Can traditional harvesting methods for cockles be accommodated in a Special Area of Conservation?

The European Natura 2000 project attempts to balance conservation and exploitation by permitting activities that do not affect the conservation status of designated sites. Given the scale of Natura 2000, guidelines are needed to facilitate the drafting of simple site management plans. This need is particularly acute for traditional harvesting methods for which there is usually strong local opposition to the imposition of controls. These issues were examined in Strangford Lough, a special area of conservation where cockles have traditionally been harvested by hand-raking. Raking was found not to affect the ability of cockles to rebury. There were significant reductions in Zostera biomass when raking was carried out within eelgrass beds (a 90% reduction in biomass available to winter migrant birds from summer raking). Traditional harvesting methods could therefore be accepted in Strangford as long as Zostera beds are avoided. A relatively low intensity of harvesting activity in Strangford Lough probably reflects low cockle densities (average 91.8 m(-2)), with the most economically valuable individuals at some distance from points of access to the shore. An economically feasible management plan could sanction traditional harvesting and result in the implementation of more resource-intensive management only if increases in cockle stocks and market prices stimulate large increases in harvesting activity.

Impacts of unregulated harvesting on a recovering stock of native oysters (Ostrea edulis)

In Strangford Lough, Northern Ireland stocks of Ostrea edulis collapsed in the 1890s and the species was rarely recorded again until 1998 when the wild stock was estimated to be 100,000. The stock increased to 1.2 million in 2003 but declined to 650,000 by 2005. In 2007 the stock exceeded 1 million. The initial recovery of wild stocks is attributed to the combined effects of spawning commercial O. edulis stocks of and larval retention due to local hydrography. The stock decline between 2003 and 2005 is attributed to unregulated harvesting. Significant differences in abundances between sites over this period may be explained by the exploitation of more-readily accessible sites initially and of less accessible sites later. Oysters at sites where there was minimal exploitation probably contributed to widespread recruitment in 2007. Sustainable management of recovering native oyster stocks in Strangford Lough and elsewhere and will be impossible without appropriate legislation and enforcement.

Wireless Energy Harvesting and Spectrum Sharing in Cognitive Radio

A wireless energy harvesting protocol is proposed for a decode-and-forward relay- assisted secondary user (SU) network in a cognitive spectrum sharing paradigm. An expression for the outage probability of the relay-assisted cognitive network is derived subject to the following power constraints: 1) the maximum power that the source and the relay in the SU network can transmit from the harvested energy, 2) the peak interference power from the source and the relay in the SU network at the primary user (PU) network, and 3) the interference power of the PU network at the relay-assisted SU network. The results show that as the energy harvesting conversion efficiency improves, the relay- assisted network with the proposed wireless energy harvesting protocol can operate with outage probabilities below 20% for some practical applications.

Design of Scaled Bridge Prototype for Energy Harvesting Testing

Energy harvesting from ambient vibration is a promising field, especially for applications in larger infrastructures such as bridges. These structures are more frequently monitored for damage detection because of their extended life, increased traffic load and environmental deterioration. In this regard, the possibility of sourcing the power necessary for the sensors from devices embedded in the structure, thus cutting the cost due to the management of battery replacing over the lifespan of the structure, is particularly attracting. Among others, piezoelectric devices have proven to be especially effective and easy to apply since they can be bonded to existing host structure. For these devices the energy harvesting capacity is achieved directly from the variation in the strain conditions from the surface of the structure. However these systems need to undergo significant research for optimisation of their harvesting capacity and for assessing the feasibility of application to various ranges of bridge span and load. In this regard scaled bridge prototypes can be effectively used not only to assess numerical models and studies in an inexpensive and repeatable way but also to test the electronic devices under realistic field conditions. In this paper the theory of physical similitude is applied to the design of bridge beams with embedded energy harvesting systems and health monitoring sensors. It will show both how bridge beams can be scaled in such a way to apply and test energy harvesting systems and 2) how experimental data from existing bridges can be applied to prototypes in a laboratory environment. The study will be used for assessing the reliability of the system over a train bridge case study undergoing a set load cycles and induced localised damage.