953 resultados para CsI(Tl)-detector
Resumo:
A realistic measurement setup for a system such system measured by a mesoscopie detector,is theoretically as a charged two-state (qubit) or multi-state quantum studied. To properly describe the measurement-induced back-action,a detailed-balance preserved quantum master equation treatment is developed. The established framework is applicable for arbitrary voltages and temperatures.
Resumo:
A SiGe/Si multi-quantum wells resonant-cavity-enhanced(RCE) detector with high reflectivity bottom mirror is fabricated by a new method.The bottom mirror is deposited in the hole,which is etched from the backside of the sample by ethylenediamine-pyrocatechol-water(EPW) solution with the buried SiO2 layer in SOI substrate as the etching-stop layer.Reflectivity spectrum indicates that the mirror deposited in the hole has a reflectivity as high as 99% in the range of 1.2~1.5μm.The peak responsivity of the RCE detector at 1.344μm is 1.2mA/W and the full width at half maximum is 12nm.Compared with the conventional p-i-n photodetector,the responsivity of RCE detector is enhanced 8 times.
Resumo:
Large area (25 mm(2)) silicon drift detectors and detector arrays (5x5) have been designed, simulated, and fabricated for X-ray spectroscopy. On the anode side, the hexagonal drift detector was designed with self-biasing spiral cathode rings (p(+)) of fixed resistance between rings and with a grounded guard anode to separate surface current from the anode current. Two designs have been used for the P-side: symmetric self-biasing spiral cathode rings (p(+)) and a uniform backside p(+) implant. Only 3 to 5 electrodes are needed to bias the detector plus an anode for signal collection. With graded electrical potential, a sub-nanoamper anode current, and a very small anode capacitance, an initial FWHM of 1.3 keV, without optimization of all parameters, has been obtained for 5.9 keV Fe-55 X-ray at RT using a uniform backside detector.
Resumo:
To achieve a better time resolution of a scintillator-bar detector for a neutron wall at the external target facility of HIRFL-CSR,we have carried out a detailed study of the photomultiplier,the wrapping material and the coupling media. The timing properties of a scintillator-bar detector have been studied in detail with cosmic rays using a high and low level signal coincidence. A time resolution of 80 ps has been achieved in the center of the scintillator-bar detector.
Resumo:
对中国科学院近代物理研究所自行生长的铊激活碘化铯闪烁晶体CsI(T1)光输出及Hamamtsu公司生产的S8664-1010型雪崩光二极管(APD)增益对温度的依赖关系做了系统研究.结果表明,CsI(T1)晶体光产额在室温范围内随着温度的增加而增加,在-2℃—8℃温度范围内的平均温度系数为0.67%/℃,在8℃—25℃温度范围内的平均温度系数为0.33%/℃.而对所使用的APD,其增益在室温范围内的温度系数为-3.68%/℃(工作电压400V).APD结合CsI(T1)晶体在室温下对~(137)Cs的662keYγ射线的能量分辨可达5.1%.
Resumo:
利用能量为170MeV的35Cl束流,通过157Gd(35Cl,4n)熔合蒸发反应研究了188Tl的高自旋态能级结构.依据实验结果建立了188Tl基于πh9/2(?)vi13/2组态的转动带.根据双奇Tl核能级结构的相似性,指定了188Tlπh9/2(?)vi13/2扁椭球转动带的自旋值.结果表明在188Tl中,πh9/2(?)vi13/2扁椭球转动带在低自旋区具有旋称反转性质.利用包含了质子-中子剩余相互作用的准粒子-转子模型,定性地解释了πh9/2(?)vi13/2扁椭球转动带的低自旋区旋称反转现象.
Resumo:
利用能量为 1 6 7— 1 75MeV的35Cl束流 ,通过16 0 Gd(35Cl,5n)熔合蒸发反应研究了190 Tl的高自旋态能级结构 .实验建立了190 Tl基于πh9/2 νi13/2 组态的转动带 .在束测量结果和194 Biα衰变的α γ测量结果确定地指定了190 Tl的πh9/2 νi13/2 转动带的自旋值 .基于自旋指定 ,发现了190 Tl的πh9/2 νi13/2 扁椭球转动带在低自旋时旋称反转 .这是首次在基于πh9/2 νi13/2 组态的扁椭球转动带中观测到旋称反转 .考虑了质子 -中子剩余相互作用的粒子 -转子模型能够解释πh9/2 νi13/2 扁椭球转动带的低自旋旋称反转 .
Resumo:
In this paper a two dimensional readout micromegas detector with a polyethylene foil as converter was simulated on GEANT4 toolkit and GARFIELD for fast neutron detection. A new track reconstruction method based on time coincidence technology was developed in the simulation to obtain the incident neutron position. The results showed that with this reconstruction method higher spatial resolution was achieved.
Resumo:
In present paper, a new Micromegas detector is developed, and its time and energy signals are obtained in the figure form. The rising time of fast time signal is less than 2 ns due to the very fast collection of avalanche electrons, and the rising time of the energy pulse is about 100 ns, which is corresponding to the total collecting time of the electrons and ions in the avalanche process. The counter plateau, energy resolution and the gas gains of the detector have been compared with other groups' experimental results and the Garfield simulation result.
Resumo:
The necessity of installing a forward tracking detector stack is discussed for the Hadron Physics LanzhoU Spectrometer(HPLUS). A local tracker is developed to solve the multi-track finding problem. The track candidates are searched iteratively via Hough Transform. The fake tracks are removed by a least square fitting process. With this tracker we have studied the feasibility of pp -> pp + phi(-> K+K-), a typical physical channel proposed on HPLUS. The single track momentum resolution due to the uncertainty of the positioning in FTD is 1.3%. The multiple scattering effect contributes about 20% to the momentum resolution in the FTD coverage. The width and the signal-to-background ratio of the reconstructed phi are 1.51 MeV and 4.36, respectively, taking into account the direct Kaon channel pp -> pp + K+K- as background. The geometry coverage of FTD for phi events is about 85.4%. Based on the current fast simulation and estimation, the geometrical configuration of FTD meets the physical requirement of HPLUS under the current luminosity and multiplicity conditions. The tracker is applicable in the full simulation coming next and is extendable to other tracking component of HPLUS.