Solar Energy assessment based on weather station data for direct site monitoring in Indonesia

This thesis evaluates different sites for a weather measurement system and a suitable PV- simulation for University of Surabaya (UBAYA) in Indonesia/Java. The weather station is able to monitor all common weather phenomena including solar insolation. It is planned to use the data for scientific and educational purposes in the renewable energy studies. During evaluation and installation it falls into place that official specifications from global meteorological organizations could not be meet for some sensors caused by the conditions of UBAYA campus. After arranging the hardware the weather at the site was monitored for period of time. A comparison with different official sources from ground based and satellite bases measurements showed differences in wind and solar radiation. In some cases the monthly average solar insolation was deviating 42 % for satellite-based measurements. For the ground based it was less than 10 %. The average wind speed has a difference of 33 % compared to a source, which evaluated the wind power in Surabaya. The wind direction shows instabilities towards east compared with data from local weather station at the airport. PSET has the chance to get some investments to investigate photovoltaic on there own roof. With several simulations a suitable roof direction and the yearly and monthly outputs are shown. With a 7.7 kWpeak PV installation with the latest crystalline technology on the market 8.82 MWh/year could be achieved with weather data from 2012. Thin film technology could increase the value up to 9.13 MWh/year. However, the roofs have enough area to install PV. Finally the low price of electricity in Indonesia makes it not worth to feed in the energy into the public grid.

Monitoring results of combined pellet and solar heating system

In this study the monitoring results of prototype installation of a recently developed solar combisystem have been evaluated. The system, that uses a water jacketed pellet stove as auxiliary heater, was installed in a single family house in Borlänge/Sweden. In order to allow an evaluation under realistic conditions the system has been monitored for a time period of one year. From the measurements of the system it could be seen that it is important that the pellet stove has a sufficient buffer store volume to minimize cycling. The measurements showed also that the stove gives a lower share of the produced heat to the water loop than measured under stationary conditions. The solar system works as expected and covers the heat demand during the summer and a part of the heat demand during spring and autumn. Potential for optimization exists for the parasitic electricity demand. The system consumes 680 kWh per year for pumps, valves and controllers which is more than 4% of the total primary heating energy demand.

Annual CO-emissions of combined pellet and solar heating systems

Emissions are an important aspect of a pellet heating system. High carbon monoxide emissions are often caused by unnecessary cycling of the burner when the burner is operated below the lowest combustion power. Combining pellet heating systems with a solar heating system can significantly reduce cycling of the pellet heater and avoid the inefficient summer operation of the pellet heater. The aim of this paper was to study CO-emissions of the different types of systems and to compare the yearly CO-emissions obtained from simulations with the yearly CO-emissions calculated based on the values that are obtained by the standard test methods. The results showed that the yearly CO-emissions obtained from the simulations are significant higher than the yearly CO-emissions calculated based on the standard test methods. It is also shown that for the studied systems the average emissions under these realistic annual conditions were greater than the limit values of two Eco-labels. Furthermore it could be seen that is possible to almost halve the CO-emission if the pellet heater is combined with a solar heating system.

Nesting architecture and population structure of the fungus-growing ant Cyphomyrmex transversus (Formicidae: Myrmicinae: Attini) in the Brazilian coastal zone of Ilheus, Bahia

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Internal Architecture and Population Size of Acromyrmex subterraneus molestans (Hymenoptera, Formicidae) Nests: Comparison Between a Rural and an Urban Area

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Observational Characterization of the Downward Atmospheric Longwave Radiation at the Surface in the City of São Paulo

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Iron phthalocyanine in non-aqueous medium forming layer-by-layer films: growth mechanism, molecular architecture and applications

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Molecular architecture and electrical properties in evaporated films of cobalt phthalocyanine

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Nest architecture and population dynamics of the Ponerinae ant, Ectatomma opaciventre Roger (Hymenoptera : Formicidae)

Eleven nests of Ectatomma opaciventre were collected from January to December, 1994, in Rio Claro, SP, southeastern Brazil. This species excavates their nests up to 68 cm deep, containing 3, 4 or 5 chambers. The hole of entrance has a chimney-like rigid structure, with up to 2/5 cm high. The most numerous colonies were found in January and February, with 47 and 62 adult ants, respectively. The quantity of individuals decreased from March, being observed colonies with only 9 adult ants in June and July. The colony population increased again since September. Reproductive forms (winged ants) were observed between October and February. We did not observed immature stages in July, but they were numerous between September and March. There was a significant correlation between the number of colony individuals and temperature, but not between the number of colony individuals and relative humidity and rainfall. E. opaciventre is a species of hunter ants which have not an efficient recruitment system for food collecting, consequently their colonies are small due to the scarcity of food resources during the colder and dry months.

Healing process after surgical treatment with scalpel, electrocautery and laser radiation: histomorphologic and histomorphometric analysis

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Architecture and relevance of several strongly adhered biofilms over a polyester imide (PEI) surface

Um estudo microscópico foi considerado para analisar a eventual adesão de fungos sobre uma superfície de poliéster-imida presente em fios de cobre esmaltados. A microscopia eletrônica de varredura, permitiu observar nestes biofilmes aderidos, uma alta quantidade de pigmentos, hifas e um arsenal enzimático possivelmente atuando na superfície desta macromolécula. Devido a natureza altamente aromática deste material e traços de derivados fenólicos usados como solventes - que se fazem ainda presentes no polímero já reticulado, uma certa atividade anti-fúngica poderia ser esperada, todavia não foram observadas alterações no crescimento dos microrganismos, bem como no processo de adesão dos fungos. Adicionalmente a este fato, os fios esmaltados revelaram total descaracterização de suas propriedades isolantes. Os estudos visam compreender e avaliar o grande potencial demonstrado pelos fungos que poderia em caráter vindouro, explorado em processos de biodeterioração e biodegradação

EFFECT OF APIS-MELLIFERA BEE VENOM AND GAMMA-RADIATION ON BONE-MARROW CELLS OF WISTAR RATS TREATED INVIVO

To determine whether the venom of Apis mellifera can exert a radioprotective effect, by reducing the frequency of chromosome aberrations induced by radiation, five different experiments were performed on bone marrow cells of Wistar rats.Animals weighing about 100 g were injected intraperitoneally with different venom concentrations (1.0 or 0.5 mul) 1 or 24 h before, or 30 min after being submitted to 3 or 4 Gy of gamma radiation, and sacrificed 24 h after the last treatment. For each experiment in addition to the group of animals submitted to combined treatment (venom + radiation) and to their control, there was also one group treated with radiation only and another treated with venom only. A decrease in the frequency of chromosome aberrations, and fragments in particular, as well as in the number of cells with aberrations was observed in the experiments in which venom was administered 24 h before irradiation, and the effect was more marked at the higher venom concentration (1 mul/100 g weight).

Homogeneous photodegradation of CI Reactive Blue 4 using a photo-Fenton process under artificial and solar irradiation

The oxidation of C.I. Reactive Blue 4 (RB4) by photo-Fenton process mediated by lerrioxalate was investigated under artificial and solar irradiation. The RB4 degradation in acidic medium (pH 2.5) was evaluated by the decrease in Total Organic Carbon (TOC) content and color, measured by the decrease in chromophore absorption band (600 nm). The influence of ferrioxalate and H2O2 concentrations on the dye degradation was studied and best results were obtained using 1.0 mM ferrioxalate and 10 nM of hydrogen peroxide. Under these experimental conditions, 80% of TOC and 100% of color removal were obtained for a 0.1 mM RB4 dye in 35 min of solar irradiation. (c) 2006 Elsevier Ltd. All rights reserved.