Clinical agreement among glaucoma experts in the detection of glaucomatous changes of the optic disk using simultaneous stereoscopic photographs

PURPOSE: To evaluate the clinical agreement in the detection of optic disk changes in patients with glaucoma using simultaneous stereophotographs. DESIGN: Masked-observer variability study. METHODS: Ten glaucoma specialists examined pairs of simultaneous stereophotographs of glaucomatous and control optic disks to determine whether there were changes compatible with progression of glaucomatous damage. RESULTS: Intraobserver agreement had a kappa value ranging from 0.55 to 0.78. Interobserver agreement among the glaucoma specialists had a kappa value ranging from 0.34 to 0.68. CONCLUSION: Clinical examination of stereophotographs to detect optic disk changes in glaucoma patients has limitations associated with suboptimal reproducibility. © 2003 by Elsevier Inc. All rights reserved.

Forensic analysis of architectural finishes using fourier transform infrared and raman spectroscopy, part II:White paint

White household paints are commonly encountered as evidence in the forensic laboratory but they often cannot be readily distinguished by color alone so Fourier transform infrared (FT-IR) microscopy is used since it can sometimes discriminate between paints prepared with different organic resins. Here we report the first comparative study of FT-IR and Raman spectroscopy for forensic analysis of white paint. Both techniques allowed the 51 white paint samples in the study to be classified by inspection as either belonging to distinct groups or as unique samples. FT-IR gave five groups and four unique samples; Raman gave seven groups and six unique samples. The basis for this discrimination was the type of resin and/ or inorganic pigments/extenders present. Although this allowed approximately half of the white paints to be distinguished by inspection, the other half were all based on a similar resin and did not contain the distinctive modifiers/pigments and extenders that allowed the other samples to be identified. The experimental uncertainty in the relative band intensities measured using FT-IR was similar to the variation within this large group, so no further discrimination was possible. However, the variation in the Raman spectra was larger than the uncertainty, which allowed the large group to be divided into three subgroups and four distinct spectra, based on relative band intensities. The combination of increased discrimination and higher sample throughput means that the Raman method is superior to FT-IR for samples of this type. © 2005 Society for Applied Spectroscopy.

Forensic Geomorphology

Geomorphology plays a critical role in two areas of geoforensics: searching the land for surface or buried objects and sampling or imaging rural scenes of crime and control locations as evidence. Most of the associated geoscience disciplines have substantial bodies of work dedicated to their relevance in forensic investigations, yet geomorphology (specifically landforms, their mapping and evolution, soils and relationship to geology and biogeography) have had no such exposure. This is strange considering how fundamental to legal enquiries the location of a crime and its evolution are, as this article will demonstrate. This work aims to redress the balance by showing how geomorphology is featured in one of the earliest works on forensic science methods, and has continued to play a role in the sociology, archaeology, criminalistics and geoforensics of crime. The application geomorphology has in military/humanitarian geography and environmental/engineering forensics is briefly discussed as these are also regularly reviewed in courts of law

Search protocols for hidden forensic objects beneath floors and within walls

The burial of objects (human remains, explosives, weapons) below or behind concrete, brick, plaster or tiling may be associated with serious crime and are difficult locations to search. These are quite common forensic search scenarios but little has been published on them to-date. Most documented discoveries are accidental or from suspect/witness testimony. The problem in locating such hidden objects means a random or chance-based approach is not advisable. A preliminary strategy is presented here, based on previous studies, augmented by primary research where new technology or applications are required. This blend allows a rudimentary search workflow, from remote desktop study, to non-destructive investigation through to recommendations as to how the above may inform excavation, demonstrated here with a case study from a homicide investigation. Published case studies on the search for human remains demonstrate the problems encountered when trying to find and recover sealed-in and sealed over locations. Established methods include desktop study, photography, geophysics and search dogs:these are integrated with new technology (LiDAR and laser scanning; photographic rectification; close quarter aerial imagery; ground-penetrating radar on walls and gamma-ray/neutron activation radiography) to propose this possible search strategy.

A RAG System for the Management Forensic and Archaeological Searches of Burial Grounds

Burial grounds are commonly surveyed and searched by both police/humanitarian search teams and archaeologists.
One aspect of an efficient search is to establish areas free of recent internments to allow the concentration of assets in suspect
terrain. While 100% surety in locating remains can never be achieved, the deployment of a red, amber green (RAG) system for
assessment has proven invaluable to our surveys. The RAG system is based on a desktop study (including burial ground
records), visual inspection (mounding, collapses) and use of geophysics (in this case, ground penetrating radar or GPR) for a
multi-proxy assessment that provides search authorities an assessment of the state of inhumations and a level of legal backup
for decisions they make on excavation or not (‘exit strategy’). The system is flexible and will be built upon as research
continues.

Environmental forensic investigations: The potential use of a novel heavy metal sensor and novel taggants

This chapter presents a novel hand-held instrument capable of real-time in situ detection and identification of heavy metals, along with the potential use of novel taggants in environmental forensic investigations. The proposed system provides the facilities found in a traditional laboratory-based instrument but in a hand held design, without the need for an associated computer. The electrochemical instrument uses anodic stripping voltammetry, which is a precise and sensitive analytical method with excellent limits of detection. The sensors comprise a small disposable plastic strip of screen-printed electrodes rather than the more common glassy carbon disc and gold electrodes. The system is designed for use by a surveyor on site, allowing them to locate hotspots, thus avoiding the expense and time delay of prior laboratory analysis. This is particularly important in environmental forensic analysis when a site may have been released back to the owner and samples could be compromised on return visits. The system can be used in a variety of situations in environmental assessments, the data acquired from which provide a metals fingerprint suitable for input to a database. The proposed novel taggant tracers, based on narrow-band atomic fluorescence, are under development for potential deployment as forensic environmental tracers. The use of discrete fluorescent species in an environmentally stable host has been investigated to replace existing toxic, broadband molecular dye tracers. The narrow band emission signals offer the potential for tracing a large number of signals in the same environment. This will give increased data accuracy and allow multiple source environmental monitoring of environmental parameters.

Quality Assurance for GCxGC-FID, Accreditation for TPH CWG Protocol

A new technological approach in the analysis and forensic interpretation of Total Hydrocarbons in soils and waters using 2D Gas Chromatography method (GC-GC) was developed alongside environmental forensic and the assessment models to provide better customer products for the environmental industry.
The objective was to develop an analytical methodology for TPH CWG. Raw data from this method is then to be evaluated for forensic interpretation and risk assessment modelling. Access will be made available to the expertise in methods of forensic tracing contaminant sources, transport modelling, human health risk modelling and detailed quantitative risk assessment.
The quantification of internal standards was key to the development of this method. As the laboratory does not test for TPH in 1D, it was requested during INAB ISO 17025 audit to individually map out where each compound falls chromatographically in the 2D. This was done through comparing carbon equivalent numbers to the n-alkane carbons. This proved e.g. 2-methylnaphthalene has 11 carbons in its structure; its carbon equivalent is 12.84 , the result of which falls within the band of Aromatic eC12-eC16 as opposed to expected eC10-eC12. This was carried out for all 16 PAH (polyaromatic hydrocarbons) and BTEX (benzene, toluene, ethylbenzene and o, m and p-xylenes). The n-alkanes were also assigned to their corresponding aliphatic bands e.g. nC8 would be expected to be in nC8-nC10.
The method was validated through a designated systematic experimental protocol and was challenged with spikes of known concentration of hydrocarbon parameters such as recoveries, precision, bias and linearity. The method was verified by testing a certified reference material which was used as a proficiency round of testing for numerous laboratories.
It is hoped that the method will be used in conjunction with the analysis through Bonn Agreement with their OSINet group. This is a panel of experts and laboratories (including CLS) who forensically identify oil spill contamination from a water source.
This method can prove itself to be a robust method and benefit the industry for contaminated land and water but the method needs to be seen as separate from the regular 1D chromatography. It will help identify contaminants and assist consultants, regulators, clients and scientists valuable information not seen in 1D

Forensic analysis of wooden safety matches - A case study

In this case, an individual was suspected of attempting to burn materials potentially relating to a murder case. A number of spent and unspent matches were seized at the scene by police for forensic examination. Coincidentally, a police raid at the suspect's house revealed a number of matchboxes, all of the same brand, containing matches that had a visual similarity to those recovered at the scene. Stable Isotope Profiling (SIP) was used to assess whether matches could either be distinguished or shown to be indistinguishable by 13C and 2H isotopic composition. These results were then compared to those from the X-ray diffraction (XRD) analysis of match heads and microscopy of the wood. SIP showed the scene matches and seized matches to be different, which was confirmed by XRD and microscopy analyses.

Energy and environmental forensic analysis for public buildings.

This paper outlines a forensic method for analysing the energy, environmental and comfort performance of a building. The method has been applied to a recently developed event space in an Irish public building, which was evaluated using on-site field studies, data analysis, building simulation and occupant surveying. The method allows for consideration of both the technological and anthropological aspects of the building in use and for the identification of unsustainable operational practice and emerging problems. The forensic analysis identified energy savings of up to 50%, enabling a more sustainable, lower-energy operational future for the building. The building forensic analysis method presented in this paper is now planned for use in other public and commercial buildings.

Compositional Data Analysis in Forensic Geoscience

Statistics are regularly used to make some form of comparison between trace evidence or deploy the exclusionary principle (Morgan and Bull, 2007) in forensic investigations. Trace evidence are routinely the results of particle size, chemical or modal analyses and as such constitute compositional data. The issue is that compositional data including percentages, parts per million etc. only carry relative information. This may be problematic where a comparison of percentages and other constraint/closed data is deemed a statistically valid and appropriate way to present trace evidence in a court of law. Notwithstanding an awareness of the existence of the constant sum problem since the seminal works of Pearson (1896) and Chayes (1960) and the introduction of the application of log-ratio techniques (Aitchison, 1986; Pawlowsky-Glahn and Egozcue, 2001; Pawlowsky-Glahn and Buccianti, 2011; Tolosana-Delgado and van den Boogaart, 2013) the problem that a constant sum destroys the potential independence of variances and covariances required for correlation regression analysis and empirical multivariate methods (principal component analysis, cluster analysis, discriminant analysis, canonical correlation) is all too often not acknowledged in the statistical treatment of trace evidence. Yet the need for a robust treatment of forensic trace evidence analyses is obvious. This research examines the issues and potential pitfalls for forensic investigators if the constant sum constraint is ignored in the analysis and presentation of forensic trace evidence. Forensic case studies involving particle size and mineral analyses as trace evidence are used to demonstrate the use of a compositional data approach using a centred log-ratio (clr) transformation and multivariate statistical analyses.

Budget 2016: experts respond

Fairness

Contribution d'experts, à l'aide de l'Internet, au développement des compétences discursives d'élèves de 6e année

Ce projet de recherche de type quasi-expérimental visait à favoriser le développement de compétences discursives chez des élèves de 6e année par l'application d'une démarche d'écriture associée à l'échange entre pairs et avec des experts. Les éléments discursifs d'un texte font référence à la capacité de juger la qualité d'un texte à partir de critères de cohérence, de structure et d'organisation des idées ainsi qu'à partir de composantes liées au respect du lecteur et de l'intention d'écriture. Trente-neuf élèves provenant d'un milieu socio-économique moyen ont participé à l'expérimentation alors que quarante-trois élèves composaient le groupe témoin. Tous les groupes d'élèves présentaient un niveau académique faible à moyen en français écrit. Dans le cadre de cette expérimentation, trois situations d'écriture ont été réalisées au cours d'une même année scolaire. Pour chacune de ces situations d'écriture, les élèves du groupe expérimental devaient écrire un texte et utiliser les questions-guides de la démarche proposée pour diriger leur attention sur les aspects discursifs du texte. Au cours de la démarche, les élèves participaient à des échanges de commentaires avec leurs pairs quant à la qualité de leur texte. Douze experts provenant des domaines du journalisme, de l'enseignement et de la littérature fournissaient des rétroactions aux élèves quant à la qualité de leur texte sur le plan discursif.

Transposition didactique : des savoirs experts d'un programme technique vers les savoirs à enseigner en physique.

Par expérience, les étudiantes et étudiants du collégial sont beaucoup plus motivés lorsque les activités d'apprentissage proposées dans le cours sont en lien direct avec leur programme, surtout lorsqu'il s'agit d'un cours d'une discipline contributive. Comme il y a seize cours de physique offerts dans neuf programmes techniques au cégep de Trois-Rivières, les applications pertinentes de chaque programme ne sont pas toujours connues du département de physique et il n'y a que peu de sources d'informations vulgarisées qui expliquent le fonctionnement de ces systèmes ou qui font des liens explicites avec la physique. Cet essai vise à élaborer une démarche permettant d'obtenir les informations pertinentes sur les systèmes utilisés dans les programmes de techniques physiques afin d'organiser les savoirs à enseigner de façon cohérente et pertinente dans les cours de physique. Cette démarche générale sera ensuite appliquée au cours de mécanique appliquée du programme de génie civil afin de la valider concrètement. Tout en s'appuyant sur les sources didactiques comme les savoirs disciplinaires, les savoirs à enseigner et le rapport des élèves aux savoirs, le cadre de référence propose un processus de transposition didactique pour déterminer et organiser les contenus du cours de physique en fonction des applications concrètes reliées au programme. Le cadre méthodologique de cette recherche-intervention propose une démarche cyclique permettant d'abord d'identifier les systèmes techniques pertinents et leurs liens avec la physique puis de modéliser le fonctionnement de ce système. Enfin, le processus de transposition didactique sera appliqué aux résultats et vérifié par des enseignantes et enseignants du département de physique.