A high frequency electronic transducer for multiphase flow measurements

This paper describes an electronic transducer for multiphase flow measurement. Its high sensitivity, good signal to noise ratio and accuracy are achieved through an electrical impedance sensor with a special guard technique. The transducer consists of a wide bandwidth and high slew rate differentiator where the lead inductance and stray capacitance effects are compensated. The sensor edge effect is eliminated by using a guard electrode based on the virtual ground potential of the operational amplifier. A theoretical modeling and a calibration method are also presented. The results obtained seem to confirm the validity of the proposed technique.

Integration of Electronic Commerce and Enterprise Systems

The necessity of EC (Electronic Commerce) and enterprise systems integration is perceived from the integrated nature of enterprise systems. The proven benefits of EC to provide competitive advantages to the organizations force enterprises to adopt and integrate EC with their enterprise systems. Integration is a complex task to facilitate seamless flow of information and data between different systems within and across enterprises. Different systems have different platforms, thus to integrate systems with different platforms and infrastructures, integration technologies, such as middleware, SOA (Service-Oriented Architecture), ESB (Enterprise Service Bus), JCA (J2EE Connector Architecture), and B2B (Business-to-Business) integration standards are required. Huge software vendors, such as Oracle, IBM, Microsoft, and SAP suggest various solutions to address EC and enterprise systems integration problems. There are limited numbers of literature about the integration of EC and enterprise systems in detail. Most of the studies in this area have focused on the factors which influence the adoption of EC by enterprise or other studies provide limited information about a specific platform or integration methodology in general. Therefore, this thesis is conducted to cover the technical details of EC and enterprise systems integration and covers both the adoption factors and integration solutions. In this study, many literature was reviewed and different solutions were investigated. Different enterprise integration approaches as well as most popular integration technologies were investigated. Moreover, various methodologies of integrating EC and enterprise systems were studied in detail and different solutions were examined. In this study, the influential factors to adopt EC in enterprises were studied based on previous literature and categorized to technical, social, managerial, financial, and human resource factors. Moreover, integration technologies were categorized based on three levels of integration, which are data, application, and process. In addition, different integration approaches were identified and categorized based on their communication and platform. Also, different EC integration solutions were investigated and categorized based on the identified integration approaches. By considering different aspects of integration, this study is a great asset to the architectures, developers, and system integrators in order to integrate and adopt EC with enterprise systems.

The Finnish Electronic Library - Basic Research Infrastructure

Kristiina Hormia-Poutasen esitys KRE-konferenssissa 2013.

It’s a workflow engine. It’s working with linked data. It’s repository! – Supporting electronic thesis related processes in University of Helsinki library

Presentation at Open Repositories 2014, Helsinki, Finland, June 9-13, 2014

A DNS Bases Approach To Electronic Persistance, or "If Your Pants Fit, Why Use Suspenders?"

Presentation at Open Repositories 2014, Helsinki, Finland, June 9-13, 2014

Imbuing airborne electronic warfare self-protection : possibilities to disguise

Tutkielman nimi käännettynä suomeksi on Lentokoneiden omasuojajärjestelmien kyllästäminen – mahdollisuuksia kätkeytymiseen. Siinä keskitytään etsimään aktiivisia, ilmauhkaa kohti säteileviä keinoja ilmahyökkääjän, lentokoneen tai helikopterin, omasuojajärjestelmän harhauttamiseksi. Järjestelmät pyrkivät varoittamaan lentäjää laser- ja tutkasäteilyhavainnoista sekä ohjuksen laukaisusta ja lähestymisestä. Omasuojajärjestelmiin kuuluviin vastakeinoihin tutkimus ei keskity. Tavoitteena harhauttamisella on ilmapuolustuksen todellisen määrän ja sijainnin suojaaminen. Epätietoisuus voi saada lentäjän tekemään vääriä johtopäätöksiä. Työ ei fokusoi harhauttamisen taktiseen kehykseen työn kannalta tarpeellista määrää enempää. Tietosuojasyistä tutkimus ei käsittele käytössä olevien omasuojajärjestelmien operatiivisia ominaisuuksia vaan käsittelee teoriaa niiden taustalla. Tutkimus tehtiin käyttäen taustatutkimukselle enemmän tyypillistä kirjallisuustutkimusta. Jo tutki-muksen alkuvaiheessa oli oletettavaa, että elektronisiin sensoreihin perustuvaa omasuojajärjestelmää pystytään harhauttamaan. Systeemianalysoinnilla pyrittiin löytämään vastauksia tähän olettamukseen. Omasuojajärjestelmästä muodostettiin jo tutkimuksen varhaisessa vaiheessa malli. Tieteellistä kirjallisuutta omasuojajärjestelmistä on olemassa jonkin verran, ja niistä löydettyä tietoa omasuojajärjestelmien ominaisuuksista ja sensoreista yhdistettiin malliin niin, että siitä saatiin mahdollisimman tarkka systeemin kuvaus todellisesta omasuojajärjestelmästä. Analyysin tavoitteena oli löytää niitä kriteereitä, joilla omasuojajärjestelmä saataisiin kohtuullisen tehokkaasti uskomaan harhautusta oikeaksi hälytykseksi. Ohjuksen laukaisusta varoittava sensori perustuu ohjuksen moottorin muodostaman pilven lämpö-säteilyyn. Säteily kuitenkin muuttuu lennon eri vaiheissa, mikä tuottaa haasteita järjestelmälle. Millimetrialueen tutkan käyttö varoittimen sensorina on myös yksi vaihtoehto. Laser-varoittimet toimivat koko sillä taajuusalueella, mitä sotilaskäytössä tulenjohtamiseen ja ohjusten ohjaamiseen käytetään. Tutkavaroittimen tutkimus on vielä kesken. Löydettyjä tuloksia analysoimalla tulen tässä vaiheessa hieman ristiriitaisiin tuloksiin. Lämpösäteilyn käytön suurin haaste on sen eteneminen ilmakehässä. Varoittimen tavoitekaan ei ole toimia kymmentä kilometriä pidemmälle. Yksi mahdollinen ratkaisu on suunnitella ja toteuttaa raketti, jonka tuottaa lämpösäteilyä kuten tietty puolustavan joukon käytössä oleva ohjus. Jos koneessa on kuitenkin myös millimetrialueen tutka tukemassa varoitusjärjestelmää, hankaloituu rakettiharhautus merkittävästi, koska sen pitäisi oletettavasti olla lentokoneen kanssa melko tarkasti kohtaavalla reitillä. Laser-varoitin on ilmeisesti herkin järjestelmistä, koska se voi tietyissä olosuhteissa ja varsinkin matalalla lentokorkeudella aiheuttaa paljon vääriä hälytyksiä ilman tarkoituksellista harhauttamista. Laserin käyttö yhdistettynä raketin laukaisuun saattaisi tuottaa halutun tuloksen. Tutkavaroittimen harhautus onnistuu, jos valelaitteen signaali on uskottavan tarkka.

An electronic pressure-meter nociception paw test for rats

The objective of the present investigation was to compare the sensitivity of an electronic nociceptive mechanical paw test with classical mechanical tests to quantify the intensity variation of inflammatory nociception. The electronic pressure-meter test consists of inducing the hindpaw flexion reflex by poking the plantar region with a polypropylene pipette tip adapted to a hand-held force transducer. This method was compared with the classical von Frey filaments test and with the rat paw constant pressure test, a modification of the Randall and Selitto test developed by our group. When comparing the three methods, the electronic pressure-meter and the rat paw constant pressure test, but not the von Frey filaments test, detected time vs treatment interactions in prostaglandin E2 (PGE2)-induced hypernociception. Both methods also detected the PGE2-induced hypernociception in dose- (50-400 ng/paw) and time- (1-4 h) dependent manners, and time vs treatment interactions induced by carrageenin (25-400 µg/paw). Furthermore, the electronic pressure-meter test was more sensitive at early times, whereas the constant pressure test was more sensitive at later times. Moreover, the electronic pressure-meter test detected the dose-dependent antinociceptive effect of local indomethacin (30-300 µg/paw) and dipyrone (80-320 µg/paw) on carrageenin- (200 µg/paw) and PGE2- (100 ng/paw) induced hypernociception, respectively, and also detected the ineffectiveness of indomethacin (300 µg) on the effect of PGE2. Our results show that the electronic pressure-meter provides a sensitive, objective and quantitative mechanical nociceptive test that could be useful to characterize new nociceptive inflammatory mediators and also to evaluate new peripheral analgesic substances.

An electronic pressure-meter nociception paw test for mice

The aim of the present investigation was to describe and validate an electronic mechanical test for quantification of the intensity of inflammatory nociception in mice. The electronic pressure-meter test consists of inducing the animal hindpaw flexion reflex by poking the plantar region with a polypropylene pipette tip adapted to a hand-held force transducer. This method was compared to the classical von Frey filaments test in which pressure intensity is automatically recorded after the nociceptive hindpaw flexion reflex. The electronic pressure-meter and the von Frey filaments were used to detect time versus treatment interactions of carrageenin-induced hypernociception. In two separate experiments, the electronic pressure-meter was more sensitive than the von Frey filaments for the detection of the increase in nociception (hypernociception) induced by small doses of carrageenin (30 µg). The electronic pressure-meter detected the antinociceptive effect of non-steroidal drugs in a dose-dependent manner. Indomethacin administered intraperitoneally (1.8-15 mg/kg) or intraplantarly (30-300 µg/paw) prevented the hypersensitive effect of carrageenin (100 µg/paw). The electronic pressure-meter also detected the hypernociceptive effect of prostaglandin E2 (PGE2; 10-100 ng) in a dose-dependent manner. The hypernociceptive effect of PGE2 (100 ng) was blocked by dipyrone (160 and 320 µg/paw) but not by intraplantar administration of indomethacin (300 µg/paw). The present results validate the use of the electronic pressure-meter as more sensitive than the von Frey filaments in mice. Furthermore, it is an objective and quantitative nociceptive test for the evaluation of the peripheral antinociceptive effect of anti-inflammatory analgesic drugs, which inhibit prostaglandin synthesis (indomethacin) or directly block the ongoing hypernociception (dipyrone).

Value creation through sponsorship in electronic sports

The objective of this thesis was to study value creation through sponsor-ship in a new emerging electronic sports environment. Sub-questions were formulated which helped in finding answers to the main research question. Theory of traditional sports and practice of electronic sports were compared with each other in order to find out how theories of tradi-tional sports fare in the new environment. B2B-relationship model of Actors, resources and activities is used in this thesis to help in clarifying the different variables used in electronic sports sponsorship environment. The empirical research was conducted via interviews with the managers working in electronic sports environment. One of the main conclusions is that relationship management is really important.. Actors in electronic sports need to find and create win-win-win situations. This means that they need to benefit the actors in sponsoring relationship and also the community.

First-principles study on electronic and structural properties of Cu(In/Ga)Se alloys for solar cells

Thin-film photovoltaic solar cells based on the Cu(In1−xGax)Se2 (CIGS) alloys have attracted more and more attention due to their large optical absorption coefficient, long term stability, low cost, and high efficiency. Modern theoretical studies of this material with first-principles calculations can provide accurate description of the electronic structure and yield results in close agreement with experimental values, but takes a large amount of calculation time. In this work, we use first-principles calculations based on the computationally affordable meta- generalized gradient approximation of the density-functional theory to investigate electronic and structural properties of the CIGS alloys. We report on the simulation of the lattice parameters and band gaps, as a function of chemical composition. The obtained results were found to be in a good agreement with the available experimental data.