Highway-vehicle-object simulation model - 1976. Volume 4: engineering manual - validation. Final report.

Federal Highway Administration, Washington, D.C.

Evaluation of fe oxide-coated granular activated carbon for removal and recovery of Cu(II) and Cr(VI) from aqueous solution /

"April 1994."--Cover.

Antenna support AB-38B/CR.

"January 1952."

Boron solubility in Fe-Cr-B cast irons

Boron solubility in the as-cast and solution treated martensite of Fe-Cr-B cast irons, containing approximately 1.35 wt.% of boron, 12 wt.% of chromium, as well as other alloying elements, has been investigated using conventional microanalysis. The significant microstructural variations after tempering at 750 degreesC for 0.5-4 h, compared with the original as-cast and solution treated microstructures, indicated that the matrix consisted of boron and carbon supersaturated solid solutions. The boron solubility detected by electron microprobe was between 0.185-0.515 wt.% for the as-cast martensite and 0.015-0.0589 wt.% for the solution treated martensite, much higher than the accepted value of 0.005 wt.% in pure iron. These remarkable increases are thought to be associated with some metallic alloying element addition, such as chromium, vanadium and molybdenum, which have atomic diameters larger than iron, and expand the iron lattice to sufficiently allow boron atoms to occupy the interstitial sites in iron lattice. (C) 2002 Elsevier Science B.V. All rights reserved.

Iridium concentrations and abundances of meteoritic ejecta from the Eltanin impact in sediment cores from POLARSTERN cruise ANT-XII/4

The abundances of meteoritic ejecta from the Eltanin asteroid impact have been examined in seven sediment cores recovered by the FS Polarstern during expedition ANT XII/4 using elemental concentrations of iridium and weights of coarse (>500 ?m) ejecta debris. Three cores with well-preserved impact deposits, PS2704-1, PS2708-1, and PS2709-1, each contain Ir and ejecta fluences similar to those found previously in USNS Eltanin core E13-4. Small Ir anomalies and traces of ejecta were found in cores PS2706-1 and PS2710-1, but since these cores lack well-defined deposits, these are considered to be reworked and not representative of the fallout. No evidence of ejecta was found in cores PS2702-1 and PS2705-1. These results confirm earlier speculation that the Eltanin impact resulted in deposits of ejecta with up to 1 g/cm**2 of debris over a wide area of the ocean floor. However, there are still large uncertainties over the actual regional or global extent of this unique sediment deposit.

Relationship between surface topography and energy density distribution of Er, Cr:YSGG beam on irradiated dentin: an atomic force microscopy study

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Preparation of bionanoparticles derived from Spirulina platensis and its application for Cr (VI) removal from aqueous solutions

Spirulina platensis nanoparticles were prepared by mechanical agitation and were applied to removal Cr (VI) from aqueous solutions. Nanoparticles preparation was function of stirring rate and contact time. In the optimal conditions, Cr (VI) removal by nanoparticles as a function of pH and initial ion concentration was carried out. The optimal conditions for preparation were 10,000 rpm and 20 min, and the nanoparticles presented mean diameter of 215.6 nm and polydispersity index of 0.151. The best conditions for Cr (VI) removal were at pH 4 and ion concentration of 250 mg L 1, and the Cr (VI) removal percentage was 99.1%.

Discurso pronunciado en la inauguración de los cursos del Bachillerato en Bibliotecología y Documentación en la Escuela de Bibliotecología de la Universidad Nacional 4 de marzo de 1991

Estimados compañeros:Reciban en nombre propio y de la Facultad de Filosofía y Letras un afectuoso saludo de inicio de curso lectivo. Por razones fortuitas, he solicitado a la Decana sustituta de esta Facultad, la M.L.S. Alice Miranda, Directora de vuestra Escuela, que represente a la Facultad en este acto de inicio del curso lectivo.No solamente le he pedido que transmita mis saludos, sino que los inste a hacer propósitos de mejoramiento académico durante este período que inicia. La crisis universitaria forma parte de nuestra institucionalidad. La Universidad desde su nacimiento ha vivido constantemente en crisis. No obstante, como toda crisis, éstas pueden resultar fértiles en realizaciones, si las aprovechamos para el mejoramiento. En este momento nos encontramos reflexionando sobre el carácter mismo de nuestra institucionalidad. Estamos en Congreso Universitario, realizaremos próximamente la Segunda Etapa del Segundo Congreso Universitario. Son momentos de reflexión, son momentos de lucidez, de hacer examen de conciencia, de pensar lo que hemos sido para lanzarnos al porvenir.

Biosorption of Cr(III) using in natura and chemically treated tropical peats

The physicochemical characteristics of three Brazilian pears were investigated using elemental analysis, scanning electron microscopy (SEM), X-ray diffractometry (XRD) and studies of Cr(III) biosorption based on adsorption isotherms. Adsorption of Cr(III) by in natura peat from Santo Amaro das Brotas (Sergipe State) was much greater than by peats from either Ribeirao Preto (São Paulo State) or Itabaiana (Sergipe State), with adsorption capacities (q) of 4.90 +/- 0.01, 1.70 +/- 0.01 and 1.40 +/- 0.01 mgg (1), respectively. Pre-treatments with HCl and NaOH + HCl reduced adsorption by the Santo Amaro clas Brotas peat, showing that adsorption efficiency was associated with the amount of organic matter present. Conversely, increase in the mineral content following pre-treatment increased adsorption of Cr(III) by the Ribeirao Preto and Itabaiana peats. Highest adsorption (retention >95.0%) was achieved at equilibrium pH 4.0 using the Santo Amaro das Brotas peat. Experimental data for the adsorption of Cr(III) from aqueous solution onto this peat were fitted to the Langmuir equation, from which an equilibrium adsorption capacity, q(max), of 5.60 mgg(-1) was obtained, which was close to the experimentally determined value. (c) 2008 Elsevier B.V. All rights reserved.

Solución interactiva de ecuaciones diferenciales en Mathematica 4.1

El propósito de este trabajo consiste en mostrar de qué manera la programación en Mathematica 4.1 nos permite resolver ecuaciones diferenciales de la forma de manera interactiva por medio de botones. Estos botones operan sobre una ecuación diferencial dada y la transforman por medio de ciertas reglas, de manera que el proceso de solución se observa paso a paso. Se ha puesto especial interés en las ecuaciones exactas de la forma y en ecuaciones de este tipo que admiten factor integrante. Con estos botones se pretende que el estudiante, antes que realizar cálculos, conceptúe los métodos usados en la solución de las ecuaciones diferenciales descritas.

Extração de metais (K, Mg, Ba, Ca, Cr, Mn, Li, Fe) de água produzida utilizando sistema microemulsionado

The produced water is a byproduct formed due to production of petroleum and carries with it a high amount of contaminants such as oil particles in suspension, organic compounds and metals. Thus, these latter pollutants are very difficult to treat because of its high solubility in water. The objective of this work is to use and evaluate a microemulsioned system to remove metals ( K , Mg , Ba , Ca , Cr , Mn , Li , Fe ) of synthetic produced water. For the extraction of metals, it was used a pseudoternary diagram containing the following phases: synthetic produced water as the aqueous phase (AP), hexane as organic phase (OP), and a cosurfactant/surfactant ratio equal to four (C/S = 4) as the third phase, where the OCS (saponified coconut oil) was used as surfactant and n-butanol as cosurfactant. The synthetic produced water was prepared in a bench scale and the region of interest in the diagram for the removal of metals was determined by experimental design called. Ten points located in the phase Winsor II were selected in an area with a large amount of water and small amounts of reagents. The samples were analyzed in atomic absorption spectrometer, and the results were evaluated through a statistical assesment, allowing the efficiency analysis of the effects and their interactions. The results showed percentages of extraction above 90% for the metals manganese, iron, chromium, calcium, barium and magnesium, and around 45% for metals lithium and potassium. The optimal point for the simultaneous removal of metals was calculated using statistical artifact multiple response function (MR). This calculation showed that the point of greatest extraction of metals occurs was the J point, with the composition [72% AP, 9% OP, 19% C/S], obtaining a global extraction percentage about 80%. Considering the aspects analyzed, the microemulsioned system has shown itself to be an effective alternative in the extraction of metals on synthetic produced water remediation

A comparative study of the structural, mechanical and tribological characteristics of TiSiC-Cr coatings prepared in CH4 and C2H2 reactive atmosphere by cathodic vacuum arc

TiSiC-Cr coatings, with Cr and Si as additional elements, were deposited on Si, C 45 and 316 L steel substrates via cathodic arc evaporation. Two series of coatings with thicknesses in the range of 3.6–3.9 μm were produced, using either CH4 or C2H2 as carbon containing gas. For each series, different coatings were prepared by varying the carbon rich gas flow rate between 90 and 130 sccm, while maintaining constant cathode currents (110 and 100 A at TiSi and Cr cathodes, respectively), substrate bias (–200 V) and substrate temperature (∼320 °C). The coatings were analyzed for their mechanical characteristics (hardness, adhesion) and tribological performance (friction, wear), along with their elemental and phase composition, chemical bonds, crystalline structure and cross-sectional morphology. The coatings were found to be formed with nano-scale composite structures consisting of carbide crystallites (grain size of 3.1–8.2 nm) and amorphous hydrogenated carbon. The experimental results showed significant differences between the two coating series, where the films formed from C2H2 exhibited markedly superior characteristics in terms of microstructure, morphology, hardness, friction behaviour and wear resistance. For the coatings prepared using CH4, the measured values of crystallite size, hardness, friction coefficient and wear rate were in the ranges of 7.2–8.2 nm, 26–30 GPa, 0.3–0.4 and 2.1–4.8 × 10−6 mm3 N−1 m−1, respectively, while for the coatings grown in C2H2, the values of these characteristics were found to be in the ranges of 3.1–3.7 nm, 41–45 GPa, 0.1–0.2 and 1.4–3.0 × 10−6 mm3 N−1 m−1, respectively. Among the investigated coatings, the one produced using C2H2 at the highest flow rate (130 sccm) exhibited the highest hardness (45.1 GPa), the lowest friction coefficient (0.10) and the best wear resistance (wear rate of 1.4 × 10−6 mm3 N−1 m−1).

Toll-like Receptor 4 Activation Promotes Cardiac Arrhythmias By Decreasing The Transient Outward Potassium Current (ito) Through An Irf3-dependent And Myd88-independent Pathway.

Cardiac arrhythmias are one of the main causes of death worldwide. Several studies have shown that inflammation plays a key role in different cardiac diseases and Toll-like receptors (TLRs) seem to be involved in cardiac complications. In the present study, we investigated whether the activation of TLR4 induces cardiac electrical remodeling and arrhythmias, and the signaling pathway involved in these effects. Membrane potential was recorded in Wistar rat ventricle. Ca(2+) transients, as well as the L-type Ca(2+) current (ICaL) and the transient outward K(+) current (Ito), were recorded in isolated myocytes after 24 h exposure to the TLR4 agonist, lipopolysaccharide (LPS, 1 μg/ml). TLR4 stimulation in vitro promoted a cardiac electrical remodeling that leads to action potential prolongation associated with arrhythmic events, such as delayed afterdepolarization and triggered activity. After 24 h LPS incubation, Ito amplitude, as well as Kv4.3 and KChIP2 mRNA levels were reduced. The Ito decrease by LPS was prevented by inhibition of interferon regulatory factor 3 (IRF3), but not by inhibition of interleukin-1 receptor-associated kinase 4 (IRAK4) or nuclear factor kappa B (NF-κB). Extrasystolic activity was present in 25% of the cells, but apart from that, Ca(2+) transients and ICaL were not affected by LPS; however, Na(+)/Ca(2+) exchanger (NCX) activity was apparently increased. We conclude that TLR4 activation decreased Ito, which increased AP duration via a MyD88-independent, IRF3-dependent pathway. The longer action potential, associated with enhanced Ca(2+) efflux via NCX, could explain the presence of arrhythmias in the LPS group.

Crystal Structure Of (3e)-3-[(4-nitro-phen-oxy)-meth-yl]-4-phenyl-but-3-en-2-one.

In the title compound, C17H15NO4, the conformation about the C=C double bond [1.348 (2) Å] is E with the ketone group almost co-planar [C-C-C-C torsion angle = 7.2 (2)°] but the phenyl group twisted away [C-C-C-C = 160.93 (17)°]. The terminal aromatic rings are almost perpendicular to each other [dihedral angle = 81.61 (9)°] giving the mol-ecule an overall U-shape. The crystal packing feature benzene-C-H⋯O(ketone) contacts that lead to supra-molecular helical chains along the b axis. These are connected by π-π inter-actions between benzene and phenyl rings [inter-centroid distance = 3.6648 (14) Å], resulting in the formation of a supra-molecular layer in the bc plane.