Análise numérica de freqüência natural de materiais compósitos híbridos com memória de forma

Dissertação (mestrado)—Universidade de Brasília, Faculdade de Tecnologia, Departamento de Engenharia Mecânica, 2007.

The influence of matrix mediated hopping conductivity, filler concentration, aspect ratio and orientation on the electrical response of carbon nanotube/polymer nanocomposites

A model to simulate the conductivity of carbon nanotube/polymer nanocomposites is presented. The proposed model is based on hopping between the fillers. A parameter related to the influence of the matrix in the overall composite conductivity is defined. It is demonstrated that increasing the aspect ratio of the fillers will increase the conductivity. Finally, it is demonstrated that the alignment of the filler rods parallel to the measurement direction results in higher conductivity values, in agreement with results from recent experimental work.

Cyclic deformation of bidisperse two-dimensional foams

In-plane deformation of foams was studied experimentally by subjecting bidisperse foams to cycles of traction and compression at a prescribed rate. Each foam contained bubbles of two sizes with given area ratio and one of three initial arrangements: sorted perpendicular to the axis of deformation (iso-strain), sorted parallel to the axis of deformation (iso-stress), or randomly mixed. Image analysis was used to measure the characteristics of the foams, including the number of edges separating small from large bubbles N-sl, the perimeter (surface energy), the distribution of the number of sides of the bubbles, and the topological disorder mu(2)(N). Foams that were initially mixed were found to remain mixed after the deformation. The response of sorted foams, however, depended on the initial geometry, including the area fraction of small bubbles and the total number of bubbles. For a given experiment we found that (i) the perimeter of a sorted foam varied little; (ii) each foam tended towards a mixed state, measured through the saturation of N-sl; and (iii) the topological disorder mu(2)(N) increased up to an "equilibrium" value. The results of different experiments showed that (i) the change in disorder, Delta mu(2)(N), decreased with the area fraction of small bubbles under iso-strain, but was independent of it under iso-stress; and (ii) Delta mu(2)(N) increased with Delta N-sl under iso-strain, but was again independent of it under iso-stress. We offer explanations for these effects in terms of elementary topological processes induced by the deformations that occur at the bubble scale.

Participação ocupacional do idoso com deficiência visual: sua percepção

O estudo apresentado visava responder às necessidades emergentes de justificação da intervenção da Terapia Ocupacional na população idosa com deficiência visual. Teve como objectivo explorar as perspectivas dos idosos com deficiência visual na experiência que têm da sua participação ocupacional. Paralelamente a este objectivo procurou-se, também, conhecer as atitudes e comportamentos em relação ao apoio da Terapia Ocupacional. Para estudar estas questões utilizou-se uma metodologia qualitativa, a fenomenologia, que permitiu descrever fielmente a experiência que se pretendia conhecer. A recolha de dados foi feita através de duas sessões de focus groups distintas, onde num dos grupos participaram idosos com deficiência visual que tiveram apoio de Terapia Ocupacional e no outro idosos com deficiência visual que não usufruíram deste apoio. Após a análise do conteúdo resultante dos focus groups emergiram os seguintes temas: impacto da deficiência visual, onde foram englobadas as categorias de implicações psicossociais da deficiência visual e restrições nas actividades e ocupações do idoso com deficiência visual; o segundo tema onde se incluíram as categorias de apoio e atitudes sociais, instituições e recursos acessíveis e estratégias utilizadas; por fim o tema dos benefícios percebidos, do qual fazem parte as categorias, benefícios psicológicos e participação. Estes temas permitiram perceber as perspectivas de participação ocupacional do idoso, após o aparecimento da deficiência visual, bem como conhecer as melhorias ao nível dessa participação após intervenção especializada, destacando-se a relevância da intervenção do terapeuta ocupacional na população idosa com deficiência visual.

European information users: topics from a comparative analysis within the European Union

Purpose – The aim of this article is to present some results from research undertaken into the information behaviour of European Documentation Centre (EDC) users. It will reflect on the practices of a group of 234 users of 55 EDCs covering 21 Member States of the European Union (EU), used to access European information. Design/methodology/approach – In order to collect the data presented here, five questionnaires were sent to users in all the EDCs in Finland, Ireland, Hungary and Portugal. In the remaining EU countries, five questionnaires were sent to two EDCs chosen at random. The questionnaires were sent by post, following telephone contact with the EDC managers. Findings – Factors determining access to information on the European Union and the frequency of this access are identified. The information providers most commonly used to access European information and the information sources considered the most reliable by respondents will also be analysed. Another area of analysis concerns the factors cited by respondents as facilitating access to information on Europe or, conversely, making it more difficult to access. Parallel to this, the aspects of accessing information on EU that are valued most by users will also be assessed. Research limitations/implications – Questionnaires had to be used, as the intention was to cover a very extensive geographical area. However, in opting for closed questions, it is acknowledged that standard responses have been obtained with no scope for capturing the individual circumstances of each respondent, thus making a qualitative approach difficult. Practical implications – The results provide an overall picture of certain aspects of the information behaviour of EDC users. They may serve as a starting point for planning training sessions designed to develop the skills required to search, access, evaluate and apply European information within an academic context. From a broader perspective, they also constitute factors which the European Commission should take into consideration when formulating its information and communication policy. Originality/value – This is the first piece of academic research into the EDCs and their users, which aimed to cover all Members State of the EU.

Avaliação de qualidade de energia de um sistema fotovoltaico numa rede elétrica

Dissertação para obtenção do grau de Mestre em Engenharia Electrotécnica Ramo de Energia

ECO-betão com adição de resíduo da indústria petrolífera

Dissertação de natureza Científica para obtenção do grau de Mestre em Engenharia Civil na Área de Especialização em Edificações

Brincadeira: marcos temporais e memória

A brincadeira, expressão maior das culturas lúdicas da infância e do saber popular infantil que colora o folclore das crianças e que entre elas constitui prática singular, tem marcos temporais indeléveis que lhe (de)marcaram um tempo e que a memória guardou para sempre. A linearidade que, durante quase todo o tempo antes da chegada da TV, a brincadeira transportou, a revolução das suas práticas que a partir daí se operou e acentuou com a chegada das novas tecnologias da comunicação e informação à vida das crianças e a consequente transformação radical do seu habitus lúdico (da rua para casa e daqui para o quarto) balizam eras distintas de tempos sociais paralelas às que ditaram, consequentemente, a transformação que as artes de e para brincar foram, historicamente, sofrendo. Ao resgatar a brincadeira pela voz das crianças, muitas das vezes expressa pela voz dos adultos que hoje são, faz-se o registo, que neste artigo se guarda, de um pedaço da herança cultural lúdica que foi passando entre as quatro gerações que estudamos qualitativamente a partir de entrevistas grupais feitas em contexto familiar, que serviram de base para o que a seguir fica relatado. A brincadeira e a parafernália que a acompanha fazem parte da história de vida de todos nós e, por isso, a cada um cabe velar para que nunca pereça.

Power law and entropy analysis of catastrophic phenomena

Catastrophic events, such as wars and terrorist attacks, tornadoes and hurricanes, earthquakes, tsunamis, floods and landslides, are always accompanied by a large number of casualties. The size distribution of these casualties has separately been shown to follow approximate power law (PL) distributions. In this paper, we analyze the statistical distributions of the number of victims of catastrophic phenomena, in particular, terrorism, and find double PL behavior. This means that the data sets are better approximated by two PLs instead of a single one. We plot the PL parameters, corresponding to several events, and observe an interesting pattern in the charts, where the lines that connect each pair of points defining the double PLs are almost parallel to each other. A complementary data analysis is performed by means of the computation of the entropy. The results reveal relationships hidden in the data that may trigger a future comprehensive explanation of this type of phenomena.

Hopping conduction and persistent photoconductivity in Cu2ZnSnS4 thin films

The temperature dependence of electrical conductivity and the photoconductivity of polycrystalline Cu2ZnSnS4 were investigated. It was found that at high temperatures the electrical conductivity was dominated by band conduction and nearest-neighbour hopping. However, at lower temperatures, both Mott variable-range hopping (VRH) and Efros–Shklovskii VRH were observed. The analysis of electrical transport showed high doping levels and a large compensation ratio, demonstrating large degree of disorder in Cu2ZnSnS4. Photoconductivity studies showed the presence of a persistent photoconductivity effect with decay time increasing with temperature, due to the presence of random local potential fluctuations in the Cu2ZnSnS4 thin film. These random local potential fluctuations cannot be attributed to grain boundaries but to the large disorder in Cu2ZnSnS4.

Incorporação de resíduo da indústria petrolífera em argamassas de cal hidráulica para a reabilitação de edifícios

Trabalho Final de Mestrado para obtenção do grau de Mestre em Engenharia Civil na Área de Especialização de Edificações

Le Crétacé inférieur de la marge atlantique portugaise: biostratigraphie, organization séquentielle, evolution paléogéographique

This paper gives a short description of main stratigraphic unities from the early Cretaceous in Estremadura and Algarve, with their lithological, sedimentological and paleontological characteristics. The distribution of facies enable to propose a paleogeographic frame including eroded high areas and sedimentary low areas roughly parallel to the present coast. The early Cretaceous from Estremadura is splited up into three megasequences each one with regressive then transgressive tendencies: this fact must be connected with the leading action of distensive, slow or sudden, movements. Beyond the hercynian fault of Messejana, Algarve presents a different sedimentary evolution during the early Cretaceous.

BITalino: a novel hardware framework for physiological computing

Physical computing has spun a true global revolution in the way in which the digital interfaces with the real world. From bicycle jackets with turn signal lights to twitter-controlled christmas trees, the Do-it-Yourself (DiY) hardware movement has been driving endless innovations and stimulating an age of creative engineering. This ongoing (r)evolution has been led by popular electronics platforms such as the Arduino, the Lilypad, or the Raspberry Pi, however, these are not designed taking into account the specific requirements of biosignal acquisition. To date, the physiological computing community has been severely lacking a parallel to that found in the DiY electronics realm, especially in what concerns suitable hardware frameworks. In this paper, we build on previous work developed within our group, focusing on an all-in-one, low-cost, and modular biosignal acquisition hardware platform, that makes it quicker and easier to build biomedical devices. We describe the main design considerations, experimental evaluation and circuit characterization results, together with the results from a usability study performed with volunteers from multiple target user groups, namely health sciences and electrical, biomedical, and computer engineering. Copyright © 2014 SCITEPRESS - Science and Technology Publications. All rights reserved.

Modular high-current generator for electromagnetic forming with energy recovery

A 10 kJ electromagnetic forming (EMF) modulator with energy recovery based on two resonant power modules, each containing a 4.5 kV/30-kA silicon controlled rectifier, a 1.11-mF capacitor bank and an energy recovery circuit, working in parallel to allow a maximum actuator discharge current amplitude and rate of 50 kA and 2 kA/mu s was successfully developed and tested. It can be plugged in standard single phase 230 V/16 A mains socket and the circuit is able to recover up to 32% of its initial energy, reducing the charging time of conventional EMF systems by up to 68%.

Multilevel high-voltage pulse generation based on a new modular solid-state switch

This paper describes a modular solid-state switching cell derived from the Marx generator concept to be used in topologies for generating multilevel unipolar and bipolar high-voltage (HV) pulses into resistive loads. The switching modular cell comprises two ON/OFF semiconductors, a diode, and a capacitor. This cell can be stacked, being the capacitors charged in series and their voltages balanced in parallel. To balance each capacitor voltage without needing any parameter measurement, a vector decision diode algorithm is used in each cell to drive the two switches. Simulation and experimental results, for generating multilevel unipolar and bipolar HV pulses into resistive loads are presented.