(Table 1) Stable oxygen isotopic ratios and yearly snow accumulation of firn and ice cores from Svalbard

We analyse ice cores from Vestfonna ice cap (Nordaustlandet, Svalbard). Oxygen isotopic measurements were made on three firn cores (6.0, 11.0 and 15.5 m deep) from the two highest summits of the glacier located on the SW-NE and NW-SE central ridges. Sub-annual d18O cycles were preserved and could be counted visually in the uppermost parts of the cores, but deeper layers were affected by post-depositional smoothing. A pronounced d18O minimum was found near the bottom of the three cores. We consider candidates for this d18O signal to be a valuable reference horizon since it is also seen elsewhere in Nordaustlandet. We attribute it to isotopically depleted snow precipitation, which NCEP/NCAR reanalysis shows was unusual for Vestfonna, and came from northerly air during the cold winter of 1994/95. Finding the 1994/95 time marker allows establishment of a precise depth/age scale for the three cores. The derived annual accumulation rates indirectly fill a geographical gap in mass balance measurements and thus provide information on spatial and temporal variability of precipitation over the glacier for the period spanned by the cores (1992-2009). Comparing records at the two locations also reveals that the snow net accumulation at the easternmost part of Vestfonna was only half of that in the western part over the last 17 years.

(Table 1) Argon dating of ash layers from DSDP Hole 18-178

Ash layers from Deep Sea Drilling Project site 178 in the northeast Pacific Ocean have been dated by the 40Ar-39Ar stepwise heating technique to resolve published discrepancies concerning the length of time explosive volcanism has affected the eastern Aleutian arc and Alaskan Peninsula. The results of the investigation indicate that the record of ash-fall deposition at site 178 extends back at least 6.5 m.y. Assuming that 6.5 m.y. ago marks the onset of renewed calc-alkalic volcanism of the volcanic arc, proposed models of continuous and discontinuous motion between the Pacific and North American lithospheric plates can be evaluated. If appreciable time elapsed between the onset of subduction and the onset of arc volcanism, the 6.5-m.y. record of ash-fall deposition in the north-east Pacific is most compatible with models of continuous plate motion throughout late Cenozoic time.

(Table 1) Physical properties of ODP Site 129-801

Compressional wave velocities and densities were measured for 6 basalt samples from ODP Hole 801B and 16 samples from ODP Hole 801C, a site that represents the first drilling of Jurassic-age crustal rocks in the Pacific basin. Incremental measurements, taken to a total pressure of 200 MPa, show a systematic decrease in velocity with increasing porosity and a related increase with increasing wet-bulk density. A comparison of the plot of porosity vs. compressional wave velocity with the theoretical equation from Wyllie et al. (1958) suggests this equation is inappropriate for oceanic basalts because of mineral alteration in high porosity samples. Also of interest is the dramatic change in velocity across a hydrothermal boundary. Basalts below this hydrothermal layer have a mean velocity of 6.05 km/s at 60 MPa while those above show a mean velocity of 4.55 km/s at 60 MPa. The low velocity values of the basalts above the hydrothermal deposit may be attributed to the higher porosity and composition observed in these rocks; the higher porosity is possibly the result of increased exposure to circulating seawater.

(Table 1) Biostratigraphic datums of ODP Leg 133 sites

We use benthic foraminifers to reconstruct the Neogene paleobathymetric history of the Marion Plateau, Queensland Plateau, Townsville Trough, and Queensland Trough on the northeastern Australian margin (Ocean Drilling Program Leg 133). Western Queensland Plateau Site 811/825 (present depth, ~938 m) deepened from the neritic zone (0-200 m) to the upper bathyal zone (200-600 m) during the middle Miocene (~13-14 Ma), with further deepening into the middle bathyal zone (600-1000 m) occurring during the late Miocene (~7 Ma). A depth transect across the southern Queensland Plateau shows that deepening from the outer neritic zone (100-200 m) to the upper bathyal zone began during the latest Miocene (~6 Ma) at the deepest location (Site 813, present depth, 539.1 m), whereas the shallower Sites 812 and 814 (present depths, 461.6 and 520.4 m, respectively) deepened during the late Pliocene (~2.7 and ~2.9 Ma). At Marion Plateau Site 815 (present depth, 465.5 m), water depth increased during the late Miocene (~6.7 Ma) from the outer neritic to the upper bathyal zone. Nearby Site 816 (present water depth, 437.3 m) contains Pliocene upper bathyal assemblages that directly overlie middle Miocene shallow neritic deposits; the timing of the deepening is uncertain because of a late Miocene hiatus. On the northern slope of the Townsville Trough (Site 817, present depth, 1015.8 m), benthic foraminifers and sponge spicules indicate deepening from the lower upper bathyal (400-600 m) to the middle bathyal zone in the late Miocene (by ~6.8 Ma). Benthic foraminiferal faunas at nearby Site 818 (present water depth, 752.1 m) do not show evidence of paleobathymetric change; however, a late Pliocene (~2-3 Ma) increase in downslope transport may have been related to the drowning of the Queensland Plateau. Site 822 (present depth, 955.2 m), at the base of the Great Barrier Reef slope, deepened from the upper bathyal to the middle bathyal zone during the late Pliocene (by ~2.3 Ma). Queensland Trough Site 823 (present depth, 1638.4 m) deepened from the middle bathyal to the lower bathyal (1000-2000 m) zone during the late Miocene (~6.5 Ma). Benthic foraminiferal faunal changes at these Leg 133 sites indicate that rapid deepening occurred during the middle Miocene (~13-14 Ma), late Miocene (6-7 Ma), and late Pliocene (2-3 Ma) along the northeastern Australian margin.

Hand receipt covering contents of Components of End Items (COEI), Basic Issue Items (BII) and Additional Authorization List (AAL) for truck, cargo, 1 1/4 ton, 6 x 6, M561, national stock no. 2320-00-873-5407, truck ambulance, 1 1/4 ton, 6 x 6 M792, national stock no. 2310-00-832-9907.

"This technical manual supersedes TM 9-2320-242-10-HR, 15 December 1978"--P. i.

Direct support and general support maintenance repair parts and special tools lists : truck, cargo, 1-1/4 ton, 6X6, M792, NSN 2320-00-873-5407, truck, ambulance, 1-1/4 ton, 6X6, M561, NSN 2310-00-832-9907.

Includes index.

Organizational maintenance repair parts and special tools lists : truck, cargo, 1-1/4 ton, 6X6, M561, NSN 2320-00-873-5407, truck, ambulance, 1-1/4 ton, 6X6, M792, NSN 2310-00-832-9907.

Includes index.

Direct support and general support level : truck, cargo, 1-1/4 ton, 6X6, M561 (NSN 2320-00-873-5407), truck, ambulance, 1-1/4 ton, 6X6, M792 (NSN 2310-00-832-9907).

Includes index.