Trawling pull exerted by a trawler: a method of estimation from propeller dimensions and its comparison with sea measurements

The proper matching of the pull exerted by a trawler and the size of trawl is important for maximizing the catching efficiency. The available pull is more dependent on the propeller and its working conditions than the installed engine power. The normal practice is to directly connect net size to the installed power in the boat by formulae without reference to the prope1ler dimensions or the available trawling pull and this is not adequate to find out the optimum combination. By the method outlined in this paper, the accurate calculation of trawling pull is possible by taking into account only the propeller diameter, pitch and r. p. m. The predictions by the method are compared for trawlers with powers between 30 and 60 hp and agreement is found to be within + 5%. The power absorbed by the propeller in trawling condition can also be calculated by this method for checking whether the engine is being overloaded.

An accelerated method of hot air drying of fish

The effects of temperature and relative humidity on the rate of drying of split open fish and salted fish in a tunnel dryer have been studied at a constant air velocity. By a judicious combination of these two, the rate of drying could be considerably accelerated, 10 to 12 hours only being required for drying to moisture levels below 30% in the case of mackerel, lactarius, otolithes and kilimeen (Nemipterus japonicus)

Centrifuge tests investigating inclined grout micro-piles as a method of liquefaction remediation for existing buildings

This paper presents a series of centrifuge tests carried out to investigate the performance of non-structural inclined micro-piles as a potential liquefaction remediation method for existing buildings. Both a single-degree-of-freedom frame structure and a two-storey, two-degree-of-freedom frame structure were used as model buildings in these tests. Centrifuge tests were carried out with and without micro-piles in the foundation soil for each structure. Results primarily from the tests with the SDOF structure are presented in this paper. It is found that the micro-piles have some beneficial effect by increasing shear strains in the soil in their vicinity and hence causing dilation in these zones. However, they also increase structural accelerations by transmitting accelerations from deep in the soil and the beneficial effects from increased dilation are outweighed by the detrimental migration of pore pressures.

A simple method of tagging prawns

The recognition of individual animals is crucial to many aspects of research. Prawns (Penaeus monodon) present unique difficulties in this respect since they molt regularly. Thus, almost all tagging and marking methods developed for prawns so far have proven inadequate. Some tags or marks are lost during molting; others cause injury to the prawns. A new and efficient method has been developed at the Igang Seafarming Station of the Aquaculture Department. Rectangular brass tags measuring 5 mm by 20 mm and numbered consecutively are used. The prawn is held gently but firmly at the base of the carapace with the left hand while the right hand slips the brass tag around the stalk of the unablated eye and presses the tag gently. All tagging must be made under water to avoid stress. From May 29 to September 7 1977 to a total of 348 unilaterally-ablated adult female prawns were tagged on the unablated eyestalk in 5 batches to enable individual observations on gonadal maturation, molting, and growth. Periodic examinations were made four times a month to coincide with the different phases of the lunar cycle. On each examination, survival and recovery rates were recorded. The data included death due to immediate mortality during ablation and loss to cannibalism for the duration of the experiments. In all five tagging experiments, most of the prawns recovered had their tags intact. These included even dead and molting animals. The eyestalk tagging method is suitable for prawns because the tags can be attached without causing injury and has no effect on the rate of growth, maturity, molting and behavior of the animal. The tags are identifiable and permanent; they remain attached to the animal even after death.

A method of immersion of panels for ecological studies on marine fouling and boring organisms

The importance of studies on the biology of marine foulers and borers needs no emphasis since they cause damage to submerged wooden structures resulting in considerable economic loss. In order to study their occurrence, settlement and to assess the rate of destruction to timber, several immersion techniques using iron racks, cages and rafts have been adopted. On the east and west coasts of India, at the Marine Centres of Forest Research Institute (Waltair, Madras, Cohin and Bombay) investigations have so far been carried out employing the first two methods.