Vortices, sound and flames - a damaging combination

The interaction between vortices, sound and combustion can lead to self-excited oscillations of such large amplitudes that structural damage is done. These occur because any small unsteadiness in the rate of combustion is a source of sound, generating pressure and velocity fluctuations. However, the velocity fluctuations perturb the flame, thereby altering the instantaneous rate of heat release. Instability is then possible because while acoustic waves perturb the combustion, the unsteady combustion generates yet more sound! Combustion oscillations can occur in afterburners and at idle in conventional aeroengine combustors. Lean premixed, prevapourized technology has tremendous potential to reduce NOx emissions, but is proving highly susceptible to self-excited oscillations. An overview of the physics of the interaction between vortices, sound and flames is presented, and illustrated by examples of instability in generic premixed ducted flames and in aeroengine combustors. The potential for both passive and active control is discussed.

Near optimal combination of sensory and motor uncertainty in time during a naturalistic perception-action task.

Most behavioral tasks have time constraints for successful completion, such as catching a ball in flight. Many of these tasks require trading off the time allocated to perception and action, especially when only one of the two is possible at any time. In general, the longer we perceive, the smaller the uncertainty in perceptual estimates. However, a longer perception phase leaves less time for action, which results in less precise movements. Here we examine subjects catching a virtual ball. Critically, as soon as subjects began to move, the ball became invisible. We study how subjects trade-off sensory and movement uncertainty by deciding when to initiate their actions. We formulate this task in a probabilistic framework and show that subjects' decisions when to start moving are statistically near optimal given their individual sensory and motor uncertainties. Moreover, we accurately predict individual subject's task performance. Thus we show that subjects in a natural task are quantitatively aware of how sensory and motor variability depend on time and act so as to minimize overall task variability.

Time-resolved volumetric measurement of fine-scale coherent structures in turbulence.

We present full volumetric (three-dimensional) time-resolved (+one-dimensional) measurements of the velocity field in a large water mixing tank, allowing us to assess spatial and temporal rotational energy (enstrophy) and turbulent energy dissipation intermittency. In agreement with previous studies, highly intermittent behavior is observed, with intense coherent flow structures clustering in the periphery of larger vortices. However, further to previous work the full volumetric measurements allow us to separate out the effects of advection from other effects, elucidating not only their topology but also the evolution of these intense events, through the local balance of stretching and diffusion. These findings contribute toward a better understanding of the intermittency phenomenon, which should pave the way for more accurate models of the small-scale motions based on an understanding of the underlying flow physics.

Decadal variation in the trans-Pacific migration of northern bluefin tuna (Thunnus thynnus) coherent with climate-induced change in prey abundance [abstract]

EXTRACT (SEE PDF FOR FULL ABSTRACT): Indices of the relative abundance of bluefin tuna in the western and eastern Pacific show decadal variation in the proportion of bluefin making trans-Pacific migrations out of the western Pacific.

PARTIALLY COHERENT DYNAMIC PROGRAMMING ALGORITHM FOR CPM DETECTION.

A dynamic programming algorithm for joint data detection and carrier phase estimation of continuous-phase-modulated signal is presented. The intent is to combine the robustness of noncoherent detectors with the superior performance of coherent ones. The algorithm differs from the Viterbi algorithm only in the metric that it maximizes over the possible transmitted data sequences. This metric is influenced both by the correlation with the received signal and the current estimate of the carrier phase. Carrier-phase estimation is based on decision guiding, but there is no external phase-locked loop. Instead, the phase of the best complex correlation with the received signal over the last few signaling intervals is used. The algorithm is slightly more complex than the coherent Viterbi algorithm but does not require narrowband filtering of the recovered carrier, as earlier appproaches did, to achieve the same level of performance.

Culture of Amblypharyngodon mola in rice fields alone and in combination with Barbodes gonionotus and Cyprinus carpio

A rice-fish culture experiment with four treatments viz., T 1 with Amblyphmyngadan mala alone, T 2 with A. mala and Barbodes gonionotus, T3 with A. mala and Cyprinis carpio and T4 as control (without fish) was carried out in the rice fields during April through August1999. The recovery rate of A. mala were 42%, 37% and 42% in treatments 1, 2 and 3 respectively and the same recorded for B. gonionotus and C. cmpio were 62% and 55% respectively. Among the three species of fish, B. gonionotus showed much higher recovery rate than both of A. mala and C. carpio. The production of A. nwla was 12.50 kg/ha/3 months in monoculture, and 7.92 kglha/3 months and 8.86 kglha/3 months in combination with B. gonionotus and C. carpio, respectively. The production of B. gonionotus in T2 was 169.29 kg/ha/3 months and C. cmpio in T 3 was 252.92 kg/ha/3 months. The total fish production was 12.50 kg/ha/3 months, 175.21 kg/ha/3 months and 261.88 kg/ha/3 months in Tp T2 and T3, respectively. The highest yields of rice grain (5.78 ton/ha) and straw (7.83 ton/ha) were recorded in T3 and the lowest of the same was in T4 (grain 4.96 ton/ha and straw 6.62 ton/ha). Rice yield increased by about 12.10% in T1, 13.30% in T2 and 16.33% in T3 in context to T4, rice-alone culture. The results demonstrated that the culture of fish in rice fields had profound beneficial impact on the production of rice grain and straw.

On the comparative efficiency of trawls made of cotton, polyethylene and combination of both the materials

The merits and demerits of cotton, polyethylene and combination of the two materials ascertained on the basis of cost, wear and tear, maintenance, total catch and qualitative analysis of the catch are discussed by making comparative fishing experiments with the three trawl gears made of these materials. The study can be concluded with a suggestion for switching over to polyethylene twisted monofilaments for better, in case of bottom trawls without in any way adversely affecting the catch of shrimps and at the same time for enhanced fish catch. Even though the combination net is found to be equal in efficiency as the polyethylene net this idea cannot be conveniently adopted from the point of view of economy.

Import substitution of combination wire rope. Part 1. Design, production and evaluation of a prototype combination wire rope

Model combination wire ropes with different covering materials were prepared and worked out specification for the prototype. A table model hand operated wire rope twisting machine was also developed for this. Prototype combination wire rope was twisted in collaboration with M/s South India Wire Ropes Ltd., Alwaye. Specification details, properties and field performance of the prototype studied are reported.

Import substitution of combination wire rope. Part 2. Production and standardisation of 17 mm dia combination wire rope.

The prototype combination wire rope (Cift-CWR 1) developed for deep sea trawling was further studied for improvement, optimisation of efficiency and standardization. A series of improved prototype combination wire ropes (Cift-CWR 2 to 6) were twisted and evaluated their mechanical properties and reported in this paper with recommendations for a standard 17mm dia combination wire rope of 6S (7C+8+1 Scr) + 6 Crs(6+1+1 Crc) construction.

Import substitution of combination wire rope. Part 3: Comparison of standard Cift-CWR and imported combination wire rope

Tensile and extension properties of standard Cift-CWR and imported combination wire ropes from Japan, Norway and Denmark are studied and the analysis is presented in the paper. Tensile and chemical properties of steel wire, tensile and abrasive properties of PP covering, effect of twist on material at different stages are worked out and reported.