Medidas de radón en espacios de trabajo subterráneos del Campus de la Universidad de Alicante

Las medidas del gas radiactivo radón en lugares de trabajo subterráneos del Campus de la Universidad de Alicante fueron realizadas mediante dispositivos E-PERM® de corto plazo durante el invierno de 2010 y el verano de 2011. Las concentraciones de radón obtenidas muestran valores máximos de 73,8 Bq/m3 en invierno y 84,0 Bq/m3 en verano, así como una media aritmética de 30,3 Bq/m3. Aunque no se abordan concentraciones medias anuales, todos los resultados se encuentran por debajo de los valores recogidos en la Recomendación 90/143/EURATOM de la Comisión Europea relativa a la protección de la población contra los peligros de una exposición al radón en el interior de edificios así como los establecidos por la Instrucción IS-33 del Consejo de Seguridad Nuclear en lugares de trabajo, contribuyendo a la evaluación de la distribución de radón a nivel nacional y prestando atención a los problemas que este gas puede ocasionar en espacios subterráneos.

Comparison of working level ratios in houses occupied by smokers and non-smokers /

"April 1986"--Cover.

Are you still holding your breath?

Mode of access: Internet.

Former Toastmaster property : soil sampling results, 401 Washington Street, McHenry County, Algonquin, Illinois /

"August 2010."

Regional-scale, fully coupled modelling of stream-aquifer interaction in a tropical catchment

The planning and management of water resources in the Pioneer Valley, north-eastern Australia requires a tool for assessing the impact of groundwater and stream abstractions on water supply reliabilities and environmental flows in Sandy Creek (the main surface water system studied). Consequently, a fully coupled stream-aquifer model has been constructed using the code MODHMS, calibrated to near-stream observations of watertable behaviour and multiple components of gauged stream flow. This model has been tested using other methods of estimation, including stream depletion analysis and radon isotope tracer sampling. The coarseness of spatial discretisation, which is required for practical reasons of computational efficiency, limits the model's capacity to simulate small-scale processes (e.g., near-stream groundwater pumping, bank storage effects), and alternative approaches are required to complement the model's range of applicability. Model predictions of groundwater influx to Sandy Creek are compared with baseflow estimates from three different hydrograph separation techniques, which were found to be unable to reflect the dynamics of Sandy Creek stream-aquifer interactions. The model was also used to infer changes in the water balance of the system caused by historical land use change. This led to constraints on the recharge distribution which can be implemented to improve model calibration performance. (c) 2006 Elsevier B.V. All rights reserved.

Projective Methods of Image Recognition

We propose a method for image recognition on the base of projections. Radon transform gives an opportunity to map image into space of its projections. Projection properties allow constructing informative features on the base of moments that can be successfully used for invariant recognition. Offered approach gives about 91-97% of correct recognition.

Generalized Backscattering and the Lax-Phillips Transform

2000 Mathematics Subject Classification: 35P25, 35R30, 58J50.

Influência da radiação ionizante natural no açude do boqueirão (RN): avaliação de risco saúde/ambiente

The contamination of water bodies with toxic substances causes a decrease in water quality, representing a risk to public health. In this context, human activities are generally seen as the main sources of water degradation. However, elements found naturally in the environment can also compromise water quality. Thus, the Boqueirão‘s dam, located in the municipality of Parelhas (RN, Brazil), was chosen as area for the development of this study, as its geological region is rich in the emission of natural ionizing radiation that produces byproducts like lead and Radon. Moreover, the area has a strong human influence that enhances the risks of pollutant discharge in this body of water.Thus, the objectives of this study were centered (i) in the analysis of risk perception in the city of Parelhas (RN/Brasil) due to the use of the water from the Boqueirão Dam; and (ii) in the assessment of water quality in the Dam using methods that quantify, mainly, heavy metals and radiation levels, as well as these toxics potential of inducing mutations on genetic material. The analysis of risk perception showed that the population in the city of Parelhas can perceive a risk in using the water from the dam and that they can recognize factors that influence the water quality. Regarding the second objective, the set of data point to the contamination of the Dam by heavy metals, as well as levels of radioactive parcicles and Radon – also present in high concentrations in outdoor air and on soil. Thus, it is possible to infer that the population residing in this area is subjected to injuries caused by exposure to natural and anthropogenic contamination. Our findings corroborate with the perception of the population regarding the risks associated with the use of the Dam for several types of activities. It is expected that the information gathered in this study can substantiate activities and future researches in this semiarid region in the Rio Grande do Norte/Brazil. Also, that the set of data can enable a better understanding of the specific toxicological scenario of risk found for the population and the effect of the contamination for the biota, which aids the development of a future risk assessment and a consequent management of this local issue.

Resolução em tomografia de tempo de trânsito poço-a-poço: a dependência da iluminação

The key aspect limiting resolution in crosswell traveltime tomography is illumination, a well known result but not as well exemplified. Resolution in the 2D case is revisited using a simple geometric approach based on the angular aperture distribution and the Radon Transform properties. Analitically it is shown that if an interface has dips contained in the angular aperture limits in all points, it is correctly imaged in the tomogram. By inversion of synthetic data this result is confirmed and it is also evidenced that isolated artifacts might be present when the dip is near the illumination limit. In the inverse sense, however, if an interface is interpretable from a tomogram, even an aproximately horizontal interface, there is no guarantee that it corresponds to a true interface. Similarly, if a body is present in the interwell region it is diffusely imaged in the tomogram, but its interfaces - particularly vertical edges - can not be resolved and additional artifacts might be present. Again, in the inverse sense, there is no guarantee that an isolated anomaly corresponds to a true anomalous body because this anomaly can also be an artifact. Jointly, these results state the dilemma of ill-posed inverse problems: absence of guarantee of correspondence to the true distribution. The limitations due to illumination may not be solved by the use of mathematical constraints. It is shown that crosswell tomograms derived by the use of sparsity constraints, using both Discrete Cosine Transform and Daubechies bases, basically reproduces the same features seen in tomograms obtained with the classic smoothness constraint. Interpretation must be done always taking in consideration the a priori information and the particular limitations due to illumination. An example of interpreting a real data survey in this context is also presented.

Resolução em tomografia de tempo de trânsito poço-a-poço: a dependência da iluminação

The key aspect limiting resolution in crosswell traveltime tomography is illumination, a well known result but not as well exemplified. Resolution in the 2D case is revisited using a simple geometric approach based on the angular aperture distribution and the Radon Transform properties. Analitically it is shown that if an interface has dips contained in the angular aperture limits in all points, it is correctly imaged in the tomogram. By inversion of synthetic data this result is confirmed and it is also evidenced that isolated artifacts might be present when the dip is near the illumination limit. In the inverse sense, however, if an interface is interpretable from a tomogram, even an aproximately horizontal interface, there is no guarantee that it corresponds to a true interface. Similarly, if a body is present in the interwell region it is diffusely imaged in the tomogram, but its interfaces - particularly vertical edges - can not be resolved and additional artifacts might be present. Again, in the inverse sense, there is no guarantee that an isolated anomaly corresponds to a true anomalous body because this anomaly can also be an artifact. Jointly, these results state the dilemma of ill-posed inverse problems: absence of guarantee of correspondence to the true distribution. The limitations due to illumination may not be solved by the use of mathematical constraints. It is shown that crosswell tomograms derived by the use of sparsity constraints, using both Discrete Cosine Transform and Daubechies bases, basically reproduces the same features seen in tomograms obtained with the classic smoothness constraint. Interpretation must be done always taking in consideration the a priori information and the particular limitations due to illumination. An example of interpreting a real data survey in this context is also presented.

Réduction du bruit de fond en vue de la détection de la matière sombre avec le projet PICASSO

Thèse numérisée par la Direction des bibliothèques de l'Université de Montréal.

Réduction du bruit de fond en vue de la détection de la matière sombre avec le projet PICASSO

Thèse numérisée par la Direction des bibliothèques de l'Université de Montréal.

Continuously measured 222Rn activity concentrations (daily means) in near surface air at Neumayer Station in the period 1995 through 2011

We report on continuously measured 222Rn activity concentrations in near-surface air at Neumayer Station in the period 1995-2011. This 17-year record showed no long-term trend and has overall mean ± standard deviation of (0.019 ± 0.012) Bq/m**3. A distinct and persistent seasonality could be distinguished with maximum values of (0.028 ± 0.013) Bq/m**3 from January to March and minimum values of (0.015 ± 0.009) Bq/m**3 from May to October. Elevated 222Rn activity concentrations were typically associated with air mass transport from the Antarctic Plateau. Our results do not support a relation between enhanced 222Rn activity concentrations at Neumayer and cyclonic activity or long-range transport from South America. The impact of oceanic 222Rn emissions could not be properly assessed but we tentatively identified regional sea ice extent (SIE) variability as a significant driver of the annual 222Rn cycle.

Radiological characterization of clay mixed red mud in particular as regards its leaching features

The reuse of industrial by-products such as red mud is of great importance. In the case of the building material industry the reuse of red mud requires a cautious attitude, since the enhanced radionuclide content of red mud can have an effect on human health. The natural radionuclide content of red mud from the Ajka red mud reservoir and the clay sample from a Hungarian brick factory were determined by gamma spectrometry. It was found that maximum 27.8% red mud content can be added to fulfil the conditions of the EU-BSS. The effect of heat treatment was investigated on a red mud-clay mixture and it was found that in the case of radon and thoron exhalation the applied heat reduced remarkably the exhalation capacities. The leaching features of red mud and different mixtures were studied according to the MSZ-21470-50 Hungarian standard, the British CEN/TS 14429 standard and the Tessier sequential extraction method. The Tessier method and the MSZ-21470-50 standard are suitable for the characterization of materials; however, they do not provide enough information for waste deposition purposes. To this end, we propose using the CEN/TS 14429 method, because it is easy to use, and gives detailed information about the material's behaviour under different pH conditions, however, further measurements are necessary.