0.35PbTiO(3) ceramic was prepared using fine powders obtained by means of an alternative and promising chemical oxide precursor method. High quality samples with improved structural, microstructural, dielectric and ferroelectric properties were obtained. The dielectric constant value (epsilon similar to 2577) measured at 1 kHz is compared to unpoled < 112 > grain-oriented ceramics while the remanent polarization (P-r similar to 19-1 mu cm(-2)) is compared with random grain-oriented ceramics. These results point out the viability to produce ferroelectric PMN-PT ceramics of very good quality using powder precursors prepared from this chemical method. (c) 2007 Elsevier B.V. All rights reserved.

The interaction between atoms of Au and Cu with clean Si(111) surface: A study combining synchrotron radiation grazing incidence X-ray fluorescence analysis and theoretical calculations

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Microstructural and transport properties of LaNiO3-delta films grown on Si(111) by chemical solution deposition

Electrically conductive LaNiO3-delta (LNO) thin films with typical thickness of 200 nm were deposited on Si (111) substrates by a chemical solution deposition method and heat-treated in air at 700 degreesC. Structural, morphological, and electrical properties of the LNO thin films were characterized by X-ray diffraction (XRD), atomic force microscopy (AFM), field-emission scanning electron microscopy (FEG-SEM), and electrical resistivity rho(T). The thin films have a very flat surface and no droplet was found on their surfaces. The average grain size observed by AFM and FEG-SEM was approximately 100 nm in excellent agreement with XRD data. The rho(T) data showed that these thin films display a good metallic character in a large range of temperature. These results suggest the use of this conductive layer as electrode in the integration of microelectronic devices. (C) 2003 Elsevier B.V. All rights reserved.

Influence of heat treatment on LiNbO3 thin films prepared on Si(111) by the polymeric precursor method

The effects of heat-treatment temperature on LiNbO3 thin films prepared by the polymeric precursor method were investigated. The precursor solution was deposited on Si(111) substrates by dip coating. X-ray diffraction and thermal analyses revealed that the crystallization process occurred at a low temperature (420 °C) and led to films with no preferential orientation. High-temperature treatments promoted formation of the LiNb3O8 phase. Scanning electron microscopy, coupled with energy dispersive spectroscopy analyses, showed that the treatment temperature also affected the film microstructure. The surface texture - homogeneous, smooth, and pore-free at low temperature - turned into an `islandlike' microstructure for high-temperature treatments.

PLANINDEX: 111-001

Contiene resúmenes bibliográficos de documentos sobre planificación y desarrollo en América Latina, recogidos y procesados en el marco del Sistema de Información para la Planificación en América Latina y el Caribe (INFOPLAN).

DOCPAL resúmenes sobre población en América Latina: 111-001

Contiene resúmenes bibliográficos de documentos sobre población y temas relacionados que se producen en América Latina y el Caribe, publicados entre 1984-1986.

Configurações magnéticas colineares e não-colineares em currais de Fe, Cr e Mn sobre a Pt (111)

Neste trabalho investigamos as propriedades magnéticas de currais de Fe, Cr e Mn adsorvidos sobre a superfície de Pt(111) utilizando o método RS-LMTO-ASA (Real Space Linear Muffin Tin Orbital - Atomic Sphere Approximation), o qual é um método de primeiros princípios baseado na Teoria do Funcional da Densidade (DFT-Density Functional Theory), que permite o cálculo de estruturas magnéticas não-colineares. Obtivemos que os átomos de Fe apresentam momentos magnéticos elevados, da ordem de 3.5µB /átomo, e têm uma interação de troca entre primeiros vizinhos forte e ferro-magnética. Isto leva a um arranjo magnético colinear no curral. Para os currais de Mn e Cr encontramos que estes possuem elevado momento magnético, da ordem de 4.51µB /átomo e 4.15µB /átomo, respectivamente, e interações de troca entre primeiros vizinhos antiferro-magnéticas. Isto conduz a arranjos magnéticos colineares em currais simples, assim como interessantes ordenamentos não-colineares, tais como estruturas tipo vértice (skyrmions), para os currais com uma geometria particular onde o antiferromagnetismo se apresenta frustado.

Propriedades magnéticas de nanoestruturas de metais de transição 3d adsorvidas na superfície de Pt(111)

Neste trabalho, utilizamos o método de primeiros princípios, RS-LMTO-ASA (“Real Space - Linear Muffin-Tin Orbital - Atomic Sphere Approximation”), baseado na Teoria do Funcional da Densidade (DFT) e implementado para o cálculo de estruturas magnéticas não-colineares, para investigar as propriedades magnéticas de nanoestruturas de metais de transição 3d (Cr, Mn, Fe, Co e Ni) adsorvidas na superfície de Pt(111). Diferentes geometrias como adátomos, dímeros, trímeros, fios lineares e zig-zag foram consideradas e, o tamanho dos aglomerados foi variado de 2 a 7 átomos. Mostramos que os aglomerados de Fe, Co e Ni sobre a superfície de Pt(111), para todas as geometrias simuladas, apresentam um ordenamento ferromagnético. Devido à redução do número de coordenação presente na superfície, os momentos de spin e orbital nos sítios de Fe, Co e Ni, para as diferentes geometrias, mostram-se elevados comparados com os respectivos valores dos momentos destes metais como bulk. Para os glomerados de Cr e Mn mostramos que a interação de troca antiferromagnética entre primeiros vizinhos leva a um ordenamento antiferromagnético colinear no caso de geometrias lineares. No entanto, se o antiferromagnetismo é frustrado por restrição geométrica imposta aos aglomerados pela superfície triangular do substrato, obtém-se um comportamento magnético não-colinear para aglomerados de Cr e Mn sobre a Pt(111). Nossos resultados estão em boa concordância com os resultados experimentais da literatura e com os resultados teóricos obtidos por outros métodos, quando existentes.

Oxidation of ethanol and its derivatives on well defined pt single crystal electrodes vicinal to pt(111): a comparative study

The oxidation of ethanol (EtOH) at Pt(111) electrodes is dominated by the 4e path leading to acetic acid. The inclusion of surface defects such as those present on stepped surfaces leads to an increase of the reactivity towards the most desirable 12e path leading to CO2 as final product. This path is also favored when the methyl group is more oxidized, as in the case of ethylene glycol (EG) that spontaneously decomposes to CO on Pt(111) electrodes, thus showing a more effective breaking of the C-C bond. Some trends in reactivity can be envisaged when other derivative molecules are compared at well-ordered electrodes. This strategy was used in the past, but the improvement in the electrode pretreatment and the overall information available on the subject suggest that relevant information is still missing.

Banks Presbyterian Church History - Accession 195 - M87 (111)

The Banks Presbyterian Church History is a history written by Mrs. Lena P. Kell entitled “The Early History of Banks Presbyterian Church” describing the history of the church from 1870s to 1947. The church is located in Waxhaw, North Carolina near Fort Mill. (Photocopies)