Evaluation of the Genotoxicity of Chitosan Nanoparticles for Use in Food Packaging Films

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Aluminum tolerance on genotypes of signal grass

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Effects of aluminum on plant growth and nutrient uptake in young physic nut plants

Aluminum (Al3+) toxicity is a major limiting factor to crop productivity in acid soils. The effects of aluminum on root and shoot growth of physic nut (Jatropha curcas L.) young plants and, the uptake and distribution of phosphorus, calcium, magnesium and aluminum in the roots and shoots were investigated in the present study. Plants were grown in 2.5L pots in a greenhouse. After fourteen days of adaptation to nutrient solution, plants were exposed to Al concentrations of 0, 370, 740, 1,100 and 1,480 mu mol L-1, corresponding to an active Al3+ solution of 13.3, 35.3, 90.0, 153.3 and 220.7 mu mol L-1, respectively. The dry matter partitioning between roots, stems and leaves, and the concentrations of P, Ca, Mg and Al in plant tissue, were measured after 75 days exposure to Al. The increasing level of Al3+ activity in solution progressively decreased the growth of the shoot and root of physic nut plants, and at the two highest active Al3+ levels, plants showed morphological abnormalities typical of the toxicity caused by this metal. Higher Al3+ activity reduced P concentrations in leaves and Ca and Mg in leaves and roots of physic nut, demonstrating the effect of Al on the uptake, transport and use of these nutrients by plants. The Al accumulated preferentially in the roots of physic nut, whereas only a small amount was transported to shoots.

Effects of gamma-irradiation on caprolactam level from multilayer PA-6 films for food packaging: Development and validation of a gas chromatographic method

A gas chromatographic method to determine caprolactam in multilayer PA-6 films used for meat foodstuffs and cheese was developed and validated. A wide linear range (0.8-400 mu g/ml), RSD <= 4.1% and recovery higher than 90.0% were obtained for the chromatographic system, while precision and accuracy of the method showed RSD <= 3.8%, recovery from 95.5-100.0% and LOQ of 32 mu g/g. Irradiated (3, 7 and 12 kGy) and non-irradiated commercial films were analyzed. Most of them increased caprolactam levels with the increase of irradiation doses. (C) 2008 Elsevier Ltd. All rights reserved.

MIGRATION MEASUREMENTS FROM PLASTIC PACKAGING: A SIMULATION STUDY ON INFLUENCE OF INITIAL CONCENTRATION PROFILE

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

The transformation between exploration and exploitation applied to inventors of packaging innovations

While the inventor is often the driver of an invention in the early stages, he/she needs to move between different social networks for knowledge in order to create and capture value. The main objective of this research is to propose a literature-based framework based on innovation network theory and complemented with C-K theory, in order to analyze the invention/innovation process of inventors and the product concepts in a packaging industry context. Empirical input from three case studies of packaging inventions and their inventors is used to elaborate the suggested framework.The article identifies important gaps in the literature of innovation networks. This is addressed through a theoretical framework based on network theories, complemented with C-K theory for the product design level. The strength-of-ties dimension of the theoretical framework suggests, in agreement with the mainstream literature and the cases presented, that weak ties are required to access the knowledge related to exploration networks and strong ties are required to utilize the knowledge in the exploitation network. The transformation network is an intermediate step acting as a bridge where entrepreneurs can find required knowledge. The transformation network is also an intermediate step where entrepreneurs find financing and companies interested in commercializing inventions. (C) 2010 Elsevier Ltd. All rights reserved.

Influence of shot peening and hard chromium electroplating on the fatigue strength of 7050-T7451 aluminum alloy

Chromium electrodeposition is a technique for the production of functional coatings on engineering components. These coatings are extensively micro-cracked and present high level of hardness, resistance to corrosion and wear and low coefficient of friction. In this paper the shot peening influence on the fatigue strength of aluminum 7050-T7451 alloy chromium electroplated, was investigated.The shot peening process was carried out to create residual stresses using ceramic and glass shots. A hard chromium electroplated coating of 100 mu m thickness was performed on the base material and the shot peened base material surfaces. S-N curves were obtained in axial and bending fatigue tests and compared with the 7050-T7451 aluminum alloy. In order to study the influence of residual stresses on fatigue life, the behavior of compressive residual stress field was measured by an X-ray tensometry.An increase in the axial fatigue strength of 25% and 50% of ceramic and glass shots, respectively, was observed. The lower performance in fatigue life for ceramic-shot peening may be attributed to higher surface damage, as a consequence of the overpeening intensity performed. However, in bending fatigue the behavior was practically equivalent for both processes. Fracture surface analysis by scanning electron microscopy was used to observe crack origin sites from shot peened and chromium electroplated samples. (C) 2006 Elsevier Ltd. All rights reserved.

Fractal analysis along stretch zone for an aluminum alloy

The topography of fracture surface along stretch zone front for Al7050 is analyzed about its fractal behavior and compared against local distributions of microstructural parameters and stretch zone height, considered here as a toughness parameter. Major influence on microscale was presented by precipitation density. Larger grains should be significant on topographic behavior at macroscale, besides the local toughness measured along stretch zone. The large scattering of fractal measurements along specimen width should limit the validity of models relating fractal values and fracture toughness. It is proposed that models based on mixed fractals must also consider some dispersion parameter instead of mean fractal measurements due to the overall complexity of fracture relief formation. It is suggested that sampling for fractal measurement must be restricted to plane strain region along fracture surface, due to smaller scattering in this region. (C) 2004 Elsevier B.V. All rights reserved.

Evaluation on fatigue strength of AISI 4340 steel aluminum coated by electroplating and IVD processes

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Fatores de sucesso ou insucesso do turismo ambientalmente sustentável : percepção das autoridades públicas no pólo costa das dunas do Rio Grande do Norte

This study aims to compare the thermal performance of tiles made from recycled material (waste packaging cardboard with aluminized film) with the tiles of fiber and bitumen, fiber cement and red ceramic with the aim of verifying the suitability of tile to be used in hot and humid climate of low latitude. The samples were selected according to the availability from Natal RN market, as they are sold to the consumers. The methodology was based on studies that used experimental apparatus composed of thermal chambers heated by banks of incandescent bulbs, to analyze the thermal performance of materials. The tiles in the study were submitted to analysis of thermal performance, thermophysical properties and absorptance, using chambers of thermal performance, measuring the thermophysical properties and portable spectrometer, respectively. Comparative analysis of thermal performance between two samples of the recycled material with dimple sizes and different amounts of aluminum were made, in order to verify, if these characteristics had some interference on the thermal performance of them; the results showed no significant performance differences between the samples. The data obtained in chambers of thermal performance and confirmed by statistical analysis, showed, that the tile of recycled material have similar thermal performance to the tile of fiber cement. In addition to these tests was carried out the automatic monitoring of a building covered with tiles of recycled material, to verify its thermal performance in a real situation. The results showed that recycled shingles must be used with technical criteria similar to those used for fiber cement tiles, with regard to the heat gain into the building. Within these criteria should be taken into account local characteristics, especially in regions with hot and humid climate, and its use must be associated, according to the literature, to elements of thermal insulation and use of passive techniques such as vented attics, ceilings and right foot higher

Large nuclear vacuoles are indicative of abnormal chromatin packaging in human spermatozoa

The aim of this investigation was to determine the presence of abnormal sperm chromatin packaging in spermatozoa with large nuclear vacuoles (LNV) selected via high magnification by analysing the pattern of chromomycin A3 (CMA3) staining. A prospective observational study was designed to analyse semen samples obtained from 66 men undergoing infertility diagnosis and treatment. The numbers of cells with normal (dull yellow staining of the sperm head/CMA3-negative) and abnormal (bright yellow fluorescence of the sperm head/CMA3-positive) chromatin packaging were determined on slides with normal and LNV spermatozoa. The presence of bright yellow fluorescence (CMA3-positive) was significantly higher (p < 0.0001) in spermatozoa with LNV than in normal spermatozoa (719/1351; 53.2% vs. 337/835; 40.3%, respectively), reflecting a higher percentage of abnormal chromatin packaging in spermatozoa with large LNV. Our data support the hypothesis that the presence of LNV reflects the presence of abnormal chromatin packaging, which may facilitate sperm DNA damage. As sperm nuclear vacuoles are evaluated more precisely at high magnifications using motile sperm organelle morphology examination (MSOME), the present results support the use of high-magnification sperm selection for intracytoplasmic sperm injection (ICSI).

Acrosomal ultrastructure of stallion spermatozoa cryopreserved with ethylene glycol using two packaging systems

The present experiments aimed to examine the substitution of glycerol (G) by ethylene glycol (E) as a cryoprotective agent for stallion spermatozoa. Two different ethylene glycol concentrations (5% and 10%) and also the association of glycerol (2%) and ethylene glycol (3%) (E/G) were studied (Experiment 1). In Experiment 2, two packing systems (0.5 x 4.0 ml) were evaluated using both cryoprotectors. In both experiments, the sperm membrane integrity after freezing was evaluated using transmission electron microscopy. The mean post-thaw motility was 34.25, 36.5, 29.25 and 34.75% for G5%, E5%, E10% and E/G, respectively. It was observed that the percentage of motile spermatozoa was significantly smaller (P<0.05) when semen was processed with E10%. A decrease in the acrosome integrity was observed in frozen thawed spermatozoa from all treated groups. It was observed that 28.0, 22.5, 25.5 and 22.5 % of the sperm cells had a normal acrosome following freezing with G5%, E5%, E10% and E/G, respectively. Undulation of the outer acrosomal membrane, acrosomal swelling and loss of acrosomal content density and homogeneity were the most evident ultrastructural alterations observed. In Experiment 2, the post-thaw motility was higher (P<0.05) for sperm frozen in 0.5 ml straws than in 4.0 mi straws, regardless of the cryoprotector used. The ultrastructural evaluation showed 26.7 and 16.0% of intact acrosomes for sperm frozen in 0.5 ml and 4.0 ml straws, respectively. We concluded that ethylene glycol has similar cryoprotective properties to glycerol and that utilisation of 0.5 ml straws improved the ability of horse sperm cells to withstand damage after the cryopreservation process.

Comparative analysis of root surface smear layer removal by different etching modalities or erbium:yttrium-aluminum-garnet laser irradiation. A scanning electron microscopy study

The purpose of this study was to evaluate the effect of erbium:yttrium-aluminum-garnet (Er:YAG) laser (2.94 mu m) irradiation on the removal of root surface smear layer of extracted human teeth and to compare its efficacy with that of citric acid, ethylenediamine tetra-acetic acid (EDTA), or a gel containing a mixture of tetracycline hydrochloride (HCl) and citric acid, using scanning electron microscopy (SEM). Thirty human dentin specimens were randomly divided into six groups: G1 (control group), irrigated with 10 ml of physiologic saline solution; G2, conditioned with 24% citric acid gel; G3, conditioned with 24% EDTA gel; G4, conditioned with a 50% citric acid and tetracycline gel; G5, irradiated with Er:YAG laser (47 mJ/10 Hz/5.8 J/cm(2)/pulse); G6, irradiated with Er:YAG laser (83 mJ/10 Hz/10.3 J/cm(2)/pulse). Electron micrographs were obtained and analyzed according to a rating system. Statistical analysis was conducted with Kruskal-Wallis and Mann-Whitney tests (P < 0.05). G1 was statistically different from all the other groups; no statistically significant differences were observed between the Er:YAG laser groups and those undergoing the other treatment modalities. When the two Er:YAG laser groups were compared, the fluency of G6 was statistically more effective in smear layer removal than the one used in G5 (Mann-Whitney test, P < 0.01). Root surfaces irradiated by Er:YAG laser had more irregular contours than those treated by chemical agents. It can be concluded that all treatment modalities were effective in smear layer removal. The results of our study suggest that the Er:YAG laser can be safely used to condition diseased root surfaces effectively. Furthermore, the effect of Er:YAG laser irradiation on root surfaces should be evaluated in vivo so that its potential to enhance the healing of periodontal tissues can be assessed.

Effects of aluminum-copper alloy filtration on photon spectra, air kerma rate and image contrast

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)