A framework of Dynamic Difficulty Adjustment in competitive multiplayer video games

The balance between player competence and the challenge presented by a task has been acknowledged as a major factor in providing optimal experience in video games. While Dynamic Difficulty Adjustment (DDA) presents methods for adjusting difficulty in real-time during singleplayer games, little research has explored its application in competitive multiplayer games where challenge is dictated by the competence of human opponents. By conducting a formal review of 180 existing competitive multiplayer games, it was found that a large number of modern games are utilizing DDA techniques to balance challenge between human opponents. From this data, we propose a preliminary framework for classifying Multiplayer Dynamic Difficulty Adjustment (mDDA) instances.

Setting water quality objectives for the health of freshwater fish

An important responsibility of the Environment Protection Authority, Victoria, is to set objectives for levels of environmental contaminants. To support the development of environmental objectives for water quality, a need has been identified to understand the dual impacts of concentration and duration of a contaminant on biota in freshwater streams. For suspended solids contamination, information reported by Newcombe and Jensen [ North American Journal of Fisheries Management , 16(4):693--727, 1996] study of freshwater fish and the daily suspended solids data from the United States Geological Survey stream monitoring network is utilised. The study group was requested to examine both the utility of the Newcombe and Jensen and the USA data, as well as the formulation of a procedure for use by the Environment Protection Authority Victoria that takes concentration and duration of harmful episodes into account when assessing water quality. The extent to which the impact of a toxic event on fish health could be modelled deterministically was also considered. It was found that concentration and exposure duration were the main compounding factors on the severity of effects of suspended solids on freshwater fish. A protocol for assessing the cumulative effect on fish health and a simple deterministic model, based on the biology of gill harm and recovery, was proposed. References D. W. T. Au, C. A. Pollino, R. S. S Wu, P. K. S. Shin, S. T. F. Lau, and J. Y. M. Tang. Chronic effects of suspended solids on gill structure, osmoregulation, growth, and triiodothyronine in juvenile green grouper epinephelus coioides . Marine Ecology Press Series , 266:255--264, 2004. J.C. Bezdek, S.K. Chuah, and D. Leep. Generalized k-nearest neighbor rules. Fuzzy Sets and Systems , 18:237--26, 1986. E. T. Champagne, K. L. Bett-Garber, A. M. McClung, and C. Bergman. {Sensory characteristics of diverse rice cultivars as influenced by genetic and environmental factors}. Cereal Chem. , {81}:{237--243}, {2004}. S. G. Cheung and P. K. S. Shin. Size effects of suspended particles on gill damage in green-lipped mussel perna viridis. Marine Pollution Bulletin , 51(8--12):801--810, 2005. D. H. Evans. The fish gill: site of action and model for toxic effects of environmental pollutants. Environmental Health Perspectives , 71:44--58, 1987. G. C. Grigg. The failure of oxygen transport in a fish at low levels of ambient oxygen. Comp. Biochem. Physiol. , 29:1253--1257, 1969. G. Holmes, A. Donkin, and I.H. Witten. {Weka: A machine learning workbench}. In Proceedings of the Second Australia and New Zealand Conference on Intelligent Information Systems , volume {24}, pages {357--361}, {Brisbane, Australia}, {1994}. {IEEE Computer Society}. D. D. Macdonald and C. P. Newcombe. Utility of the stress index for predicting suspended sediment effects: response to comments. North American Journal of Fisheries Management , 13:873--876, 1993. C. P. Newcombe. Suspended sediment in aquatic ecosystems: ill effects as a function of concentration and duration of exposure. Technical report, British Columbia Ministry of Environment, Lands and Parks, Habitat Protection branch, Victoria, 1994. C. P. Newcombe and J. O. T. Jensen. Channel suspended sediment and fisheries: A synthesis for quantitative assessment of risk and impact. North American Journal of Fisheries Management , 16(4):693--727, 1996. C. P. Newcombe and D. D. Macdonald. Effects of suspended sediments on aquatic ecosystems. North American Journal of Fisheries Management , 11(1):72--82, 1991. K. Schmidt-Nielsen. Scaling. Why is animal size so important? Cambridge University Press, NY, 1984. J. S. Schwartz, A. Simon, and L. Klimetz. Use of fish functional traits to associate in-stream suspended sediment transport metrics with biological impairment. Environmental Monitoring and Assessment , 179(1--4):347--369, 2011. E. Al Shaw and J. S. Richardson. Direct and indirect effects of sediment pulse duration on stream invertebrate assemb ages and rainbow trout ( Oncorhynchus mykiss ) growth and survival. Canadian Journal of Fish and Aquatic Science , 58:2213--2221, 2001. P. Tiwari and H. Hasegawa. {Demand for housing in Tokyo: A discrete choice analysis}. Regional Studies , {38}:{27--42}, {2004}. Y. Tramblay, A. Saint-Hilaire, T. B. M. J. Ouarda, F. Moatar, and B Hecht. Estimation of local extreme suspended sediment concentrations in california rivers. Science of the Total Environment , 408:4221--

Accelerating entomology with Web3D insects

Capturing high-quality 3D models of insects is challenging - they are usually too small for laser or depth camera based systems, and techniques such as CT scanning do not record color. We have developed a prototype system that generates unprecedentedly high-quality natural-color 3D models of various insects from 3mm to 30 mm in length. Through the use of 3D web standards we are able to use these models to develop novel applications for entomologists and ensure wide accessibility. © 2014 Authors.

Environmental dynamism as a moderator of the relationship between bricolage and firm performance

Many firms initially face significant resource constraints during attempts to develop and grow (Shepherd et al., 2000). One promising theory that explicitly links to ways entrepreneurial firms respond to resource constraints is bricolage (Lévi-Strauss, 1966). Bricolage is defined as “making do by applying combinations of the resources at hand to new problems and opportunities” (Baker & Nelson, 2005, p. 333). Bricolage aligns with notions of resourcefulness: using what’s on hand, through making do, and recombining resources for new or novel purposes. Through a bias for action and a refusal to enact limitations on the resources that are available to create solutions, bricoleurs can tackle unexpected complex challenges, take advantage of opportunities, and go where most other firms won’t, in their attempts at firm development. Bricolage studies have previously not empirically examined the impact of bricolage on firm performance. Our work contributes to the emerging behavioral theory of bricolage by offering the first empirical test evaluating the impact of bricolage on early stage firm performance (i.e. venture emergence in nascent firms and sales in young firms). Using new product development (NPD) theories of speed of development, co-creation and innovativeness, we theorise that bricolage has a positive effect on early stage firm performance. We then introduce environmental dynamism as a moderator which influences this relationship.

In vivo non-invasive high resolution MR-based method for the determination of the elastic modulus of arterial vessels

The mechanical properties of arterial walls have long been recognized to play an essential role in the development and progression of cardiovascular disease (CVD). Early detection of variations in the elastic modulus of arteries would help in monitoring patients at high cardiovascular risk stratifying them according to risk. An in vivo, non-invasive, high resolution MR-phase-contrast based method for the estimation of the time-dependent elastic modulus of healthy arteries was developed, validated in vitro by means of a thin walled silicon rubber tube integrated into an existing MR-compatible flow simulator and used on healthy volunteers. A comparison of the elastic modulus of the silicon tube measured from the MRI-based technique with direct measurements confirmed the method's capability. The repeatability of the method was assessed. Viscoelastic and inertial effects characterizing the dynamic response of arteries in vivo emerged from the comparison of the pressure waveform and the area variation curve over a period. For all the volunteers who took part in the study the elastic modulus was found to be in the range 50-250 kPa, to increase during the rising part of the cycle, and to decrease with decreasing pressure during the downstroke of systole and subsequent diastole.

The impact of wall shear stress and pressure drop on the stability of the atherosclerotic plaque

Rupture of vulnerable atheromatous plaque in the carotid and coronary arteries often leads to stroke and heart attack respectively. The mechanism of blood flow and plaque rupture in stenotic arteries is still not fully understood. A three dimensional rigid wall model was solved under steady state conditions and unsteady conditions by assuming a time-varying inlet velocity profile to investigate the relative importance of axial forces and pressure drops in arteries with asymmetric stenosis. Flow-structure interactions were investigated for the same geometry and the results were compared with those retrieved with the corresponding 2D cross-section structural models. The Navier-Stokes equations were used as the governing equations for the fluid. The tube wall was assumed hyperelastic, homogeneous, isotropic and incompressible. The analysis showed that the three dimensional behavior of velocity, pressure and wall shear stress is in general very different from that predicted by cross-section models. Pressure drop across the stenosis was found to be much higher than shear stress. Therefore, pressure may be the more important mechanical trigger for plaque rupture other than shear stress, although shear stress is closely related to plaque formation and progression.

Measurement of stenotic carotid arterial compliance with MRI

Arterial compliance has been shown to correlate well with overall cardiovascular outcome and it may also be a potential risk factor for the development of atheromatous disease. This study assesses the utility of 2-D phase contrast Magnetic Resonance (MR) imaging with intra-sequence blood pressure measurement to determine carotid compliance and distensibility. 20 patients underwent 2-D phase contrast MR imaging and also ultrasound-based wall tracking measurements. Values for carotid compliance and distensibility were derived from the two different modalities and compared. Linear regression analysis was utilised to determine the extent of correlation between MR and ultrasound derived parameters. In those variables that could be directly compared, an agreement analysis was undertaken. MR measures of compliance showed a good correlation with measures based on ultrasound wall-tracking (r=0.61, 95% CI 0.34 to 0.81 p=0.0003). Vessels that had undergone carotid endarterectomy previously were significantly less compliant than either diseased or normal contralateral vessels (p=0.04). Agreement studies showed a relatively poor intra-class correlation coefficient (ICC) between diameter-based measures of compliance through either MR or ultrasound (ICC=0.14). MRI based assessment of local carotid compliance appears to be both robust and technically feasible in most subjects. Measures of compliance correlate well with ultrasound-based values and correlate best when cross-sectional area change is used rather than derived diameter changes. If validated by further larger studies, 2-D phase contrast imaging with intra-sequence blood pressure monitoring and off-line radial artery tonometry may provide a useful tool in further assessment of patients with carotid atheroma.

Aging-in-place: Perspectives from the construction industry

Older adults report a desire to remain within the preferred environment for as long as possible. This desire is referred to as aging-in-place. Aging-in-place integrates housing and care options. Factors affecting the ability to remain within the preferred environment include current home designs, access to housing choices, social support networks, and community services, to name a few. Research supports physical and psychosocial benefits of aging-in-place for the individual. Home modifications have the potential to influence the quality of life in a number of positive directions that range from personal mobility to community engagement. Modifications range from minor to significant. Financial resources, contractor interest and expertise, consumer awareness and consumer opportunity affect the degree of change. Increasingly, construction professionals express an interest in learning more about aging-in place. Queries ranged from obtaining a greater understanding of the meaning of the concept, impact of demographic change on housing stock, and increased awareness of universal design features. This paper presents findings from a survey administered to current members of the Canadian Home Builders’ Association – Calgary Regional Office. Within this presentation, we report findings on members understanding of demographic change and the effect of this change on the current and future housing stock. We discuss perceived barriers and benefits of the development of business models to support aging-in-place. Finally, we conclude with discussion of educational support to enhance the understanding of aging-in-place.

PIV study on the dimple mid-plane of a narrow rectangular channel with dimples applied to one wall

This paper presents an investigation of the fluid flow in the fully developed portion of a rectangular channel (Aspect Ratio of 2) with dimples applied to one wall at channel Reynolds numbers of 20,000, 30,000, and 40,000. The dimples are applied in a staggered-row, racetrack configuration. Results for three different dimple geometries are presented: a large dimple, small dimple, and double dimple. Heat transfer and aerodynamic results from preceding works are presented in Nusselt number and friction factor augmentation plots as determined experimentally. Using particle image velocimetry, the region near the dimple feature is studied in detail in the location of the entrainment and ejection of vortical packets into and out of the dimple; the downstream wake region behind each dimple is also studied to examine the effects of the local flow phenomenon that result in improved heat transfer in the areas of the channel wall not occupied by a feature. The focus of the paper is to examine the secondary flows in these dimpled channels in order to support the previously presented heat transfer trends. The flow visualization is also intended to improve the understanding of the flow disturbances in a dimpled channel; a better understanding of these effects would lead the development of more effective channel cooling designs. Copyright © 2011 by ASME.

PICES Press, Vol. 9, No. 1, January 2001

The state of PICES science – 2000 [pp. 1-2] [pdf, 0.6 Mb] The state of the western North Pacific in the first half of 2000 [pp. 3-5] [pdf, 0.7 Mb] The status of the Bering Sea: January – August 2000 [pp. 6-7] [pdf, 0.3 Mb] The state of the eastern North Pacific since spring 2000 [pp. 8-9] [pdf, 0.4 Mb] Makoto Kashiwai [pp. 10-14] [pdf, 0.9 Mb] Alkalinity measurement quality improves for PICES nations [pp. 15-16] [pdf, 0.4 Mb] Dr. Timothy R. Parsons Awarded 2001 Japan Prize [p. 17] [pdf, 0.2 Mb] Highlights of the PICES Nineth Annual Meeting [pp. 18-19] [pdf, 0.4 Mb] Tangible outline of the whole elephant (Results of ecosystem studies of biological resources in the far-eastern seas in 1990s) [pp. 20-24] [pdf, 0.7 Mb] The Oshoro Maru: A short history of Hokkaido University's workhorse in the North Pacific [pp. 25-28] [pdf, 0.4 Mb] Bering Sea and North Pacific Ocean Theme Page [pp. 29-30] [pdf, 0.3 Mb] PICES IX Japan/East Sea cruise [pp. 31-34] [pdf, 1.1 Mb] 35 PICES Wooster Award [p. 35] [pdf, 0.2 Mb] PICES Intern Program [p. 35] [pdf, 0.2 Mb] Obituary - Prof. Michael M. Mulin [p. 36] [pdf, 0.2 Mb]