Ellipsometric Study of Single-Crystal γ-Inse From 1.5 To 9.2 Ev

We report the component E ┴ c of the pseudodielectric-function tensor <ε(E)> = <ε1(E)> + i< ε2(E)> of γ-phase single-crystal InSe, obtained from 1.5 to 9.2 eV by vacuum-ultraviolet spectroscopic ellipsometry with the sample at room temperature. Overlayer artifacts were reduced as far as possible by measuring fresh surfaces prepared by cleavage. Accurate critical-point energies of observed structures were obtained by a combined method of spectral analysis.

LARGE-SCALE DISTRIBUTION OF ARRIVAL DIRECTIONS OF COSMIC RAYS DETECTED ABOVE 10(18) eV AT THE PIERRE AUGER OBSERVATORY

A thorough search for large-scale anisotropies in the distribution of arrival directions of cosmic rays detected above 10(18) eV at the Pierre Auger Observatory is presented. This search is performed as a function of both declination and right ascension in several energy ranges above 10(18) eV, and reported in terms of dipolar and quadrupolar coefficients. Within the systematic uncertainties, no significant deviation from isotropy is revealed. Assuming that any cosmic-ray anisotropy is dominated by dipole and quadrupole moments in this energy range, upper limits on their amplitudes are derived. These upper limits allow us to test the origin of cosmic rays above 10(18) eV from stationary Galactic sources densely distributed in the Galactic disk and predominantly emitting light particles in all directions.

Discovery of the Persistent Luminescence Mechanism of CdSiO3:Tb3+

The persistent luminescence of CdSiO3:Tb3+ was investigated with photoluminescence, thermoluminescence (TL), synchrotron radiation X-ray absorption (XANES and EXAFS) and UV-VUV spectroscopies. Only the typical intraconfigurational 4f(8)-4f(8) transitions of the Tb3+ ion were observed with no traces of band emission in either the conventional UV excited or persistent luminescence spectra. The trap structure from TL with three traps from 0.65 to 0.85 eV is ideal for room-temperature persistent luminescence similar to, e.g., Sr2MgSi2O7:Eu2+,R3+. Despite the rather low band gap energy, 5.28 eV, the persistent luminescence from Tb3+ is produced only under UV irradiation due to the inauspicious position of the F-7(6) ground level deep in the band gap of CdSiO3. This confirms the role of electrons as the charge carriers in the mechanism of Tb3+ persistent luminescence. The XANES spectra indicated the presence of only the trivalent Tb3+ species, thus excluding the direct Tb3+ -> Tb-IV oxidation during the charging process of persistent luminescence. Eventually, a unique persistent luminescence mechanism for Tb3+ in CdSiO3 was constructed based on the comprehensive experimental data.

Constraints on the origin of cosmics rays above '10 POT. 18' eV from large-scale anisotropy searches in data of the Pierre Auger observatory

A thorough search for large-scale anisotropies in the distribution of arrival directions of cosmic rays detected above '10 POT. 18' eV at the Pierre Auger Observatory is reported. For the first time, these large-scale anisotropy searches are performed as a function of both the right ascension and the declination and expressed in terms of dipole and quadrupole moments.Within the systematic uncertainties, no significant deviation from isotropy is revealed. Upper limits on dipole and quadrupole amplitudes are derived under the hypothesis that any cosmic ray anisotropy is dominated by such moments in this energy range. These upper limits provide constraints on the production of cosmic rays above '10 POT. 18' eV, since they allow us to challenge an origin from stationary galactic sources densely distributed in the galactic disk and emitting predominantly light particles in all directions.

Suche nach einem leichten Higgs-Boson im Kanal WH ev e bb in pp-Kollisionen bei s=1.96 TeV am DO-Detektor des Tevatron

Eine wichtige Komponente des Standardmodells der Teilchenphysik bildet der Higgs-Mechanismus, der benötigt wird um den vom Standardmodell beschriebenen Teilchen Masse zu verleihen. Dieser Mechanismus beinhaltet jedoch ein weiteres schweres Elementarteilchen das bislang noch nich beobachtet werden konnte. Die Suche nach diesem Teilchen ist eines Hauptziele der derzeitigen Forschung an Teilchenbeschleunigern. Diese Arbeit untersucht die vom D0-Detektor am Tevatron des Fermi National Accelerator Laboratory (FNAL) aufgezeichneten Daten von ppbar-Kollisionen bei einer Schwerpunktsenergie von sqrt{s}=1.96 TeV, um im Kanal WH -> enu bb nach einem leichten Higgs-Boson zu suchen. Darüber hinaus wird der Produktionswirkungsquerschnitt der Wbb-Produktion ermittelt. Für die Analyse stand eine integrierte Luminosität von L=255pb^{-1} zur Verfügung. Zur Selektion dieser Prozesse, werden Ereignisse ausgewählt, die Elektronen und fehlenden Transversalimpuls enthalten, sowie mindestens zwei Jets, die sich als b-Jets identifizieren lassen. Um eine effiziente Selektion zu erhalten, wurden Schnitte auf verschiedene Kenngrößen entwickelt, getestet und optimiert. Aus den selektierten Ereignissen wird der Wbb-Wirkungsquerschnitt ermittelt, der für Ereignisse angegeben wird, in denen die b-Quarks p_T>8 GeV und |eta|<3 erfüllen. Der unter Berücksichtigung des Verzweigungsverhältnisses BR(W->enu)=0.108 errechnete Wert ist sigma(Wbb)=21.8 pb (+15.5; -20.0 pb(sys+stat)). Wegen der geringen Signifikanz der Messung von etwa 1.2sigma wurden die Ereigniszahlen auch zur Berechnung einer oberen Grenze auf den Wirkungsquerschnitt verwendet, die sich bei einem Konfidenzniveau von 95% zu sigma^95(Wbb)=60.9pb ergibt. Ebenso wurden Grenzen auf den WH-Produktionswirkungsquerschnitt ermittelt. Dafür wurde die statistische Methode von Feldman und Cousins angewandt, nachdem sie nach den Vorschlägen von Conrad et al. erweitert worden war, um systematische Unsicherheiten zu berücksichtigen. Für ein Standardmodell Higgs-Boson der Masse 115 GeV kann eine obere Grenze auf den Produktionswirkungsquerschnitt von sigma^{95} (WH)=12.2pb angegeben werden. Für höhere Massen bis 135 GeV werden ähnliche Grenzen ermittelt.

Studies of degradation of organic solar cell materials using electrical scanning probe microscopy

Intense research is being done in the field of organic photovoltaics in order to synthesize low band-gap organic molecules. These molecules are electron donors which feature in combination with acceptor molecules, typically fullerene derivarntives, forming an active blend. This active blend has phase separated bicontinuous morphology on a nanometer scale. The highest recorded power conversionrnefficiencies for such cells have been 10.6%. Organic semiconductors differ from inorganic ones due to the presence of tightly bonded excitons (electron-hole pairs)resulting from their low dielectric constant (εr ≈2-4). An additional driving force is required to separate such Frenkel excitons since their binding energy (0.3-1 eV) is too large to be dissociated by an electric field alone. This additional driving force arises from the energy difference between the lowest unoccupied molecular orbital (LUMO) of the donor and the acceptor materials. Moreover, the efficiency of the cells also depends on the difference between the highest occupied molecular orbital (HOMO) of the donor and LUMO of the acceptor. Therefore, a precise control and estimation of these energy levels are required. Furthermore any external influences that change the energy levels will cause a degradation of the power conversion efficiency of organic solar cell materials. In particular, the role of photo-induced degradation on the morphology and electrical performance is a major contribution to degradation and needs to be understood on a nanometer scale. Scanning Probe Microscopy (SPM) offers the resolution to image the nanometer scale bicontinuous morphology. In addition SPM can be operated to measure the local contact potential difference (CPD) of materials from which energy levels in the materials can be derived. Thus SPM is an unique method for the characterization of surface morphology, potential changes and conductivity changes under operating conditions. In the present work, I describe investigations of organic photovoltaic materials upon photo-oxidation which is one of the major causes of degradation of these solar cell materials. SPM, Nuclear Magnetic Resonance (NMR) and UV-Vis spectroscopy studies allowed me to identify the chemical reactions occurring inside the active layer upon photo-oxidation. From the measured data, it was possible to deduce the energy levels and explain the various shifts which gave a better understanding of the physics of the device. In addition, I was able to quantify the degradation by correlating the local changes in the CPD and conductivity to the device characteristics, i.e., open circuit voltage and short circuit current. Furthermore, time-resolved electrostatic force microscopy (tr-EFM) allowed us to probe dynamic processes like the charging rate of the individual donor and acceptor domains within the active blend. Upon photo-oxidation, it was observed, that the acceptor molecules got oxidized first preventing the donor polymer from degrading. Work functions of electrodes can be tailored by modifying the interface with monomolecular thin layers of molecules which are made by a chemical reaction in liquids. These modifications in the work function are particularly attractive for opto-electronic devices whose performance depends on the band alignment between the electrodes and the active material. In order to measure the shift in work function on a nanometer scale, I used KPFM in situ, which means in liquids, to follow changes in the work function of Au upon hexadecanethiol adsorption from decane. All the above investigations give us a better understanding of the photo-degradation processes of the active material at the nanoscale. Also, a method to compare various new materials used for organic solar cells for stability is proposed which eliminates the requirement to make fully functional devices saving time and additional engineering efforts.

Minimizing residential distribution system operating costs through intelligently scheduled plug-in hybrid electric vehicle charging

Rising fuel prices and environmental concerns are threatening the stability of current electrical grid systems. These factors are pushing the automobile industry towards more effcient, hybrid vehicles. Current trends show petroleum is being edged out in favor of electricity as the main vehicular motive force. The proposed methods create an optimized charging control schedule for all participating Plug-in Hybrid Electric Vehicles in a distribution grid. The optimization will minimize daily operating costs, reduce system losses, and improve power quality. This requires participation from Vehicle-to-Grid capable vehicles, load forecasting, and Locational Marginal Pricing market predictions. Vehicles equipped with bidirectional chargers further improve the optimization results by lowering peak demand and improving power quality.