Hospital-acquired infections: a cost estimation for CLABSI in Portugal

A Work Project, presented as part of the requirements for the Award of a Masters Degree in Economics from the NOVA – School of Business and Economics

An estimation of the frequency of gestational toxoplasmosis in the Brazilian Federal District

Acute infections by the protozoan Toxoplasma gondii during pregnancy (gestational toxoplasmosis) are known to cause serious health problems to the fetus (congenital toxoplasmosis). In Brasília, there have been few studies on the incidence of toxoplasmosis. This report summarizes a retrospective study performed on 2,636 selected pregnant women attended by the public health system of Guará, a satellite-city of Brasília. In this survey, 17 cases of gestational toxoplasmosis were detected; 15 of which were primary maternal infection and the remaining 2 were consistent with secondary maternal infection. These results suggest an annual seroconversion rate of 0.64 percent (90 percent confidence interval: 0.38, 0.90).

Evaluation of uv spectrophotometry for estimation of nitrite and nitrate in nitrified urine

Water is a limited resource for which demand is growing. Contaminated water from inadequate wastewater treatment provides one of the greatest health challenges as it restricts development and increases poverty in emerging and developing countries. Therefore, the connection between wastewater and human health is linked to access to sanitation and to human waste disposal. Adequate sanitation is expected to create a barrier between disposed human excreta and sources of drinking water. Different approaches to wastewater management are required for different geographical regions and different stages of economic governance depending on the capacity to manage wastewater. Effective wastewater management can contribute to overcome the challenges of water scarcity. Separate collection of human urine at its source is one promising approach that strongly reduces the economic and load demands on wastewater treatment plants (WWTP). Treatment of source-separated urine appears as a sanitation system that is affordable, produces a valuable fertiliser, reduces pollution of water resources and promotes health. However, the technical realisation of urine separation still faces challenges. Biological hydrolysis of urea causes a strong increase of ammonia and pH. Under these conditions ammonia volatilises which can cause odour problems and significant nitrogen losses. The above problems can be avoided by urine stabilisation. Biological nitrification is a suitable process for stabilisation of urine. Urine is a highly concentrated nutrient solution which can lead to strong inhibition effects during bacterial nitrification. This can further lead to process instabilities. The major cause of instability is accumulation of the inhibitory intermediate compound nitrite, which could lead to process breakdown. Enhanced on-line nitrite monitoring can be applied in biological source-separated urine nitrification reactors as a sustainable and efficient way to improve the reactor performance, avoiding reactor failures and eventual loss of biological activity. Spectrophotometry appears as a promising candidate for the development and application of on-line nitrite monitoring. Spectroscopic methods together with chemometrics are presented in this work as a powerful tool for estimation of nitrite concentrations. Principal component regression (PCR) is applied for the estimation of nitrite concentrations using an immersible UV sensor and off-line spectra acquisition. The effect of particles and the effect of saturation, respectively, on the UV absorbance spectra are investigated. The analysis allows to conclude that (i) saturation has a substantial effect on nitrite estimation; (ii) particles appear to have less impact on nitrite estimation. In addition, improper mixing together with instabilities in the urine nitrification process appears to significantly reduce the performance of the estimation model.

EDP - A new estimation algorithm

The aim of this work project is to analyze the current algorithm used by EDP to estimate their clients’ electrical energy consumptions, create a new algorithm and compare the advantages and disadvantages of both. This new algorithm is different from the current one as it incorporates some effects from temperature variations. The results of the comparison show that this new algorithm with temperature variables performed better than the same algorithm without temperature variables, although there is still potential for further improvements of the current algorithm, if the prediction model is estimated using a sample of daily data, which is the case of the current EDP algorithm.

Genetic algorithm for shipping route estimation with long-range tracking data : automatic reconstruction of shipping routes based on the historical ship positions for maritime safety applications

Ship tracking systems allow Maritime Organizations that are concerned with the Safety at Sea to obtain information on the current location and route of merchant vessels. Thanks to Space technology in recent years the geographical coverage of the ship tracking platforms has increased significantly, from radar based near-shore traffic monitoring towards a worldwide picture of the maritime traffic situation. The long-range tracking systems currently in operations allow the storage of ship position data over many years: a valuable source of knowledge about the shipping routes between different ocean regions. The outcome of this Master project is a software prototype for the estimation of the most operated shipping route between any two geographical locations. The analysis is based on the historical ship positions acquired with long-range tracking systems. The proposed approach makes use of a Genetic Algorithm applied on a training set of relevant ship positions extracted from the long-term storage tracking database of the European Maritime Safety Agency (EMSA). The analysis of some representative shipping routes is presented and the quality of the results and their operational applications are assessed by a Maritime Safety expert.

Simulation of humidity fields in concrete: experimental validation and parameter estimation

The moisture content in concrete structures has an important influence in their behavior and performance. Several vali-dated numerical approaches adopt the governing equation for relative humidity fields proposed in Model Code 1990/2010. Nevertheless there is no integrative study which addresses the choice of parameters for the simulation of the humidity diffusion phenomenon, particularly in concern to the range of parameters forwarded by Model Code 1990/2010. A software based on a Finite Difference Method Algorithm (1D and axisymmetric cases) is used to perform sensitivity analyses on the main parameters in a normal strength concrete. Then, based on the conclusions of the sensi-tivity analyses, experimental results from nine different concrete compositions are analyzed. The software is used to identify the main material parameters that better fit the experimental data. In general, the model was able to satisfactory fit the experimental results and new correlations were proposed, particularly focusing on the boundary transfer coeffi-cient.

A model to simulate the moment-rotation and crack width of FRC members reinforced with longitudinal bars

The present work describes a model for the determination of the moment–rotation relationship of a cross section of fiber reinforced concrete (FRC) elements that also include longitudinal bars for the flexural reinforcement (R/FRC). Since a stress–crack width relationship (σ–w)(σ–w) is used to model the post-cracking behavior of a FRC, the σ–w directly obtained from tensile tests, or derived from inverse analysis applied to the results obtained in three-point notched beam bending tests, can be adopted in this approach. For a more realistic assessment of the crack opening, a bond stress versus slip relationship is assumed to simulate the bond between longitudinal bars and surrounding FRC. To simulate the compression behavior of the FRC, a shear friction model is adopted based on the physical interpretation of the post-peak compression softening behavior registered in experimental tests. By allowing the formation of a compressive FRC wedge delimited by shear band zones, the concept of concrete crushing failure mode in beams failing in bending is reinterpreted. By using the moment–rotation relationship, an algorithm was developed to determine the force–deflection response of statically determinate R/FRC elements. The model is described in detail and its good predictive performance is demonstrated by using available experimental data. Parametric studies were executed to evidence the influence of relevant parameters of the model on the serviceability and ultimate design conditions of R/FRC elements failing in bending.

Nonparametric estimation of time-dependent ROC curves conditional on a continuous covariate

The receiver-operating characteristic (ROC) curve is the most widely used measure for evaluating the performance of a diagnostic biomarker when predicting a binary disease outcome. The ROC curve displays the true positive rate (or sensitivity) and the false positive rate (or 1-specificity) for different cut-off values used to classify an individual as healthy or diseased. In time-to-event studies, however, the disease status (e.g. death or alive) of an individual is not a fixed characteristic, and it varies along the study. In such cases, when evaluating the performance of the biomarker, several issues should be taken into account: first, the time-dependent nature of the disease status; and second, the presence of incomplete data (e.g. censored data typically present in survival studies). Accordingly, to assess the discrimination power of continuous biomarkers for time-dependent disease outcomes, time-dependent extensions of true positive rate, false positive rate, and ROC curve have been recently proposed. In this work, we present new nonparametric estimators of the cumulative/dynamic time-dependent ROC curve that allow accounting for the possible modifying effect of current or past covariate measures on the discriminatory power of the biomarker. The proposed estimators can accommodate right-censored data, as well as covariate-dependent censoring. The behavior of the estimators proposed in this study will be explored through simulations and illustrated using data from a cohort of patients who suffered from acute coronary syndrome.

Nonparametric estimation of the survival function for ordered multivariate failure time data: a comparative study

In longitudinal studies of disease, patients may experience several events through a follow-up period. In these studies, the sequentially ordered events are often of interest and lead to problems that have received much attention recently. Issues of interest include the estimation of bivariate survival, marginal distributions and the conditional distribution of gap times. In this work we consider the estimation of the survival function conditional to a previous event. Different nonparametric approaches will be considered for estimating these quantities, all based on the Kaplan-Meier estimator of the survival function. We explore the finite sample behavior of the estimators through simulations. The different methods proposed in this article are applied to a data set from a German Breast Cancer Study. The methods are used to obtain predictors for the conditional survival probabilities as well as to study the influence of recurrence in overall survival.

A review of mycotoxins in food and feed products in Portugal and estimation of probable daily intakes

Mycotoxins are toxic secondary metabolites produced by filamentous fungi that occur naturally in agricultural commodities worldwide. Aflatoxins, ochratoxin A, patulin, fumonisins, zearalenone, trichothecenes and ergot alkaloids are presently the most important for food and feed safety. These compounds are produced by several species that belong to the Aspergillus, Penicillium, Fusarium and Claviceps genera and can be carcinogenic, mutagenic, teratogenic, cytotoxic, neurotoxic, nephrotoxic, estrogenic and immunosuppressant. Human and animal exposure to mycotoxins is generally assessed by taking into account data on the occurrence of mycotoxins in food and feed as well as data on the consumption patterns of the concerned population. This evaluation is crucial to support measures to reduce consumer exposure to mycotoxins. This work reviews the occurrence and levels of mycotoxins in Portuguese food and feed to provide a global overview of this issue in Portugal. With the information collected, the exposure of the Portuguese population to those mycotoxins is assessed, and the estimated dietary intakes are presented.

Promising blood-derived biomarkers for estimation of the postmortem interval

A precise estimation of the postmortem interval (PMI) is one of the most important topics in forensic pathology. However, the PMI estimation is based mainly on the visual observation of cadaverous pheno- mena (e.g. algor, livor and rigor mortis) and on alternative methods such as thanatochemistry that remain relatively imprecise. The aim of this in vitro study was to evaluate the kinetic alterations of several bio- chemical parameters (i.e. proteins, enzymes, substrates, electrolytes and lipids) during putrefaction of human blood. For this purpose, we performed kinetic biochemical analysis during a 264 hour period. The results showed a significant linear correlation between total and direct bilirubin, urea, uric acid, transferrin, immunoglobulin M (IgM), creatine kinase (CK), aspartate transaminase (AST), calcium and iron with the time of blood putrefaction. These parameters allowed us to develop two mathematical models that may have predictive values and become important complementary tools of traditional methods to achieve a more accurate PMI estimation

Estimation of statistical cure from cancer using population-based data

Dissertação de mestrado em Estatística

Relationship between estimation and real motor performance in school-age children

The relationship between estimated and real motor competences was analyzed for several tasks. Participants were 303 children (160 boys and 143 girls), which had between 6 and 10 years of age (M=8.63, SD=1.16). None of the children presented developmental difficulties or learning disabilities, and all attended age-appropriate classes. Children were divided into three groups according to their age: group 1 (N= 102; age range: 6.48-8.01 years); group 2 (N= 101; age range: 8.02-9.22 years); and group 3 (N=100; age range: 9.24-10.93 years). Children were asked to predict their maximum distance for a locomotor, a manipulative, and a balance task, prior to performing those tasks. Children’s estimations were compared with their real performance to determine their accuracy. Children had, in general, a tendency to overestimate their performance (standing long jump: 56.11%, kicking: 63.37%, throwing: 73.60%, and Walking Backwards (WB) on a balance beam: 45.21%), and older children tended to be more accurate, except for the manipulative tasks. Furthermore, the relationship between estimation and real performance in children with different levels of motor coordination (Köperkoordinationstest für Kinder, KTK) was analyzed. The 75 children with the highest score comprised the Highest Motor Coordination (HMC) group, and the 78 children with the lowest score were placed in the Lowest Motor Coordination (LMC) group. There was a tendency for LMC and HMC children to overestimate their skills at all tasks, except for the HMC group at the WB task. Children with the HMC level tended to be more accurate when predicting their motor performance; however, differences in absolute percent error were only significant for the throwing and WB tasks. In conclusion, children display a tendency to overestimate their performance independently of their motor coordination level and task. This fact may be determinant to the development of their motor competences, since they are more likely to engage and persist in motor tasks, but it might also increase the occurrence of unintended injuries.

Estimation of nonparametric probability density functions with applications to automatic speech recognition

Magdeburg, Univ., Fak. für Elektrotechnik und Informationstechnik, Diss., 2007