Mineral and chemical compositions of clay sediments from the Pacific Ocean, DSDP data

Mineral and chemical compositions, as well as conditions of formation of clay sediments in major structural elements of the Pacific Ocean floor with different ages are under consideration in the monograph. Depending on evolution of the region two ways of clay sediment formation are identified: terrigenous and authigenic. It is shown that terrigenous clay sediments predominate in marginal parts of the Pacific Ocean. Authigenic mineral formation occurring in the basal part of the sedimentary cover primarily results from removal of material from underlying basalts. This material is released during secondary alteration of the basalts due to their interaction with sea water, as well as with deep solutions.

Composition of bottom sediments, rocks, and ores from the Tropical Atlantic

Geological features of some areas of the Tropical Atlantic (stratigraphy, tectonic structure, lithology, distribution of ore components in bottom sediments, petrography of bedrocks, etc.) are under consideration in the book. Regularities of concentration of trace elements in iron-manganese nodules, features of these nodules in bottom sediments, distribution of phosphorite nodules and other phosphorites have been studied. Much attention is paid to rocks of the ocean crust. A wide range of mineralization represented by magnetite, chromite, chalcopyrite, pyrite, pentlandite, and other minerals has been found.

Ice rafte debris of ODP Hole 178-1101A

Sediment drifts on the continental rise west of the Antarctic Peninsula received fine-grained sediment and ice-rafted debris (IRD) directly from the continental shelf and thus indirectly record the history of West Antarctic glaciation. Site 1101 contains a 218-m-thick, nearly continuous section extending from the late Pliocene to the Holocene. To assess the presence of calving glaciers at sea level in the Antarctic Peninsula region, the mass accumulation rate (MAR) of IRD was calculated using the weight percent terrigenous sand fraction (250 µm to 2 mm). IRD MAR is cyclic throughout, with small peaks alternating with periods of low or no IRD. Many cycles have a sawtooth pattern that increases gradually to the peak then abruptly decreases to zero. This pattern is consistent with rapid disintegration of ice streams and release of icebergs from the continental shelf. Three unusually large peaks (three to five times the size of other peaks) occurred at approximately 2.8, 1.9, and 0.88 Ma and indicate periods of intense ice rafting. Lithofacies were described in detail using X-radiographs and core descriptions for the interval from 1.34 to 0.54 Ma. Glacial units are represented by thickly laminated mud deposited by distal turbidites and meltwater plumes. Less commonly, thinly laminated sediment formed by contour currents and diamicton by intense ice rafting. Interglacials are represented by foraminifer-bearing mud with IRD. Ice rafting appears to have increased in the later part of the glacial period and remained high in the interglacial period.

Uranium and radioactive isotopes in bottom sediments and Fe-Mn nodules and crusts of seas and oceans

The main stages of the sedimentary cycle of uranium in modern marine basins are under consideration in the book. Annually about 18 thousand tons of dissolved and suspended uranium enters the ocean with river runoff. Depending on a type of a marine basin uranium accumulated either in sediments of deep-sea basins, or in sediments of continental shelves and slopes. In the surface layer of marine sediments hydrogenic uranium is predominantly bound with organic matter, and in ocean sediments also with iron, manganese and phosphorus. In diagenetic processes there occurs partial redistribution of uranium in sediments, as well as its concentration in iron-manganese, phosphate and carbonate nodules and biogenic phosphate detritus. Concentration of uranium in marine sediments of various types depending on their composition, as well as on forms of its entering, degree of differentiation and of sedimentation rates, on hydrochemical regime and water circulation, and on intensity of diagenetic processes.

Sedimentological, biogeomcial and geochronological data of thermokarst lake sediment core PG1967

Ice-rich permafrost landscapes are sensitive to climate and environmental change due to the melt-out of ground ice during thermokarst development. Thermokarst processes in the northern Yukon Territory are currently not well-documented. Lake sediments from Herschel Island (69°36'N; 139°04'W) in the western Canadian Arctic provide a record of thermokarst lake development since the early Holocene. A 727 cm long lake sediment core was analyzed for radiographic images, magnetic susceptibility, granulometry, and biogeochemical parameters (organic carbon, nitrogen, and stable carbon isotopes). Based on eight calibrated AMS radiocarbon dates, the sediment record covers the last ~ 11,500 years and was divided into four lithostratigraphic units (A to D) reflecting different thermokarst stages. Thermokarst initiation at the study area began ~ 11.5 cal ka BP. From ~ 11.5 to 10.0 cal ka BP, lake sediments of unit A started to accumulate in an initial lake basin created by melt-out of massive ground ice and thaw subsidence. Between 10.0 and 7.0 cal ka BP (unit B) the lake basin expanded in size and depth, attributed to talik formation during the Holocene thermal maximum. Higher-than-modern summer air temperatures led to increased lake productivity and widespread terrain disturbances in the lake's catchment. Thermokarst lake development between 7.0 and 1.8 cal ka BP (unit C) was characterized by a dynamic equilibrium, where lake basin and talik steadily expanded into ambient ice-rich terrain through shoreline erosion. Once lakes become deeper than the maximum winter lake ice thickness, thermokarst lake sediments show a great preservation potential. However, site-specific geomorphic factors such as episodic bank-shore erosion or sudden drainage through thermo-erosional valleys or coastal erosion breaching lake basins can disrupt continuous deposition. A hiatus in the record from 1.8 to 0.9 cal ka BP in Lake Herschel likely resulted from lake drainage or allochthonous slumping due to collapsing shore lines before continuous sedimentation of unit D recommenced during the last 900 years.

Index properties, calcium carbonate content and opal concentration of ODP Core 167-1016B-17H sediments

Physical properties measurements provide a relatively inexpensive and fast way to obtain high-resolution estimates of the variations in sedimentological properties. To better resolve the validity and cause of the geophysical signals measured by the Ocean Drilling Program (ODP) shipboard multisensor track (MST) instruments, 223 x 10 cm**3 core samples were collected at 4 cm intervals in Core 167-1016B-17H at the California Margin Conception Transect for the measurements of index properties, carbonate content, and opal content. This core was chosen because hole-to-hole stratigraphic correlation of MST data suggested that Core 17H corresponds to a depth interval that displays the greatest range of amplitude of many physical properties.

Contents, partition, and isotopic composition of sulphur in sediments from ODP Sites 680 and 686

We have determined (1) the abundance and isotopic composition of pyrite, monosulphide, elemental sulphur, organically bound sulphur, and dissolved sulphide; (2) the partition of ferric and ferrous iron; (3) the organic carbon contents of sediments recovered at two sites drilled on the Peru Margin during Leg 112 of the Ocean Drilling Program. Sediments at both sites are characterised by high levels of organically bound sulphur (OBS). OBS comprises up to 50% of total sedimentary sulphur and up to 1% of bulk sediment. The weight ratio of S to C in organic matter varies from 0.03 to 0.15 (mean = 0.10). Such ratios are like those measured in lithologically similar, but more deeply buried petroleum source rocks of the Monterey and Sisquoc formations in California. The sulphur content of organic matter is not limited by the availability of porewater sulphide. Isotopic data suggest that sulphur is incorporated into organic matter within a metre of the sediment surface, at least partly by reaction with polysulphides. Most inorganic Sulphur occurs as pyrite. Pyrite formation occurred within surface sediments and was limited by the availability of reactive iron. But despite highly reducing sulphidic conditions, only 35-65% of the total iron was converted to sulphide; 10-30% of the total iron still occurs as Fe(III). In surface sediments, the isotopic composition of pyrite is similar to that of both iron monosulphide and dissolved sulphide. Either pyrite, like monosulphide, formed by direct reaction between dissolved sulphide and detrital iron, and/or the sulphur species responsible for converting FeS to FeS2 is isotopically similar to dissolved sulphide. Likely stoichiometries for the reaction between ferric iron and excess sulphide imply a maximum resulting FeS2:FeS ratio of 1:1. Where pyrite dominates the pool of iron sulphides, at least some pyrite must have formed by reaction between monosulphide and elemental sulphur and/or polysulphide. Elemental sulphur (S°) is most abundant in surface sediments and probably formed by oxidation of sulphide diffusing across the sediment-water interface. In surface sediments, S° is isotopically heavier than dissolved sulphide, FeS and FeS2 and is unlikely to have been involved in the conversion of FeS to FeS2. Polysulphides are thus implicated as the link between FeS and FeS2.

Composition of marine phosphorites and phosphate-bearing sediments

The book deals with behavior of phosphorus and its concentration in oceanic phosphorites. The major stages of marine geochemical cycle of phosphorus including its supply to sedimentary basins, precipitation from sea water, distribution and speciation in bottom sediments, diagenetic redistribution, and relation to other elements are under consideration. Formation of recent phosphorites as a culmination of phosphate accumulation in marine and oceanic sediments is examined. Distribution, structure, mineral and chemical compositions of major phosphorite deposits of various age on continental margins, as well as on submarine plateaus, uplifts and seamounts and some islands are described. A summary of trace element abundances in oceanic phosphorites is presented. Problems of phosphorite origin are discussed.