Resinas para facetas estéticas de próteses fixas. III. Análise conjunta das variáveis alteração dimensional e alteração de peso em função de materiais, condição de armazenamento e tempos.

The authors analysed the simultaneous effects of the dimensional and weight alteration of resins utilized for esthetic facets submitted to warehousing conditions and periods of time. The resins showed different behaviour and a neat correlation between dimensional alteration and weight. The condition of immersion promoted dimensional alteration 50% lower and an alteration of weight three times higher.

Isolamento e caracterização de candida albicans e outras leveduras de águas de recreação não marinha e de materiais clínicos

Candida albicans and other yeasts from recreational water or clinical materials were isolated. Sixty-six water samples, originating from eight swimming pools and five lakes with beaches were examined for the presence of these yeasts, by a membrane filter method and 'pour plate' technique. Sixty-two clinical materials from suspected cases of candidiasis were studied in the same period. Rhodotorula sp and C. albicans were more frequently isolated from lakes and swimming pools, respectively; C. albicans and C. parapsilosis from clinical materials. From 44 samples of C. albicans, 90,9% were serotype A, and 9,1%, serotype B; C. albicans from recreational waters belong only serotype A. No difference was observed in the M.I.C. of C. albicans strains from waters and clinical materials. All strains were susceptible to the antifungal drugs tested.

Liberação de mitomicina C - Influência de diferentes materiais

Purpose: To evaluate the quantity of Mitomycin C discharged from different materials with the same size, potentially used in the application of this medicine accessible in the surgery center of an Universitarian Hospital. Material and Method: It was studied 20 fragments with 5 to 5mm, from each 5 materials: Lyostypt, Weck sponge, absorbable cloth which is used to clean, cotton plate and of cotton swab concerning the saturation capacity and the quantity of mitomicyn discharged. In the first stage, it was studied the saturation capacity from each material. In the second stage, it was applied 0,1 ml solution of Mitomicyn C (0,5 mg/ml) and it was measured the biggest discharge halo in the filter paper and the discharged quantity (the difference between the weight before and after the medicine discharge). Results: The absorveble capacity from each material varied from 0,144 ml (absorbable cloth) to 0,216 ml Weck sponge. The discharge of Mitomicyn C was varied too, the biggest was the cotton plate and absorbable cloth. The Weck sponge and the cotton (of cotton swab) discharges the same quantity. Conclusion: The different materials discharged different quantities of Mitomicyn C. This can explain the different results of the trabeculectomy with Mitomicyn C. The surveys must inform not only the material used to apply the mitomycin C but the volume used too. Because the same values of mitomycin C liberation, cotton may substitute Weck sponje in trabeculectomy.

Revendo os códigos hamming e CRC para tratar com erros na transmissão de dados

This article has the purpose to review the main codes used to detect and correct errors in data communication specifically in the computer's network. The Hamming's code and the Ciclic Redundancy Code (CRC) are presented as the focus of this article as well as CRC hardware implementation. Each code is reviewed in details in order to fill the gaps in the literature and to make it accessible to the computer science and engineering students as well as to anyone who may be interested in learning the technique to treat error in data communication.

Comparação entre o sistema Autoścan-4 e métodos convencionais na identificação de bacilos Gram-negativos não fermentadores, isolados de materiais clínicos de pacientes em Presidente Prudente - SP

Ninety eight strains of glucose-nonfermenting Gram-negative bacilli were analyzed and isolated from several clinical materials of 95 patients admitted at the Dr. Domingos Leonardo Cerávolo University Hospital and three from outpatients. All of them were assisted in the Laboratory of Clinical Analysis of Unoeste University, Presidente Prudente, SP, from the period of October of 1999 to April of 2001. In this work, the level of agreement between the semi-automated commercial system AutoScan-4 and the conventional system for the identification of those bacteria were studied comparatively. There was agreement in 81 (82.7%), showing that both methodologies are useful for identification; partial agreement in six strains (6.1%) and disagreement in 11 (11.2%). The comercial system did not identify nine (9.2%) of the strains and reported them as very rare biotypes.

Estudo das características morfológicas dos pites nos materiais resistentes à corrosão

This paper has as a purpose a new alternative technique development to characterize pitting corrosion evolution, aiming classification, size and determination of morphological parameters which rule pits increase. In this case, the method will be applied to the 304 ABNT stainless steel, thermally treated and exposed to different times in salt spray. Different 304 steel conditions, rolled and thermally treated have exhibited similar geometry, predominantly conic, near-conic and irregular pits. On rolled steel, pits width increases faster than height; however, on thermally treated steel, pits are found to increase in height.

Padrão de sensibilidade aos antimicrobianos de bacilos gram-negativos não fermentadores isolados de materiais clínicos de pacientes em Presidente Prudente - SP

The aim of this study was the assessment of isolation frequency and antimicrobial susceptibility pattern of nonfermenting Gram-negative bacilli. Ninety eight strains of nonfermenting Gram-negative bacilli, isolated from several clinical materials of patients admited at the Dr. Domingos Leonardo Cerávolo University Hospital and at Dr. Odilo Antunes Siqueira State Hospital, as well as from every outpatient; assisted at Laboratory of Clinical Analysis of Unoeste University, Presidente Prudente, São Paulo, in the period of October 1999 to April 2001 were analyzed. The most frequent species were Pseudomonas aeruginosa (65.3%) and Acinetobacter baumannii (23.5%). The frequency of the other isolated species was smaller than 2.5%. In the antimicrobial susceptibility tests, the two species more prevalent showed high resistance. The antibiotic most active in vitro was the imipenem, with 79.6% in microdiluition method, and 76.6% in diffusion method, for Pseudomonas aeruginosa strains and 100.0% in both microdiluition and diffusion methods, for Acinetobacter baumannii. The cephalosporins of third generation, the ciprofloxacin and the aminoglycosides, presented percentage of susceptibility varying from 22.4 to 69.7%. These results bring implications to the emergency use of the antimicrobial agents in the treatment of patients with severe infection.

Frutose em humanos: Efeitos metabólicos, utilização clínica e erros inatos associados

This article reviews the metabolism of fructose and sorbitol, their main clinical indications and the consequences of inadequate use. Fructose, an important carbohydrate in the diet, is present mostly in fruits and vegetables; it can also be synthesized from glucose in the organism, through the sorbitol. Fructose is known for its metabolism's inherent errors, whose clinical manifestations are potentially serious, as well as for its use as a glucose substitute in the diabetic patients' diet, due to its metabolism not being dependent from insulin. In the last years, especially in developed countries, the consumption of fructose has increased considerably, due to its use as a sweetener in industrialized foods. However, adverse side-effects may occur with the excessive ingestion of fructose, such as the increase in blood's triglycerides and cholesterol. Therefore, to know which are the patients' normal blood levels is quite important for establishing the safe amount of fructose to be prescribed, as well as for allowing the screening of metabolism diseases associated with fructose.

Experienciando Materiais Manipulativos para o Ensino e a Aprendizagem da Matemática

This paper presents some outcomes from research based on classroom experiences. The main themes are the use of mirrors, kaleidoscopes, dynamic geometry software, and manipulative material considering their possibilities for the teaching and learning of Euclidean and non-Euclidean geometries.

Esterilização de materiais termossensíveis através de aplicação de plasma gerado por descarga com barreira dielétrica (DBD)

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Educação, visualidade e informação em materiais gráficos educativos

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Em foco: professores de Artes e suas experiências com os materiais educativos Lá vai Maria Bem-vindo professor! arte br

Pós-graduação em Artes - IA

Avaliação e implementação de métodos de estimação de tempo de atraso de sinais de ultra-som

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Metodologias de medição de energia elétrica reativa (varh) e erros de medição em equipamentos eletrônicos de (varh)

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Análise experimental de erros de medição de energia elétrica ativa em medidores eletromagnéticos tipo indução, sujeitos a distorções harmônicas de correntes e tensões, em sistemas equilibrados e desequilibrados

Pós-graduação em Engenharia Elétrica - FEIS