The internal wave field in Sau reservoir : Observation and modeling of a third vertical mode

Water withdrawal from Mediterranean reservoirs in summer is usually very high. Because of this, stratification is often continuous and far from the typical two-layered structure, favoring the excitation of higher vertical modes. The analysis of wind, temperature, and current data from Sau reservoir (Spain) shows that the third vertical mode of the internal seiche (baroclinic mode) dominated the internal wave field at the beginning of September 2003. We used a continuous stratification two-dimensional model to calculate the period and velocity distribution of the various modes of the internal seiche, and we calculated that the period of the third vertical mode is ;24 h, which coincides with the period of the dominating winds. As a result of the resonance between the third mode and the wind, the other oscillation modes were not excited during this period

The seasonal evolution of high vertical–mode internal waves in a deep reservoir

The causal mechanism and seasonal evolution of the internal wave field in a deep, warm, monomictic reservoirare examined through the analysis of field observations and numerical techniques. The study period extends fromthe onset of thermal stratification in the spring until midsummer in 2005. During this time, wind forcing wasperiodic, with a period of 24 h (typical of land–sea breezes), and the thermal structure in the lake wascharacterized by the presence of a shallow surface layer overlying a thick metalimnion, typical of small to mediumsized reservoirs with deep outtakes. Basin-scale internal seiches of high vertical mode (ranging from mode V3 toV5) were observed in the metalimnion. The structure of the dominant modes of oscillation changed asstratification evolved on seasonal timescales, but in all cases, their periods were close to that of the local windforcing (i.e., 24 h), suggesting a resonant response. Nonresonant oscillatory modes of type V1 and V2 becamedominant after large frontal events, which disrupted the diurnal periodicity of the wind forcing

Developing A Knowledge Management Process Model for Internal IT Organization, Case: Stora Enso Oyj, Corporate IT

The objectives of this Master’s Thesis were to find out what kind of knowledge management strategy would fit best an IT organization that uses ITIL (Information Technology Infrastructure Library) framework for IT Service Management and to create a knowledge management process model to support chosen strategy. The empirical material for this research was collected through qualitative semi-structured interviews of a case organization Stora Enso Corporate IT. The results of the qualitative interviews indicate that codification knowledge management strategy would fit best for the case organization. The knowledge management process model was created based on earlier studies and a literature of knowledge management. The model was evaluated in the interview research and the results showed that the created process model is realistic, useful, and it responds to a real life phenomenon.

El juego y su estructura interna en relación con el trabajo de la condición física en primaria = Games and their internal structure in relation to the work of physical condition in Primary Education

One of the methodological resources that teachers use in a generalised way in Physical Education classes is the game. Inthis article we define the concept of game and analyse the characteristics of their internal structure. On the other hand welook at the concepts of physical condition and conditional skills and describe the objectives of its work in Primary Education.Finally, we relate these concepts and propose two practical examples of modifying the internal structure of the game so asto produce variations in the implied conditional skills

Internal standard versus external standard calibration: an uncertainty case study of a liquid chromatography analysis

Traditionally, in the cigarettes industry, the determination of ammonium ion in the mainstream smoke is performed by ion chromatography. This work studies this determination and compares the results of this technique with the use of external and internal standard calibration. A reference cigarette sample presented measurement uncertainty of 2.0 μg/cigarette and 1.5 μg/cigarette, with external and internal standard, respectively. It is observed that the greatest source of uncertainty is the bias correction factor and that it is even more significant when using external standard, confirming thus the importance of internal standardization for this correction.

Influence of internal seedborne Fusarium semitectum on cotton seedlings

Fusarium semitectum was found to be the major seed colonizing fungus in the commercial acid delinted cotton (Gossypium hirsutum) seed lots. There was no correlation, however, between its incidence and seedling emergence and disease symptoms on the emerged seedlings in autoclaved sand. Inoculation technique simulating internally seedborne nature of the fungus showed that the observed non-correlation might be related to the threshold level of seed coat colonization. The internally seedborne inoculum besides reducing seedling emergence, incited an array of symptoms on the emerged seedlings, which ranged from negative geotropism, leaf tearing, collar rot leading to dry root rot and seedling mortality. The dry root rot continued to develop on the plants surviving the seedling phase. The collar rot symptoms can be confused with those caused by Rhizoctonia solani.

CFD Simulation of Two-phase and Three-phase Flows in Internal-loop Airlift

Airlift reactors are pneumatically agitated reactors that have been widely used in chemical, petrochemical, and bioprocess industries, such as fermentation and wastewater treatment. Computational Fluid Dynamics (CFD) has become more popular approach for design, scale-up and performance evaluation of such reactors. In the present work numerical simulations for internal-loop airlift reactors were performed using the transient Eulerian model with CFD package, ANSYS Fluent 12.1. The turbulence in the liquid phase is described using κ- ε the model. Global hydrodynamic parameters like gas holdup, gas velocity and liquid velocity have been investigated for a range of superficial gas velocities, both with 2D and 3D simulations. Moreover, the study of geometry and scale influence on the reactor have been considered. The results suggest that both, geometry and scale have significant effects on the hydrodynamic parameters, which may have substantial effects on the reactor performance. Grid refinement and time-step size effect have been discussed. Numerical calculations with gas-liquid-solid three-phase flow system have been carried out to investigate the effect of solid loading, solid particle size and solid density on the hydrodynamic characteristics of internal loop airlift reactor with different superficial gas velocities. It was observed that averaged gas holdup is significantly decreased with increasing slurry concentration. Simulations show that the riser gas holdup decreases with increase in solid particle diameter. In addition, it was found that the averaged solid holdup increases in the riser section with the increase of solid density. These produced results reveal that CFD have excellent potential to simulate two-phase and three-phase flow system.

Internal ambience of bee colonies submitted to strengthening management by adding broods

This study aimed to investigate the ideal brood area to be introduced for strengthening Apis mellifera colonies, considering variations in the hive's internal ambience. Therefore, eight colonies were equipped with data loggers for recording variations in temperature and humidity inside the hives. Then, these colonies were split in four treatments involving the swapping of four, three, two and one brood comb between strong and weak colonies. Growth in the amount of brood and food stores to the four colony strengthening treatments was assessed counting the comb cells to record changes in the brood and food area. The colonies tended to restore their normal thermoregulation within four hours after they had been manipulated and the hive cover had been closed, which quickly increased brood area in the receiving colonies. Results showed that adding up to three brood combs constitute an important alternative for strengthening Apis mellifera colonies because it did not interfere with nest thermoregulation, speeded up population growth in weak colonies and did not affect the development of strong colonies.

Internal ambience of beehives Apis mellifera with different colors and roofing materials in the sub middle of the São Francisco Valley

ABSTRACTThe current study aimed to evaluate the influence of three colors and two types of roofing materials under the internal temperature of bee colonies Apis mellifera. The experiment was conducted at the Agricultural Sciences Campus at the Federal University of Sao Francisco Valley located in Petrolina-PE, in November and December 2013, using 24 colonies housed in Langstroth hives. The experiment was a completely randomized factorial design (3x2) with three colors of box (blue, white, and traditional) and two types of cover (with and without the use of plaster) with six treatments and four replications. The internal temperature dates of the colonies were hourly recorded, during 24 hours, and surface temperatures were hourly recorded between 08h00 and 17h00. The highest values for surface and internal temperature were registered in the blue painted boxes without the use of plasterboard, and the blue painted boxes covered with plasterboard respectively. However, the lowest values ​​were found in the white painted hives and hives that have not received the plasterboard. It is recommended to paint boxes with bright colors, and the use of plasterboard had no effect in reducing the internal temperature.

On Innovative Search: the use of internal and external sources of innovation among Finnish innovators

This dissertation explores the use of internal and external sources of knowledge in modern innovation processes. It builds on a framework that combines theories such as a behavioural theory of the firm, the evolutionary theory of economic change, and modern approaches to strategic management. It follows the recent increase in innovation research focusing on the firm-level examination of innovative activities instead of traditional industry-level determinants. The innovation process is seen as a problem- and slack- driven search process, which can take several directions in terms of organizational boundaries in the pursuit of new knowledge and other resources. It thus draws on recent models of technological change, according to which firms nowadays should build their innovative activities on both internal and external sources of innovation rather than relying solely on internal resources. Four different research questions are addressed, all of which are empirically investigated via a rich dataset covering Finnish innovators collected by Statistics Finland. Firstly, the study examines how the nature of problems shapes the direction of any search for new knowledge. In general it demonstrates that the nature of the problem does affect the direction of the search, although under resource constraints firms tend to use external rather than internal sources of knowledge. At the same time, it shows that those firms that are constrained in terms of finance seem to search both internally and externally. Secondly, the dissertation investigates the relationships between different kinds of internal and external sources of knowledge in an attempt to find out where firms should direct their search in order to exploit the potential of a distributed innovation process. The concept of complementarities is applied in this context. The third research question concerns how the use of external knowledge sources – openness to external knowledge – influences the financial performance of firms. Given the many advantages of openness presented in the current literature, the focus is on how it shapes profitability. The results reveal a curvilinear relationship between profitability and openness (taking an inverted U-shape), the implication being that it pays to be open up to a certain point, but being too open to external sources may be detrimental to financial performance. Finally, the dissertation addresses some challenges in CISbased innovation research that have received relatively little attention in prior studies. The general aim is to underline the fact that comprehensive understanding of the complex process of technological change requires the constant development of methodological approaches (in terms of data and measures, for example). All the empirical analyses included in the dissertation are based on the Finnish CIS (Finnish Innovation Survey 1998-2000).