热处理对尼龙1010结构影响研究

采用ＷＡＸＤ，ＳＡＸＳ方法研究了热处理对尼龙１０１０聚集态结构的影响．结果表明，在温度为１７５℃左右对样品进行退火处理可获得较完善的结晶．利用Ｗｃ．ｘ~Ｔ关系曲线外推法得到尼龙１０１０样品的Ｔｇ大约为５８℃．根据一维电子密度相关函数法求得了系列样品在所研究条件下的结晶片层厚，过渡层厚，长周期和结晶非晶相间的密度差．得到了不同退火条件尼龙１０１０样品的结晶相密度ρｃ．

辐照异相成核结晶PA1010体系的ESR研究——结晶表面积对俘陷自由基的影响

本文通过WAXD,DSC方法讨论成核剂(Nd2O3)对PA1010的聚集态结构的影响。用ESR研究辐照不同聚集态结构PA1010体系的俘陷自由基行为。结果表明:俘陷自由基—CH2CONHCHCH2—主要存在于结晶表面,结晶的表面积越大,俘陷自由基—CH2CONHCHCH2—的含量越高,在一定条件下,如升温,常温放置一段时间,转化为俘陷自由基—CH2C=O的量也越大;俘陷自由基-CH2C=O主要存在于非晶区

LLDPE／LDPE共混体系的相容性与性能

ＬＬＤＰＥ／ＬＤＰＥ共混体系的相容性与性能杨毓华，花荣，白春霞，于旻李三喜，葛铁军（中国科学院长春应用化学研究所长春１３００２２）（沈阳化工学院高分子系沈阳）关键词ＤＳＣ，ＷＡＸＤ，力学性能，ＬＬＤＰＥ，ＬＤＰＥ，共混，相容性非晶－非晶－结晶共混体系...

Synthesis and characterization of thermotropic copolyesters and copoly(ester-amide)s containing oxyethylene-ether as the spacer

Flexible oxyethylene-ether was introduced into the aromatic copolyesters and copoly (ester-amide)s to reduce the melting point of resulting polymers. The melting point was greatly reduced to 200 degrees C or even lower in some cases, and the molecular weight was satisfactorily high as reflected by inherent viscosity. The polymers exhibited high thermal stability and good mechanical properties as determined by TGA and mechanical tests. The copolyester showed better crystallinity and liquid crystallinity than corresponding copoly (ester-amide)s with similar monomer composition as reflected by POM observation and WAXD study. The melting points for both copolyesters and copoly (ester-amide)s showed great dependence on the p-acetoxybenzoic acid (PAB) content in monomer composition and reached the lowest value when PAB was 29 mol%.

THE INFLUENCE OF GAMMA-RADIATION ON POLYAMIDE-1010 AGGREGATE STRUCTURES

The influence of gamma-radiation on polyamide 1010 aggregate structures and crystal damage were examined by using wide angle X-ray diffraction (WAXD) and small angle X-ray scattering (SAXS) techniques. The results revealed that some structural parameters of the aggregated state, the density differences and the degree of crystallinity W-c,W-x, essentially decreased with increasing radiation dose, but the specific surface O-s increased. Crosslinking and scission of irradiated polyamide 1010 samples occurred mainly in amorphous and interphase regions, and crystal damage and amorphization induced by gamma-radiation spread from the interphase and extended into the crystal phase with increasing radiation dose. This result also indicated that the (010) reflection with the hydrogen bond was more susceptible to the action of radiation.

LIQUID-CRYSTALLINE POLYSURFACTANT

A new kind of amphiphilic polymer(PAMC(16)B) has been synthesized where the amphiphilic moiety is attached as a side chain via the hydrophilic end to the polymer backbone. DSC, POM, and WAXD study revealed that the polysurfactant formed thermotropic liquid crystalline phase. The liquid crystalline domains appeared after annealed at the melt for a period of time, and evolved with annealing. It was indicated that the thermodynamic effect played a significant role on the self-aggregation of hydrophobic ends, so as to form liquid crystalline structure. X-ray investigation suggested that the mesophase structure could be described as smectic with lamellar type of packing, in which alkyl tails aggregated to form layer, A model of supermolecular structure was given.

SYNTHESIS AND CHARACTERIZATION OF POLYACRYLATES CONTAINING CHARGE-TRANSFER GROUPS

Polyacrylates containing para-nitro azobenzene have been synthesized by free radical polymerization. The influence of the length of the spacer of the homopolyacrylates (HPn, n=3,4,6), content of methyl acrylate in the copolyacrylates (CP6) with para-nitro azobenzene groups on the thermal properties, such as liquid crystallinity, Tg and Tm, was studied by DSC, WAXD and polarized optical microscopy. Among the polymers studied, only the homopolyacrylate (HP6)with six carbon atoms in the spacer exhibited a nematic phase. The second-harmonic generation (SHG) signal of the poled HP6 film was detected qualitatively by Maker-fringer method.

ULTRASTRUCTURE OF LIQUID-CRYSTALLINE POLYACRYLATES CONTAINING P-NITRO AZOBENZENE

The phase behaviour ai the side chain liquid crystalline polyacrylates containing p-nitro azobenzene was studied bg DSC, WAXD and the polarized optical microscopy. It was shown that nematic phase can be formed for homopolymer HP6, no LC phase can be observed for HF3 and HP4; whereas smectic S-Ad phase can be obtained tor P-n when n was equal to 3,4, 6,8. The unique phase behaviour of the copolymers P-n was due to the existence of H bond between -COOH and -NO2 which lias been confirmed by FTIR. The molecular arrangement of the copolymers in their LC states was proposed from the results of WAXD and FTIR.

Synthesis and properties of thermotropic liquid crystalline copolyesters containing bis(4-hydroxyphenyl)methanone(V)

A new series of fully aromatic thermotropic liquid crystalline copolyesters were synthesized by thermal polycondensation of p-hydroxybenzoic acid (PHB), terephthalic acid (TPA), resorcinol (RES) and bis (4-hydroxyphenyl) methanone (BHP). The DSC traces of copolyesters exhibited two or three endotherms, the low temperature endotherm(Tm) of which indicated the transition from solid state to anisotropic phase. Observation under polarizing microscope and WAXD measurements suggested that the LC-phase formed immediately above Tm had a nematic character.

Synthesis and properties of thermotropic liquid crystalline copolyesters containing bis(4-hydroxyphenyl)methanone(IV)

A series of thermotropic liquid crystalline copolyesters were synthesized by thermal polycondensation of p-hydroxybenzoic acid, terephthalic acid, bis (4-hydroxyphenyl) methanone and diols. The resulting copolyesters were characterized by WAXD,DSC and PLM. All the copolyesters formed a nematic phase.

COMPATIBILIZATION AND STRUCTURE OF POLY(PROPYLENE) NYLON-12 BLENDS

In this paper, scanning electron microscopy (SEM), differential scanning calorimetry (DSC) and wide-angle X-ray diffraction (WAXD) were used to study the structure and compatibilization of poly(propylene) (PP)/nylon-12 (PA 12) blends. The compatibilizatio

尼龙－1010的聚集态结构

用ＷＡＸＤ、ＤＳＣ、方差－范围函数．密度测量等方法，研究了经不同热处理的尼龙－１０１０的聚集态结构．发现退火处理更有利于尼龙－１０１０结晶的生成和稳定，且尼龙－１０１０的结晶，有一个最佳的热处理温度．在该温度附近，尼龙－１０１０的结晶度和微晶尺寸里最大值．

MOLECULAR CHARACTERISTICS AND CRYSTALLINE-STRUCTURE OF ETHYLENE-DIMETHYLAMINOETHYL-METHACRYLATE COPOLYMERS

The relationship between molecular and crystalline structural characteristics of the ethylene -dimethylaminoethylmethacrylate copolymers (EDAM) was investigated and related to melt flow index MI and average gross content of DAM comonomer, in comparison with low density polyethylene (LDPE) produced by the common high-pressure radical polymerization process. Although the average molecular weight and its distribution are influenced predominantly by the polymerization conditions, DAM-content seems not to depend significantly on molecular weight according to the GPC-FT/IR measurement. Comonomer sequence distributions were determined quantitatively with the C-13-NMR spectra entirely assigned by DEPT and H-1-C-13 COSY techniques. The result suggests the alternating copolymerization tendency and surprisingly coincides with the simulation out-puts based on the assumption of continuous complete mixing reactor model, using Mayo-Lewis equation and the same Q-e values as previously reported on different types of copolymers such as EVA and St.DAM (VA;vinylacetate, St;styrene). It was confirmed by WAXD and SAXS analyses that the crystallinity X(c) and the thickness of lamellar crystal l(c) decreased with increasing DAM-content, whereas the a-lattice and b-lattice dimensions enlarged. X(c) and l(c) can definitely be correlated to the heats of fusion and crystallization measured by DSC. The average size of spherulites measured with light scattering photometry tends to be enlarged with decreasing molecular weight (increasing MI) and DAM-content.

STRUCTURES AND PROPERTIES OF DIALKYL FUMARATES POLYMERS

Polymers of methyl-iso-propyl fumarate, di-iso-propyl fumarate, di-t-butyl fumarate, di-s-butyl fumarate, di-s-amyl fumarate and di-cyclo-hexyl fumarate were prepared by radical polymerization. The structures of the polymers were examined by H-1-NMR, C-13-NMR and WAXD. Some properties of the polymers, including thermal properties, were examined.

CRYSTAL-STRUCTURE AND THERMODYNAMIC PARAMETERS OF NYLON-1010

WAXD, SAXS, FTIR, DSC and density techniques have been used to investigate the crystal structure, crystal density rho(c), amorphous density rho(a), equilibrium heat of fusion DELTAH(m)degrees and equilibrium melting temperature T(m)degrees. By extrapolating the straight lines in the FTIR absorbance against density plot to zero intensity, rho(c) and rho(a) were estimated to be 1.098 and 1.003 g/cm3 respectively. The rho(c) obtained was too low in value. From X-ray diffraction patterns of uniaxially oriented fibres, the crystal structure of Nylon-1010 was determined. The Nylon-1010 crystallized in the triclinic system, with lattice dimensions: a = 4.9 angstrom, b = 5.4 angstrom, c = 27.8 angstrom, alpha = 49-degrees, beta = 77-degrees, gamma = 63.5-degrees. The unit cell contained one monomeric unit, the space group was P1BAR, and the correct value of rho(c) was 1.135 g/cm3. The degree of crystallinity of the polymer was determined as about 60% (at RT) using Ruland's method. SAXS has been used to investigate the crystalline lamellar thickness, long period, transition zone, the specific inner surface and the electron density difference between the crystalline and amorphous regions for Nylon-1010. The analysis of data was based upon a one-dimensional electron-density correlation function. DELTAH(m)degrees was estimated to be 244.0 J/g by extrapolation of DELTAH(m)degrees in the plot of heat of fusion against specific volume of semicrystalline specimens to the completely crystalline condition (V(sp)c = 1/rho(c)). Owing to the ease of recrystallization of melt-crystallized Nylon-1010 specimens, the well-known Hoffman's T(m)-T(c) method failed in determining T(m)degrees and a Kamide double extrapolation method was adopted. The T(m)degrees value so obtained was 487 K.