A full spd tight-binding treatment for electronic bands of graphitic tubes

A tight-binding (TB) treatment with the inclusion of d orbitals is applied to the electronic structures of graphitic tubes. The results show that the high angular moment bases in TB scheme are necessary to account the severe curvature effect in ultra-thin single wall carbon nanotubes, especially for properly reproducing the band edge overlap behavior in (5, 0) tube, predicted by the existing ab initio calculations. In the large diameter limit, the participation of two synnmetry-allowed d bases provides a natural replication to the recent measured electronic dispersions of valence band of graphene when the strong anisotropy due to the two-dimensional planar hexagonal sheet structure is dealt with properly. In addition, the detailed relation between the two sets of quantum numbers of screw symmetry and that of zone folding is formulated in appendix. (C) 2008 Elsevier Ltd. All rights reserved.

Raman evidence for atomic correlation between the two constituent tubes in double-walled carbon nanotubes

Four well-resolved peaks with very narrow linewidths were found in the D-band and G'-band features of double-walled carbon nanotubes (DWNTs). This fact implies the occurrence of additional van Hove singularities (vHSs) in the joint density of states (JDOS) of DWNTs, which is consistent with theoretical calculations. According to their peak frequencies and theoretical analysis, the two outer peaks can be deduced to originate from a strong coupling between the two constituent tubes of commensurate DWNTs and the two inner peaks were curvature-related and assigned to originate from the two tubes with a weak coupling. This observation and elucidation constitute the first Raman evidence for atomic correlation and the resulting electronic structure change of the two constituent tubes in DWNTs. This result opens the possibility of predicting and modifying the electronic properties of DWNTs for their electronic applications.

A fast-settling frequency-presetting PLL frequency synthesizer with process variation compensation and spur reduction

This paper proposes a fast-settling frequency-presetting PLL frequency synthesizer. A mixed-signal VCO and a digital processor are developed to accurately preset the frequency of VCO and greatly reduce the settling time. An auxiliary tuning loop is introduced in order to reduce reference spur caused by leakage current. The digital processor can automatically compensate presetting frequency variation with process and temperature, and control the operation of the auxiliary tuning loop. A 1.2 GHz integer-N synthesizer with 1 MHz reference input Was implemented in a 0.18μm process. The measured results demonstrate that the typical settling time of the synthesizer is less than 3μs,and the phase noise is -108 dBc/Hz@1MHz.The reference spur is -52 dBc.

Low conductance injection tubes for storage cell targets

The effect of adding internal fins to the injection tube of a storage cell target filled with a polarized atomic beam source has been studied. The tube conductance and the atomic beam intensity at the exit of the injection tube have been measured, observing an unexpectedly large beam loss. Simulations of the atomic beam reproduce the observed attenuation only when the non-zero azimuthal component of the atom's velocity is taken into account.

Hyperbranched polymer-assisted hydrothermal in situ synthesis of submicrometer silver tubes

We produced silver tubes with an outer diameter of 1 mu m, wall thickness of 200 nm, and length of hundreds of micrometers by hydrothermal treatment of aqueous solutions of AgNO3 and hyperbranched polyglycidol (HPG) at 165 degrees C. The surfaces of the silver tubes were chemically modified by HPG, which was confirmed by FTIR of the silver tubes.

Macroscopic single-crystal tubes assembled with porous supramolecular architecture of water-soluble calixarene and phenanthroline

Single-crystal tubular products on the millimetre scale have been synthesized from water-soluble calixarene and phenanthroline in the presence of lanthanides by a hydrothermal method, in which the extended structures contain some 1D infinite channels.

Preparation of Ga2O3 nanoribbons and tubes by electrospinning

A simple way to synthesize beta-Ga2O3 nanoribbons and tubes by electrospinning is introduced. The diameters of the electrospun fibers range from 150 nm to 2.5 mu m and their lengths reach up to several millimeters. The relationship among precursors, precursor concentrations, and crystal growth of beta-Ga2O3 nanoribbons and tubes are discussed. The structures of beta-Ga2O3 fibers have been investigated by various methods such as thermogravimetric (TG) and differential thermal analysis (DTA), X-ray diffraction, FT-IR, Raman spectra, scanning electron micrograph (SEM), and transmission electron micrograph (TEM).

Settling abalone veliger larvae in a free-swimming microalgal culture

In the current abalone hatchery in China, insufficient diatoms on vertically placed corrugated pvc plates at later stage often could not support the growth of postlarvae up to the stage that they can feed on live macroalgae. As a result, stripping the spats (35 mm) off by anaesthetization and switching the diet from live diatoms to artificial powdered diet in combination has to be performed in most of the abalone farms. This manipulation normally leads to more than 50% mortality. Here we report the direct use of the unicellular green alga Platymonas helgolandica Kylin var. tsingtaoensis as a potential alga to be used to settle the veliger larvae of the Pacific abalone Haliotis discus hannai and to feed the postlarvae. Settlement rate of 2-day-old veliger larvae in mono culture of P helgolandica could be as high as 92% ( +/- 4.2%) on day 10 in small scale trials, higher than that in the selected benthic diatom strain (53.6% +/- 12.7%) when settled in the water in which bacteria propagation was controlled by treatment of 2 ppm of benzylpenicillinum calcium and streptomycin sulfate. Postlarvae fed solely on P. helgolandica or the selected benthic diatom Navicula-2005-A grew at rates of 40.1 ( +/- 1.9) and 45.8 (+/- 13.4) mu m day(-1), respectively, when raised at 22 degrees C until day 50 postfertilization. P. helgolandica was shown to have distinct diurnal settling rhythm characterized with a peak of settled cells in the middle of the night for cell division and a peak of free-swimming cells in the middle of the day. High density of attached P. helgolandica cells on the inner surface of the culture facility in the night fits the nocturnal feeding behavior of the abalone spats. Judged by the promising larvae settling rate, growth and survival rates of the postlarvae fed with this alga, the free-swimming micro-green alga P. helgolandica constitutes a potential species for settling the veliger larvae and for supporting the growth of postlarvae as well. (c) 2006 Published by Elsevier B.V.

Characteristics and flux of settling particulate matter in neritic waters: The southern Yellow Sea and the East China Sea

The typology and flux of settling particulate matter (SPM) were investigated based on sediment trap sampling at six typical stations in the Yellow Sea and the East China Sea. The settling particulate matter in the neritic seas was sorted into three categories, lithogenic particles, living organisms, and particle aggregates. The mass of individual organisms is an important portion of particulate matter in the neritic waters. The aggregates contain six types, mucus aggregates, fecal pellets, diatom aggregates, silicoflagellate aggregates, tintinnids, and miscellaneous aggregates, of which the silicoflagellate aggregates and tintinnids are the most abundant in the Yellow Sea and the East China Sea. High particle fluxes, such as 215 to 874 g m(-2). day(-1) SPM in the bottom layer, were found at three stations where the water was well mixed, and the maximum flux was detected in the boundary area between the Yellow Sea and the East China Sea, where a wide nepheloid layer was present. Hence, particle flux in neritic waters can be easily shifted by water turbulence. The net vertical flux (123 to 961 mg C day(-1)), the contribution of lateral advection to resuspension flux (5 to 76%), and the particulate organic carbon export ratio (18 to 60%) were estimated for the other three stations where the water was stratified. The highest values were all found in the upwelling area off the Zhejiang coast, suggesting that the area of high productivity provides a high net vertical flux of SPM. (C) 2010 Elsevier Ltd. All rights reserved.

Identification of factors affecting the growth and survival of the settling Japanese flounder larvae, Paralichthys olivaceus

A series of experiments were conducted to identify the factors that affected the growth and survival of the settling flounder larvae Paralichthys olivaceus. Settling larvae 24 days after hatching (DAH) were reared in 10-l experimental tanks up to 40 DAH, and two of the following factors were changed as controlled factors in each experiment: light regime (24L:0D or 12L:12D), prey density (1500, 3000, or 5000 Artemia l(-1)), shelter (sand or no sand) and stocking density (5, 10, or 15 fish l(-1)). Early settling larvae (24-35 DAH) experienced little mortality (less than 10% of the overall mortality) that was not significantly affected by above factors. In contrast, late settling larvae (36-40 DAH) suffered high cannibalistic mortality which was significantly influenced by each of the above factors. Larvae experienced significantly lower mortality at 10 fish l(-1) level than at other densities. Larvae at 15 fish l(-1) level had higher mortality than at 5 fish l(-1) when all other factors were identical. Larvae at 3000 and 5000 Artemia l(-1) treatments survived significantly better than at 1500 Artemia l(-1), but no significant differences in larval mortality were found between the two higher densities. Larvae suffered higher mortality at low prey density or at the absence of sand when they were exposed to longer photoperiod. Low stocking density significantly improved the growth of the settling larvae. The average daily instantaneous growth rate (G) at 5 and 15 fish l(-1) treatments were 0.050 and 0.034, with the coefficient of variation (CV) in final length at 16.4 and 23.5, respectively. Daily instantaneous growth rate increased significantly from 0.033 in the 1500 Artemia l(-1) to 0.041 and 0.045 in the 3000 and 5000 Artennia l(-1), respectively, but no significant difference in larval growth existed between the two higher prey densities. These findings suggested that the optimal prey density for growth and survival of the settling flounder larvae at a stocking density of 5 - 15 fish l(-1) was around 3000 Artemia l(-1) . Larvae that were exposed to 24L showed 20% increase in growth ( G = 0.046, CV = 18.7) than those exposed to 12L ( G = 0.037, CV = 20.5). Longer exposure to light significantly improved larval growth, provided sufficient food was available. Sand substrate did not show significant effects on larval growth, possibly because the larvae spent most of the time swimming or feeding in the water column during this stage. (C) 2003 Elsevier Science B.V. All rights reserved.

A review of the effectiveness and meaningfulness of education interventions to enable children, young people and their families to self-care for their gastrostomy tubes in the community.

A systematic review of qualitative and quantitative evidence of the effectiveness and meaningfulness of education interventions to enable children, young people and their families to self-care for their gastrostomy tubes in the community

Chaetopterid tubes from vent and seep sites: Implications for fossil record and evolutionary history of vent and seep annelids

Vestimentiferan tube worms living at deep-sea hydrothermal vents and cold seeps have been considered as a clade with a long and continuing evolutionary history in these ecosystems. Whereas the fossil record appears to support this view, molecular age estimates do not. The two main features that are used to identify vestimentiferan tubes in the fossil record are longitudinal ridges on the tube's surface and a tube wall constructed of multiple layers. It is shown here that chaetopterid tubes from modern vents and seeps—as well as a number of fossil tubes from shallow-water environments—also show these two features. This calls for a more cautious interpretation of tubular fossils from ancient vent and seep deposits. We suggest that: current estimates for a relatively young evolutionary age based on molecular clock methods may be more reliable than the inferences of ancient “vestimentiferans” based on putative fossils of these worms; not all of these putative fossils actually belong to this group; and that tubes from fossil seeps should be investigated for chitinous remains to substantiate claims of their potential siboglinid affinities.

Characterisation and evaluation of novel surfactant bacterial anti-adherent coatings for endotracheal tubes designed for the prevention of ventilator-associated pneumonia.

It is accepted that ventilator-associated pneumonia is a frequent cause of morbidity and mortality in intensive care patients. This study describes the physicochemical properties of novel surfactant coatings of the endotracheal tube and the resistance to microbial adherence of surfactant coated endotracheal tube polyvinylchloride (PVC). Organic solutions of surfactants containing a range of ratios of cholesterol and lecithin (0:100, 25:75, 50:50, 75:25, dissolved in dichloromethane) were prepared and coated onto endotracheal tube PVC using a multiple dip-coating process. Using modulated temperature differential scanning calorimetry it was confirmed that the binary surfactant systems existed as physical mixtures. The surface properties of both surfactant-coated and uncoated PVC, following treatment with either pooled human saliva or phosphate-buffered saline (PBS), were characterised using dynamic contact angle analysis. Following treatment with saliva, the contact angles of PVC decreased; however, those of the coated biomaterials were unaffected, indicating different rates and extents of macromolecular adsorption from saliva onto the coated and uncoated PVC. The advancing and receding contact angles of the surfactant-coated PVC were unaffected by sonication, thereby providing evidence of the durability of the coatings. The cell surface hydrophobicity and zeta potentials of isolates of Staphylococcus aureus and Pseudomonas aeruginosa, following treatment with either saliva or PBS, and their adherence to uncoated and surfactant-coated PVC (that had been pre-treated with saliva) were examined. Adherence of S. aureus and Ps. aeruginosa to surfactant-coated PVC at each successive time period (0.5, 1, 2, 4, 8 h) was significantly lower than to uncoated PVC, the extent of the reduction frequently exceeding 90%. Interestingly, the microbial anti-adherent properties of the coatings were dependent on the lecithin content. Based on the impressive microbial anti-adherence properties and durability of the surfactant coating on PVC following dip coatings, it is proposed that these systems may usefully reduce the incidence of ventilator-associated pneumonia when employed as luminal coatings of the endotracheal tube.