Testing extractants for Cu, Fe, Mn, and Zn in tropical soils treated with sewage sludge for 13 consecutive years

In this paper, we report on a field experiment being carried out in a Typic Eutrorthox. The experiment was initiated in the 1997-98 agricultural season as a randomized block design with four treatments (0, 5, 10, and 20 t ha -1) of sewage sludge and five replicates. Compound soil samples were obtained from 20 subsamples collected at depths of 0-0.1 and 0.1-0.2 m. Cu, Fe, Mn, and Zn concentrations were extracted with DTPA pH 7.3; 0.1 mol L -1 HCl, Mehlich-I, Mehlich-III, and 0.01 mol L-1 CaCl 2. Metal concentrations were determined via atomic absorption spectrometry. Diagnostic leaves and the whole above-ground portion of plants were collected to determine Cu, Fe, Mn, and Zn concentrations extracted by nitric-perchloric digestion and later determined via atomic absorption spectrometry. Sewage sludge application caused increases in the concentrations of soil Cu, Fe, and Mn in samples taken from the 0-0.1 m depth evaluated by the extractants Mehlich-I, Mehlich-III, 0.01 mol L-1 HCl and DTPA pH 7.3. None of the extractants provided efficient estimates of changes in Mn concentrations. The acid extractants extracted more Cu, Fe, Mn, and Zn than the saline and chelating solutions. The highest concentrations of Cu, Fe, and Zn were obtained with Mehlich-III, while the highest concentrations of Mn were obtained with HCl. We did not observe a correlation between the extractants and the concentrations of elements in the diagnostic leaves nor in the tissues of the whole maize plant (Zea mays L.). © 2013 Springer Science+Business Media Dordrecht.

The relation between structural features and electrochemical activity of MnO2 nanoparticles synthesized from a polyol-made Mn 3O4 precursor

A simple hybrid synthesis processing method was developed to synthesize γ-MnO2 nanocrystalline particles. The polyol method was modified by the addition of nitric acid in order to allow the synthesizing of single-phase Mn3O4 in a large scale. In the sequence, the acid digestion technique was used to transform Mn3O4 into γ-MnO2. Structural and morphological characterization was carried out by X-ray diffractometry, Infrared and Raman spectroscopy, thermogravimetric analysis, nitrogen adsorption isotherm, scanning electron microscopy, and transmission electron microscopy. The electrochemical properties were investigated by cyclic voltammetry and galvanostatic charge-discharge measurements. The synthesized material exhibits a specific capacitance of 125.1 F g-1 at a mass loading of 0.98 mg cm-2. The relation between structural features and electrochemical activity is discussed by comparing the synthesized material with commercial electrolytic manganese dioxide. © 2013 Springer-Verlag Berlin Heidelberg.

Intrinsic magnetic properties of BixCo2-xMnO 4 spinels obtained by short-time etching

We report the structural and magnetic properties of Co2MnO 4, partially substituted by Bi at the octahedral site. Bismuth enhances ferromagnetism due to a decrease of the Co2+-Co2+ antiferromagnetic interactions and an increase of the Mn3+-Mn 4+ exchanges. Spurious phases (magnetic and/or nonmagnetic oxides) can easily form because of the large differences between the ionic radii of Bi3+ and Co3+, hiding or altering the intrinsic physical properties of the main BixCo2-xMnO4 phase. An easy way to eliminate the secondary phases is using acid reagents. Short-time etching of Bi0.1Co1.9MnO4 using nitric acid was successfully used, keeping most of the properties of the initial compound, with no alteration of the crystallographic structure. Final stoichiometry was respected (∼Bi0.08Co1.82MnO4), meaning that the material after etching definitely contains bismuth elements in its structure and the observed properties are intrinsic to the oxide spinel. Additional experiments were performed as a function of the synthesis conditions, showing that an optimal pH value of 7 allowed the best magnetic response of the non-doped material. © 2013 Elsevier B.V. All rights reserved.

Evaluation of sample preparation procedures and krypton as an interference standard probe for arsenic speciation by HPLC-ICP-QMS

Different conditions of extraction using water, a methanol-water mixture and nitric acid solutions were evaluated for speciation of As(iii), As(v), DMA and MMA in plant samples that previously received As(v) after being sown and emergence was investigated. Microwave-assisted extraction (MAE) using diluted nitric acid solutions was also performed for arsenic extraction from chicken feed samples. The separation and determination of arsenic species were performed using HPLC-ICP-MS. The interference standard method (IFS) using 83Kr+ as the IFS probe was employed to minimize spectral interferences caused by polyatomic species, such as 40Ar 35Cl+. The extraction procedures tested presented adequate extraction efficiencies (90%), and the four arsenic species evaluated were found in plant samples. Extractions with diluted nitric acid solution at 90 °C were the most efficient strategy, with quantitative recoveries for all four As species in plant tissues. On the other hand, the methanol-water mixture was the solvent with the lowest extraction efficiency (50-60%). For chicken feed samples, MAE at 100 °C for 30 min resulted in an extraction efficiency of 97% and only As(v) was found, without any species interconversion. The IFS method contributed to improving precision and limits of detection and quantification for all tested extraction procedures. Significant improvements on accuracy were obtained by applying the IFS method and recoveries between 77 and 94%, and 82 and 93% were obtained for plant extracts and chicken feed samples, respectively. This journal is © 2013 The Royal Society of Chemistry.

Anthropogenic impacts on mineral weathering: A statistical perspective

Correspondence Analysis was adopted as tool for investigating the statistical structure of hydrochemical and weathering datasets of groundwater samples, with the main purpose of identifying impacts on mineral weathering caused by anthropogenic activities, namely fertilizing of farmlands. The hydrochemical dataset comprised measured concentrations of major inorganic compounds dissolved in groundwater, namely bicarbonate, silica (usually by-products of chemical weathering), chloride, sulphate and nitrate (typically atmospheric plus anthropogenic inputs). The weathering dataset consisted of calculated mass transfers of minerals being dissolved in loess sediments of a region located in SW Hungary (Szigetvár area), namely Na-plagioclase, calcite and dolomite, and of pollution-related concentrations of sodium, magnesium and calcium. A first run of Correspondence Analysis described groundwater composition in the study area as a system of triple influence, where spots of domestic effluents-dominated chemistries are surrounded by areas with agriculture-dominated chemistries, both imprinted over large regions of weathering dominated chemistries. A second run revealed that nitrification of N-fertilizers is promoting mineral weathering by the nitric acid reaction (anthropogenic pathway), in concurrence with the retreating of weathering by carbonic acid (natural pathway). It also indicated that dolomite and calcite are being players in a dedolomitization process driven by dissolution of gypsum fertilizers and nitrification of N-fertilizers. © 2013 Elsevier Ltd.

Potencial do eucalipto na fitorremediação de um solo contaminado por chumbo

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Características reológicas do exopolissacarídeo botiosferana produzido pelo Botryosphaeria rhodina MAMB-05 em três fontes de carbono: glucose, frutose e sacarose

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Características físico-químicas e estruturais de amidos nativos e suas dextrinas Naegeli

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Propriedades reológicas de exopolissacarídeos produzidos por bactérias dos gêneros

Pós-graduação em Engenharia e Ciência de Alimentos - IBILCE

Produção de levana e bioetanol utilizando cascas de banana por Zymomona mobilis

Pós-graduação em Engenharia e Ciência de Alimentos - IBILCE

Caracterização do efeito corona em isoladores poliméricos do tipo bastão submetidos à poluição salínica

Pós-graduação em Ciência e Tecnologia de Materiais - FC

Aplicações de secagem para o aproveitamento de resíduos da banana, visando sua aplicação na indústria

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Preparação e caracterização de sílicas mesoporosas

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Transformações estruturais em xerogéis de sílica tratados termicamente

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Aplicação de sílica organicamente modificada em sistema de extração em fase sólida de íons Cu(II), Cd(II) e Pb(II) em meio aquoso

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)