Low-frequency, high-density, inductively coupled plasma sources : operation and applications

Operation regimes, plasma parameters, and applications of the low-frequency (∼500 kHz) inductively coupled plasma (ICP) sources with a planar external coil are investigated. It is shown that highly uniform, high-density (ne∼9×1012 cm-3) plasmas can be produced in low-pressure argon discharges with moderate rf powers. The low-frequency ICP sources operate in either electrostatic (E) or electromagnetic (H) regimes in a wide pressure range without any Faraday shield or an external multipolar magnetic confinement, and exhibit high power transfer efficiency, and low circuit loss. In the H mode, the ICP features high level of uniformity over large processing areas and volumes, low electron temperatures, and plasma potentials. The low-density, highly uniform over the cross-section, plasmas with high electron temperatures and plasma and sheath potentials are characteristic to the electrostatic regime. Both operation regimes offer great potential for various plasma processing applications. As examples, the efficiency of the low-frequency ICP for steel nitriding and plasma-enhanced chemical vapor deposition of hydrogenated diamond-like carbon (DLC) films, is demonstrated. It appears possible to achieve very high nitriding rates and dramatically increase micro-hardness and wear resistance of the AISI 304 stainless steel. It is also shown that the deposition rates and mechanical properties of the DLC films can be efficiently controlled by selecting the discharge operating regime.

Effect of ion current density on the properties of vacuum arc-deposited TiN coatings

The influence of ion current density on the thickness of coatings deposited in a vacuum arc setup has been investigated to optimize the coating porosity. A planar probe was used to measure the ion current density distribution across plasma flux. A current density from 20 to 50 A/m2 was obtained, depending on the probe position relative to the substrate center. TiN coatings were deposited onto the cutting inserts placed at different locations on the substrate, and SEM was used to characterize the surfaces of the coatings. It was found that lowdensity coatings were formed at the decreased ion current density. A quantitative dependence of the coating thickness on the ion current density in the range of 20-50 A/m2 were obtained for the films deposited at substrate bias of 200 V and nitrogen pressure 0.1 Pa, and the coating porosity was calculated. The coated cutting inserts were tested by lathe machining of the martensitic stainless steel AISI 431. The results may be useful for controlling ion flux distribution over large industrial-scale substrates.

Charge transport and density of trap states in balanced high mobility ambipolar organic thin-film transistors

We report on charge transport and density of trap states (trap DOS) in ambipolar diketopyrrolopyrrole-benzothiadiazole copolymer thin-film transistors. This semiconductor possesses high electron and hole field-effect mobilities of up to 0.6 cm 2/V-s. Temperature and gate-bias dependent field-effect mobility measurements are employed to extract the activation energies and trap DOS to understand its unique high mobility balanced ambipolar charge transport properties. The symmetry between the electron and hole transport characteristics, parameters and activation energies is remarkable. We believe that our work is the first charge transport study of an ambipolar organic/polymer based field-effect transistor with room temperature mobility higher than 0.1 cm 2/V-s in both electrons and holes.

Interpreting scratch assays using pair density dynamics and approximate Bayesian computation

Quantifying the impact of biochemical compounds on collective cell spreading is an essential element of drug design, with various applications including developing treatments for chronic wounds and cancer. Scratch assays are a technically simple and inexpensive method used to study collective cell spreading; however, most previous interpretations of scratch assays are qualitative and do not provide estimates of the cell diffusivity, D, or the cell proliferation rate,l. Estimating D and l is important for investigating the efficacy of a potential treatment and provides insight into the mechanism through which the potential treatment acts. While a few methods for estimating D and l have been proposed, these previous methods lead to point estimates of D and l, and provide no insight into the uncertainty in these estimates. Here, we compare various types of information that can be extracted from images of a scratch assay, and quantify D and l using discrete computational simulations and approximate Bayesian computation. We show that it is possible to robustly recover estimates of D and l from synthetic data, as well as a new set of experimental data. For the first time, our approach also provides a method to estimate the uncertainty in our estimates of D and l. We anticipate that our approach can be generalized to deal with more realistic experimental scenarios in which we are interested in estimating D and l, as well as additional relevant parameters such as the strength of cell-to-cell adhesion or the strength of cell-to-substrate adhesion.

Silvicultural management of Hypsipyla species

Existing evidence for successful silvicultural control of Hypsipyla spp. is conflicting and to a large extent anecdotal. Levels of attack have been correlated with factors such as shade, planting density, species mixtures, site characteristics, etc. These factors have often been poorly defined and are usually interdependent. The actual mechanisms that determine whether or not Hypsipyla spp. adversely affects plants we define as host-finding, host suitability, host recovery and natural enemies. These mechanisms can be influenced by the silvicultural techniques applied to a stand. Success of silvicultural techniques can usually be attributed to more than one mechanism and it is difficult to assess which is most the important for minimising the impact of Hypsipyla as these analytical data are lacking. This highlights the need for further research on silvicultural methods for controlling Hypsipyla spp. However, several silvicultural techniques that are briefly described show promise for improving the performance of future plantations. Examples of silvicultural control are reviewed with reference to these mechanisms.

Development of a dragline in-bucket bulk density monitor

This paper details the implementation and trialling of a prototype in-bucket bulk density monitor on a production dragline. Bulk density information can provide feedback to mine planning and scheduling to improve blasting and consequently facilitating optimal bucket sizing. The bulk density measurement builds upon outcomes presented in the AMTC2009 paper titled ‘Automatic In-Bucket Volume Estimation for Dragline Operations’ and utilises payload information from a commercial dragline monitor. While the previous paper explains the algorithms and theoretical basis for the system design and scaled model testing this paper will focus on the full scale implementation and the challenges involved.

Mismatch negativity in recent-onset and chronic schizophrenia : a current source density analysis

Mismatch negativity (MMN) is a component of the event-related potential elicited by deviant auditory stimuli. It is presumed to index pre-attentive monitoring of changes in the auditory environment. MMN amplitude is smaller in groups of individuals with schizophrenia compared to healthy controls. We compared duration-deviant MMN in 16 recent-onset and 19 chronic schizophrenia patients versus age- and sex-matched controls. Reduced frontal MMN was found in both patient groups, involved reduced hemispheric asymmetry, and was correlated with Global Assessment of Functioning (GAF) and negative symptom ratings. A cortically-constrained LORETA analysis, incorporating anatomical data from each individual's MRI, was performed to generate a current source density model of the MMN response over time. This model suggested MMN generation within a temporal, parietal and frontal network, which was right hemisphere dominant only in controls. An exploratory analysis revealed reduced CSD in patients in superior and middle temporal cortex, inferior and superior parietal cortex, precuneus, anterior cingulate, and superior and middle frontal cortex. A region of interest (ROI) analysis was performed. For the early phase of the MMN, patients had reduced bilateral temporal and parietal response and no lateralisation in frontal ROIs. For late MMN, patients had reduced bilateral parietal response and no lateralisation in temporal ROIs. In patients, correlations revealed a link between GAF and the MMN response in parietal cortex. In controls, the frontal response onset was 17 ms later than the temporal and parietal response. In patients, onset latency of the MMN response was delayed in secondary, but not primary, auditory cortex. However amplitude reductions were observed in both primary and secondary auditory cortex. These latency delays may indicate relatively intact information processing upstream of the primary auditory cortex, but impaired primary auditory cortex or cortico-cortical or thalamo-cortical communication with higher auditory cortices as a core deficit in schizophrenia.

Interface of graphane with copper : a van der Waals density-functional study

Various forms of hydrogenated graphene have been produced to date by several groups, while the synthesis of pure graphane has not been achieved yet. The study of the interface between graphane, in all its possible hydrogenation configurations, and catalyst metal surfaces can be pivotal to assess the feasibility of direct CVD growth methods for this material. We investigated the adhesion of graphane to a Cu(111) surface by adopting the vdW-DF2-C09 exchange-correlation functional, which is able to describe dispersion forces. The results are further compared with the PBE and the LDA exchange-correlation functionals. We calculated the most stable geometrical configurations of the slab/graphane interface and evaluated how graphane's geometrical parameters are modified. We show that dispersion forces play an important role in the slab/graphane adhesion. Band structure calculations demonstrated that in the presence of the interaction with copper, the band gap of graphane is not only preserved, but also enlarged, and this increase can be attributed to the electronic charge accumulated at the interface. We calculated a substantial energy barrier at the interface, suggesting that CVD graphane films might act as reliable and stable insulating thin coatings, or also be used to form compound layers in conjunction with metals and semiconductors.

Simulation-based density estimation for time series using covariate data

This paper proposes a simulation-based density estimation technique for time series that exploits information found in covariate data. The method can be paired with a large range of parametric models used in time series estimation. We derive asymptotic properties of the estimator and illustrate attractive finite sample properties for a range of well-known econometric and financial applications.

With budget cuts coming, ABC and SBS stand divided

Did SBS chief executive Michael Ebeid score a well-timed free kick or an own goal in his attack on the ABC this week? The ABC recently secured the free-to-air television rights for the Asian Cup football tournament to be held in Australia early next year, together with tonight’s match between the Socceroos and Japan. A lower bid by SBS – still in some circles fondly known as the “Soccer Broadcasting Service” – was rejected, dealing a significant blow to the smaller public broadcaster. The ABC was reportedly asked to make a bid by Football Federation Australia. The FFA presumably believes the ABC’s coverage will attract larger audiences to the game. This is despite SBS’s long-term success with the sport. It should not be forgotten, however, that while SBS has largely been defined by its long connection with the world game, ABC was the home of football from the late 1950s until the 1980s. But the stoush is only partly about football. It was surely no coincidence that it comes on the eve of the government’s formal announcement of the size of the cuts to public broadcasting...

Density of trap states in a polymer field-effect transistor

We report a more accurate method to determine the density of trap states in a polymer field-effect transistor. In the approach, we describe in this letter, we take into consideration the sub-threshold behavior in the calculation of the density of trap states. This is very important since the sub-threshold regime of operation extends to fairly large gate voltages in these disordered semiconductor based transistors. We employ the sub-threshold drift-limited mobility model (for sub-threshold response) and the conventional linear mobility model for above threshold response. The combined use of these two models allows us to extract the density of states from charge transport data much more accurately. We demonstrate our approach by analyzing data from diketopyrrolopyrrole based co-polymer transistors with high mobility. This approach will also work well for other disordered semiconductors in which sub-threshold conduction is important.

Long-tailed bats' use of a Pinus radiata stand in Kinleith Forest : Recommendations for monitoring

Targeted monitoring of threatened species within plantations is becoming more important due to forest certification programmes’ requirement to consider protection of threatened species, and to increase knowledge of the distribution of species. To determine patterns of long-tailed bat (Chalinolobus tuberculatus) activity in different habitat structures, with the aim of improving the likelihood of detection by targeting monitoring, we monitored one stand of 26 year-old Pinus radiata over seven months between December 2007 and June 2008 in Kinleith Forest, an exotic plantation forest centred around Tokoroa, South Waikato, New Zealand. Activity was determined by acoustic recording equipment, which is able to detect and record bats’ echolocation calls. We monitored activity from sunset to sunrise along a road through the stand, along stand edges, and in the interior of the stand. Bats were recorded on 80% of the 35 nights monitored. All activity throughout the monitoring period was detected on the edge of the stand or along the road. No bats were detected within the interior of the stand. Bat activity was highest along the road through the stand (40.4% of all passes), followed by an edge with stream running alongside (35.2%), along the road within a skidsite (19.8%), and along an edge without a stream (4.6%). There was a significant positive relationship between bat pass rate (bat passes h-1) and the feeding buzz rate (feeding buzzes h-1) indicating that bat activity was associated with feeding and not just commuting. Bat feeding activity was also highest along the road through the stand (59.2% of feeding buzzes), followed by the road within the skidsite (30.6%), and along the stream-side edge (10.2%). No feeding buzzes were recorded in either the interior or along the edge without the stream. Differences in overall feeding activity were significant only between the road and edge and between edges with and without a stream. Bat activity was detected each month and always by the second night of monitoring, and in this stand was highest during April. We recommend targeted monitoring for long-tailed bats be focused on road-side and stand edge habitat, and along streams, and that monitoring take place for at least three nights to maximise probability of detection.