Geochemistry of sediment cores GeoB13820-1 and GeoB13863-1 from the western South Atlantic

Here, we present results from sediments collected in the Argentine Basin, a non-steady state depositional marine system characterized by abundant oxidized iron within methane-rich layers due to sediment reworking followed by rapid deposition. Our comprehensive inorganic data set shows that iron reduction in these sulfate and sulfide-depleted sediments is best explained by a microbially mediated process-implicating anaerobic oxidation of methane coupled to iron reduction (Fe-AOM) as the most likely major mechanism. Although important in many modern marine environments, iron-driven AOM may not consume similar amounts of methane compared with sulfate-dependent AOM. Nevertheless, it may have broad impact on the deep biosphere and dominate both iron and methane cycling in sulfate-lean marine settings. Fe-AOM might have been particularly relevant in the Archean ocean, >2.5 billion years ago, known for its production and accumulation of iron oxides (in iron formations) in a biosphere likely replete with methane but low in sulfate. Methane at that time was a critical greenhouse gas capable of sustaining a habitable climate under relatively low solar luminosity, and relationships to iron cycling may have impacted if not dominated methane loss from the biosphere.

Geochemistry, mineralogy and isotopes at DSDP Hole 62-464

The relationships between mineralogical and geochemical data on the three successive sedimentary facies at Deep Sea Drilling Project Site 464 are studied. The evolution of siliceous biogenic sediments is derived from the analyses of one Fe-Ti smectite concretion, and of siliceous aggregates occurring in the pelagic "brown clays." Along the sedimentary section, the trace elements enriching the authigenic silicates and the Fe-Mn oxyhydroxides vary, depending on the marine environment. The proportion of clays and carbonates into the siliceous deposits controls the diagenetic evolution of silica making up the quartz aggregates from the "brown clay" or the cristobalite cherts.

Sandstone and siltstone beds overlying conglomerate at DSDP Hole 59-439

Massive sandstone and siltstone beds with many shallow-water megafossils overlie acidic volcanic conglomerates at DSDP Site 439. Smear-slides, thin sections from coarse fractions, and heavy minerals of the sandstone and siltstone beds were analyzed. The sandstones and siltstones are very rich in lithic fragments and are classified as lithic arenite and (or) lithic wacke. Hornblende and clinopyroxene are abundant, and zircon is present in most of the examined samples. The proportions of sandstone, chert, and volcanic rock in the coarse fraction are variable, but fragments of clastic rocks and cherts are predominant. Plagioclase crystals of volcanic-rock origin, such as highly zoned plagioclase and very fine, euhedral, lath-shaped plagioclase, are frequently observed. Metamorphic-rock fragments and metamorphic minerals are also observed. Thus, the provenance of the sandstone and siltstone beds appears to have been a slightly mature island arc, the Oyashio ancient landmass, consisting of clastic sediments and metamorphic and volcanic rocks.

Geochemistry of ODP Site 123-765 sediments

Drilling at Site 765 in the Argo Abyssal Plain sampled sediments and oceanic crust adjacent to the Australian margin. Some day, this site will be consumed in the Java Trench. An intensive analytical program was conducted to establish this site as a geochemical reference section forcrustal recycling calculations. About 150 sediment samples from Site 765 were analyzed for major and trace elements. Downhole trends in the sediment analyses agree well with trends in sediment mineralogy, as well as in Al and K logs. The primary signal in the geochemical variability is dilution of a detrital component by both biogenic silica and calcium carbonate. Although significant variations in the nonbiogenic component occur through time, its overall character is similar to nearby Canning Basin shales, which are typical of average post-Archean Australian shales (PAAS). The bulk composition of the hole is calculated using core descriptions to weight the analyses appropriately. However, a remarkably accurate estimate of the bulk composition of the hole can be made simply from PAAS and the average calcium carbonate and aluminum contents of the hole. Most elements can be estimated within 30% in this way. This means that estimating the bulk composition of other sections dominated by detrital and biogenic components may require little analytical effort: calcium carbonate contents, average Al contents, and average shale values can be taken from core descriptions, geochemical logs, and the literature, respectively. Some of the geochemical systematics developed at Site 765 can be extrapolated along the entire Sunda Trench. However, results are general, and Site 765 should serve as a useful reference for estimating the compositions of other continental margin sections approaching trenches around the world (e.g., outboard of the Lesser Antilles, Aegean, and Eolian arcs).

Oxygen-isotope composition, temperature and depth of formation of chert at DSDP Leg 62 Holes

We measured oxygen-isotope compositions of 16 siliceous rocks from Deep Sea Drilling Project Sites 463, 464, 465, and 466 (Leg 62). Samples are from deposits that range in age from about 40 to 103 m.y. and that occur at sub-bottom depths of 9 to 461 meters. Mean d18O values range from 28.4 to 36.8 per mil and 36.0 ± 0.3 per mil for quartz-rich and opal-CTrich rocks, respectively. d18O values in chert decrease with increasing sub-bottom depth; the slope of the d18O/depth curve is less steep for Site 464 than for the other sites which indicates that chert at Site 464 formed at higher temperatures than chert at Sites 463, 465, and 466. Temperatures of formation of cherts were 7 to 42°C, using the silica-water fractionation factor of Knauth and Epstein (1976), or 19 to 56°C, using the equation of Clayton et al. (1972). Temperatures in the sediment where the cherts now occur are lower than their isotopically determined temperatures of formation, which means that the cherts record an earlier history when temperatures in the sediment section were greater. Estimated sediment temperatures when the cherts formed are comparable to, but generally slightly lower than, those calculated from Knauth and Epstein's equation. The isotopic composition of cherts is more closely related to environment of formation (diagenetic environment) or paleogeothermal gradients, than to paleoclimates (bottom-water temperatures). Opal-CT-rich rocks may better record paleo-bottom-water temperature. In Leg 62 cherts, better crystallinity of quartz corresponds to lower d18O values; this implies progressively higher temperatures of equilibration between quartz and water during maturation of quartz. The interrelationship of d18O and crystallinity is noted also in continental-margin deposits such as the Monterey Formation - but for higher temperatures. The apparent temperature difference between open-ocean and continental-margin deposits can be explained by the dominant control of temperature on silica transformation in the rapidly deposited continental-margin deposits, whereas time, as well as temperature, has a strong influence on the transformations in open-ocean deposits. Comparisons between the chemistry and d18O values of cherts reveal two apparent trends: both boron and SiO2 increase as d18O increases. However, the correspondence between SiO2 and d18O is only apparent, because the two cherts lowest in SiO2 are also the most deeply buried, so the trend actually reflects depth of burial. The correspondence between boron and d18O supports the conclusion that boron is incorporated in the quartz crystal structure during precipitation

Upper Cretaceous agglutinated foraminifers from the western Pacific Ocean

Abyssal agglutinated foraminifers allow biostratigraphic correlation of Upper Cretaceous brown zeolitic claystones in Deep Sea Drilling Project Holes 196A and 198A and Ocean Drilling Program Holes 800A and 801 A. Three agglutinated foraminiferal zones subdivide the strata overlying the Campanian to Cenomanian cherts. The lower zone is characterized by Hormosina gigantea, which is a Campanian zonal marker in the North Atlantic Ocean and western Tethys. A major correlation level, which was observed in all holes studied, is based on the acme of evolute Haplophragmoides spp. This acme zone was observed in Sample 129-801A-6R-CC, about 9 m above the first occurrence of H. gigantea in Sample 129-801A-7R-1, 62-67 cm (approximately middle Campanian). The uppermost zone is characterized by dominant Paratrochamminoides spp. and in some instances common Bolivinopsis parvissimus (late Campanian to Maestrichtian). The available biostratigraphic data for the Upper Cretaceous of Sites 196, 198, 800, and 801 are correlated with the biochronologic framework of the North Atlantic, western Mediterranean, and Carpathians. Additionally, we use quantitative estimates of the diversity and abundance of agglutinated foraminiferal species to monitor general faunal trends with time in the western Pacific.