Average dip directions from intervals of dipmeter log in drill hole CRP-2A

Bedding dips in the CRP-2A drillhole were determined in two ways (1) analysis of a dipmeter log, and (2) identification of bed boundaries on digital images of the outer core surface. The two methods document the downhole increase in structural dip, to a maximum of 15° in the lowest 150 m of the hole. Dipmeter data, which are azimuthally oriented, indicate a 75° azimuth for structural tilting, in agreement with seismic reflection profiles. Core and log dips indicate that structural dip increases by 5-7° between 325 and 480 mbsf. Both, however, also exhibit high dip inhomogeneity because of depositional (e.g., cross bedding) and post-depositional (e.g., softsediment deformation) processes. This variability adds ambiguity to the search for angular unconformities within the CRP-2A drillhole. Dip directions of different lithologies are generally similar, as are dip directions for the four kinds of systems tracts. Downdip azimuths of sands and muds are slightly different from those of diamicts, possibly reflecting the divergence between ENE offshore dip and ESE glacial advance.

Cretaceous-Tertiary ichthyoliths of brown clay intervals

The pattern of ichthyolith distribution established in sequences with stratigraphies based on calcareous or siliceous microfossils is used to provide age correlations for three deep-sea pelagic clay intervals that lack the better known microfossils. At Site 637, approximately 25 m of brown clay in Cores 103-637A-21R through 103-637A-23R underlies upper Miocene sediments and is of Paleocene to early Eocene age. At Site 639, 1.7 m of brown clay in Core 103-639C-2R is Eocene to Oligocene. At Site 640, 3.5 m of clay in Cores 103-640A-1R and 103-640A-2R contains a Cretaceous to Paleocene sequence, with the Cretaceous/Tertiary boundary between 84 and 103 cm in Section 103-640A-2R-1.

Geochemical and mineralogical analyses of clay-rich intervals in ODP Sites 166-1006 and 166-1007

The western flank of the Great Bahama Bank, drilled during ODP Leg 166 at seven sites, represents a prograding carbonate sequence from late Oligocene to Holocene [Eberli et al., Proc. ODP Init. Reports 166 (1997)]. The signatures of the detrital input and of diagenetic alteration are evident in clay enriched intervals from the most distal Sites 1006 and 1007 in the Straits of Florida. Mineralogical and chemical investigations (XRD, TEM, SEM, ICP-MS) run on bulk rocks and on the clay fractions enable the origin and evolution of silicate parageneses to be characterized. Plio-Pleistocene silt and clay interbeds contain detrital clay assemblages comprising chlorite, illite, interstratified illite smectite, smectite, kaolinite and palygorskite. The greater smectite input within late Pliocene units than in Pleistocene oozes may relate either varying source areas or change in paleoclimatic conditions and weathering intensity. The clay intervals from Miocene-upper Oligocene wackestone sections are fairly different, with prevalent smectite in the fine fraction, whose high crystallinity and Mg contents that point towards an authigenic origin. The lower Miocene section, below 1104 mbsf, at depths where compaction features are well developed, is particularly characterized by abundant authigenic Na-K-clinoptilolite filling foraminifer tests. The authigenic smectite and clinoptilolite paragenesis is recorded by the chemical trends, both of the sediment and the interstitial fluid. This diagenetic evolution implies Si- and Mg rich fluids circulating in deeper and older sequences. For lack of any local volcaniclastic input, the genesis of zeolite and the terms of water rock interaction are discussed. The location of the diagenetic front correlates with that of the seismic sequence boundary P2 dated as 23.2 Ma. This correspondence may allow the chronostratigraphic significance of some specific seismic reflections to be reassessed.

(Table 2) Details of laminated intervals of ODP Leg 158 holes

Scanning electron microscope (SEM)-based analyses of the laminated diatom oozes encountered during Leg 138 reveal three major laminae types. The first lamina type is composed of multiple layers of ~20-?m-thick diatom mats, which form laminae dominated by assemblages of the pennate diatom, Thalassiothrix longissima. More than one variety/subspecies of T. longissima occurs within these laminae (referred to as the T. longissima Group). The second lamina type is composed of a mixed-assemblage of several species of diatoms (centric and pennate varieties), calcareous nannofossils, and subordinate quantities of radiolarians, silicoflagellates and foraminifers. The third lamina type is dominated by an assemblage of nannofossils and minor amounts of those fossil components mentioned above. This last form of lamination is compositionally similar to the background sediment type, foraminifernannofossil ooze (F-NO). Two lamina associations occur within the laminated intervals; the first comprises alternations of T. longissima Group and mixed-assemblage laminae (average thickness is ~6 mm) and the second is composed of T. longissima and nannofossil-rich laminae (average thickness is ~3.5 mm). The arrangement of laminae probably originates from the deposition of multiple layers of 20-?m-thick mats from one mat-flux episode. The much thinner nannofossil-rich laminae are interpreted to represent periods of more ônormalö deposition between mat-flux episodes. The occurrence of several varieties/subspecies of T. longissima within individual mat layers is consistent with observations of Rhizosolenia diatom mats in the modern world ocean.