Carboplatin pharmacokinetics following a single-dose infusion in sulphur-crested cockatoos (Cacatua galerita)

Objective To determine the pharmacokinetics of carboplatin in sulphur-crested cockatoos, so that its use in clinical studies in birds can be considered. Design A pharmacokinetic study of carboplatin, following a single intravenous (IV) or intraosseus (10) infusion over 3 min, was performed in six healthy sulphur-crested cockatoos (Cacatua galerita). Procedure Birds were anaesthetised and a jugular vein cannulated for blood collection. Carboplatin (5 mg/kg) was infused over 3 min by the IV route in four birds via the contralateral jugular vein, and by the 10 route in two birds via the ulna. Serial blood samples were collected for 96 h after initiation of the infusion. Tissue samples from 11 organs were obtained at necropsy, 96 h after carboplatin administration. Total Pt and filterable Pt in plasma and tissue Pt concentrations were assayed by inductively coupled plasma-mass spectrometry. A noncompartmental pharmacokinetic analysis was performed on the plasma data. Results The mean +/- SD for the C-max of filterable Pt was 27.3 +/- 4.06 mg/L and in all six birds occurred at the end of the 3 min infusion, thenceforth declining exponentially over the next 6 h to an average concentration of 0.128 +/- 0.065 mg/L. The terminal half-life (T-1/2) was 1.0 +/- 0.17 h, the systemic clearance (CI) was 5.50 +/- 1.06 mL/min/kg and the volume of distribution (Vss) was 0.378 +/- 0.073 L/kg. The extrapolated area under the curve (AUC(0-x)) was 0.903 +/- 0.127 mg/mL.min; the area extrapolated past the last (6 h) data point to infinite time averaged only 1.25% of the total AUC(0-x). The kidneys had the greatest accumulation of Pt (7.04 +/- 3.006 mug/g), followed by the liver (3.08 +/- 1.785 mug/g DM). Conclusions and clinical relevance Carboplatin infusion in sulphur-crested cockatoos produced mild, transient alimentary tract signs and the Pt plasma concentration was similar whether carboplatin was given intravenously or intraosseously. Filterable plasma Pt concentrations for carboplatin persisted longer than for cisplatin, due mostly to the difference in systemic clearance between these drugs in sulphur-crested cockatoos. The distribution of tissue Pt after carboplatin administration was similar to that reported for cisplatin in sulphur-crested cockatoos. Despite anatomical, physiological and biochemical differences among animal species, the pharmacokinetic disposition of filterable Pt in the sulphur-crested cockatoo shares some features with the kinetics reported previously in other animals and human beings.

Carboplatin administration in sulphur-crested cockatoos (Cacatua galerita): Clinical observations

To determine the clinical effect of systemic carboplatin administration in birds, 6 sulphur-crested cockatoos (Cacatua galerita) were anesthetized and infused intravenously or intraosseously with carboplatin at 5 mg/kg over 3 minutes. Four birds were euthanatized 96 hours after infusion and 2 birds given an intravenous dose were euthanatized 21 days after dosing. All birds tolerated the anesthesia and carboplatin infusion and recovered uneventfully. At 24 hours after dosing, all birds were bright and active. Within 12 hours of dosing, feed intake was reduced and 3 birds vomited, but these signs abated by 48 hours after dosing. Mean body weight decreased by 4% at 24 hours after dosing and continued to decrease, but not significantly, until 96 hours after dosing. Changes in packed cell volume (PCV) and plasma total solids reflected blood loss caused by sampling. The mean PCV decreased significantly by 6 hours after dosing, and the concentration of plasma total solids decreased significantly at 1 hour after dosing and continued to decrease until 12 hours after dosing before progressively and significantly increasing toward baseline values by 96 hours after dosing. At necropsy, myelosuppression was not observed in any bird and no evidence of carboplatin toxicity was found. These results provide veterinarians with useful data for formulating efficacious and safe protocols for platinum-containing compounds when treating neoplasia in parrots and other companion birds.

Doxorubicin pharmacokinetics following a single-dose infusion to sulphur-crested cockatoos (Cacatua galerita)

Objective To determine the pharmacokinetics of doxorubicin in sulphur-crested cockatoos, so that its use in clinical studies in birds can be considered. Design A pharmacokinetic study of doxorubicin, following a single intravenous (IV) infusion over 20 min, was performed in four healthy sulphur-crested cockatoos (Cacatua galerita). Procedure Birds were anaesthetised and both jugular veins were cannulated, one for doxorubicin infusion and the other for blood collection. Doxorubicin hydrochloride (2 mg/kg) in normal saline was infused IV over 20 min at a constant rate. Serial blood samples were collected for 96 h after initiation of the infusion. Plasma doxorubicin concentrations were assayed using an HPLC method involving ethyl acetate extraction, reverse-phase chromatography and fluorescence detection. The limit of quantification was 20 ng/mL. Established non-parametric methods were used for the analysis of plasma doxorubicin data. Results During the infusion the mean +/- SD for the C-max of doxorubicin was 4037 +/- 2577 ng/mL. Plasma concentrations declined biexponentially immediately after the infusion was ceased. There was considerable intersubject variability in all pharmacokinetic variables. The terminal (beta-phase) half-life was 41.4 +/- 18.5 min, the systemic clearance (Cl) was 45.7 +/- 18.0 mL/min/kg, the mean residence time (MRT) was 4.8 +/- 1.4 min, and the volume of distribution at steady state (V-SS) was 238 131 mL/kg. The extrapolated area under the curve (AUC(0-infinity)) was 950 +/- 677 ng/mL.h. The reduced metabolite, doxorubicinol, was detected in the plasma of all four parrots but could be quantified in only one bird with the profile suggesting formation rate-limited pharmacokinetics of doxorubicinol. Conclusions and clinical relevance Doxorubicin infusion in sulphur-crested cockatoos produced mild, transient inappetence. The volume of distribution per kilogram and terminal half-life were considerably smaller, but the clearance per kilogram was similar to or larger than reported in the dog, rat and humans. Traces of doxorubicinol, a metabolite of doxorubicin, were detected in the plasma.

Particle and gaseous emissions from compressed natural gas and ultralow sulphur diesel-fuelled buses at four steady engine loads

Exhaust emissions from thirteen compressed natural gas (CNG) and nine ultralow sulphur diesel in-service transport buses were monitored on a chassis dynamometer. Measurements were carried out at idle and at three steady engine loads of 25%, 50% and 100% of maximum power at a fixed speed of 60 kmph. Emission factors were estimated for particle mass and number, carbon dioxide and oxides of nitrogen for two types of CNG buses (Scania and MAN, compatible with Euro 2 and 3 emission standards, respectively) and two types of diesel buses (Volvo Pre-Euro/Euro1 and Mercedez OC500 Euro3). All emission factors increased with load. The median particle mass emission factor for the CNG buses was less than 1% of that from the diesel buses at all loads. However, the particle number emission factors did not show a statistically significant difference between buses operating on the two types of fuel. In this paper, for the very first time, particle number emission factors are presented at four steady state engine loads for CNG buses. Median values ranged from the order of 1012 particles min-1 at idle to 1015 particles km-1 at full power. Most of the particles observed in the CNG emissions were in the nanoparticle size range and likely to be composed of volatile organic compounds The CO2 emission factors were about 20% to 30% greater for the diesel buses over the CNG buses, while the oxides of nitrogen emission factors did not show any difference due to the large variation between buses.

The impact of sulphur content of diesel fuel on ultrafine particle formation

Early this year the Australian Department of Environment and Heritage commissioned a desktop literature review with a focus on ultrafine particles including analysis of health impacts of the particles as well as the impact of sulphur content of diesel fuel on ultrafine particle emission. This paper summarizes the findings of the report on the link between the sulphur content of diesel fuels and the number of ultrafine particles in diesel emissions. The literature search on this topic resulted in over 150 publications. The majority of these publications, although investigating different aspects of the influence of fuel sulphur level on diesel vehicle emissions, were not directly concerned with ultrafine particle emissions. A specific focus of the paper is on: ----- ----- summary of state of knowledge established by the review, and ----- ----- summary of recommendations on the research priorities for Australia to address the information gaps for this issue, and on the appropriate management responses.

Phase-selective hydrothermal synthesis of Cu2ZnSnS4nanocrystals: The effect of the sulphur precursor

High quality Cu2ZnSnS4 (CZTS) films with uniform thickness and smooth surface were prepared using nanocrystals synthesized by a one-step hydrothermal method. It is found that the nature of the sulphur precursor used in the hydrothermal reaction influences both the compositional purity and the crystal structure of the synthesized hydrothermal product significantly. The CZTS material consisting of both wurtzite and kesterite crystal structures was obtained when using an organic sulfur precursor such as thioacetamide and thiourea in the precursor solution of the hydrothermal reaction while the pure kesterite phase CZTS nanocrystals were made when Na2S was employed as the sulphur precursor. CZTS thin films deposited on a Mo–soda lime glass substrate with uniform thickness (1.7 μm) were made by a simple doctor-blading method. The investigation of the effect of thermal treatment on the film has indicated that the wurtzite CZTS material was completely transformed to the kesterite phase when the material was annealed at 550 °C. Large grains (around 2 μm in size) were found on the surface of the CZTS film which was annealed at 600 °C. The evaluation of the photoresponse of the CZTS thin films has showed that a higher and very stable photocurrent was generated by the film annealed at 600 °C compared to the film annealed at 550 °C.

Low temperature fluorination of sulphur compounds with elemental fluorine

Low temperature fluorination technique is adopted for fluorination of the following sulphur compounds in freon-11 medium (1) Sulphur dioxide (2) Thionyl chloride (3) Sulphuryl chloride (4) Tetrasulphur tetra nitride and (5) Sulphur bromide. All the compounds undergo oxidative fluorination to give rise to sulphur-fluorine compounds except sulphuryl chloride which resists fluorination. Sulphuryl chloride thus behaves as a good solvent medium for fluorination of other reactive compounds like elemental sulphur. Details of the experimental procedures adopted and the identification of the products will be presented.

Reactivities of tetrahalosilanes and silane with sulphur trioxide

Reactions of tetrahalosilanes [SiX4 (X= F, Cl or Br)] and silane (SiH4) with sulphur trioxide (SO3) have been studied under different experimental conditions. Each of the silanes behaves differently in accordance with the bond energy of the Si—X bond. While SiF4 remains unreactive even at 600°C, SiCl4 reacts with SO3 at 500°C giving rise to hexachlorodisiloxane [(SiCl3)2O] as the major product. In contrast SiBr4 and SiH4 react with SO3 at room temperature and below room temperature, respectively, yielding silica as one of the products of reaction. In all cases the SO3 is reduced to sulphur dioxide.

A gravimetric procedure for the determination of wet precipitated sulphur, dissolved sulphur, soluble sulphides and hydrogen sulphide

Elemental sulphur (in wet precipitated form or dissolved in organic solvents) and hydrogen sulphide have been determined gravimetrically at room temperature by conversion into copper sulphide by elemental copper in presence of an organic solvent such as benzene or acetonitrile. Any solvent in which sulphur is soluble can be used. The black copper sulphide formed can be weighed or determined iodometrically. Analysis indicates the black compound to be Cu1.8S. This room temperature method is a versatile one-step procedure sensitive to microgram or macro amounts of sulphur. It has been used for determining the solubility of sulphur in tetrahydrofuran and dioxan. The apparent heat of solution indicates that sulphur dissolves in these solvents without any marked solute—solvent interactions.

Reaction of thiophosphoryl fluoride with sulphur trioxide

Thiophosphoryl fluoride is observed to undergo a facile reaction with sulphur trioxide forming phosphoryl fluoride, sulphur dioxide and elemental sulphur in quantitative yields. In the presence of excess of sulphur trioxide, however, the elemental sulphur released combines with it to form sulphur sesquioxide which subsequently decomposes and gives off sulphur dioxide. Similar observations are made with oleum.

The reaction of sulphur tetrafluoride with pyridine

Abstract is not available.