Recycling of NR Based Cured Latex Material Reclaimed with 2,2'-Dibenzamidodiphenyldisulphide in a TruckTire Tread Compound

It is observed that reclamation of natural rubber latex based rubber using 2,2'-dibenzamidodiphenvldisulphide as reclaiming agent is an optional methodology for recycling of waste latex rubber (WLR). For progressive replacement of virgin natural rubber by the reclaim, two alternatives curing system were investigated: adjustment or reduction of the curing system with increasing reclaim content, to compensate for the extra amount of curatives brought along by the reclaim. For fixed curing system, as if the reclaim were equivalent to virgin NR. The cure behavior, final crosslink density and distribution, mechanical properties, and dynamic viscoelastic properties of the blends with reclaimed WLR are measured and compared with the virgin compound. The morphology of the blends, sulfur migration, and final distribution are analyzed.The mechanical and dynamic viscoelastic properties deteriorate for both curing systems, but to a lesser extent for fixed curing system compared to adjusted curing system. With the fixed cure system, many properties like tensile strength and compression set do still deteriorate, but tan 6 and Mrrr„/Murxr, representative for the rolling resistance of tires are improved. On the other hand, with the adjusted cure system both mechanical and dynamic properties still deteriorate.

Tunable diode Laser Absorption Spectroscopy ,Nir Overtone and Life Studies of Some Organic Compound

The present work is mainly concentrated on setting up a NIR tunable diode laser absorption (TDLA) spectrometer for high-resolution molecular spectroscopic studies. For successfully recording the high-resolution tunable diode laser spectrum, various experimental considerations are to be taken into account like the setup should be free from mechanical vibrations, sample should be kept at a low pressure, laser should be in a single mode operation etc. The present experimental set up considers all these factors. It is to be mentioned here that the setting up of a high resolution NIR TDLA spectrometer is a novel experiment requiring much effort and patience. The analysis of near infrared (NIR) vibrational overtone spectra of some substituted benzene compounds using local mode model forms another part of the present work. An attempt is made to record the pulsed laser induced fluorescence/Raman spectra of some organic compounds. A Q-switched Nd:YAG laser is used as the excitation source. A TRIAX monochromator and CCD detector is used for the spectral recording. The observed fluorescence emission for carbon disulphide is centered at 680 nm; this is assigned as due to the n, p* transition. Aniline also shows a broad fluorescence emission centered at 725 nm, which is due to the p,p* transition. The pulsed laser Raman spectra of some organic compounds are also recorded using the same experimental setup. The calibration of the set up is done using the laser Raman spectra of carbon tetrachloride and carbon disulphide. The observed laser Raman spectra for aniline, o-chloroaniline and m-chlorotoluene show peaks characteristics of the aromatic ring in common and the characteristics peaks due to the substitutuent groups. Some new peaks corresponding to low-lying vibrations of these molecules are also assigned

A Simple Free-Space Method for Measuring the Complex Permittivity of Single and Compound Dielectric Materials

A simple and efficient method for determining the complex permittivity of dielectric materials from both reflected and transmitted signals is presented. It is also novel because the technique is implemented using two pyramidal horns without any focusing mechanisms. The dielectric constant of a noninteractive and distributive (NID) mixture of dielectrics is also determined

Theoretical approach to the magnetostructural correlations in spin-Peierls compound CuGeO3

A theoretical density-functional study has been carried out to analyze the exchange coupling in the chains of CuGeO3 using discrete models. The results show a good agreement with the experimental exchange coupling constant (J) together with a strong dependence of J with the Cu-O-Cu angle. The calculation of the J values for a distorted model indicates a larger degree of dimerization than those reported previously.

Exploring oligo(p-phenylenevinylene) gelators as sensors and stimuli responsive materials

Gelation provides a unique medium, which often induces organization of molecules resulting in the modulation of their optical, morphological and electronic properties thereby opening a new world of fascinating materials with interesting physical properties at nano- meso- and macroscopic levels. Supramolecular gels based on linear π-systems have attracted much attention due to their inherent optical and electronic properties which find application in organic electronics, light harvesting and sensing. They exhibit reversible properties due to the dynamic nature of noncovalent forces. As a result, studies on such soft materials are currently a topic of great interest. Recently, researchers are actively involved in the development of sensors and stimuli-responsive materials based on self-assembled π-systems, which are also called smart materials. The present thesis is divided into four chapters

An inhibitory compound produced by Pseudomonas with effectiveness on Vibrio harveyi

Persistence of the antivibrio property of the potential antagonistic probiotics, Pseudomonas MCCB 102 and 103, at di¡erent temperatures, pH and in organic solvents was studied. The antivibrio compound was extracted, puri¢ed and characterized using thin-layer chromatography, high-pressure liquid chromatography, liquid chromatography-mass spectroscopy, UV^ Vis and nuclear magnetic resonance spectroscopy and identi¢ed as N-methyl-1-hydroxyphenazine, a phenazine antibiotic. The toxicity of the compound was tested in Penaeus monodon haemocyte culture and the IC50 valuewas found to be1.4 0.31mg L 1. The compound was found to be bacteriostatic at 0.5mg L 1. Its stability to varying temperature, pH, organic solvents, prolonged shelf-life and vibriostatic nature point to its suitability for prophylatic aquaculture application.

Self-Assembly of Stimuli-Responsive Water-Soluble [60]Fullerene End-Capped Ampholytic Block Copolymer

Well-defined, water-soluble, pH and temperature stimuli-responsive [60]fullerene (C₆₀) containing ampholytic block copolymer of poly((methacrylic acid)-block-(2-(dimethylamino)ethyl methacrylate))-block–C₆₀ (P(MAA-b-DMAEMA)-b-C₆₀) was synthesized by the atom transfer radical polymerization (ATRP) technique. The self-assembly behaviour of the C₆₀ containing polyampholyte in aqueous solution was characterized by dynamic light scattering (DLS), and transmission electron microscopy. This amphiphilic mono-C₆₀ end-capped block copolymer shows enhanced solubility in aqueous medium at room and elevated temperatures and at low and high pH but phase-separates at intermediate pH of between 5.4 and 8.8. The self assembly of the copolymer is different from that of P(MAA-b-DMAEMA). Examination of the association behavior using DLS revealed the co-existence of unimers and aggregates at low pH at all temperatures studied, with the association being driven by the balance of hydrophobic and electrostatic interactions. Unimers and aggregates of different microstructures are also observed at high pH and at temperatures below the lower critical solution temperature (LCST) of PDMAEMA. At high pH and at temperatures above the LCST of PDMAEMA, the formation of micelles and aggregates co-existing in solution is driven by the combination of hydrophobic, electrostatic, and charge-transfer interactions.

Stimuli-responsive Novel Amphiphilic Polymers for Chemical and Biomedical Applications

Amphiphilic polymers are a class of polymers that self-assemble into different types of microstructure, depending on the solvent environment and external stimuli. Self assembly structures can exist in many different forms, such as spherical micelles, rod-like micelles, bi-layers, vesicles, bi-continuous structure etc. Most biological systems are basically comprised of many of these organised structures arranged in an intelligent manner, which impart functions and life to the system. We have adopted the atom transfer radical polymerization (ATRP) technique to synthesize various types of block copolymer systems that self-assemble into different microstructure when subject to an external stimuli, such as pH or temperature. The systems that we have studied are: (1) pH responsive fullerene (C60) containing poly(methacrylic acid) (PMAA-b-C60); (2) pH and temperature responsive fullerene containing poly[2-(dimethylamino)ethyl methacrylate] (C₆₀-b-PDMAEMA); (3) other responsive water-soluble fullerene systems. By varying temperature, pH and salt concentration, different types microstructure can be produced. In the presence of inorganic salts, fractal patterns at nano- to microscopic dimension were observed for negatively charged PMAA-b-C60, while such structure was not observed for positively charged PDMAEMA-b-C60. We demonstrated that negatively charged fullerene containing polymeric systems can serve as excellent nano-templates for the controlled growth of inorganic crystals at the nano- to micrometer length scale and the possible mechanism was proposed. The physical properties and the characteristics of their self-assembly properties will be discussed, and their implications to chemical and biomedical applications will be highlighted.

Targeted Stimuli-Responsive Dextran Conjugates for Doxorubicin Delivery to Hepatocytes

A targeted, stimuli-responsive, polymeric drug delivery vehicle is being developed in our lab to help alleviate severe side-effects caused by narrow therapeutic window drugs. Targeting specific cell types or organs via proteins, specifically, lectin-mediated targeting holds potential due to the high specificity and affinity of receptor-ligand interactions, rapid internalization, and relative ease of processing. Dextran, a commercially available, biodegradable polymer has been conjugated to doxorubicin and galactosamine to target hepatocytes in a three-step, one-pot synthesis. The loading of doxorubicin and galactose on the conjugates was determined by absorbance at 485 nm and elemental analysis, respectively. Conjugation efficiency based on the amount loaded of each reactant varies from 20% to 50% for doxorubicin and from 2% to 20% for galactosamine. Doxorubicin has also been attached to dextran through an acid-labile hydrazide bond. Doxorubicin acts by intercalating with DNA in the nuclei of cells. The fluorescence of doxorubicin is quenched when it binds to DNA. This allows a fluorescence-based cell-free assay to evaluate the efficacy of the polymer conjugates where we measure the fluorescence of doxorubicin and the conjugates in increasing concentrations of calf thymus DNA. Fluorescence quenching indicates that our conjugates can bind to DNA. The degree of binding increases with polymer molecular weight and substitution of doxorubicin. In cell culture experiments with hepatocytes, the relative uptake of polymer conjugates was evaluated using flow cytometry, and the killing efficiency was determined using the MTT cell proliferation assay. We have found that conjugate uptake is much lower than that of free doxorubicin. Lower uptake of conjugates may increase the maximum dose of drug tolerated by the body. Also, non-galactosylated conjugate uptake is lower than that of the galactosylated conjugate. Microscopy indicates that doxorubicin localizes almost exclusively at the nucleus, whereas the conjugates are present throughout the cell. Doxorubicin linked to dextran through a hydrazide bond was used to achieve improved killing efficiency. Following uptake, the doxorubicin dissociates from the polymer in an endosomal compartment and diffuses to the nucleus. The LC₅₀ of covalently linked doxorubicin is 7.4 μg/mL, whereas that of hydrazide linked doxorubicin is 4.4 μg/mL.

Global and dominance with concentric hierarchical stimuli and orientation classification task. 'Dominancia global y local con est??mulos conc??ntricos y tareas de clasificaci??n de la orientaci??n'

Resumen tomado de la publicaci??n. Resumen tambi??n en ingl??s

Emotional stimuli reduce the attentional blink in sub-clinical anxious subjects. 'Los est??mulos emocionales reducen el parpadeo atencional (attentional blink) en sujetos con ansiedad subcl??nica'

Resumen tomado de la publicaci??n