1-苯基-3-甲基-4-苯甲酰基-5-吡唑啉酮和磷酸三丁脂协同萃取镭的研究

用1-苯基-3-甲基-4-苯甲酰基-5-吡唑啉酮(PMBP)为萃取剂,苯为稀释剂,从pH5的水相中萃取船224Ra,发现224Ra的萃取效率非常低。若往PMBP中加入少量的磷酸三丁脂(TBP),则会极大地提高镭的萃取效率,这说明TBP对PMBP萃取镭有显著的协同萃取效应。完成了萃取时间和反萃时间对224Ra萃取效率的影响以及224Ra萃取效率与TBP量之间的依赖关系等条件实验。

用1-苯基-3-甲基-4-苯甲酰基-5-吡唑啉酮从硝酸介质中萃取钪

用1-苯基-3-甲基-4-苯甲酰基-5-吡唑啉酮(PMBP)做萃取剂研究了从HNO_3介质中痕量钪的溶剂萃取行为。发现在很低的酸度下,PMBP几乎可以定量地萃取痕量的钪。同时,也讨论了用PMBP从~(18)O离子辐照过的铀靶溶液中萃取分离钍时钪的沾污。

1-苯基-3-甲基-4-苯甲酰基-5-吡唑啉酮(PMBP)萃取钍流程的改进

在用PMBP(1 苯基 3 甲基 4 苯甲酰基 5 吡唑啉酮 )从 14MeV中子照射过的天然U靶溶液中萃取Th流程的基础上 ,将萃取介质改为HNO3溶液 ,并将单次萃取 反萃改为两次萃取 反萃 ;在反萃溶液中加入I- 载体和NaNO2溶液 ,在Fe(OH) 3沉淀溶液中加入Br- 载体。用改进后的流程从 6 0MeV/u18O离子轰击天然U的HNO3溶液中分离Th ,从制得的Th样品的γ射线谱可以看出 ,该流程能去除绝大部分产物元素 ,特别是能完全去除溴和碘

用1-苯基-3-甲基-4-苯甲酰基-5-吡唑啉酮从硝酸中萃取痕量钍

用1-苯基-3-甲基-4-苯甲酰基-5-吡唑啉酮(PMBP)为萃取剂,~(234)Th作示踪剂,完成了在硝酸介质中痕量钍溶剂萃取行为的研究。在~(234)Th萃取效率与酸度、萃取剂浓度、平衡时间等依赖关系的条件实验的基础上,获得了萃取钍的最佳条件。使用改进的PMBP萃取钍的流程,从~(18)O离子辐照过的铀靶中分离钍,钍样品的γ射线单谱显示绝大部分反应产物和大量铀的去除是满意的。

钯/铁双金属对土壤中2,2′,3,4,4′,5,5′-七氯联苯的催化脱氯研究

采用Fe0还原、钯催化法对土壤中2,2′,3,4,4′,5,5′-七氯联苯的的还原特性进行了实验研究.结果表明,Pd/Fe双金属能有效地进行2,2′,3,4,4′,5,5′-七氯联苯的催化脱氯.在钯化率为0.05%、钯/铁加入量1 g、初始pH为5.6、反应时间5 d的条件下,钯/铁双金属对土壤中2,2′,3,4,4′,5,5′-七氯联苯去除率达54%.实验还考察了钯化率、初始pH、反应时间、钯/铁投加量、2,2′,3,4,4′,5,5′-七氯联苯初始浓度等参数对2,2′,3,4,4′,5,5′-七氯联苯脱氯效果的影响.研究表明,较高的钯化率、钯/铁加入量,较低的2,2′,3,4,4′,5,5′-七氯联苯初始浓度及弱酸性等条件更有利于Pd/Fe对2,2′,3,4,4′,5,5′-七氯联苯的还原脱氯.在Pd/Fe双金属表面,2,2′,3,4,4′,5,5′-七氯联苯的脱氯符合一级动力学反应,反应速率常数为0.014 2/h,其半衰期为49 h.利用实验数据,对钯/铁双金属作用下的2,2′,3,4,4′,5,5′-七氯联苯还原脱氯的反应机制也进行了分析.

The synthesis and characterization of novel liquid crystalline, meso-tetra[4-(3,4,5-trialkoxybenzoate)phenyl]porphyrins

Five, novel, meso-tetra[4-(3,4,5-trialkoxybenzoate)phenyl]porphyrins and their metal complexes were synthesized and their molecular structures were confirmed by H-1 NMR, FTIR spectroscopy and elemental analysis. Mesomorphic studies using DSC, polarizing optical microscope and X-ray diffraction revealed that all compounds exhibited thermotropic columnar mesophases over a wide mesophase temperature range and low liquid crystalline-crystal line transition temperature. (c) 2007 Elsevier Ltd. All rights reserved

Effect of the nucleating agent 1,3 : 2,4-di(3,4-dimethylbenzylidene) sorbitol on the gamma phase content of propylene/ethylene copolymer

The influence of the concentration of a nucleating agent (NA), namely 1,3:2,4-di(3,4-dimethylbenzylidene) sorbitol (DMDBS), on the gamma phase content in a propylene/ethylene copolymer was investigated by means of Differential Scanning Calorimetry (DSC), Wide-Angle X-ray Diffraction (WAXD), Small- Angle X-ray Scatter (SAXS) and Polarized Optical Microscopy (POM).

Crystallization behavior of a thermoplastic polyimide derived from 3,3 ',4,4 '-oxydiphthalic dianhydride and 4,4 '-oxydianiline

Nonisothermal and isothermal crystallization kinetics of an aromatic thermoplastic polyimide derived from 3,3',4,4'-oxydiphthalic dianhydride and 4,4'-oxydianiline have been investigated by means of differential scanning calorimetry (DSC) and wide-angle X-ray diffraction. The results for nonisothermal crystallization study showed that a weak melting peak appeared during the first heating process, whereas no crystallization peak appeared in the DSC curve during the subsequent cooling process. On the other hand, the study for the isothermal crystallization in the temperature range of 260-330 degrees C showed that a new exothermic peak appeared at lower temperature for the samples crystallized for 100 min at 300 degrees C.

Highly 3,4-selective living polymerization of isoprene with rare earth metal fluorenyl N-heterocyclic carbene precursors

Fluorenyl modified N-heterocyclic carbene ligated rare earth metal bis(alkyl) complexes, (Flu-NHC)Ln(CH2SiMe3)2 (Flu-NHC = (C13H8CH2CH2(NCHCCHN)C6H2Me3-2,4,6); Ln = Sc (1a); Ln = Y (1b); Ln = Ho (1c); Ln = Lit (1d)), were synthesized and fully characterized by NMR and X-ray diffraction analyses. Complexes Ib-d with the activation of (AlBu3)-Bu-i and [Ph3C][B(C6F5)4] exhibited high activity, medium syndio-but remarkably high 3,4-regio-selectivity, and the unprecedented livingness for the polymerization of isoprene. Such distinguished catalytic performances could be maintained under various monomer-to-initiator ratios (500-5000) and broad polymerization temperatures (25-80 degrees C).

New rare earth metal bis(alkyl)s bearing an iminophosphonamido ligand. Synthesis and catalysis toward highly 3,4-selective polymerization of isoprene

Newrareearth metal bis(alkyl) complexes [(NPNPh)Ln(CH2SiMe3)(2)(THF) (NPNPh:N(Ph)PPh2=NC6H2Me3-2,4,6; Ln = Sc (3a), Ln = Y (3b), Ln = Lu (3c)) and [(NPNPy)Sc(CH2SiMe3)(2)(THF)1 (NPNPY = N(Py)PPh2=NC6H2Me3-2,4,6) (3d)) have been prepared via protonolysis reaction between rare earth metal tris(alkyl)s and the corresponding iminophosphonamines. Complexes 3a-d are analogous monomers of THF solvate. Each metal ion coordinates to a eta(2)-chelated NPN ligand and two cis-located alkyl groups, adopting tetrahedron geometry.

Enantioselective Iodolactonizations of 4-Pentenoic Acid Derivatives Mediated by Chiral Salen-Co(II) Complex

This work presents the salen-Co(II) complex catalyzed enantioselective iodolactonizations of various 4-pentenoic acid derivatives with good enantioselectivities (up to 83% ee).

1,2,3,4-Alternate double cone conformational extreme in the supramolecular assemblies of p-sulfonatocalix[8]arene

Two supramolecular assemblies of p-sulfonato-calix[8]arene were stacked by some infinite 1D 'molecular capsule' chains in which the calixarenes adopt an unprecedented 1,2,3,4-alternate double cone conformation.

Performance Enhancement of Polymer Light-Emitting Diodes by Using Ultrathin Fluorinated Polyimide Modifying the Surface of Poly(3,4-ethylene dioxythiophene):Poly(styrenesulfonate)

Herein, an insulating fluorinated polyimide (F-PI) is utilized as an ultrathin buffer layer of poly(3,4-ethylenedioxythiophene):poly(styrenesulfonate) (PEDOT:PSS) in polymer light-emitting diodes to enhance the device performance. The selective solubility of F-PI in common solvents avoids typical intermixing interfacial problems during the sequential multilayer spin-coating process. Compared to the control device, the F-PI modification causes the luminous and power efficiencies of the devices to be increased by a factor of 1.1 and 4.7, respectively, along with almost 3-fold device lifetime enhancement. Photovoltaic measurement, single-hole devices, and X-ray photoelectron spectroscopy, are utilized to investigate the underlying, mechanisms, and it is found that the hole injection barrier is lowered owing to the interactions between the PEDOT:PSS and F-PI. The F-PI modified PEDOT:PSS layer demonstrates step-up ionization potential profiles from the intrinsic bulk PEDOT:PSS side toward the F-PI-modified PEDOT:PSS surface, which facilitate the hole injection.