Workers' compensation in the United States: high costs, low benefits

Studies suggest that income replacement is low for many workers with serious occupational injuries and illnesses. This review discusses three areas that hold promise for raising benefits to workers while reducing workers' compensation costs to employers: improving safety, containing medical costs, and reducing litigation. In theory, workers' compensation increases the costs to employers of injuries and so provides incentives to improve safety. Yet, taken as a whole, research does not provide convincing evidence that workers' compensation reduces injury rates. Moreover, unlike safety and health regulation, workers' compensation focuses the attention of employers on individual workers. High costs may lead employers to discourage claims and litigate when claims are filed. Controlling medical costs can reduce workers' compensation costs. Most studies, however, have focused on costs and have not addressed the effectiveness of medical care or patient satisfaction. Research also has shown that workers' compensation systems can reduce the need for litigation. Without litigation, benefits can be delivered more quickly and at lower costs.

Cerebellar Learning in an Opponent Motor Controller for Adaptive Load Compensation and Synergy Formation

This paper shows how a minimal neural network model of the cerebellum may be embedded within a sensory-neuro-muscular control system that mimics known anatomy and physiology. With this embedding, cerebellar learning promotes load compensation while also allowing both coactivation and reciprocal inhibition of sets of antagonist muscles. In particular, we show how synaptic long term depression guided by feedback from muscle stretch receptors can lead to trans-cerebellar gain changes that are load-compensating. It is argued that the same processes help to adaptively discover multi-joint synergies. Simulations of rapid single joint rotations under load illustrates design feasibility and stability.

Phase estimation receiver for full-field detection: a novel receiver structure for electronic dispersion compensation of metropolitan area networks

The development of ultra high speed (~20 Gsamples/s) analogue to digital converters (ADCs), and the delayed deployment of 40 Gbit/s transmission due to the economic downturn, has stimulated the investigation of digital signal processing (DSP) techniques for compensation of optical transmission impairments. In the future, DSP will offer an entire suite of tools to compensate for optical impairments and facilitate the use of advanced modulation formats. Chromatic dispersion is a very significant impairment for high speed optical transmission. This thesis investigates a novel electronic method of dispersion compensation which allows for cost-effective accurate detection of the amplitude and phase of the optical field into the radio frequency domain. The first electronic dispersion compensation (EDC) schemes accessed only the amplitude information using square law detection and achieved an increase in transmission distances. This thesis presents a method by using a frequency sensitive filter to estimate the phase of the received optical field and, in conjunction with the amplitude information, the entire field can be digitised using ADCs. This allows DSP technologies to take the next step in optical communications without requiring complex coherent detection. This is of particular of interest in metropolitan area networks. The full-field receiver investigated requires only an additional asymmetrical Mach-Zehnder interferometer and balanced photodiode to achieve a 50% increase in EDC reach compared to amplitude only detection.

Becoming a CEO: an exploration of the theory and practice of effective organisational leadership

This Thesis is an exploration of potential enhancement in effectiveness, personally, professionally and organisationally through the use of Theory as an Apparatus of Thought. Enhanced effectiveness was sought by the practitioner (Subject), while in transition to becoming Chief Executive of his organization. The introduction outlines the content and the structure of the University College Cork DBA. Essay One outlines what Theory is, what Adult Mental Development is and an exploration of Theories held in the Authors past professional practice. Immunity to change is also reflected on. Essay Two looks at the construct of the key Theories used in the Thesis. Prof. Robert Kegan’s Theory of Adult Mental Development was used to aid the generation of insight. The other key Theories used were The Theory of The Business, Theory of the Co‐operative and a Theory of Organisational Leadership. Essay Three explores the application of the key Theories in a professional setting. The findings of the Thesis were that the subject was capable of dealing with increased environmental complexity and uncertainty by using Theory as an Apparatus of Thought, which in turn enhanced personal, professional and organisational effectiveness. This was achieved by becoming more aware of the Theories held by the practitioner, the experiences from the application of those Theories, which then led to greater insight. The author also found that a detailed understanding of the Theory of the Business and a Theory of Leadership would support any new CEO in the challenging early part of their tenure.

Burst-mode electronic dispersion compensation in long reach PONs

Long reach passive optical networks (LR-PONs), which integrate fibre-to-the-home with metro networks, have been the subject of intensive research in recent years and are considered one of the most promising candidates for the next generation of optical access networks. Such systems ideally have reaches greater than 100km and bit rates of at least 10Gb/s per wavelength in the downstream and upstream directions. Due to the limited equipment sharing that is possible in access networks, the laser transmitters in the terminal units, which are usually the most expensive components, must be as cheap as possible. However, the requirement for low cost is generally incompatible with the need for a transmitter chirp characteristic that is optimised for such long reaches at 10Gb/s, and hence dispersion compensation is required. In this thesis electronic dispersion compensation (EDC) techniques are employed to increase the chromatic dispersion tolerance and to enhance the system performance at the expense of moderate additional implementation complexity. In order to use such EDC in LR-PON architectures, a number of challenges associated with the burst-mode nature of the upstream link need to be overcome. In particular, the EDC must be made adaptive from one burst to the next (burst-mode EDC, or BM-EDC) in time scales on the order of tens to hundreds of nanoseconds. Burst-mode operation of EDC has received little attention to date. The main objective of this thesis is to demonstrate the feasibility of such a concept and to identify the key BM-EDC design parameters required for applications in a 10Gb/s burst-mode link. This is achieved through a combination of simulations and transmission experiments utilising off-line data processing. The research shows that burst-to-burst adaptation can in principle be implemented efficiently, opening the possibility of low overhead, adaptive EDC-enabled burst-mode systems.

Design of differential amplifier with negative impedance compensation

Design of differential amplifier with high gain accuracy and high linearity is presented in the paper. The amplifier design is based on the negative impedance compensation technique reported by the authors in [1]. A negative impedance with high precision, low sensitivity, wide input signal range and simple structure is used for the compensation of differential amplifier. Analysis and simulation results show that gain accuracy and linearity can be improved significantly with the negative impedance compensation

Stability analysis of the amplifier with negative impedance compensation

A novel amplifier design technique based on negative impedance compensation has been proposed in our recent paper. In this paper, we investigate the stability of this amplifier system. The parameter space approach has been used to determine system parameters in the negative impedance circuit such that the stability of the amplifier system can be guaranteed in a certain region represented by those parameters. The simulation results have demonstrated that stable circuit behavior for the amplifier can be achieved

Challenges to Slovakia and Poland health policy decisions: use of investment treaties to claim compensation for reversal of privatisation/liberalisation policies

Investment treaties, and possibly the EU Treaty itself, are being used by multinational companies Penta and Eureko to try and force the Slovak government to pay compensation for reversing health privatisation and liberalisation policies. Similar action has been used against the Polish government by Eureko to win compensation worth nearly 2 billion Euros and a policy commitment to further privatisation.

Automated analysis of non-mass-enhancing lesions in breast MRI based on morphological, kinetic, and spatio-temporal moments and joint segmentation-motion compensation technique

Dynamic contrast-enhanced magnetic resonance imaging (DCE-MRI) represents an established method for the detection and diagnosis of breast lesions. While mass-like enhancing lesions can be easily categorized according to the Breast Imaging Reporting and Data System (BI-RADS) MRI lexicon, a majority of diagnostically challenging lesions, the so called non-mass-like enhancing lesions, remain both qualitatively as well as quantitatively difficult to analyze. Thus, the evaluation of kinetic and/or morphological characteristics of non-masses represents a challenging task for an automated analysis and is of crucial importance for advancing current computer-aided diagnosis (CAD) systems. Compared to the well-characterized mass-enhancing lesions, non-masses have no well-defined and blurred tumor borders and a kinetic behavior that is not easily generalizable and thus discriminative for malignant and benign non-masses. To overcome these difficulties and pave the way for novel CAD systems for non-masses, we will evaluate several kinetic and morphological descriptors separately and a novel technique, the Zernike velocity moments, to capture the joint spatio-temporal behavior of these lesions, and additionally consider the impact of non-rigid motion compensation on a correct diagnosis.