Academic spin-offs incubation strategies: the case of the Andalusian region

[EN] The objective of this paper is to analyze the incubation strategies developed in the universities of Andalusia, a relatively low-income region of Spain, to promote the creation of university spin-offs. These strategies are also compared to the incubation models noted in the literature. The performance of the university spin-offs created and its relation to the incubation strategies developed by the university are also analysed. The analysis is based on data from a survey of nine public universities that carry out strategies for the promotion of university spin-offs. The result of the analysis shows that university spin-off incubation strategies in Andalusia present specific characteristics not covered by certain models that are well-known in the literature on innovation. Then, a new stage in the process of the university spin-off incubation is proposed. We consider it to be a pre-strategic stage to the academic spin-off incubation strategies. The analysis also finds certain environmental factors associated to those spin-offs promoted by Andalusian universities that achieve the highest level of performance. This result suggests that previous to making any decision involving investment into developing incubation strategies, universities should gauge whether they have sufficient resources and the possibilities of connecting with a Technology Park.

Excimer laser plasma to control laser pulse duration

An injection-locking excimer laser beam with a pulse duration of 25 ns is focused on the surface of a polymide film. The laser beam that passes through the etching film is shorter than the original one. By optimizing the thickness of the film and the beam power density, a pulse with a 3-ns pulse duration can be obtained using this switch technology.

Investigation of damage threshold to TiO2 coatings at different laser wavelength and pulse duration

Laser-induced damages to TiO2 single layers and TiO2/SiO2 high reflectors at laser wavelength of 1064 nm, 800 run, 532 urn, and pulse width of 12 ns, 220 ps, 50 fs, 8 ns are investigated. All films are prepared by electron beam evaporation. The relations among microstructure, chemical composition, optical properties and laser-induced damage threshold (LIDT), have been researched. The dependence of damage mechanism on laser wavelength and pulse width is discussed. It is found that from 1064 nm to 532 nm, LIDT is mainly absorption related, which is determined by film's extinction coefficient and stoichiometric defects. The rapid decrease of LIDT at 800 nm is due to the pulse width factor. TiO2 coatings are mainly thermally by damaged at long pulse (tau >= 220 ps). The damage shows ablation feature at 50 fs. (C) 2007 Elsevier B.V. All rights reserved.

The effect of temperature on the duration of spawning markers—migratory-nucleus and hydrated oocytes and postovulatory follicles—in the multiple-batch spawner Japanese flounder (Paralichthys olivaceus)

The duration of spawning markers (e.g. signs of previous or imminent spawnings) is essential information for estimating spawning frequency of fish. In this study, the effect of temperature on the duration of spawning markers (i.e., oocytes at early migratory nucleus, late migratory nucleus, and hydrated stages, as well as new postovulatory follicles) of an indeterminate multiple-batch spawner, Japanese f lounder (Paralichthys olivaceus), was evaluated. Cannulation was performed to remove samples of oocytes, eggs, and postovulatory follicles in individual females at 2–4 hour intervals over 27–48 hours. The duration of spawning markers was successfully evaluated in 14 trials ranging between 9.2° and 22.6°C for six females (total length 484–730 mm). The durations of spawning markers decreased exponentially with temperature and were seen to decrease by a factor of 0.16, 0.36, 0.30, and 0.31 as temperature increased by 10°C for oocytes at early migratory nucleus, late migratory nucleus, and hydrated stages, and new postovulatory follicles, respectively. Thus, temperature should be considered when estimating spawning frequency from these spawning markers, especially for those fish that do not spawn synchronously in the population.

Duration of unassisted swimming activity for spotted dolphin (Stenella attenuata) calves: implications for mother-calf separation during tuna purse-seine sets

Size-related differences in power production and swim speed duration may contribute to the observed deficit of nursing calves in relation to lactating females killed in sets by tuna purse-seiners in the eastern tropical Pacific Ocean (ETP). Power production and swim-speed duration were estimated for northeastern spotted dolphins (Stenella attenuata), the species (neonate through adult) most often captured by the fishery. Power required by neonates to swim unassisted was 3.6 times that required of an adult to swim the same speed. Estimated unassisted burst speed for neonates is only about 3 m/s compared to about 6 m/s for adults. Estimated long-term sustainable speed is about 1 m/s for neonates compared to about 2.5 m/s for adults. Weight-specific power requirements decrease as dolphin calves increase in size, but power estimates for 2-year-old spotted dolphin calves are still about 40% higher than power estimates for adults, to maintain the same speed. These estimated differences between calves and adults are conservative because the calculations do not include accommodation for reduced aerobic capacity in dolphin calves compared to adults. Discrepancies in power production are probably ameliorated under normal circumstances by calves drafting next to their mothers, and by employing burst-coast or leap-burst-coast swimming, but the relatively high speeds associated with evasion behaviors during and after tuna sets likely diminish use of these energy-saving strategies by calves.

Studies on the growth temperature ranges of bacteria isolated from fresh sardine at different primary incubation temperature

The effect of primary incubation temperature on the growth temperature range was studied with reference to 296 bacterial cultures isolated from sardine using streak plate technique. The primary incubation temperature used during bacteriological sampling caused a selection of strains according to their growth temperature requirements. Incubation at 8°C caused greater recoveries of psychrotrophs while 30°C favored mesophiles. An incubation temperature of 30°C facilitated the growth of both psychrotrophs and mesophiles.

The influence of plating technique and incubation temperature on bacterial count from fish and fishery products

For bacterial sampling of raw unprocessed fish and frozen fishery products, spread plate method is preferable to pour plate method; incubation of plates at 30°C gives a higher count than incubation at 37°C. Analysis of variance of the data shows that sample variation between different types of fishes is highly significant whereas the variations between triplicate plates are not significant at 5 % level.