辽东山区长白落叶松(Larixolgensis)种子雨和种子库

长白落叶松是东北地区主要的用材树种,其种子雨和种子库研究鲜见报道。在辽东山区用收集器收集的种子分析了长白落叶松种子雨组成、质量和扩散距离,每隔2个月调查1次种子库数量,并结合靛蓝染色法测定每次种子的活力来分析土壤种子库动态。结果表明,辽东山区的长白落叶松种子雨从8月中旬开始,9月末到10月初达到高峰期,11月初结束。在起始期,种子雨以干瘪的不完整种子为主,而从高峰期开始,种子雨以完整种子为主。整个长白落叶松种子雨中不完整种子约占种子雨总量的45%,这些不完整种子由被动物取食、空粒和病虫害危害种子组成。完整种子的平均生活力为56.4%,即有活力的种子仅占整个种子雨的30%。种子雨集中在母树周围,在林缘1次扩散距离一般不超过1.5倍树高。种子雨到达地面之后,主要分布在枯枝落叶层,土壤0~5cm层有少量分布,土壤5 cm以下没有种子分布;土壤种子库的种子主要在翌年雪融化后开始萌发、被取食、搬运以及腐烂,其中腐烂种子数占45.4%,动物取食为30.0%。种子库的种子数量和活力在冬季没有明显变化,而在翌年,种子数量和活力明显减少,4、6月和8月份种子数量分别为(506.3±35.56)粒m-2,(267.1±17.47)粒m-2和(143.6±9.83)粒m-2,对应的活力分别为47.8%±4.68%,19.4%±3.39%和0%,这表明长白落叶松种子不能在地面形成连续的种子库。

北京地区气候变化和植被的关系:基于遥感数据和物候资料的分析

气候变化对陆地生态系统的影响及其反馈是全球变化研究的焦点之一。本文利用1951～2000年的气温、降水等气候资料、1982～2000年的NOAA/AVHRR遥感数据和1951～2000年北京春季物候的代表性指标———山桃(Prunusdavidiana)始花的物候数据,分析了在年际和年内时间尺度上北京地区各气候参量与植被变化之间的关系。结果显示:植物生长与温度之间的关系远比其与降水之间的关系密切;各气候参量和植被生长状况之间的关系因时间尺度而不同。1)月际水平上,具有显著生态学意义的气候指标对植被生长状况

The influence of variant PE-b-PEO segments on physical properties of LLDPE graft copolymers

A method was adopted to fix a series of polymers of PE-b-PEO with different PEO/PE segments on the chains of LLDPE. Maleic anhydride (MA) reacting with hydroxyl group of PE-b-PEO (mPE-b-PEO) was used as the intermediate. The structures of intermediates and graft copolymers were approved by H-1 NMR and FTIR. XPS analysis revealed a great amount of oxygen on the surface of grafted copolymers although the end group of PEO was fixed on the LLDPE chains through MA. Thermal properties of the graft copolymers as determined by differential scanning calorimetry (DSC) showed that PE segments in the grafted monomers could promote the heterogeneous nucleation of the polymer, increase T., and crystal growth rate.

Electrochemical designing of Au/Pt core shell nanoparticles as nanostructured catalyst with tunable activity for oxygen reduction

Au/Pt core shell nanoparticles (NPs) have been prepared via a layer-by-layer growth of Pt layers on An NPs using underpotential deposition (UPD) redox replacement technique. A single UPD Cu monolayer replacement with Pt(11) yielded a uniform Pt film on Au NPs, and the shell thickness can be tuned by controlling the number of UPD redox replacement cycles. Oxygen reduction reaction (ORR) in air-saturated 0.1 M H2SO4 was used to investigate the electrocatalytic behavior of the as-prepared core shell NPs. Cyclic voltammograms of ORR show that the peak potentials shift positively from 0.32 V to 0.48 V with the number of Pt layers increasing from one to five, suggesting the electrocatalytic activity increases with increasing the thickness of Pt shell. The increase in electrocatalytic activity may originate mostly from the large decrease of electronic influence of Au cores on surface Pt atoms. Rotating ring-disk electrode voltammetry and rotating disk electrode voltammetry demonstrate that ORR is mainly a four-electron reduction on the as-prepared modified electrode with 5 Pt layers and first charge transfer is the rate-determining step.

用于树脂传递模塑工艺的聚酰亚胺基体树脂

本文报道了两种具有稳定的低熔体黏度的有望用树脂转移模塑成形工艺的聚酰亚胺基体树脂,讨论了树脂的高温流变行为以及黏度与温度、时间的关系.

Fabrication of self-assembled palladium nanosheets using layered organic/inorganic hybrid as the template

In this paper, a simple route to the fabrication of palladium nanosheets is described. The interaction of palladium chloride (PdCl2) and n-octylamine salt resulted in the formation of a quasi-perovskite-type composite with a layered structure on a molecular scale. This composite can be employed as a template for preparing ultrathin Pd nanosheets when a {PdCl4}(2-) network is reduced in situ by hydrogen in toluene. The x-ray diffraction results indicate that the resulting Pd nanosheets are highly ordered, and they are confined inside the organic matrix as evidenced by high resolution transmission electron microscopy. These Pd nanosheets can be reorganized into layered structures in non-polarized organic solvent when the ordered structure is destroyed. This method of preparing Pd nanosheets is expected to be applicable to other layered organic/inorganic perovskite systems for obtaining the corresponding metal nanosheets.

Effect of samarium on Mn activated zinc borosilicate storage glasses

Samarium and manganese co-doped zinc borosilicate storage glasses were prepared by high temperature solid state method. The effect of doping samarium on the defect of Mn activated sample was studied by means of thermoluminescence spectra. It was found that the shallower traps of the sample predominate with the addition of samarium, as a result, the phosphorescence and storage properties of the manganese doped zinc borosilicate glasses were greatly changed.

Polyimides from isomeric biphenyltetracarboxylic dianhydrides and the effects of chemical structure on solubility

A series of homopolyimides and copolyimides was synthesized by the solution condensation of biphenyltetracarboxylic dianhydride (BPDA) isomers and various diamines followed by chemical imidization. These polyimides had intermediate to high molecular weights with inherent viscosities of 0.34-1.01 dL/g for homopolyimides and 0.48-1.02 dL/g for copolyimides. Thermogravimetric analysis indicated that the aromatic polyimides were stable up to 500degreesC, and the 5% weight loss temperatures were recorded in the range of 506-597degreesC in an air atmosphere and in the range of 517-601degreesC in a nitrogen atmosphere, depending on the diamines used. The glass transition temperatures of aromatic homopolyimides were above 271degreesC, while the glass transition temperatures of the copolyimides increased with an increase in the 2, 2', 3, 3'-BPDA-component. The effects of the chemical structure of the polymer chain on the solubility were investigated. It was found that the solubility of BPDA-based polyimides could be improved by the introduction of flexible units, nonlinear and non-coplanar units, and copolymerization. The polyimides with nonlinear and non-coplanar units derived from 2, 2', 3, 3'-BPDA appeared to have prominently enhanced solubility in polar aprotic solvents and polychlorocarbons when compared with the homopolyimide derived from 3, 3', 4, 4'-BPDA.

Stimulated emission in the film of polymer/dye blend

Optically pumped stimulated emission behavior in an organic film was demonstrated in this study. The gain material consists of a laser dye perylene doped into polystyrene (PS) matrix in an appropriate weight ratio. The sample was transversely pumped by the three harmonic output of a mode-locked Nd:YAG laser. The change of the emission spectra showed a clear threshold action and gain narrowing phenomenon when increasing the excitation intensity. Three emission peaks were observed below the excitation threshold, which are locate at 446, 475 and 506 nm, respectively. However, only the gain narrowing peak centered at 475 nm could be detected above the threshold. The spectra narrowing observed results from the amplified spontaneous emission (ASE) in the gain material. (C) 2000 Elsevier Science S.A. All rights reserved.

Synthesis, electrochemistry, and fluorescence of two Ru(phen)(3)(2+)-based surfactants

Two new Ru(phen)(3)(2+)-based surfactants, Ru(phen)(2)(phenNHCO-C-11)(PF6)(2) and Ru(phen)(2)(phenNHCO-C-17)(PF6)(2), have been designed and synthesized, whose chemical structures were characterized by means of IR, H-1 NMR and MS. Also, electrochemistry and fluorescence of them are reported.

Study on the synthesis of mixed oxide La2CuO4 and the effect on the catalytic activity to catalytic removal of NO

The mixed oxide La2CuO4 was synthesized by four different methods and characterized with XRD, BET, TEM and low angle XRD. The effect of the synthetic method on the crystal structure, crystal size, surface area and catalytic activity to NO - CO reaction were studied. The results showed that the samples derived from different methods exhibited different activity to NO-CO reaction, the reason may be that the concentration and type of oxygen defect were different when the synthetic methods were different.

La_2CuO_4的制备及其对催化消除NO活性的影响

用四种制备方法：柠檬酸络合爆炸法，聚乙二醇凝胶法，聚丙烯酰胺凝胶法，DTPA络合法合成了La2CuO4.比较了四种方法的特点及其对La2CuO4结构的影响，并对所得La2CuO4在NO-CO反应中的催化活性的影响进行了研究．结果发现聚乙二醇凝胶法和DTPA络合法有利于形成好的晶形，而聚乙二醇凝胶法和聚丙烯酰胺凝胶法对NO-CO反应有较好的活性，这是由于不同制备方法得到的样品中的缺陷的种类和含量不同所致

(η~5-C_9H_7)_2Yb(THF)_2的晶体结构

双(茚基)镱(Ⅱ)四氢呋喃配合物(η~5-C_9H_7)_2Yb(THF)_2的晶体属单斜晶系,C_c空间群,晶体学参数a=13.506(4),b=11.081(2),c=15.577(5),β=92.68(3)°,V=2329(1),D_c=1.56g/cm~3,Z=4,μ=42.4cm~(-1),F(000)=1088,最终编离因子R=0.029,R_w=0.031。中心离子Yb~(2+)与两个茚基以η~5形式成键且与两个四氢呋喃中的氧成键,茚基的两个质心和四氢呋喃中的两个氧形成扭曲的四面体,Yb~(2+)在四面体的中心。Yb~(2+)的配位数为8。Yb~(2+)到质心In1的距离为2.52,到质心In2的距离为2.40。Yb~(2+)到O(1)的键长为2.356(7),到O(2)的键长为2.417(5)。