Transmittance properties of contact lens multipurpose solutions and their effects on a hydrogel lens

Purpose The aim was to assess the compatibility of different multipurpose solutions (MPSs) with one type of silicone hydrogel (SiH) contact lens by, assessing the changes in both ultraviolet (UV) and visible light transmissibility of the hydrogel lens caused by the MPSs. Methods The light transmittance from 200-700 nm were measured for the lotrafilcon B blister pack solution (BPS), six MPSs namely, ReNuMultiPlus Multi-Purpose Solution (Bausch and Lomb Inc., Rochester NY, USA.); Complete RevitaLens Multi-Purpose (Abbott Medical Optics Inc., Quarryvale Co. Dublin, Ireland); All In One Light (Sauflon Pharmaceuticals Ltd., Twickenham, England); SOLO-care AQUA™ (Ciba Vision Corporation Duluth, Georgia, USA.); Biomedics All-in-one solution (CooperVision, Hamble, UK); and HippiaMultiPlus All-in-one solution (Interojo Inc., Kyeonggi-do, Korea), and a lotrafilcon B SiH lens (before and after storage), using a spectrophotometer. Results The UV transmitted through the BPS and the MPS were similar (p >.05, for all), except for the HippiaMultiPlus which was lower (p < 0.001) by 19.8%. Mean transparency values were statistically (p<.001) significantly different between the BPS and the MPSs. All MP solution/SiH lens combinations resulted in relatively high UV transmittance values especially in the UVC spectrum, and significantly increased (p <.001) the visible light transmittance values of the SiH lens. Greater changes in transparency were observed in the ReNu/SiH lens (28.5%) and the Complete RevitaLens/SiH lens (24.9%) combinations. Conclusion The six MPSs showed significant variations in the transmitted UV and visible light. Similar to the BPS, all MPSs were equally transparent, but showed very poor UVA & UVB attenuation, except for the Hippia MultiPlus. The MPS/SiH lens combinations did not significantly affect the lens transparency but it significant increased the lens transmittance of UV radiation, after storage. Further in-vivo studies are needed to validate if this effect is constant.

Improving access to housing for low-income communities in Dhaka: From rhetoric to reality in community participation

The research explores how community participation can address affordable housing problems of the poor in Dhaka. The research, based on extensive interviews, community focus groups and household surveys in different Dhaka slums, identifies the limiting factors to promote community participation in affordable housing creation. In Dhaka housing options for poor are currently limited to affordable shelters in informal settlements. Public housing programs have failed to reach the poor and meet affordability levels due to a number of factors including lack of beneficiary participation. Beneficiary participation, though widely recognized for success in housing initiatives, often deteriorates in process of implementation into mere involvement, not reflecting community needs and aspirations and thus failing to meet its core objectives. This research identified the most significant impediments as well as opportunities to advance participation in their own housing provisions in Dhaka city.

Generalized element load method for first- and second-order element solutions with element load effect

The finite element method in principle adaptively divides the continuous domain with complex geometry into discrete simple subdomain by using an approximate element function, and the continuous element loads are also converted into the nodal load by means of the traditional lumping and consistent load methods, which can standardise a plethora of element loads into a typical numerical procedure, but element load effect is restricted to the nodal solution. It in turn means the accurate continuous element solutions with the element load effects are merely restricted to element nodes discretely, and further limited to either displacement or force field depending on which type of approximate function is derived. On the other hand, the analytical stability functions can give the accurate continuous element solutions due to element loads. Unfortunately, the expressions of stability functions are very diverse and distinct when subjected to different element loads that deter the numerical routine for practical applications. To this end, this paper presents a displacement-based finite element function (generalised element load method) with a plethora of element load effects in the similar fashion that never be achieved by the stability function, as well as it can generate the continuous first- and second-order elastic displacement and force solutions along an element without loss of accuracy considerably as the analytical approach that never be achieved by neither the lumping nor consistent load methods. Hence, the salient and unique features of this paper (generalised element load method) embody its robustness, versatility and accuracy in continuous element solutions when subjected to the great diversity of transverse element loads.

A framework for understanding and generating integrated solutions for residential peak energy demand

Supplying peak energy demand in a cost effective, reliable manner is a critical focus for utilities internationally. Successfully addressing peak energy concerns requires understanding of all the factors that affect electricity demand especially at peak times. This paper is based on past attempts of proposing models designed to aid our understanding of the influences on residential peak energy demand in a systematic and comprehensive way. Our model has been developed through a group model building process as a systems framework of the problem situation to model the complexity within and between systems and indicate how changes in one element might flow on to others. It is comprised of themes (social, technical and change management options) networked together in a way that captures their influence and association with each other and also their influence, association and impact on appliance usage and residential peak energy demand. The real value of the model is in creating awareness, understanding and insight into the complexity of residential peak energy demand and in working with this complexity to identify and integrate the social, technical and change management option themes and their impact on appliance usage and residential energy demand at peak times.

The provision of visitable housing in Australia: Down to the detail

In response to the ratification of the United Nations Convention of the Rights of People with Disabilities (CRPD), Australian housing industry leaders, supported by the Australian Government, committed to transform their practices voluntarily through the adoption of a national guideline, called Livable Housing Design. They set a target in 2010 that all new housing would be visitable by 2020. Research in this area suggests that the anticipated voluntary transformation is unrealistic and that mandatory regulation will be necessary for any lasting transformation to occur. It also suggests that the assumptions underpinning the Livable Housing Design agreement are unfounded. This paper reports on a study that problematised these assumptions. The study used eleven newly-constructed dwellings in three housing contexts in Brisbane, Australia. It sought to understand the logics-of-practice in providing, and not providing, visitable housing. By examining the specific details that make a dwelling visitable, and interpreting the accounts of builders, designers and developers, the study identified three logics-of-practice which challenged the assumptions underpinning the Livable Housing Design agreement: focus on the point of sale; an aversion to change and deference to external regulators on matters of social inclusion. These were evident in all housing contexts indicating a dominant industry culture regardless of housing context or policy intention. The paper suggests that financial incentives for both the builder and the buyer, demonstration by industry leaders and, ultimately, national regulation is a possible pathway for the Livable Housing Design agreement to reach the 2020 goal. The paper concludes that the Australian Government has three options: to ignore its obligations under the CRPD; to revisit the Livable Housing Design agreement in the hope that it works; or to regulate the housing industry through the National Construction Code to ensure the 2020 target is reached.

Removal of herbicides from aqueous solutions by modified forms of montmorillonite

This investigation for the removal of agricultural pollutants, imazaquin and atrazine was conducted using montmorillonite (MMT) exchanged with organic cations through ion exchange. The study found that the adsorption of the herbicides was affected by the degree of organic cation saturations, the size of organic cations and the different natures of the herbicides. The modified clays intercalated with the larger surfactant molecules at the higher concentrations tended to enhance the adsorption of imazaquin and atrazine. In particular, the organoclays were highly efficient for the removal of imazaquin while the adsorption of atrazine was minimal due to the different hydrophobicities. Both imazaquin and atrazine were influenced by the changes of pH. The amphoteric imazaquin exists as an anion at the pH 5–7 and the anionic imazaquin was protonated to a neutral and further a cationic form when the pH is lower. The weak base, atrazine was also protonated at lower pH values. The anionic imazaquin had a strong affinity to the organoclays on the external surface as well as in the interlayer space of the MMT through electrostatic and hydrophobic interactions. In this study, the electrostatic interaction can be the primary mechanism involved during the adsorption process. This study also investigated a comparative adsorption for the imazaquin and atrazine and the lower adsorption of atrazine was enhanced and this phenomenon was due to the synergetic effect. This work highlights a potential mechanism for the removal of specific persistence herbicides from the environment.

Effective removal of zinc (II) from aqueous solutions by tricalcium aluminate (C3A)

Recently, studies have identified high zinc levels in various environmental resources, and excessive intake of zinc has long been considered to be harmful to human health. The aim of this research was to investigate the effectiveness of tricalcium aluminate (C3A) as a removal agent of zinc from aqueous solution. Inductively coupled plasma-atomic emission spectrometer (ICP-AES), X-ray diffraction (XRD) and scanning electron microscopy (SEM) have been used to characterize such removal behavior. The effects of various factors such as pH influence, temperature and contact time were investigated. The adsorption capacity of C3A for Zn2+ was computed to be up to 13.73 mmol g−1, and the highest zinc removal capacity was obtained when the initial pH of Zn(NO3)2 solution was between 6.0 and 7.0, with temperature around 308 K. The XRD analysis showed that the resultant products were ZnAl-LDHs. Combined with the analysis of solution component, it was proved the existence of both precipitation and cation exchange in the removal process. From the experimental results, it was clear that C3A could be potentially used as a cost-effective material for the removal of zinc in aqueous environment.

Impact of agricultural chemicals on the environment and human health in Asia: Are there solutions?

Modern commercial agricultural practices in Asia during the last three to four decades involving chemicals (fertilisers and pesticides) have been associated with large increases in food production never witnessed before, especially under the Green Revolution technology in South Asia. This also involves large-scale increases in commercial vegetable crops. However, the high reliance on chemical inputs to bring about these increases in food production is not without problems. A visible, parallel correlation between higher productivity, high artificial input use and environmental degradation and human ill-health is evident in many countries where commercial agriculture is widespread. In this chapter, we focus on the impact of chemical inputs, in particular the impact of pesticides on the environment and on human health in South Asia with special reference to Sri Lanka...

Psychological services for asylum seekers in the community: Challenges and solutions

Objective: Given the Australian government’s current policy of placing asylum seekers into the community while their applications for asylum are being considered, it is important that mental health practitioners are able to offer culturally safe, sensitive, and competent services in this context. Method: A qualitative approach was used to interview seven practitioners, who provided services to asylum seekers at a specialist health clinic in the community. These professionals used their experience to identify the psychosocial issues faced by these asylum seekers, the challenges of providing culturally effective services to this group, and how these services can be improved. Result: Data were thematically analysed using NVivo. The findings indicated that participants perceived that clients experienced psychological, health, and cultural difficulties. The stress and uncertainty around visa applications emerged as the most severe factor impacting asylum seekers’ mental health. Working effectively with interpreters and culturally adapting assessment and treatment for these clients emerged as effective strategies. Gathering information in a conversational way and using clients’ different cultural explanatory models were methods used to identify and address mental health issues, rather than using formal measures. Interventions were eclectic and holistic, and reflected treatments that were appropriate for the clients’ cultural backgrounds. Conclusion: The study has implications for how psychological services are offered to asylum seekers in the community. Further, it identifies areas that can be incorporated in the future training of practitioners.

Developer charges and housing affordabilty in Brisbane, Australia

Purpose - This paper empirically examines the effect of developer charges on housing affordability in Brisbane, Australia. Developer paid fees or charges are a commonly used mechanism for local governments to pay for new urban infrastructure. Despite numerous government reports and many years of industry advocacy, there remains no empirical evidence in Australia to confirm or quantify passing on of these charges to home buyers. Design/methodology/approach - This research applies a hedonic house price model to 4,699 new and 25,053 existing house sales in Brisbane from 2005 to 2011. Findings – The findings of is research are consistent with international studies that support the proposition that developer charges are over passed. This study has provided evidence that suggest developer charges are over passed to both new and existing homes in the order of around 400%. Research limitations/implications - These findings suggest that developer charges are thus a significant contributor to increasing house prices and reduced housing affordability. Practical/Social Implications: By testing this effect on both new and existing homes, this research provides evidence in support of the proposition that not only are developer charges over passed to new home buyers but also to buyers of existing homes. Thus the price inflationary effect of these developer charges are being felt by all home buyers across the community, resulting in increased mortgage repayments of close to $1000 per month. Originality/value - This is the first study to empirically examine the impact of developer charges on house prices in Australia. These results are important as they will inform governments on the outcomes of growth management strategies on housing affordability, providing the first evidence of its kind in Australia.

De-risking development of medium density housing to improve housing affordability and boost supply

Housing price inflation is a national concern given the serious decline in the number of low and middle income households able to purchase housing. In addition housing supply lags well behind demand. In Melbourne, urban consolidation policies explicitly seek intensification to promote housing supply but planning regulation is often criticised for being a significant cost driver for medium density housing. It is assumed that easing supply constraints will improve affordability. We suggest that laissez-faire planning exacerbates affordability issues because this approach fails to address the basic economic problem: the current inability of the market to efficiently match supply and demand in order to progress an orderly and de-risked development process. The role of “exchange” one of the four housing market sub-systems identified by Burke (2012) has until recently generally been ignored but our examination reveals significant economic transaction costs that manifest as development risks that impact on affordability. Fortunately these can be mitigated, but only if there is a more consumer driven supply response.

Energy Transformed: Sustainable Energy Solutions for Climate Change Mitigation

This 600+ page online education program provides free access to a comprehensive education and training package that brings together the knowledge of how countries, specifically Australia, can achieve at least 60 percent cuts to greenhouse gas emissions by 2050. This resource has been developed in line with the activities of the CSIRO Energy Transformed Flagship research program which is focused on research that will assist Australia to achieve this target. This training package provides industry, governments, business and households with the knowledge they need to realise at least 30 percent energy efficiency savings in the short term while providing a strong basis for further improvement. It also provides an updated overview of advances in low carbon technologies, renewable energy and sustainable transport to help achieve a sustainable energy future. Whist this education and training package has an Australian focus, it outlines sustainable energy strategies and provide links to numerous online reports which will assist climate change mitigation efforts globally. This training program seeks to compliment other initiatives seeking to encourage the reduction of greenhouse gas emissions through behaviour change, sustainable consumption, and constructive changes in economic incentives and policy.

Water transformed: Sustainable water solutions for climate change adaptation

This online textbook provides free access to a comprehensive education and training package that brings together the knowledge of how countries, specifically Australia, can adapt to climate change. This resource has been developed formally as part of the Federal Government’s Department of Climate Change’s Climate Change Adaptation Professional Skills program.

Re-engineering higher education for energy efficiency solutions

Emerging 21st century challenges require higher education institutions (HEIs) to play a key role in developing graduates and professionals, particularly in engineering and design, who can forge sustainable solutions. The trouble is there’s currently a significant lag in the preparedness of HEIs to provide the stream of professionals needed. Addressing energy efficiency competencies is one critical area.

Water solutions adapted for climate change

The Water Transformed online education package demonstrates how Australia is leading in many aspects of water management, as well as how, across a number of sectors, companies and organisations are achieving significant savings – of both water and money...