利用相互染色体涂色技术分析两株人肺腺癌细胞系(A549和GLC-82)的核型特征(英文)

肺癌是全世界癌症死亡中的一个主要的原因。除吸烟外,一些肺癌患者的发病与氡气污染相关。该研究采用包括染色体分选、正向和反向染色体涂色技术,分析了两株肺腺癌细胞系A549和GLC-82的核型特征。A549和GLC-82细胞系都属于非小细胞肺癌细胞系,但诱因不同,后者来源于一个长期生活在氡气污染环境肺癌病人的癌组织。染色体涂色结果表明,这两株肺癌细胞系发生了复杂的染色体重排。在A549和GLC-82细胞系中,除正常染色体拷贝数变化外,还分别存在13条和24条畸变染色体。约一半的畸变染色体是通过非相互易位形成的,其余的畸变染色体则是通过一些正常染色体的片段缺失或重复而产生的。尽管这两株肺癌细胞系都没有共同的畸变染色体,但它们似共享两个染色体易位断裂点:HSA8q24和12q14。

The effect of increase in the number of fishing trips on the economic efficiency of 9.82 m and 11 m fishing trawlers along Kerala coast

Cost-benefit analysis of a 9.82 m and 11 m fishing trawlers based on the number of fishing trips is presented. The number of fishing trips per year determines the profit and loss of the trawler. With the increase in the number of fishing trips, the profit also increase for both the sizes of trawlers. The minimum quantity of prawn and fish to be landed for 0-20% profit for varying number of fishing trips are worked out. The break-even for 9.82 and 11m trawlers was observed to be 185 and 210 fishing trips respectively during 1980-81.

Paraphyly of Chinese Amolops (Anura, Ranidae) and phylogenetic position of the rare Chinese frog, Amolops tormotus

In order to evaluate the five species groups of Chinese Amolops based on morphological characteristics, and to clarify the phylogenetic position of the concave-eared torrent frog Amolops tormotus, we investigated the phylogeny of Amolops by maximum parsim

Adaptive control of stiffness to stabilize hand position with large loads.

The goal of this work was to investigate stability in relation to the magnitude and direction of forces applied by the hand. The endpoint stiffness and joint stiffness of the arm were measured during a postural task in which subjects exerted up to 30% maximum voluntary force in each of four directions while controlling the position of the hand. All four coefficients of the joint stiffness matrix were found to vary linearly with both elbow and shoulder torque. This contrasts with the results of a previous study, which employed a force control task and concluded that the joint stiffness coefficients varied linearly with either shoulder or elbow torque but not both. Joint stiffness was transformed into endpoint stiffness to compare the effect on stability as endpoint force increased. When the joint stiffness coefficients were modeled as varying with the net torque at only one joint, as in the previous study, we found that hand position became unstable if endpoint force exceeded about 22 N in a specific direction. This did not occur when the joint stiffness coefficients were modeled as varying with the net torque at both joints, as in the present study. Rather, hand position became increasingly more stable as endpoint force increased for all directions of applied force. Our analysis suggests that co-contraction of biarticular muscles was primarily responsible for the increased stability. This clearly demonstrates how the central nervous system can selectively adapt the impedance of the arm in a specific direction to stabilize hand position when the force applied by the hand has a destabilizing effect in that direction.

The morphology of decorated amyloid fibers is controlled by the conformation and position of the displayed protein.

Self-assembled structures capable of mediating electron transfer are an attractive scientific and technological goal. Therefore, systematic variants of SH3-Cytochrome b(562) fusion proteins were designed to make amyloid fibers displaying heme-b(562) electron transfer complexes. TEM and AFM data show that fiber morphology responds systematically to placement of b(562) within the fusion proteins. UV-vis spectroscopy shows that, for the fusion proteins under test, only half the fiber-borne b(562) binds heme with high affinity. Cofactor binding also improves the AFM imaging properties and changes the fiber morphology through changes in cytochrome conformation. Systematic observations and measurements of fiber geometry suggest that longitudinal registry of subfilaments within the fiber, mediated by the interaction and conformation of the displayed proteins and their interaction with surfaces, gives rise to the observed morphologies, including defects and kinks. Of most interest is the role of small molecule modulation of fiber structure and mechanical stability. A minimum complexity model is proposed to capture and explain the fiber morphology in the light of these results. Understanding the complex interplay between these factors will enable a fiber design that supports longitudinal electron transfer.

Phylogenetic analysis of the family Thermaceae with an emphasis on signature position and secondary structure of 16S rRNA

The sequences of the 16S rRNA genes from 38 strains of the family Thermaceae were compared by alignment analysis. The genus-specific and species-specific base substitutions or base deletions (signature positions) were found in three hypervariable regions (in the helices 6, 10 and 17). The differentiation of secondary structures of the high variable regions in the 5' end (38-497) containing several signature positions further supported the concept. Based on the comparisons of the secondary structures in the segments of 16S rRNAs, a key to the species of the family Thermaceae was proposed. (C) 2003 Published by Elsevier Science B.V. on behalf of the Federation of European Microbiological Societies.

Characterization and control of a pneumatic microactuator with an integrated inductive position sensor

As the intelligence and the functionality of microrobots increase, there is a growing need to incorporate sensors into these robots. In order to limit the outer dimensions of these microsystems, this research investigates sensors that can be integrated efficiently into microactuators. Here, a pneumatic piston-cylinder microactuator with an integrated inductive position sensor was developed. The main advantage of pneumatic actuators is their high force and power density at microscale. The outside diameter of the actuator is 1.3 mm and the length is 15 mm. The stroke of the actuator is 12 mm, and the actuation force is 1 N at a supply pressure of 1.5 MPa. The position sensor consists of two coils wound around the cylinder of the actuator. The measurement principle is based on the change in coupling factor between the coils as the piston moves in the actuator. The sensor is extremely small since one layer of 25 μm copper wire is sufficient to achieve an accuracy of 10 μm over the total stroke. Position tests with a PI controller and a sliding mode controller showed that the actuator is able to position with an accuracy up to 30 μm. Such positioning systems offer great opportunities for all devices that need to control a large number of degrees of freedom in a restricted volume. © 2007 Elsevier B.V. All rights reserved.

User target intention recognition from cursor position using kalman filter

This paper discusses user target intention recognition algorithms for pointing - clicking tasks to reduce users' pointing time and difficulty. Predicting targets by comparing the bearing angles to targets proposed as one of the first algorithms [1] is compared with a Kalman Filter prediction algorithm. Accuracy and sensitivity of prediction are used as performance criteria. The outcomes of a standard point and click experiment are used for performance comparison, collected from both able-bodied and impaired users. © 2013 Springer-Verlag Berlin Heidelberg.

The complete mitochondrial DNA sequence and the phylogenetic position of Achalinus meiguensis (Reptilia: Squamata)

The mitochondrial genome complete sequence of Achalinus meiguensis was reported for the first time in the present study. The complete mitochondrial genome of A. meiguensis is 17239 bp in length and contains 13 protein-coding genes, 22 tRNA, 2 rRNA, and 2 non-coding regions (Control regions). On the basis of comparison with the other complete mitochondrial sequences reported, we explored the characteristic of structure and evolution. For example, duplication control regions independently occurred in the evolutionary history of reptiles; the pseudo-tRNA of snakes occurred in the Caenophidia; snake is shorter than other vertebrates in the length of tRNA because of the truncations of T psi C arm (less than 5 bp) and "DHU" arm. The phylogenic analysis by MP and BI analysis showed that the phylogenetic position of A. meiguensis was placed in Caenophidia as a sister group to other advanced snakes with the exclusion of Acrochordus granulatus which was rooted in the Caenophidia. Therefore we suggested that the subfamily Xenodermatinae, which contains A. meiguensis, should be raised to a family rank or higher rank. At the same time, based on the phylogenic statistic test, the tree of Bayesian was used for estimating the divergence time. The results showed that the divergence time between Henophidia and Caenophidia was 109.50 Mya; 106.18 Mya for divergence between Acrochordus granulatus and the other snakes of the Caenophidia; the divergence time of A. meiguensis was 103 Mya, and Viperidae diverged from the unilateral of Elapidae and Colubridae was 96.06 Mya.

Vulnerability assessment of buildings subject to tunnel-induced settlements: the influence of orientation and position of the building

The assessment of settlement induced damage on buildings during the preliminary phase of tunnel excavation projects, is nowadays receiving greater attention. Analyses at different levels of detail are performed on the surface building in proximity to the tunnel, to evaluate the risk of structural damage and the need of mitigation measures. In this paper, the possibility to define a correlation between the main parameters that influence the structural response to settlement and the potential damage is investigated through numerical analysis. The adopted 3D finite element model allows to take into account important features that are neglected in more simplified approaches, like the soil-structure interaction, the nonlinear behaviour of the building, the three dimensional effect of the tunnelling induced settlement trough and the influence of openings in the structure. Aim of this approach is the development of an improved classification system taking into account the intrinsic vulnerability of the structure, which could have a relevant effect on the final damage assessment. Parametric analyses are performed, focusing on the effect of the orientation and the position of the structure with respect to the tunnel. The obtained results in terms of damage are compared with the Building Risk Assessment (BRA) procedure. This method was developed by Geodata Engineering (GDE) on the basis of empirical observations and building monitoring and applied during the construction of different metro lines in urban environment. The comparison shows a substantial agreement between the two procedures on the influence of the analysed parameters. The finite element analyses suggest a refinement of the BRA procedure for pure sagging conditions.

Growth of CeO2 : Bi12SiO20 crystals in multi-position furnace(II) - Space growth experiment

Ce-doped Bi12SiO20 single crystal with size of phi10mm x 40mm was successfully grown in space on board of the spacecraft Shenzhou No.3. The surface morphology of space-grown crystal is different from that of ground-grown crystal The space- and ground-grown crystals were measured by X-ray rocking curves, absorption spectra and micro-Raman spectra. The results show that the quality of Ce-deped crystal grown in space is better than that of the ground-grown one. The effect of doping on optical properties of BSO grown in space is evident in comparison with the ground-grown crystal.